On the recovery of surface wave by pressure transfer function

Except the commonly selected pressure transfer function derived from the linear wave theory, a previous study on the pressure transfer function for recovering surface wave from underwater pressure transducer suggested that the pressure transfer function is a function of frequency parameter only. With careful analysis, this study showed that the pressure transfer function should include a transducer submergence parameter as that given by the linear theory. It was found that the previously suggested empirical formula should be restricted to measurements with the pressure transducer close to the surface; otherwise overestimation of wave height would result. Field measurements were carried out with an acoustic wave gauge and a synchronized pressure transducer located at various depths with submergence parameter close to 1 (near the sea floor). It was shown that the previous one-parameter empirical formula might overestimate the significant wave height by more than 30%. This study found that with deep-water wave bursts excluded, the transfer function based on the linear wave theory provided a fairly good estimation on the significant wave heights, with an average deviation of 3.6%.     

台湾及其邻海的重力特征与构造、地震的关系

分析认为，在台湾及其邻海的重力场中，具有短波长特征的空间重力异常受地形与海深所制约．玉山的200×10     

港口靠船桩工作性状计算的双参数法

港口靠船桩是承受重复性荷载或多循环荷载的一种横向承载桩。双参数法能较好地描述靠船桩 (单桩、群桩 )的桩土工作性状。用双参数法进行计算时 ,所给的地面条件必须由重复荷载或多循环荷载作用下实测出来。根据现场试桩资料 ,标定桩土参数 ,即k =mx1/n的指数l/n、桩土相对柔度系数α、桩土综合刚度EI等值 ,可以用来设计试桩附近局部地区同类条件下的其它长桩。对于没有进行试桩的某些工程 ,可以联合运用双参数法和p -y曲线法进行桩的分析     

利用地下水水位资料推求水文地质参数

依据模糊集合理论,提出了反求水文地质参数的一种新方法,即用模糊模式识别评价计算水位与观测水位的拟合程度,依模糊ISODATA聚类法的原理建立目标函数,以相应的聚类中心作为要求的水文地质参数。     

海岸工程中海浪数值模拟和环境参数选取的进展

主要介绍了我国近的来在海岸工程设计，建设中有关海浪数值模拟及环境参数选取方面的研究进展。     

Wave runup on a concentric twin perforated circular cylinder

The regular wave interaction with a twin concentric porous circular cylinder system consisting of an inner impermeable cylinder and an outer perforated cylinder was studied through physical model and numerical model studies. The experiments were carried out on the twin concentric cylinder model in a wave flume to study the wave runup and rundown at the leading and trailing edges of the perforated cylinder. It was found that the maximum wave runup on the perforated cylinder is almost same as the incident wave height. The experimental results were used to develop the predictive formulae for the wave runup and rundown on the perforated cylinder, which can be easily used for design applications. The wave runup profiles around the perforated cylinder for different values of ka and porosities were studied numerically using Green's Identity Method. The results of the numerical study are presented and compared with the experimental measurements.     

1999年以来台湾及邻近海域7.5级以上强震前的条带现象

中国台湾地区地处欧亚板块与菲律宾海板块之间,地震活动频繁．本文报道了 我国台湾地区及其邻近海域1985～2002年间5．5级以上地震的条带内外频度比分 布,并着重研究了1999—2002年中发生的3次7．5级以上地震前的条带现象．其结 果表明:台湾地区近期发生的3次7．5级以上大地震前,5．5级以上地震呈条带分 布．这些条带符合条带内地震个数Nin≥6的条件,符合条带内、外频度比Nin／(Nin Nout)≥75％的条件,也符合条带长宽比大于5的要求,只是与板内地震条带相比,条 带的长度较短．     

SAS测量水体表观光学参数的方法

SeaWiFS航空模拟器（SAS）是专门为在水面之上测量水体表观光学参数的现场设备。文章在介绍SAS现场测量以及数据处理基本方法的基础上，分析了2002年黄海试验SAS的应用效果，并与剖面法测量数据进行了比对。     

中国海区区域地质编图中重磁图的编制方法

本文简要介绍了局控项目《中国海区１∶５０万区域地质编图（大连幅）》重力异常图、磁力异常图的编制过程，给出了一种以计算机为手段、实现编图自动化的新方法，并分析了该方法与以往编图方法的不同和优点，以国际分幅在中国海区开展区域地质编图尚属首次，在既无海区地质调查规范，又无海区地质调查编图规范的情况下，这一工作无异具有开创性。从理论上系统总结出一套切实可行的编图方法，对于编制中国海区区域地质调查编图规范以     

合浦珠母贝卵子电击脉冲参数的初步研究

运用电脉冲转基因仪对合浦珠母贝卵子进行电脉冲处理以优化电穿孔法转基因的电击参数。实验中调制百分比：100％；脉冲间隔：1．0s：电极距离：2mm；脉冲个数：5个，参数保持不变。用不同的电脉冲参数组合（脉冲电压100-400V、脉冲持续时间0．5～3．0ms、脉冲频率10～50kHz，共28个组合）对卵子电击，然后加入精子进行授精，统计各组受精率和孵化率，以受精率和孵化率达到50％以上为衡量指标。结果表明，合浦珠母贝卵子对低脉冲频率和高电压非常敏感，当频率低于20kHz或脉冲电压高于400V时对卵子损伤较大。脉冲持续时间对其影响不大，适应范围较宽。优化的转基因电击脉冲参教组合为：脉冲电压1.0kV／cm，脉冲持续时间20ms，脉冲频率50kHz，或者脉冲电压1．5kV／cm，脉冲持续时间1．5ms，脉冲频率50kHz。