Strain accumulation in sand due to cyclic loading: drained triaxial tests

Our aim is the prediction of the accumulation of strain and/or stress under cyclic loading with many (thousands to millions) cycles and relatively small amplitudes. A high-cycle constitutive model is used for this purpose. Its formulas are based on numerous cyclic tests. This paper describes drained tests with triaxial compression and uniaxial stress cycles. The influence of the strain amplitude, the average stress, the density, the cyclic preloading history and the grain size distribution on the direction and the intensity of strain accumulation is discussed.     

Effect of the Mahanadi River on the Development of Storm Surge Along the Orissa Coast of India: A Numerical Study

River-ocean coupled models are described for the evaluation of the interaction between river discharge and surge development along the Orissa coast of India. The models are used to study the effect of fresh water discharge from the Mahanadi River on the surge response along the Orissa coast due to the October 1999 super cyclone which led to severe flooding of the coastal and delta regions of Orissa. The so-called 1999 Paradip cyclone was one of the most severe cyclones; causing extensive damage to property and loss of lives. The present study emphasizes the impact of the Mahanadi River on overall surge development along the Orissa coast. Therefore, we have developed a location specific fine resolution model for the Orissa coast and coupled it with a one–dimensional river model. The numerical experiments are carried out, both with and without inclusion of fresh water discharge from the river. The bathymetry for the model has been taken from the naval hydrographic charts extending from the south of Orissa to the south of west Bengal. A simple drying scheme has also been included in the model in order to avoid the exposure of land near the coast due to strong negative sea-surface elevations. The simulations with river-ocean coupled models show that the discharge of fresh water carried by the river may modify the surge height in the Bay, especially in the western Bay of Bengal where one of the largest river systems of the east coast of India, the Mahanadi River, joins with the Bay of Bengal. Another dynamic effect of this inlet is the potentially deep inland penetration of the surge originating in the Bay. The model results are in good agreement with the available observations/estimates.     

Numerical model of convection in sills

The numerical model of convection in magma sills is developed. The model is based on a full system of equations of fluid dynamics and includes heat transfer, buoyancy effects and diffusion of some minor component (marker). Solidification is treated as a phase transition. The results indicate that there are some qualitative differences between very thin sills with Rayleigh number Ra = 10⁵ and thin sills with Ra = 10⁶. For a basaltic magma the first case corresponds to the thickness of the sills of approximately 30 cm and the second case corresponds to the thickness of 60 cm. In the first case mixing is inefficient and conduction is the dominant form of heat transfer. In the second case mixing is efficient and convection is the dominant form of heat transfer. Some of the results can be scaled for the more viscous magmas in thicker sills.     

Study on the Source Parameters of Earthquakes in the Middle Eastern Area of North Tianshan in Xinjiang

INTRODUCTIONThe study of source parameters is usually based oninversionfromobservational seismic waveformdata.Seismic wave affected bygeometric spreading,inelastic attenuation,scatteringandsite effects ofthe mediumontheir way fromsource to station.Therefo…     

A comparative study of concentrated plasticity models in dynamic analysis of building structures

Concentrated plasticity (CP) models are frequently used in static and dynamic building analysis and have been implemented in available commercial software. This investigation deals with three different CP‐models, a simplified macroelement model (SEM) for a complete building story, a frame element with elasto‐plastic interaction hinges (PH), and a frame element with fiber hinges (FB). The objectives of this work are to evaluate the quality of the earthquake responses predicted by these models and to identify important aspects of their implementation and limitations for their use in dynamic analysis. The three elements are tested in a single‐story asymmetric plan building and in a three‐story steel building. Results show that base shear and global response values are usually computed with better accuracy than interstory deformations and local responses. Besides, the main limitation of elasto‐plastic CP models is to control the displacement offsets that result from perfect elasto‐plastic behavior. On the other hand, calibration of the SEM‐model shows that global responses in steel structures may be computed within 20% error in the mean at a computational cost two orders of magnitude smaller than that of the other CP elements considered. However, the three element models considered lead to increasing levels of accuracy in the dynamic response and their use depends on the refinement of the analysis performed. Copyright © 2005 John Wiley & Sons, Ltd.     

Pseudo‐dynamic seismic response of reinforced concrete frames infilled with non‐structural brick masonry

This paper presents pseudo‐dynamic test results on the in‐plane seismic behaviour of infilled frames. Thirteen single‐storey, single‐bay, half‐size‐scale, reinforced concrete‐frame specimens, most of which infilled with non‐structural masonry made of perforated bricks and cement mortar are tested. The infills are in contact with frames, without any connector; openings are not covered. The frames are different in their strength and details, reinforcement grade, and aspect ratio. Seismic input is the 1976 Tolmezzo (Friuli, Italy) ground acceleration, to which specimens are subjected two times: virgin and damaged by the previous test. The global seismic response of initially virgin infilled specimens considerably differs from that of bare specimens. This follows a dramatic change of properties: compared to a bare frame, the initial stiffness increases by one order of magnitude, and the peak strength more than doubles. The peak drift lessens; however, the displacement ductility demand does not. The energy demand is greater. Nevertheless, the influence of infill decreases as damage proceeds. Displacement time histories of damaged specimens are quite similar. At the local level, infill causes asymmetry and concentration of the frame deformation. Copyright © 2005 John Wiley & Sons, Ltd.     

A practical method for estimating dynamic soil stiffness on surface of multi‐layered soil

It is important to estimate the influence of layered soil in soil–structure interaction analyses. Although a great number of investigations have been carried out on this subject, there are very few practical methods that do not require complex calculations. In this paper, a simple and practical method for estimating the horizontal dynamic stiffness of a rigid foundation on the surface of multi‐layered soil is proposed. In this method, waves propagating in the soil are traced using the conception of the cone model, and the impulse response function can be calculated directly and easily in the time domain with a good degree of accuracy. The characteristics of the impedance, that is the transformed value to the frequency domain of the obtained impulse response, are studied using two‐ to four‐layered soil models. The cause of the fluctuation of impedance is expressed clearly from its relation to reflected waves from the lower layer boundary in the model. Copyright © 2005 John Wiley & Sons, Ltd.     

Developing efficient scalar and vector intensity measures for IDA capacity estimation by incorporating elastic spectral shape information

Scalar and vector intensity measures are developed for the efficient estimation of limit‐state capacities through incremental dynamic analysis (IDA) by exploiting the elastic spectral shape of individual records. IDA is a powerful analysis method that involves subjecting a structural model to several ground motion records, each scaled to multiple levels of intensity (measured by the intensity measure or IM), thus producing curves of structural response parameterized by the IM on top of which limit‐states can be defined and corresponding capacities can be calculated. When traditional IMs are used, such as the peak ground acceleration or the first‐mode spectral acceleration, the IM‐values of the capacities can display large record‐to‐record variability, forcing the use of many records to achieve reliable results. By using single optimal spectral values as well as vectors and scalar combinations of them on three multistorey buildings significant dispersion reductions are realized. Furthermore, IDA is extended to vector IMs, resulting in intricate fractile IDA surfaces. The results reveal the most influential spectral regions/periods for each limit‐state and building, illustrating the evolution of such periods as the seismic intensity and the structural response increase towards global collapse. The ordinates of the elastic spectrum and the spectral shape of each individual record are found to significantly influence the seismic performance and they are shown to provide promising candidates for highly efficient IMs. Copyright © 2005 John Wiley & Sons, Ltd.     

"云娜"台风的监视和预报

2004年“云娜”台风的监视和预报工作中，在应用常规天气资料的基础上加强了对历史热带气旋资料、天气雷达资料和过去对台风与台风暴雨分析预报研究成果的运用。在台风登陆前、登陆过程中和登陆后三个不同阶段中，应用多种资料进行有针对性的分析判断，并向防台风指挥部门及时提供信息服务，在防台工作中发挥了有效作用。，     

在卸荷产生拉剪情况下裂隙岩体的力学行为

据岩体在卸荷情况下的拉剪应力状态,确定了节理岩体的线弹性断裂力学模型。依照此模型,可以得到相对远离裂隙(该位置的点到裂隙中心的距离比裂缝长度大)且受裂隙影响区域内应力、应变和变形方程。这些对评估裂隙岩石变形有重要的参考意义。通过用理论方程的计算结果和卸荷情况下试验观测所得的数据对比,证明该模型应用于实际工程中具有可行性。