A high‐speed digital camera was employed to record the sand grain/bed collision process. With image processing and a statistical method, a series of parameters of the collision process were obtained. The results show that the collision process of a grain with rebounding can be represented by two parameters: the kinetic energy restitution coefficient and the collision angle. Both parameters satisfy a normal distribution, and they are dependent on one another. With an increase of the collision angle, the distribution of the kinetic energy restitution gradually reduces from a broad to a narrow range with low values. The percentage of vertical velocity restitution coefficients greater than 1 can reach 70% or more, which ensures that the settling time of the sand grains in the air increases and that they receive more energy from the air to progress the saltation movement. 相似文献
We designed a new seismic source model for Italy to be used as an input for country-wide probabilistic seismic hazard assessment (PSHA) in the frame of the compilation of a new national reference map.
We started off by reviewing existing models available for Italy and for other European countries, then discussed the main open issues in the current practice of seismogenic zoning.
The new model, termed ZS9, is largely based on data collected in the past 10 years, including historical earthquakes and instrumental seismicity, active faults and their seismogenic potential, and seismotectonic evidence from recent earthquakes. This information allowed us to propose new interpretations for poorly understood areas where the new data are in conflict with assumptions made in designing the previous and widely used model ZS4.
ZS9 is made out of 36 zones where earthquakes with Mw > = 5 are expected. It also assumes that earthquakes with Mw up to 5 may occur anywhere outside the seismogenic zones, although the associated probability is rather low. Special care was taken to ensure that each zone sampled a large enough number of earthquakes so that we could compute reliable earthquake production rates.
Although it was drawn following criteria that are standard practice in PSHA, ZS9 is also innovative in that every zone is characterised also by its mean seismogenic depth (the depth of the crustal volume that will presumably release future earthquakes) and predominant focal mechanism (their most likely rupture mechanism). These properties were determined using instrumental data, and only in a limited number of cases we resorted to geologic constraints and expert judgment to cope with lack of data or conflicting indications. These attributes allow ZS9 to be used with more accurate regionalized depth-dependent attenuation relations, and are ultimately expected to increase significantly the reliability of seismic hazard estimates. 相似文献
MODFLOW is a groundwater modeling program. It can be compiled and remedied according to the practical applications. Because
of its structure and fixed data format, MODFLOW can be integrated with Geographic Information Systems (GIS) technology for
water resource management. The North China Plain (NCP), which is the politic, economic and cultural center of China, is facing
with water resources shortage and water pollution. Groundwater is the main water resource for industrial, agricultural and
domestic usage. It is necessary to evaluate the groundwater resources of the NCP as an entire aquifer system. With the development
of computer and internet information technology it is also necessary to integrate the groundwater model with the GIS technology.
Because the geological and hydrogeological data in the NCP was mainly in MAPGIS format, the powerful function of GIS of disposing
of and analyzing spatial data and computer languages such as Visual C and Visual Basic were used to define the relationship
between the original data and model data. After analyzing the geological and hydrogeological conditions of the NCP, the groundwater
flow numerical simulation modeling was constructed with MODFLOW. On the basis of GIS, a dynamic evaluation system for groundwater
resources under the internet circumstance was completed. During the process of constructing the groundwater model, a water
budget was analyzed, which showed a negative budget in the NCP. The simulation period was from 1 January 2002 to 31 December
2003. During this period, the total recharge of the groundwater system was 49,374 × 106 m3 and the total discharge was 56,530 × 106 m3 the budget deficit was −7,156 × 106 m3. In this integrated system, the original data including graphs and attribution data could be stored in the database. When
the process of evaluating and predicting groundwater flow was started, these data were transformed into files that the core
program of MODFLOW could read. The calculated water level and drawdown could be displayed and reviewed online. 相似文献
Flood mapping requires the combination and integration of geomorphological and hydrological-hydraulic methods; however, despite
this, there is very little scientific literature that compares and validates both methods. Two types of analysis are addressed
in the present article. On the one hand, maps of flood plains have been elaborated using geomorphological evidence and historical
flood data in the mountainous area of northwestern Spain, covering an area of more then 232 km2 of floodplains. On the other hand, a hydrometeorological model has been developed (Clark semidistributed unit hydrograph)
in the Sarria River basin (155 km2, NW Spain). This basin is not gauged, hence the model was subjected to a goodness-of-fit test of its parameter (curve number)
by means of Monte Carlo simulation. The peak flows obtained by means of the hydrological model were used for hydraulic modeling
(one-phase, one-dimensional and steady flow) in a 4 km2 urban stretch of the river bed. The delineation of surface areas affected by floods since 1918, as well as those analyzed
subsequent to the geomorphological study, reveals a high degree of reliability in the delineation of the flooded areas with
frequent recurrence intervals (<50 years). If we compare these flooded surface areas with the estimate obtained by the hydrological-hydraulic
method we can see that the latter method overestimates the extent of the surface water by 144% for very frequent recurrence
intervals (>10 years) and underestimates it as the recurrence interval increases, by up to 80% less floodplain for exceptional
events (>500 years). Finally, a management map is put forth combining the most reliable results available by integrating both
methods.
Originally presented at the Sixth International Conference on Geomorphology. 相似文献
The Orissa coast of India is one of the most vulnerable regions of extreme sea levels associated with severe tropical cyclones.
There was extensive loss of life and property due to the October 1999 super cyclone, which devastated large part of the Orissa
coast. The shallow nature of the head bay, presence of a large number of deltas formed by major rivers of Orissa such as Mahanadi
and Dhamra, and high tidal range are responsible for storm surge flooding in the region. Specifically, rising and falling
tidal phases influence the height, duration, and arrival time of peak surge along the coast. The objective of the present
study is to evaluate the tide-surge interaction during the 1999 Orissa cyclone by using nonlinear vertically integrated numerical
models. The pure tidal solution for the head bay region of the Bay of Bengal provides the initial condition for the fine resolution
nested grid Orissa model. However, the feedback from the Orissa model does not affect the head bay model as the study provides
a one-way interaction. Numerical experiments are performed to study the tide-surge interaction by considering various relative
phases of the tidal waves with the surge-wave produced by 1999 Orissa cyclone. The comparison, although utilizing only the
limited estimates of tidal data, appears adequate to assert that the principal features are reproduced correctly. 相似文献
Summary Structural non-stationarity of surface roughness affects accurate morphological characterization as well as mechanical behaviour
of rock joints at the laboratory scale using samples with a size below the stationarity threshold. In this paper, the effect
of structural non-stationarity of surface roughness is investigated by studying the scale dependence of surface roughness
and mechanical behaviour of rock joints. The results show that the structural non-stationarity mainly affects the accurate
characterization of the surface roughness of the fracture samples. It also controls the amount and location of the contact
areas during shear tests, which in turn affects the mechanical properties and asperity degradation of the samples. It is concluded
that for accurate determination of the morphological and mechanical properties of rock joints at laboratory and field scales,
samples with size equal to or larger than the stationarity threshold are required.
Author’s address: Nader Fardin, Rock Mechanics Group, Department of Mining Engineering, Faculty of Engineering, University
of Tehran, P.O. Box: 11365/4563, Tehran, Iran 相似文献
In this article, analytical methods have been used to estimate ground motion during the 8 October 2005, Kashmir earthquake.
Peak ground acceleration (PGA) values at several stations in the epicentral region have been estimated by empirical analytical
source mechanism models. As an alternate analysis, PGA estimates have also been obtained using the stochastic finite fault
seismological model. The estimated PGAs are compared with that obtained from damage values. A PGA contour map in the near-source
region is provided. It is found that very near to the epicenter, PGA would have reached more than 1 g. It is demonstrated
that empirical analytical models can be effectively used to estimate ground motion due to rupture of active faults. 相似文献