高层建筑地震反应全反馈主动TMD控制理论研究

本文应用最近提出的全反馈主动控制法对高层建筑地震反应进行了全反馈主动ＴＭＤ（调谐质量阻尼器）控制的理论研究，考虑了实时控制过程中控制力的时间滞后效应，并通过数值模拟分析了不同的反馈形式以及不同的时间滞后量对主动ＴＭＤ控制效果的影响。最后得出结论：对高层建筑地震反应实施全反馈主动ＴＭＤ控制，既能更有效地降低结构的位移反应和速度反应，又能大幅度地降低结构的加速度反应；且当控制力时间滞后量较大时，对主动     

采用基础摩擦隔震房屋高宽比限值的研究

大量的试验结果和地震经验表明，采用基础隔震方法能有效地提高建筑物的抗震能力，但建筑物的高度在什么范围，即建筑物的高宽比在什么范围内才适合采用这种方法，仍然是一个有待解决的课题。本文对采用基础滑移隔震多层砌体房屋在实际地震作用下的抗倾覆高宽比限值进行了研究，利用Ｗｉｌｓｏｎ－θ数值积分方法计算，得到了多层砌体房屋的高宽比限值的统计值。其数值结果可供编制建筑隔震设计规程参考。     

既有房屋饱和土地基极限承载力增长的探讨

饱和土地基在既有房屋长期荷载作用下,地基土强度参数值随着地基土的排水固结和压密而提高,地基极限承载力也同时增大,如何估算此提高值而挖掘其潜力,传统方法只是借助于统计回归讨论了设计承载力。本文从土力学基本原理出发,借助Prandtl假定,对既有房屋饱和土地基极限承载力的增长进行了探讨。     

Surface chemical analysis in coal preparation research: complementary information from XPS and ToF-SIMS

The application of X-ray photoelectron spectroscopy (XPS) to coal surface characterisation for preparation research is described. Progress towards the acquisition of complementary surface chemical information by time-of-flight secondary ion mass spectrometry (ToF-SIMS) is also discussed. Surface-based beneficiation techniques such as flotation are assuming greater importance as the proportion of fines in raw coal increases due to the proliferation of high capacity mining methods. A necessary condition for the floatability of a coal particle is adequate hydrophobicity, and the degree of hydrophobicity of the flotation concentrate is one factor influencing the ease with which its dewatering can be affected. The hydrophobicity of a coal is very difficult to measure directly because of microporosity, and it is often necessary to deduce the degree of hydrophobicity from a knowledge of the surface chemistry. XPS is able to provide sufficient analytical data to allow relative levels of hydrophobicity to be estimated. In principle, ToF-SIMS should be able to supply additional information enabling refinement of such estimates; however, there are insufficient data at present to allow the ionic fragments detected to be related to specific functional groups at the coal surface.     

秦岭造山带地壳构造与楔入成山

横穿秦岭的河南叶县至湖北南漳的反射地震剖面揭示，秦岭造山带地壳由一系列由南向北楔入到中地壳的鳄鱼式构造所组成。南北溱岭上地壳分别形成南秦岭和北秦岭推覆系。北秦岭推覆系是组成基底的地壳沿脆转换面拆离冲叠形成的一个推覆系，可以分出栾川推覆体，瓦穴子推覆体，二郎坪推覆体及朱夏推覆体。     

钻孔扩底灌注桩施工新工艺

本文介绍钻孔扩底灌注桩的施工新工艺，多应式扩底钻头特点，成桩技术标准，适用范围及经济效益分析。     

建筑结构抗震能力评估技术的研究及应用

简要介绍影响建筑结构抗震能力的主要因素，重点评述目前建筑结构抗震能力评估的主要技术方法并指出其存在的问题，展望今后抗震能力评估技术的应用及发展趋势。     

A modal pushover analysis procedure to estimate seismic demands for unsymmetric‐plan buildings

An Erratum has been published for this article in Earthquake Engng. Struct. Dyn. 2004; 33:1429. Based on structural dynamics theory, the modal pushover analysis (MPA) procedure retains the conceptual simplicity of current procedures with invariant force distribution, now common in structural engineering practice. The MPA procedure for estimating seismic demands is extended to unsymmetric‐plan buildings. In the MPA procedure, the seismic demand due to individual terms in the modal expansion of the effective earthquake forces is determined by non‐linear static analysis using the inertia force distribution for each mode, which for unsymmetric buildings includes two lateral forces and torque at each floor level. These ‘modal’ demands due to the first few terms of the modal expansion are then combined by the CQC rule to obtain an estimate of the total seismic demand for inelastic systems. When applied to elastic systems, the MPA procedure is equivalent to standard response spectrum analysis (RSA). The MPA estimates of seismic demand for torsionally‐stiff and torsionally‐flexible unsymmetric systems are shown to be similarly accurate as they are for the symmetric building; however, the results deteriorate for a torsionally‐similarly‐stiff unsymmetric‐plan system and the ground motion considered because (a) elastic modes are strongly coupled, and (b) roof displacement is underestimated by the CQC modal combination rule (which would also limit accuracy of RSA for linearly elastic systems). Copyright © 2004 John Wiley & Sons, Ltd.     

A Model-Based Approach to Semi-Automated Reconstruction of Buildings from Aerial Images

Automated reconstruction of building objects from aerial images is a complex problem due to the diversity of buildings as well as noise and low contrast of images, which are the results of distant photography, atmospheric effects and poor illumination. In this paper, a semi-automated approach to the reconstruction of parametric building models from aerial images is presented, which works with line segments extracted from the image. The model is selected interactively from a library of parametric models. A perceptual grouping technique is used to select the most significant image lines in terms of relations such as proximity and parallelism. Model lines are searched for the same relations as in the grouped image lines, and the corresponding lines undergo a matching procedure, which determines whether or not a match can be found between the given model and image lines. An experiment with aerial images of flat-roof and gable-roof buildings is shown and its results indicate the robustness and efficiency of the proposed approach.