黄海、东海区域漫衰减系数光谱遥感反演及激光测深性能评估

本文在总结和比较中国现有黄海、东海海域漫衰减系数反演算法的基础上,利用水色测量数据分析得到漫衰减系数Kd(532)与Kd(490)之间的关系,为激光测深系统(以CZMIL为例)的性能评估提供了基础。利用MODIS二级数据产品评估了中国黄海、东海海域在CZMIL海道测量模式下最大可测水深的空间分布。研究结果表明CZMIL在黄海、东海海域可测水深基本在0—50 m,该区域的面积占研究区域面积的比例为76.2%,为浅海海域开展激光测深作业提供了测深能力评估的依据和方法。     

机载激光雷达技术和摄影测量匹配技术在DEM生产中的应用

机载激光雷达技术和摄影测量匹配技术是国内制作DEM最为常见的两种技术,本文对这两种技术的作业流程及优缺点进行了详细论述,并在实验中将这两种技术组合应用,最终证明这两种技术如果能恰当地组合使用,可在DEM生产中显著提高生产效率.     

Scale factor calibration of a superconducting gravimeter at Esashi Station, Japan, using absolute gravity measurements

The scale factor of a superconducting gravimeter (SG) at the Esashi Earth Tides Station, Japan, was revised by repeating co-located absolute gravity measurements with an FG5 gravimeter. Although the calibration results from the absolute gravimeter (AG) show an apparent secular change in the scale factor of the SG (0.4% for the period 1993–2002), the relative scale factors, which are determined by tidal analysis with the response method, indicate that it has changed by no more than 0.01% during the above period. If the mean scale factor over the 10 years is adopted, a value of –56.082±0.029 Gal/V (1 Gal =10^–8 m s^–2) is obtained, which is about 0.4% smaller than that used in the global geodynamics project (GGP) database. Based on this newly determined scale factor, the tidal gravity factors at Esashi have been re-estimated. The observed tidal factors, corrected for the ocean tide effects with recent models, indicate that the theoretical gravity factors for an inelastic Earth model are more consistent with the observations than are those for an elastic model.     

Arsenic Speciation in Lichens and in Coarse and Fine Airborne Particulate Matter by HPLC–UV–HG–AFS

A three-step sequential extraction procedure with Milli-Q, CaCl₂ and H₃PO₄ was applied for extraction of arsenic species in lichen transplants and airborne particulate matter (fine and coarse fractions). The samples used in this work were collected in 1994–1995 near coal-fired power plants. Both transplant lichens and airborne particulate matter were submitted to the same environment simultaneously. Arsenic species identification and quantification was performed by HPLC–UV–HG–AFS. Inorganic forms of arsenic (arsenite and arsenate) were present in significant amounts in most of the samples. Only in lichens also organic forms of arsenic (monomethyl arsonic acid and dimethyl arsinic acid) were identified which may indicate biotransformation of inorganic arsenic.     

航空重力测量数据向下延拓中空间协方差函数特性研究

本文通过对航空重力测量数据的分析,建立起具有空间相关特性的空间协方差函数模型。利用所建立的模型,将航空重力测量试验数据采用最小二乘配置的方法向下延拓到地面,与地面已知重力数据进行比较。由比较结果,分析了空间协方差函数模型对航空重力测量数据向下延拓结果的影响,并表明所建立的空间协方差函数模型,满足协方差函数特性,且在局部区域使用能够达到满意的精度要求。     

高分辨率机载SAR影像判读实验

近年来机载SAR系统在国内得到快速发展。由于SAR系统具有不同于光学传感器的成像机理,因而可以提供全新的数据获取手段和不同的地物信息。利用高分辨率机载SAR影像进行解译时必须熟悉其成像机理和图像信息特点,充分了解SAR图像解译标志的特点和各类地物的解译规律。本文以高分辨率机载SAR数据为基础,对比光学影像,从SAR成像特点和地物散射特性出发,对SAR影像进行了目视解译,分析了SAR影像在地形地物要素识别中的应用潜力。     

系统自振对绝对重力仪的影响模式分析

隔振问题是绝对重力仪研制中的关键技术难题之一。在自主研制"小型mGal级绝对重力仪"过程中发现,除了需要克服地面振动的影响之外,系统自振的影响也不容忽视,最大能达到mGal量级。通过对研制样机实验观测结果的分析,研究了系统自振产生的原因以及对系统偏差与观测内符合精度的影响模式,并给出了改进方案,以消除"系统自振"的影响,提高研制仪器的观测精度。     

利用CG-5重力仪标定动态检定场

介绍了使用CG-5相对重力仪对宝坻重力仪动态精度检定场进行标定的情况,并对观测成果精度进行了分析,实现了对检定场的成功标定。     

空气滤膜采集大气浮尘样品中多元素的测定

用氢氟酸-盐酸-硝酸-高氯酸体系对空气滤膜上附着的浮尘样品进行分解,电感耦合等离子体发射光谱法、电感耦合等离子体质谱法同时测定溶液中15个主量和微量元素铁、铜、锌、镍、镧、铈、锂、锰、铬、镉、钴、铅、钍、铊、铀。将国家一级标准物质模拟浮尘样品加入空白滤膜进行测定,结果与标准值相符。各元素4次测定结果的相对标准偏差(RSD)小于5%。     

Effect of flying altitude and pulse repetition frequency on laser scanner penetration rate for digital elevation model generation in a tropical forest

In tropical forests, the penetration ability of airborne laser scanning (ALS) may be limited because of highly dense vegetation cover. However, in the typical planning of ALS surveys, the ability of laser pulses to penetrate forests is not considered. Nine round-trip flight lines covering the area of a tropical forest on the northeast side of the Tsengwen Reservoir in Taiwan were designed in this study. Five flight lines flew at altitudes of 1.525, 1.830, 2.135, 2.440, and 2.745 km, and the other four had pulse repetition frequencies (PRFs) of 100, 150, 200, and 250 kHz. The laser penetration index (LPI) is a quantitative index measuring the penetration ability of the ALS and consists of the ratio of the number of laser pulses reaching the forest floor to the total number of laser pulses. The LPI was used to represent the laser penetration rate and investigate the influence of flying altitude and PRF on the LPI. The results showed that as the flying altitude decreased by 1 km, the average LPI increased by 10%, and as the PRF decreased by 50 kHz, the average LPI increased by 2%. The effect of the LPI on digital elevation models (DEMs) was confirmed by visual images obtained by DEMs at five altitudes. The DEM obtained at an altitude of 2.745 km was coarsely textured, whereas that obtained at an altitude of 1.525 km was finely textured. The in-situ height data obtained from the electronic Global Navigation Satellite System (eGNSS) were compared with the data of the ALS-generated DEMs. The results indicated that when the LPI ≥60%, the height difference between the in situ data and DEM data was not prominent. However, when the LPI <60%, the ALS-derived DEM could be higher or lower than the in-situ height; the largest difference between the two was 1.7 m. The LPI of a forest should be considered for ALS survey planning, especially when consistent DEM precision for large tropical forest areas is paramount.