煤炭资源勘查误差理论研究

对煤炭资源勘查资源量与客观物质量之间差值的误差理论探讨,提出误差由真值误差、系统误差和离差3个基本部分组成,其中真值误差是不可消除的观测误差、系统误差是控制网度所决定的准确度标准、而离差是由地质构造及矿床形态的多解性产生的资源量波动。在此基础上,构筑了一个关于误差的数学模型,最后应用误差理论对现行勘查工作中常见的错误进行分析,并就如何避免错误及减少误差提出了见解。     

对提高导航型GPS定位精度之工作方法的探讨

论文主要介绍了导航型GPS坐标转换参数的计算方法和测量误差的改正方法。该方法的要点是通过实测多个公共点来计算坐标转换参数,以此获得较好的转换精度;并进一步对观测结果加以误差改正,从而提高其定位精度。     

单中继星单低轨卫星的联合定轨精度分析

针对由单中继星和单低轨卫星组成的联合定轨系统,给出了系统内不同轨道卫星摄动项的选取方案和卫星间的可见性判别模型。在模拟出含有白噪声的四程测距观测数据文件的基础上,研究了测距精度和采样弧段对联合定轨中高、低轨卫星定轨精度的影响。得出如下结论:联合定轨更有利于对低轨卫星的轨道改进;同样的采样时间条件下,测距噪声越小定轨精度越高,并且采样时间越短它的影响越明显;同样的测距噪声条件下,所用资料的采样时间越长精度越高,但当测距精度很高时,TDRS达到最好定轨精度所需的采样时间相应有所缩短。并在定出轨道后进行了轨道预报,分析了轨道预报的趋势及精度。     

GPS单点测速的误差分析及精度评价 (英文)

Error sources which decrease the accuracy of GPS in absolute velocity determination have been changed since SA was turned off. Firstly, quantities of all kinds of error sources that influence velocity determination are analyzed. The potential accuracy of GPS absolute velocity determination is derived from both theory and field GPS data simulation. After that, two tests were carried out to evaluate the performance of GPS absolute velocity determination in the case of a static and an airborne GPS receiver and INS （Inertial Navigation System） instrument in kinematic mode. In static mode, the receiver velocity has been estimated to be several mm/s with the carrier-phase derived Doppler measurements, and several cm/s with the receiver generated Doppler measurements. In kinematic mode, GPS absolute velocity estimates are compared with the synchronized measurements from the high accuracy INS. The root mean square statistics of the velocity discrepancies between GPS and INS come up to dm/s. Moreover, it has a strong correlation with the acceleration or jerk of the aircraft.     

北京市地铁暗挖施工沉降控制探讨

仅以北京市地铁4#线张自忠车站主体暗挖施工的沉降监控项目为研究背景,对穿越城市主干道的车站结构暗挖施工进行连续性的沉降变形监测;从地下构筑物暗挖施工的工序变化与地表沉降的关系进行试验研究.在预测基础上对获取的数据进行多层次的统计与分析,以研究其变形规律与稳定性,实现了信息化施工.     

全站仪似水准法和对向法高程测量的比较研究

通过对似水准法和对向法高程测量原理、误差来源及精度的比较分析,我们发现随着距离和竖直角度的增大,对向法高程测量中误差的变化大于似水准法高程测量中误差的变化;当两观测点间的水平距离小于等于1km时,对向法高程测量精度一般高于似水准法高程测量精度,但是当两观测点间的水平距离大于1km时,似水准法高程测量精度一般高于对向法高程测量精度。     

基于LBV变换的遥感影像多步骤分类法研究

面对与日俱增的遥感数据,如何快速准确地进行影像分类成为遥感领域亟待解决的问题。本文在前人的基础上提出了一种基于LBV变换的遥感影像多步骤分类方法。L:地物的总辐射水平,集中反映了裸地的信息;B:地物的可见-红外光辐射平衡,是地面水分状况和水体存在的一个良好指标;V:地物辐射随波段变化的方向和速度向量,能集中反映地面植被状况。多步骤分类法遵循由易到难的原则,能克服类别之间的互相影响,从而提高分类精度。文章结合LBV变换和多步骤分类法的优点对影像进行了分类,结果表明该方法简单易行,且能达到良好的分类精度。     

Accuracy assessment of lidar-derived digital elevation models

Despite the relatively high cost of airborne lidar-derived digital elevation models (DEMs), such products are usually presented without a satisfactory associated estimate of accuracy. For the most part, DEM accuracy estimates are typically provided by comparing lidar heights against a finite sample of check point coordinates from an independent source of higher accuracy, supposing a normal distribution of the derived height differences or errors. This paper proposes a new methodology to assess the vertical accuracy of lidar DEMs using confidence intervals constructed from a finite sample of errors computed at check points. A non-parametric approach has been tested where no particular error distribution is assumed, making the proposed methodology especially applicable to non-normal error distributions of the type usually found in DEMs derived from lidar. The performance of the proposed model was experimentally validated using Monte Carlo simulation on 18 vertical error data-sets. Fifteen of these data-sets were computed from original lidar data provided by the International Society for Photogrammetry and Remote Sensing Working Group III/3, using their respective filtered reference data as ground truth. The three remaining data-sets were provided by the Natural Environment Research Council's Airborne Research and Survey Facility lidar system, together with check points acquired using high precision kinematic GPS. The results proved promising, the proposed models reproducing the statistical behaviour of vertical errors of lidar using a favourable number of check points, even in the cases of data-sets with non-normally distributed residuals. This research can therefore be considered as a potentially important step towards improving the quality control of lidar-derived DEMs.     

半参数平差模型估计量的精度评定

将半参数估计理论引入测量数据处理理论中,利用Blight和Ott提出的思想,用多项式函数来表示半参数平差模型中的非参数分量,从而得到了半参数平差模型中参数分量和非参数分量的Bayes估计量,通过理论证明,半参数模型参数分量的Bayes估计为通常意义下高斯马尔可夫模型参数估计值与参数期望的加权平均,是一致、渐近无偏和渐近有效估计量,并且其方差小于参数模型中参数估计量的方差。在一定情况下推广了平差理论,具有一定的理论价值。     

框架预应力锚杆边坡支护结构的稳定性分析方法及其 应用

以边坡极限平衡理论及框架预应力锚杆边坡支护结构的圆弧滑动破坏模式为基础,在考虑框架、锚杆对土体边坡稳定性影响的情况下,基于圆弧滑动条分法的思想利用积分法建立了内部稳定性安全系数计算模型和最危险滑移面搜索模型。确定滑移面圆心坐标为几何控制参数,推导了安全系数计算模型中各变量与滑移面圆心坐标之间的函数关系式,从而获得了滑移面几何控制参数与内部稳定性安全系数之间的函数关系。利用网格法对框架预应力锚杆支护结构最危险滑移面的圆心坐标进行动态搜索和求解。最后采用Matlab语言编制了框架预应力锚杆边坡支护结构的稳定性分析程序,并结合工程实例进行了验算,讨论了此种方法的适用条件,结果表明该方法简明适用,较传统的经验分析方法更加合理。