云南地区地热基本特征

本文从实测26口井的地热数据中取得14个大地热流值,认为云南地区地热场具有西高东低,并自西往东呈波浪式逐渐变低的趋势,该区具有高地热特征的地质发展历史。由于该区地处世界两大地震带的过渡地区,具有岛弧型的高地热特征,也具有岛弧地带地震活跃的特点,强震多发生在深大断裂带上。该区不同构造单元中的地热场存在的明显不均一性,影响着地震的孕育和地震的发生,地热场、温泉和地震的分布呈良好的对应关系     

雷州半岛局部地热异常及其形成机制

雷州半岛地热场主要受基底构造格局的控制和地下水活动的影响,隐伏花岗岩体放射性元素生热对盖层地温的贡献不可忽视,第四纪更新世火山喷发活动的岩浆余热已几乎完全散失,岩浆体和围岩温度已趋于平衡。由火山喷发而形成的雷北螺岗岭和雷南石峁岭两个玄武岩台地,为半岛地下水的主要补给区,由于冷水流下渗的地温效应,新生界盖层浅部地温梯度<3℃/100m,呈现地热负异常。在以传导传热为主的区域,地热场特点与华北盆地相似,新生界盖层地温梯度与基底岩面的埋深密切相关。由于地壳深部较均一的热流在地壳表部再分配的结果,若干凸起区盖层地温梯度为4—5℃/100m,呈现地热正异常。某些控制凸起区的边界断裂,当深层热水沿其上涌,造成附加热源,和传导传热相叠加,盖层地温梯度可高达5—8℃/100m,形成更鲜明的地热正异常。     

松辽盆地地热场

本文实测了65口井的地热数据,从中取得17个大地热流值,松辽盆地地热场具有中部高边部低,并呈环状分布,该区地热具有高特征的地质发展历史。分区计算盆地的沉积岩层、花岗岩质层和玄武岩质层各底部的温度和热流值,也都具有中部高边部低的变化趋势。分析了盆地地热场受影响的状况和地热高的主要原因。还分析了盆地地热场与构造活动性、地震活动性、重磁力场、岩石圈厚度的关系,以及与石油生成、运移和富集的关系。     

电子地图及其应用

本文从高技术条件下现代战争的需要出发，研究了电子地图的内涵及特征，阐述了当前电子地图的主要品种形式和在军事领域中的一些应用情况。     

A preliminary scanning electron microscope study of honeycomb weathering of sandstone in a coastal environment

Honeycomb weathering has been observed in a Carboniferous sandstone at a coastal location near Ballycastle on the north coast of Northern Ireland. Specimens of this sandstone have been analysed by X-ray diffraction, scanning electron microscopy, and energy dispersive spectrometry. Results reveal that calcium sulphate (gypsum) is the only salt present and is found only at and immediately below the rock surface. SEM observations suggest that crystallization of salts in pores could easily dislodge quartz grains to promote granular disintegration, whilst etching of quartz grain surfaces attests to chemical weathering activity within the rock However, the reason for the development of the honeycomb pattern is not known.     

Slope process change and colluvium deposition in Swaziland: An SEM analysis

Electron microscope analysis of sixty samples taken from six colluvium sites in Swaziland has shown that the quartz grains exhibit marked edge abrasion in the uppermost beds of exposures. This edge abrasion is lacking in the lower beds in all sections examined and indicates slope process change during colluvium deposition. A model of slope evolution is provided, in which slope erosion progressively brings about more channelling and causes greater surface roughness because of the exhumation of more core stones and differentially weathered rock. This roughness causes increased edge abrasion.     

1901-1995年气候变化导致陆地生态系统净吸收碳

The spatial and temporal variability of land carbon flux over the past one hundred years was investigated based on an empirical model directly calculating soil respiration rate. Our model shows that during 1901-1995, about 44-89 PgC (equals to 0.5, 0.9 PgC/yr respectively) were absorbed by terrestrial biosphere. The simulated net ecosystem productivity (NEP) after the 1930s was close to the estimated value of" missing C sink” from deconvolution analysis. Most of the total carbon sink happened during 1951-1985 with the estimated value of 33-50 PgC. Three major sinks were located in the tropics (10°S-10°N), Northern mid-latitudes (30°-60°N) and Southern subtropics (10°-40°S). During 1940s-mid-1970s, carbon sinks by terrestrial ecosystem increased with time, and decreased after the mid-1970s. These may be due to the ch anging of climate condition, as during the 1940s-1970s, temperature decreased and precipitation increased, while after the mid-1970s, an opposite climate situation occurred with evident increasing in temperature and decreasing in precipitation. Usually, warmer and dryer climate condition is not favor for carbon absorption by biosphere and even induces net carbon release from soil, while cooler and wetter condition may induce more carbon sink. Our model results show that the net carbon flux is particularly dependent on moisture / precipitation effect despite of temperature effect. The changing of climate in the past century may be a possible factor inducing increases in carbon sink in addition to CO2 and N fertilizer.     

Ilmenite composition in the Tellnes Fe–Ti deposit,SW Norway: fractional crystallization,postcumulus evolution and ilmenite–zircon relation

Major and trace element XRF and in situ LA-ICP-MS analyses of ilmenite in the Tellnes ilmenite deposit, Rogaland Anorthosite Province, SW Norway, constrains a two stage fractional crystallization model of a ferrodioritic Fe-Ti-P rich melt. Stage 1 is characterized by ilmenite-plagioclase cumulates, partly stored in the lower part of the ore body (Lower Central Zone, LCZ), and stage 2 by ilmenite-plagioclase-orthopyroxene-olivine cumulates (Upper Central Zone, UCZ). The concentration of V and Cr in ilmenite, corrected for the trapped liquid effect, (1) defines the cotectic proportion of ilmenite to be 17.5 wt% during stage 1, and (2) implies an increase of D _V^Ilm during stage 2, most likely related to a shift in fO₂. The proportion of 17.5 wt% is lower than the modal proportion of ilmenite (ca. 50 wt%) in the ore body, implying accumulation of ilmenite and flotation of plagioclase. The fraction of residual liquid left after crystallization of Tellnes cumulates is estimated at 0.6 and the flotation of plagioclase at 26 wt% of the initial melt mass. The increasing content of intercumulus magnetite with stratigraphic height, from 0 to ca. 3 wt%, results from differentiation of the trapped liquid towards magnetite saturation. The MgO content of ilmenite (1.4–4.4 wt%) is much lower than the expected cumulus composition. It shows extensive postcumulus re-equilibration with trapped liquid and ferromagnesian silicates, correlated with distance to the host anorthosite. The Zr content of ilmenite, provided by in situ analyses, is low (<114 ppm) and uncorrelated with stratigraphy or Cr content. The data demonstrate that zircon coronas observed around ilmenite formed by subsolidus exsolution of ZrO₂ from ilmenite. The U-Pb zircon age of 920 ± 3 Ma probably records this exsolution process. Electronic supplementary material The online version of this article (doi:) contains supplementary material, which is available to authorized users.     

激光测距—成像组合扫描仪多源数据采集技术的研究

阐述一套机载运行的光学－机械扫描式激光测距和被动式热红外外扫描成像组合遥感器，结合飞机平台的姿态测量和GPS定位，可实时（准实时）获取地面景物的三维位置和影像灰度信息。由多源数据采集技术获得的多种同步数据经地面计算机回放和处理，可以快速生成数字地面高程模型（DEM）和地学编码图像。扫描激光测距仪与扫描成像仪的电同步技术控制激光测距采样时刻与图像采样时刻在时序上的一致性，从而达到高程数据与图像像元的匹配。