On the Correlation between Convective Plume Updrafts and Downdrafts,Lidar Reflectivity and Depolarization Ratio

We question the correlation between vertical velocity (w) on the one hand and the occurrence of convective plumes in lidar reflectivity (i.e. range corrected backscatter signal Pz ²) and depolarization ratio (Δ) on the other hand in the convective boundary layer (CBL). Thermal vertical motion is directly investigated using vertical velocities measured by a ground-based Doppler lidar operating at 2 μm. This lidar provides also simultaneous measurements of lidar reflectivity. In addition, a second lidar 200 m away provides reflectivities at 0.53 and 1 μm and depolarization ratio at 0.53 μm. The time series from the two lidars are analyzed in terms of linear correlation coefficient (ρ). The main result is that the plume-like structures provided by lidar reflectivity within the CBL as well as the CBL height are not a clear signature of updrafts. It is shown that the lidar reflectivity within the CBL is frequently anti-correlated (ρ (w, Pz ² )) with the vertical velocity. On the contrary, the correlation coefficient between the depolarization ratio and the vertical velocity ρ (w, Δ ) is always positive, showing that the depolarization ratio is a fair tracer of updrafts. The importance of relative humidity on the correlation coefficient is discussed. An erratum to this article can be found at     

内马铁路一期工程局部不规则二维场地地震反应分析

基于内马铁路一期工程地质资料，利用ABAQUS有限元软件建立某局部不规则二维场地有限元计算模型，利用Python语言进行二次开发，编制二维等效线性化计算程序。开展50年超越概率63%、10%和2%水准下的土层地震反应分析计算，对不规则地形不同位置处的地震动峰值加速度和频谱特性进行对比分析。研究结果表明，不规则地形对地震动特性的影响显著。本文研究结果对内马铁路一期工程地震动参数确定具有指导意义，同时可为跨越不规则地形工程结构抗震设计提供参考。     

X-ray binary unified analysis: pulse/RV application to Vela X1: GP Velorum

A procedure for simultaneous analysis of multiple kinds of observations is developed for binaries that contain X-ray pulsars. A wide variety of observation types might be included, although we consider only velocity: pulse and light: velocity: pulse cases at present. The model operates with equipotentials and can accommodate non-synchronous rotation and eccentric orbits. The duration condition imposed by observed X-ray eclipses is incorporated as an embedded constraint, so that only solutions consistent with the eclipse duration are found. Relations needed for the method of differential corrections in least-squares solutions are specified, and we apply the Marquardt scheme for improvement of solution convergence. Parameters of Vela X1: GP Velorum are obtained from seven combinations of pulse and radial velocity data. The estimated masses are thereby put into some perspective, especially for the neutron star. The mass of the supergiant ( m  sin³  i ) now ranges only ±5 per cent from the mean of seven results, although the uncertainty in i makes the actual mass range larger. We discuss the determinacy of certain parameters and their historical consistency. For example, the systemic radial velocity differs among spectroscopic data sets by more than 20 km s⁻¹. We show that, contrary to published assertions, the orbital inclinations of high-mass X-ray binaries are essentially indeterminable by the usual methods, although lower limits to inclination may be meaningful for some examples.     

云南天文台三孔较差视宁度监视仪的建立

较详细地讲述了云南天文台三孔较差视宁度监视仪的情况,然而,与一般天文理论和天文技术的专题研究不一样,天文仪器的研制有如说是研究,还不如说是归纳;它不是分析一个具体的尚未解决的难题,而是把许多已知的理论和技术综合起来,构成一台具体的仪器。所以,本文把许多至少是表面上互不相关的理论和技术问题归纳到一篇论文中。仪器是有许多模块组成的,为了看起来逻辑性较强,我们将仪器分模块叙述,全文遵循如下顺序：１在第一篇中,回顾世界各天文台视宁度测量设备的发展史和云南天文台的宁静度测量发展史;２在第二篇中,介绍：１）云南天文台三孔较差视宁度研制任务的来源,仪器的整体状况;２）介绍云南天文台三孔较差视宁度仪的硬件系统;３）介绍云南天文台三孔较差视宁度仪的软件系统;若大模块中有多个小模块,在每一个大模块中,又遵循下述顺序：１）本模块的总体功能;２）构成该模块的基本技术;３）这些基本技术如何构成整体和完成预定功能。３在第三篇中,介绍我们所作的与视宁度测量有关的一些实验和实验结果。     

Characteristics of the Variation of Cross Fault Short-Baseline and Short-Range Leveling in Western Yunnan Earthquake Test Site Before Lijiang M_S7.0 Earthquake

Results of analysis of variation of cross fault short-baseline and short-range leveling in Western Yunnan Earthquake Test Site (WYETS), results show that among five observation stations of cross fault short-baseline and short-range leveling in WYETS before the Lijiang MS7.0 Earthquake occurred in February 1996 only Yongsheng observation station (epicentral distance 82 km) located at Chenghai fault shows great variation about one year before the earthquake. And the nearest observation station, Lijiang (epicentral distance 42 km); presents great coseismic variation, but does not show obvious anomalous variation before the earthquake. There are no significant variations related to the earthquake at the other three observation stations. Two methods are used in analysis of the observed data and some valuable results have been obtained.     

A dense array experiment for the observation of waveform perturbations

We analyze observed three-component seismograms recorded by a dense array of 21 short-period receivers (f>2 Hz) installed on a homogeneous Quaternary plain with 1.5×3.5 km² horizontal dimensions. The experiment was conducted in the district of Caille, in SE France for 3 months. The observed waveform data are related to diffraction and refraction of the direct wavefield by different geological structures and topographic morphologies surrounding the array. The origin of the coda energy following the energetic Pg or Sg arrivals is either influenced by heterogeneities close to and inside of the valley, for instance thrust of Jurassic limestones over Cretaceous marls in the northern and southern limits of the valley, or by heterogeneities located outside of the valley such as the interface unconformity between crystalline basement and sedimentary cover in the northern border of the Maures–Tanneron ranges. The main energetic arrivals of the seismograms arrive at the array with a definite range of azimuths that is not correlated with the event back-azimuth. Moreover, these arrivals do not appear with azimuths related to the characteristic NS and EW valley orientations, and thus may be related to heterogeneities located outside of the valley.     

长治水泥厂区域地震地质环境评价

长治水泥厂位于山西隆起区南部长治盆地, 长治盆地属中强潜在震原区。场地附近晋获断裂现代活动相对较弱, 晚更新后断裂基本停止活动, 对水泥厂场地无直接影响。     

Simulations for multi-object spectrograph planet surveys

Radial velocity surveys for extrasolar planets generally require substantial amounts of large telescope time in order to monitor a sufficient number of stars. Two of the aspects which can limit such surveys are the single-object capabilities of the spectrograph, and an inefficient observing strategy for a given observing window. In addition, the detection rate of extrasolar planets using the radial velocity method has thus far been relatively linear with time. With the development of various multi-object Doppler survey instruments, there is growing potential to dramatically increase the detection rate using the Doppler method. Several of these instruments have already begun usage in large-scale surveys for extrasolar planets, such as Fibre Large Array Multi Element Spectrograph (FLAMES) on the Very Large Telescope (VLT) and Keck Exoplanet Tracker (ET) on the Sloan 2.5-m wide-field telescope.
In order to plan an effective observing strategy for such a program, one must examine the expected results based on a given observing window and target selection. We present simulations of the expected results from a generic multi-object survey based on calculated noise models and sensitivity for the instrument and the known distribution of exoplanetary system parameters. We have developed code for automatically sifting and fitting the planet candidates produced by the survey to allow for fast follow-up observations to be conducted. The techniques presented here may be applied to a wide range of multi-object planet surveys.     

The relationship between rock glacier and contributing area parameters in the Front Range of Colorado

Rock glaciers are an end unit of the coarse debris system that links frost weathering and rockfall to debris transport in mountainous environments. By examining topographic and climatic controls on creep, a better understanding of rock glacier formation and evolution could be obtained. A series of statistical tests were run comparing contributing area parameters (width, length, area, slope, headwall height, etc.) and rock glacier variables (width, length, area, thickness, slope, creep and temperature) in the Front Range of Colorado. Results showed that rock glacier width had the strongest correlation with contributing area width due to an abundance of lobate rock glaciers (r = 0.78). Rock glacier area and contributing area size were also related (r = 0.74), but are also a function of talus production factors. Mean surface velocity appears to be better correlated with thickness (r = 0.58) and length (r = 0.62), rather than slope (r = 0.33). Mean annual air temperature had a stronger exponential relationship with maximum velocities (r = 0.76) compared to mean annual velocity (r = 0.60). Front Range rock glacier velocities tend to decrease with warming, suggesting that the volume of ice and debris, rates of shear in plastic layers, or melt water may have a greater influence on deformation. Copyright © 2007 John Wiley & Sons, Ltd.