A new assessment model for evacuation vulnerability in urban areas

In the high-speed urbanization process of China, the urban population has been increasing significantly, leading to a high-density aggregation of population. However, the sharp increase in population density has not produced commensurate improvements in the road networks. On the contrary, the population increase induced a serious evacuation vulnerability, which cities experience during various hazards and catastrophic events. Therefore, research on evacuation vulnerability is important to urban planning. To assess the evacuation vulnerability, the optimal and worst scenarios should be considered because all possible evacuation plans occur between these extremes. However, most previous evacuation vulnerability studies are based on the worst-case scenario, only providing an upper bound of a potential evacuation assessment. To provide a more comprehensive theoretical basis for decision-makers to understand the consequences caused by all possible evacuations, this paper proposes an optimal evacuation vulnerability assessment model that provides the lower bound on potential evacuation difficulties. The model is solved by a stepwise spreading algorithm based on Graph Theory. Subsequently, to evaluate the effectiveness of the model, the study adopts the model to assess the evacuation capability of different road network topologies. A comparison with previous research was performed. The model was demonstrated in an application to the South Luogu Alley of Beijing, China. The significance of this paper is that the combination of our model with previous research may provide a more complete theoretical basis for an evacuation vulnerability assessment.     

A New Reference Material for Tritium Organic Molecules in Sediment: Results of an International Intercomparison Exercise

Solid matrix ³H reference materials are challenging to prepare given the volatile nature of ³H and are often unrepresentative of the range of ³H forms that may be encountered during routine analysis. As a result, few ³H reference materials are currently available, undermining verification of analytical techniques for environmental ³H measurement. To address this, an International Working Group on Organically‐Bound Tritium Analysis determined to produce a tritium natural matrix reference material (NMRM). The reference material comprises marine sediment blended with sewage sludge contaminated with ³H‐organic species arising from authorised discharges from a radiopharmaceutical manufacturing site. Previous studies have demonstrated that the ³H species have persisted in the environment over three decades providing valuable supporting data to underpin the characterisation of the NMRM. The preparation and characterisation of the NMRM are described along with the subsequent application of the reference material in an international intercomparison exercise involving nineteen laboratories from nine countries. A reference value of 168 ± 22 Bq kg^?1 was derived from the data arising from the proficiency test.     

微波等离子体原子发射光谱法测定偏远矿区海泡石中的主微量元素

海泡石是具有层状结构的含水富镁硅酸盐黏土矿物,其中无机元素含量是揭示其成矿物质来源、成矿流体性质和矿床成因的重要依据,通常采用电感耦合等离子体发射光谱/质谱法(ICP-OES/MS)进行测定,等离子体(ICP)的高温激发会产生成大量谱线干扰,维持ICP稳定工作需使用高纯氩气,持续供气对于偏远矿区海泡石的检测还将面对气体采购和运输不便的问题。本文基于微波等离子体原子发射光谱(MP-AES)的低温激发技术减少光谱干扰,建立了准确测定偏远矿区海泡石中主量元素Mg、Al、Ca、Fe、K、Na和微量元素Cu、Zn、Mn、Pb含量的分析方法。利用硝酸-盐酸-氢氟酸混合酸对海泡石进行微波消解,避免了样品处理过程中分析元素的损失,加快了样品处理速度,同时提高了样品溶液的稳定性。通过选择各元素光谱线的分析波长,并利用快速线性干扰校正(FLIC)技术校正光谱干扰,以Lu为内标元素校正基体效应,提高了灵敏度和准确度。各元素的检出限为0.19～14.6μg/L。海泡石国家标准物质(GBW07138)各元素测定值与认定值的相对误差在-5.0%～6.7%之间。本方法具有检出限低、线性范围宽、结果准确等优点;MP-AES采用自带的氮气发生器为等离子体提供氮气作为工作气,无需引入复杂气体,提高了分析效率,尤其适用于气体采购和运输不便的偏远矿区。     

白涧铁矿南区复杂地层钻探施工技术

邢台白涧铁矿南区地层岩石破碎、部分地层含角砾、胶结性差、漏失严重,钻探施工中存在掉块卡钻、缩径、坍塌、埋钻及孔内泥浆全部漏失等难题。通过优化钻孔结构、使用新工艺、新方法,合理选择钻进参数,采用绳索取心钻进配合预留技术套管,有效解决了上部煤系地层的坍塌问题;采用反丝套管的方法,极大地减轻了由于地层缩径、掉块引起的套管下不到位、起拔困难等风险;常规型绳索取心钻杆替代套管方法的采用,提高了含角砾、松散地层的穿过速度,减少了钻探工作量的报废,加快了施工进度;特别是高胎体双水口钻头的使用,提高了钻进效率,节约了钻探施工成本,项目得以如期完成。     

Inter‐laboratory Characterisation of Apatite Reference Materials for Chlorine Isotope Analysis

Here we report on a set of six apatite reference materials (chlorapatites MGMH#133648, TUBAF#38 and fluorapatites MGMH#128441A, TUBAF#37, 40, 50) which we have characterised for their chlorine isotope ratios; these RMs span a range of Cl mass fractions within the apatite Ca₁₀(PO₄)₆(F,Cl,OH)₂ solid solution series. Numerous apatite specimens, obtained from mineralogical collections, were initially screened for ³⁷Cl/³⁵Cl homogeneity using SIMS followed by δ³⁷Cl characterisation by gas source mass spectrometry using both dual‐inlet and continuous‐flow modes. We also report major and key trace element compositions as determined by EPMA. The repeatability of our SIMS results was better than ± 0.10‰ (1s) for the five samples with > 0.5 % m/m Cl and ± 0.19‰ (1s) for the low Cl abundance material (0.27% m/m). We also observed a small, but significant crystal orientation effect of 0.38‰ between the mean ³⁷Cl/³⁵Cl ratios measured on three oriented apatite fragments. Furthermore, the results of GS‐IRMS analyses show small but systematic offset of δ³⁷Cl_SMOC values between the three laboratories. Nonetheless, all studied samples have comparable chlorine isotope compositions, with mean 10³δ³⁷Cl_SMOC values between +0.09 and +0.42 and in all cases with 1s ≤ ± 0.25.     

基于交通网络空间权重的区域经济空间相关分析——以甘肃省为例

在区域经济中,交通是联系地理空间和区域经济活动的纽带,交通的发达程度决定了各地理单元空间相互作用的广度与深度.针对不同交通模式赋以不同的权重,基于最短加权交通网络,提出新的空间权重矩阵构建方法,构建了交通网络空间权重,与各种传统空间权重一起,对比研究甘肃省各县域单元之间的区域经济的空间相关性.研究结果表明,利用交通网络空间权重生成的空间权重矩阵,能更真实地反映区域间实际的空间过程;甘肃省的区域经济具有空间相关性但不显著,核心城市经济外溢现象不明显.     

基于显著性图像与纹理特征的遥感影像云检测

遥感影像云检测是遥感影像处理中非常关键的环节,准确识别影像含云区域能够提升影像的利用价值.根据遥感影像的成像特点,将阈值法和纹理特征结合实现云和下垫面的分割.首先将影像从RGB(red-green-blue)空间转化为HSI(hue-saturation-intensity)空间,进而构建影像的显著性图像,利用Otsu...     

Solution of the propagation of the waves in open channels by the transfer matrix method

Many problems in mechanics can be solved by the use of the transfer matrix method. The use of this method in hydraulics engineering is not widespread and only limited studies are available. In this study, linearized St. Venant equations were used and the use of transfer matrix in ocean engineering was investigated for long waves in open channels, and numerical application was carried out. The results obtained through the transfer matrix method, which is quite easy to use, program and comprehend, showed similar results obtained from the characteristics method and finite differences method.     

�������˲�ģ������Ӱ�����

???????????????????????????????????Kalman????????????????????????????????????????????????????????????в?????     

数码相机检验中出现的问题及解决方法

数码相机的检验是近景摄影测量中经常碰到的问题。最常用的主要还是基于共线方程的后方交会法。但由于普通数码相机存在较大的镜头畸变,内方位元素也未知,所以仅用单片进行后方交会求取有关参数时,法方程可能会出现病态现象,从而影响最后的检验结果。文中对此现象进行了讨论,并给出了一些实用的解决方法。