Influence of gas production induced volumetric strain on permeability of coal

Summary The gas permeability of a coalbed, unlike that of conventional gas reservoirs, is influenced during gas production not only by the simultaneous changes in effective stress and gas slippage, but also by the volumetric strain of the coal matrix that is associated with gas desorption. A technique for conducting laboratory experiments to separate these effects and estimate their individual contribution is presented in this paper. The results show that for a pressure decrease from 6.2 to 0.7 MPa, the total permeability of the coal sample increased by more than 17 times. A factor of 12 is due to the volumetric strain effect, and a factor of 5 due to the gas slippage effect. Changes in permeability and porosity with gas depletion were also estimated using the measured volumetric strain and the matchstick reservoir model geometry for flow of gas in coalbeds. The resulting variations were compared with results obtained experimentally. Furthermore, the results show that when gas pressure is above 1.7 MPa, the effect of volumetric strain due to matrix shrinkage dominates. As gas pressure falls below 1.7 MPa, both the gas slippage and matrix shrinkage effects play important roles in influencing the permeability. Finally, the change in permeability associated with matrix shrinkage was found to be linearly proportional to the volumetric strain. Since volumetric strain is linearly proportional to the amount of gas desorbed, the change in permeability is a linear function of the amount of desorbing gas.     

半空间埋置动点源荷载问题的传递矩阵法

引用了流体饱和两相多孔介质的动力控制方程分析半空间埋置动点源荷载问题的位移和变形。经过Laplace Hankel变换 ,控制方程化成常微分方程组。利用数学软件mathmatic对上述方程组求解 ,可以得到单层砂土的传递矩阵。分析过程中 ,假设在两层面上 ,位移与应力相互连续 ,可以借鉴有限元的思想进行耦合计算。这样就获得了在饱和砂土中施加竖向动荷载问题的Laplace Hankel变换解 ,其最终的解还需要通过Laplace Hankel逆变换得到     

Triaxial stress state deep in orogenic belts: an example from Turkey

A rare metachert pebble containing amphibole grains with microboudin structures in a wide range of orientations provides an opportunity to perform stress analysis in two orthogonal orientations on the foliation surface. The sample was analysed by the microboudin method to infer the triaxial stress state during microboudinage. Stress parameters proportional to the far-field differential stress were determined for sodic amphibole grains in the two orientations. The ratio of the stresses in the two orthogonal orientations (σ₁−σ₂)/(σ₁−σ₃) was calculated to be 0.64, indicating that σ₂ lies closer to the midpoint between σ₁ and σ₃ than to σ₃.     

适用于大旋转角的三维基准转换的一种简便模型

基于大角度的空间直角坐标转换，提出了以方向余弦为参数、适用于任何角度旋转的空间直角坐标转换的简明计算方法。     

石墨炉原子吸收光谱法测定土壤样品中镉

采用磷酸氢二铵作基体改进剂塞曼扣背景石墨炉原子吸收光谱法测定土壤样品中镉，方法检出限DL=0．012μg／g，精密度RSD在3．55％～7．33％，满足了土壤样品中镉测定的镉质量要求。     

Direct Current Plasma Emission Spectrometric Determination of Major, Minor and Trace Elements in Microwave Oven Acid Leachates of Powdered Whole Coal Samples

Major concentrations of Al₂O₃, Fe₂O₃, MgO, CaO, Na₂O and K₂O, minor levels of TiO₂, P₂O₅ and thirty petrologically, geochemically and environmentally significant trace elements have been determined in microwave oven acid leachates of whole powdered coal samples by direct current plasma‐atomic emission spectrometry (DCP‐AES). A single sample preparation procedure was suitable for all the determinations with no additional dilution step for major elements solution. Dried samples (0.5 g) were treated in low‐pressure PFA digestion vessels with HF/HCl/HNO₃/HClO₄ acids to quantitatively extract the analytes from the bulk material, while leaving the major part of organic matrix as a residue. The major constituents of geological samples, in particular the easily ionised elements (EIEs) such as alkali and alkaline earths, may complicate the instrumental determinations in DCP‐AES because of differential enhancements of elemental emission intensities and stray light interferences. Taking account of these factors, the coal matrix is considered to have very low major oxide totals as compared to many other common geo‐environmental and related materials (rocks, sediments, soil, ashes etc.). The sample size employed here, while yielding a relatively concentrated solution to cover a wide range of elemental determinations, provided a sample matrix that significantly diminished interferences for DCP measurements. The need for closely matching the unknowns and calibrators was eliminated except for overall acidity and an excess quantity of caesium for EIE buffering. Calibration of the spectrometer was accomplished by simple aqueous single element solutions as high concentration calibrators in addition to a reagent blank as a low concentration calibrator. Two point working curves were established to allow for the maximum concentrations of each element expected in the unknowns. The precision of determinations under routine conditions as well as the reproducibility of the leaching and precision of instrumental measurements have been evaluated. Relative standard deviations (RSD) were of 1–2% for those elements whose concentrations in solid samples were well above the limits of quantification. Method detection limits in the buffered solutions were also evaluated. To evaluate the accuracy of the microwave oven‐DCP method a suite of eight certified coal reference materials of differing rank, were analysed with good agreement with the certified and/or available published data. Results are presented for the uncertified major oxides in the AR series reference materials.     

Transient seepage analysis in zoned anisotropic soils based on the scaled boundary finite‐element method

The scaled boundary finite‐element method, a semi‐analytical computational scheme primarily developed for dynamic stiffness of unbounded domains, is applied to the analysis of unsteady seepage flow problems. This method is based on the finite‐element technology and gains the advantages of the boundary element method as well. Only boundary of the domain is discretized, no fundamental solution is required and singularity problems can be modeled rigorously. Anisotropic and non‐homogeneous materials satisfying similarity are modeled with no additional efforts. In this study, firstly, formulation of the method for the transient seepage flow problems is derived followed by its solution procedures. The accuracy, simplicity and applicability of the method are demonstrated via four numerical examples of transient seepage flow – three of them are available in the literature. Homogenous, non‐homogenous, isotropic and anisotropic material properties are considered to show the versatility of the technique. Excellent agreement with the finite‐element method is observed. The method out‐performs the finite‐element method in modeling singularity points. Copyright © 2014 John Wiley & Sons, Ltd.     

2000～2015年会理县地表覆盖变化监测

以LandSat多时相影像为数据源,采用基于规则的面向对象分类方法,监测会理县2000～ 2015年地表覆盖变化.结合1∶50 000 DEM数据,分析了会理县地表覆盖构成与转移、变化动态度及潜在退耕地情况.监测分析结论能为会理县加强空间管制、促进土地资源集约利用、指导生态文明建设等提供决策信息支撑.     

求解GM(1,1)模型新总体最小二乘算法

在GM(1,1)模型中系数矩阵和观测向量都是由原始序列组成的。系数矩阵中同样是有误差的,与观测向量中的误差一样,亦来源于原始序列,即它们误差同源。不同位置的相同元素应该有相同的改正数,采用传统总体最小二乘求解则不能达到此目的。针对这一缺陷,推导了一种新的总体最小二乘算法;并且通过算例验证了新方法的可行性和有效性。