2011年3月24日缅甸7.2级地震对云南地区的影响研究

利用2011年1—6月云南地区的连续波形资料,采用背景噪声和波形互相关方法分别反演该地区的速度结构以及2011年3月24日缅甸7.2级地震前后60d的速度变化图像。同时,根据云南地区中小地震计算缅甸地震前后应变能释放响应比空间分布,并利用缅甸地震的震源参数,计算了缅甸地震对云南地区主要断裂产生的库仑破裂应力影响。结果显示:(1)禄劝至华坪一带、永定至泸水区域和通海至建水地区震后波速增加,同时该地区地震活动增强,相应断裂上库仑破裂应力增加,说明缅甸地震对这些区域具有加速构造活动的正影响;(2)小江断裂带以东马龙至宣威地区和南汀河断裂带以南临沧至景洪地区震后波速降低,地震活动减弱,断裂上库仑破裂应力降低,说明缅甸地震对该区域具有减缓构造活动的负影响。     

1.56m望远镜新CCD相机MPP模式开与关的对比(英文)

1 .5 6m望远镜新CCD系统是在里克天文台用其控制电路组装而成的。该系统能在MPP模式与非MPP模式之间自由快速转换。我们比较了两种模式的性能差异 ,得到 :(1)增益和读出噪音不变。 (2 )在 - 10 0℃温度 ,MPP模式的暗流对短的或中等长度的露光可以忽略 ,并且暗流对CCD芯片的温度变化不太敏感 ;非MPP模式的暗流有确定的图案 ,对CCD的温度变化比MPP敏感。因此稳定的低温是必须的 ,并且使用时须减暗流。 (3)使用MPP的代价是 ,相对于非MPP模式 ,动态范围至少减小约 90 0 0adu(增益 4 .6e- /adu)。用户使用时应按照科学目的选择模式。     

Variations of local seismic response in Benevento (Southern Italy) using earthquakes and ambient noise recordings

The city of Benevento (Southern Italy) has been repeatedly struck by large historical earthquakes. A heterogeneous geologic structure and widespread soft soil conditions make the estimation of site effects crucial for the seismic hazard assessment of the city. From 2000 until 2004, we installed seismic stations to collect earthquake data over zones with different geological conditions. Despite the high level of urban noise, we recorded more than 150 earthquakes at twelve sites. This data set yields the first, well documented experimental evidence for weak to moderate local amplifications. We investigated site effects primarily by the classical spectral ratio technique (CSR) using a rock station placed on the Benevento hill as reference. All sites in the Calore river valley and in the eastern part of the Benevento hill show a moderate high-frequency (f > 4 Hz) amplification peak. Conversely, sites in the Sabato river valley share weak-to-moderate amplification in a wide frequency band (from 1–2 to 7–10 Hz), without evident frequency peaks. Application of no-reference-site techniques to earthquake and noise data confirms the results of the CSRs in the sites of the Calore river valley and of the eastern part of the Benevento hill, but fails in providing indications for site effects in the Sabato river valley, being the H/V ratios nearly flat. One-dimensional modeling indicates that the ground motion amplification can be essentially explained in terms of a vertically varying geologic structure. High-frequency narrow peaks are caused by the strong impedance contrast existing between near-surface soft deposits and stiff cemented conglomerates. Conversely, broad-band amplifications in the Sabato river valley are likely due to a more complex layering with weak impedance contrasts both in the shallow and deep structure of the valley.     

50万伏超高压输电线的电磁噪声的研究

目前的野外电磁测量已很难回避各种输电线的干扰,且有时各种输电线已影响到地震台站的电磁测量。高压输电线的电磁场规律如何对各种电磁测量具有重要的实际意义。利用自行研制的阵列大地电磁测深仪对长春—哈尔滨超高压输电线的电磁场进行了实际观测,对获得的数据进行了分析,对高压线的电磁场规律给出了明确的结论。     

S-wave Velocity Profiles for Earthquake Engineering Purposes for the Cologne Area (Germany)

Local S-wave velocity-depth profiles are a key factor in seismic hazard assessment, as they allow the amplification potential of the sedimentary cover to be evaluated. Ambient seismic noise is mainly composed of surface waves, and therefore contains vital information about the S-wave velocity structure, allowing polarization or dispersion curves to be obtained from single station or array noise recordings. At two sites in the area of Cologne, Germany, the extended spatial correlation method was applied to such recordings and apparent phase velocity curves in the frequency range of interest for earthquake engineering were obtained. Using this data, a linearized inversion, the simplex downhill method, and a genetic algorithm yielded similar S-wave profiles. However, the latter method is recommended since it is less dependent upon a good starting model. Importantly, the presence of low-velocity layers in the Cologne area made it necessary to consider in the frequency range of interest higher modes in the inversion procedures. Finally, independent information on the total thickness of the sedimentary cover permitted the estimation of a 2D S-wave velocity profile crossing the Cologne area. Here, the H/V ratio inversion using 20 single-station noise recordings was used, with the results in good agreement with a geological profile.     

Retrospective Prediction of Macroseismic Intensities Using Strong Ground Motion Simulation: The Case of the 1978 Thessaloniki (Greece) Earthquake (M6.5)

The densely populated city of Thessaloniki (Northern Greece) is situated in~the vicinity of active seismic faults, capable of producing moderate to strong earthquakes. The city has been severely affected by such events several times during the last 15 centuries. The most recent event occurred on 20 June 1978 (M6.5) in the Mygdonian graben, with an epicentral distance of about 30 km, causing extended damage in the city, with macroseismic intensities between MSK V+ and VIII+. The majority of buildings affected by the earthquake were of reinforced-concrete typology, typical to many southern European metropolitan areas. The source properties of the normal-faulting causative event and the source-to-city propagation path are well known from previous studies. The soil structure under the metropolitan area of Thessaloniki is assigned NEHRP categories B, C, D on the basis of geotechnical and geologic information and single-station ambient-noise measurements. A finite source model and various rupture scenarios of the June 1978 earthquake are used to perform forward stochastic modeling of strong ground motion in terms of peak ground and spectral acceleration. Rock motion is assessed under the city and it is transferred to the surface in accordance with the respective soil category. A GIS tool is employed to compare the estimated strong-motion parameters with the observed detailed damage pattern induced by the 1978 earthquake. For selected natural periods, a satisfactory correlation is established between macroseismic intensity and peak ground and spectral acceleration, thus encouraging the application of stochastic modeling for generating realistic ground-shaking scenarios in metropolitan areas.     

自然光环境下目标的快速提取方法研究

介绍了一种自然光环境下目标提取的方法：在分析自然光下CCD相机获取图像中噪声的特点的基础上，发现被测目标经测量场中特定纹理背景调制后．可以采用差分算法提取图像中的目标及其位置。实践证明，该方法在目标提取中抑制自然光的干扰是有效的和可靠的。     

青藏高原东北缘盆山结合部位深反射资料处理方法与初步地质认识

盆山结合带地质条件复杂、地形起伏大,深地震反射资料具有信噪比低、各种干扰波严重以及速度横向变化大等特点。针对盆山结合部位深反射资料的特点,主要利用ProMAX处理系统对横跨若尔盖盆地和西秦岭造山带结合部位的二维深地震反射资料(简称SP04-2剖面)进行折射静校正、叠前去噪、地表一致性处理、人机交互速度分析、剩余静校正循环迭代处理、地表基准动校正叠加和叠后去噪处理等方法试验研究,形成一套适应盆山结合部位深地震反射资料的处理方法和流程,最终得到SP04-2叠加剖面。该剖面首次揭示出若尔盖盆地—西秦岭造山带盆山结合部位的岩石圈结构,为研究盆山深部接触关系提供了可靠的地震学依据。