Changes in stream water quality due to logging of the boreal forest in the Montmorency Forest,Québec

Summer stream water quality was monitored before and following the logging of 50% of the boreal forest within three small watersheds (<50 ha) nested in the ‘Ruisseau des Eaux‐Volées’ Experimental Watershed, Montmorency Forest (Québec, Canada). Logging was conducted in winter, on snow cover according to recommended best management practices (BMPs) to minimize soil disturbance and protect advance growth. A 20‐m forest buffer was maintained along perennial streams. In watershed 7·2, cut‐blocks were located near the stream network and logging was partially allowed within the riparian buffer zone. In watersheds 7·5 and 7·7, logging occurred farther away from the stream network. Observations were also made for watershed 7·3 that collected the runoff from watersheds 7·2 and 7·5, and watershed 7·6, the uproad portion of watershed 7·7. The control watershed 0·2 was contiguous to the impacted watersheds and remained undisturbed. Following clearcutting, changes in summer daily maximum and minimum stream temperatures remained within ± 1 °C while changes in diurnal variation did not decrease by more than 0·5 °C. Concentrations of NO₃^? greatly increased by up to 6000% and concentrations of K⁺ increased by up to 300% during the second summer after logging. Smaller increases were observed for Fe_total (up to 71%), specific conductance (up to 26%), and Mg²⁺ (up to 19%). Post‐logging pH decreased slightly by no more than 7% while PO₄^3? concentration remained relatively constant. Suspended sediment concentrations appeared to increase during post‐logging, but there was not enough pre‐logging data to statistically confirm this result. Logging of moderate intensity and respecting established BMPs may account for the limited changes of water quality parameters and the low exceedances of the criteria for the protection of aquatic life. The proximity of the cutover to the stream network and logging within the riparian zone did not appear to affect water quality. Copyright © 2008 John Wiley & Sons, Ltd.     

Cometary outbursts – the post-Deep Impact outlook on collisions as possible causes

The possibility of impacts between comets belonging to the Jupiter Family and other small bodies orbiting in the main asteroid belt, and the consequences in relation to cometary activity are discussed. The probability of such events and the jumps in cometary brightness caused by impacts are examined. The results are compared with the results of the Deep Impact mission to Comet 9P/Tempel 1. The main conclusion of this paper is in agreement with previous findings, namely that an impact mechanism cannot be the main cause of the outburst activity of comets.     

可口革囊星虫(Phascolosoma esculenta)铁结合

以克隆获得的可口革囊星虫(Phasolosma esculenta)、枝吻纽虫(Dendrorhynchus zhejiangensis)、泥蚶(Tegillarca granosa)、缢蛏(Sinonovacula constricta)、仿刺参(Apostichopus japonicus)和白肛海地瓜(Acaudina leucoprocta)6种无脊椎动物的铁结合蛋白基因为基础, 通过NCBI检索下载相应的氨基酸序列, 采用SingalP程序查找信号肽, 用TMHMM程序搜寻预测跨膜区, 采用Clustal W程序多序列比对, 构建进化树。对其编码蛋白的信号肽、跨膜区以及磷酸化位点等进行分析。结果表明, 6种动物的铁结合蛋白都没有信号肽, 也无跨膜区, 不可能是膜上的受体或定位于膜上, 均为胞外蛋白。泥蚶的ferritin有4个磷酸化位点, 仿刺参ferritin有10个, 枝吻纽虫有8个, 白肛海地瓜有9个, 可口革囊星虫和缢蛏的ferritin未搜寻到磷酸化位点。6种铁结合蛋白的疏水性有一定的差异, 最大值在1.0—1.6之间, 最小值在?3.3—?2.8之间。可口革囊星虫和仿刺参的铁结合区域特征序列完全相同, 与文昌鱼、缢蛏、泥蚶、牡蛎、盘鲍有2个氨基酸差异, 与人、小家鼠和叉尾有1个氨基酸差异。     

Photometry of Comet 9P/Tempel 1 during the 2004/2005 approach and the Deep Impact module impact

The results of the 9P/Tempel 1 CARA (Cometary Archive for Amateur Astronomers) observing campaign is presented. The main goal was to perform an extended survey of the comet as a support to the Deep Impact (DI) Mission. CCD R, I and narrowband aperture photometries were used to monitor the Afρ quantity. The observed behavior showed a peak of 310 cm 83 days before perihelion, but we argue that it can be distorted by the phase effect, too. The phase effect is roughly estimated around 0.0275 mag/degree, but we had no chance for direct determination because of the very similar geometry of the observed apparitions. The log-slope of Afρ was around −0.5 between about 180-100 days before the impact but evolved near the steady-state like 0 value by the impact time. The DI module impact caused about a 60% increase in the value of Afρ and a cloud feature in the coma profile which was observed just after the event. The expansion of the ejecta cloud was consistent with a fountain model with initial projected velocity of 0.2 km/s and β=0.73. Referring to a 25,000 km radius area centered on the nucleus, the total cross section of the ejected dust was 0.06 days after the impact, and 1.93 days after the impact (A is the dust albedo). Five days after the event no signs of the impact were detected, nor deviations from the expected activity referring both to the average pre-impact behavior and to the previous apparitions.     

Définition et datation de la Formation de Venaco (Corse) : dépôt d’origine gravitaire d’âge Priabonien

Priabonian age is highlighted for the first time in Corsica in the Venaco Formation using the presence of specific microfauna (in particular some representatives of Turborotalia cerroazulensis lineage). This silicoclastic formation is mainly represented by coarse facies. It is composed of three members from south to north and from oldest towards youngest: member of Uboli, Cardo and Orsu. The sedimentologic analysis reveals a gravity depositional environment, involving different type of currents. Sedimentologic and chronologic characteristics make the Venaco Formation and the Annot Formation (p.p.) equivalent. Dating the Venaco Fm. brings confirmation that the green schist metamorphism of the Variscan batholith and the related deformation are from the pre-Priabonian period.     

Response to climate change of different tree species and NDVI variation since 1923 in the middle arid region of Ningxia, China

The normalized difference vegetation index （NDVI） is used extensively to describe vegetation cover and ecological environ- ment change. The purpose of this study was to contrast the response of different tree species growing in the same habitat to climate change and retrieve past NDVI using tree-ring width data from tree cores collected from the transitional zone of Pinus tabulaeformis and Picea crassifolia in the Luoshan Mountains in the middle arid region of Ningxia. Correlation analysis indi- cated that radial growth ofP tabulaeJbrmis is more sensitive to precipitation and temperature change than that ofP crassifolia. Natural factors such as water availability and heat at this elevation are more suited to the growth ofP crassifolia, and are more advantageous to its renewal and succession. P. crassifolia is probably the better of the two species for protecting the forest ecosystem and conserving water in the Luoshan desertification area. Ring width of P. crassifolia correlates significantly with average NDVI for April-May （r =0.641, p 〈0.01）, and both of them are influenced positively by precipitation in April-May. The reconstructed NDVI for 1923-2007 shows the relatively low vegetation cover occurred in the 1920s-1930s, the 1960s-1970s, and the early 21 st century. The reconstructed NDVI better reflected the drought climate in the study area.     

Calcium,Na, K and Mg Concentrations in Seawater by Inductively Coupled Plasma‐Atomic Emission Spectrometry: Applications to IAPSO Seawater Reference Material,Hydrothermal Fluids and Synthetic Seawater Solutions

We report a measurement procedure to determine simultaneously the major cation concentrations (Na, Ca, K and Mg) of seawater‐derived solutions by inductively coupled plasma‐atomic emission spectrometry. The best results were obtained when the IAPSO (‘standard’) seawater reference material was diluted by thirty times with Milli‐Q^® water. We obtained an average reference value r_K (the ratio of the mass fraction of potassium to that of chlorine, i.e., (g kg^?1)/(g kg^?1)) for IAPSO seawater of 0.0205 ± 0.0006 (2.9% RSD), not significantly different from 0.0206 ± 0.0005 (2.4% RSD) for seawater composition reported in the literature. The measured Na, Ca and Mg concentrations correspond to r_Na, r_Ca and r_Mg values of 0.5406 ± 0.0026 (0.5% RSD), 0.02192 ± 0.00048 (2.2% RSD) and 0.06830 ± 0.00047 (0.7% RSD), respectively, in line with previous values measured by wet‐chemistry and atomic absorption spectrophotometry or wet‐chemical titration. Our measurement procedure was used successfully on synthetic seawater solutions and high‐temperature hydrothermal fluids.     

Sulfur Concentration in Geochemical Reference Materials by Solution Inductively Coupled Plasma‐Mass Spectrometry

With implications for the origin of ore deposits, redox state of the atmosphere, and effects of volcanic outgassing, understanding the sulfur cycle is vital to our investigation of Earth processes. However, the paucity of sulfur concentration measurements in silicate rocks and the lack of well‐calibrated reference materials with concentrations relevant to the rocks of interest have hindered such investigations. To aid in this endeavour, this study details a new method to determine sulfur concentration via high mass resolution solution inductively coupled plasma‐mass spectrometry (ICP‐MS). The method is based on an aqua regia leach, involving relatively rapid sample preparation and analysis, and uses small test portion masses (< 50 mg). We utilised two independently prepared standard solutions to calibrate the analyses, resulting in 4% accuracy, and applied the method to eight geochemical reference materials. Measurements were reproducible to within ~ 10%. Sulfur concentrations and isotopes of six reference materials were measured additionally by elemental analyser‐combustion‐isotope ratio mass spectrometry to independently evaluate the accuracy of the ICP‐MS method. Reference materials that yielded reproducible measurements identical to published values from other laboratories (JGb‐1, JGb‐2 and MAG‐1) are considered useful materials for the measurement of sulfur. Reference materials that varied between studies but were reproducible for a given test portion perhaps suffer from sample heterogeneity and are not recommended as sulfur reference materials.     

Precise and Accurate In Situ Determination of Lead Isotope Ratios in NIST,USGS, MPI‐DING and CGSG Glass Reference Materials using Femtosecond Laser Ablation MC‐ICP‐MS

Lead isotope ratio data were obtained with good precision and accuracy using a 266 nm femtosecond laser ablation (fLA) system connected to a multi‐collector ICP‐MS (MC‐ICP‐MS) and through careful control of analytical procedures. The mass fractionation coefficient induced by 266 nm femtosecond laser ablation was approximately 28% lower than that by 193 nm excimer laser ablation (eLA) with helium carrier gas. The exponential law correction method for Tl normalisation with optimum adjusted Tl ratio was utilised to obtain Pb isotopic data with good precision and accuracy. The Pb isotopic ratios of the glass reference materials NIST SRM 610, 612, 614; USGS BHVO‐2G, BCR‐2G, GSD‐1G, BIR‐1G; and MPI‐DING GOR132‐G, KL2‐G, T1‐G, StHs60/80‐G, ATHO‐G and ML3B‐G were determined using fLA‐MC‐ICP‐MS. The measured Pb isotopic ratios were in good agreement with the reference or published values within 2s measurement uncertainties. We also present the first high‐precision Pb isotopic data for GSE‐1G, GSC‐1G, GSA‐1G and CGSG‐1, CGSG‐2, CGSG‐4 and CGSG‐5 glass reference materials obtained using the femtosecond laser ablation MC‐ICP‐MS analysis technique.