沉积过程的三维计算机模拟及其应用

利用模拟沉积、剥蚀和搬运过程的数学模型和基本算法,开发了模拟软件SSSP(simulating system of sedimentary processes)。该软件能够进行主要沉积环境的大规模剥蚀、搬运和沉积过程的复杂模拟,并可控制各种参数实时显示模拟结果,包括剖面图、沉积相图、等值线图、网格图和速度矢量图等。在已知沉积环境参数的情况下,利用SSSP再现盆地的沉积演化过程、沉积构型和沉积相分布,并给出了三角洲、河道和水下台阶沉积环境模拟实例。     

涡北河网区三维地震采集技术

涡北勘探区属于河网地带,难以进行正常的地震施工。为此,本文提出了一种以规则束状观测为基础和特殊观测系统相结合的数据采集方法。该方法适应了这种复杂的地表条件,获得了"空白区"的地震资料,为今后类似地表条件地区的三维地震勘探提供了经验。      

利用FY-3C气象卫星GNSS掩星估计全球重力波变化与分析

大气重力波是地球大气层中广泛存在的重要大气动力学扰动,研究其分布和变化规律对理解大气物理、大气结构以及大气动力学等具有重要意义.传统大气重力波探测手段,如雷达和探空气球等,均存在探测时间短、有效探测高度低等缺点,全球卫星导航系统（GNSS）掩星观测具有全天候、低成本、高精度等优点,被广泛应用于地球大气探测和研究,为研究区域或全球重力波变化和活动特征提供了新的观测手段.本文利用中国第一颗搭载GNSS掩星设备气象卫星——风云3C （FY-3C）获得的掩星数据,反演得到2014年8月—2016年12月大气温度轮廓线,并首次估计重力波参数分布,分析了重力波参数的时空变化分布特征.结果表明,海陆季节性对流导致冬夏两季的重力波势能强于春秋两季,赤道对流作用导致赤道区域重力波强于两极,夏季南半球中低纬度地区重力波活动频繁,冬季北半球中低纬度区域重力波活动频繁.重力波随着高度的上升,势能逐渐下降.另外,地形是低层大气重力波的主要来源.     

三维变分同化雷达资料暴雨个例试验

采用中国新一代数值预报模式及其同化系统开展雷达资料的三维变分同化和数值模拟研究.通过一次暴雨个例的对比试验,结果表明:不考虑垂直运动影响的情况下,仅同化多普勒雷达径向风资料可以增加初始场中的中小尺度系统信息,并在一定程度上改善预报开始阶段的降水;同化由反射率因子导出的垂直速度、雨水混合比并令上升区饱和,可以较大改善降水预报结果;联合同化径向速度和反射率因子资料将得到它们的共同影响.模拟的β中尺度对流系统6 h的演变过程与观测十分一致,基本消除了旋转加强现象.发展旺盛阶段的对流单体南北方向范围约50 km,最大上升速度位于500 hPa附近,超过3.0 m/s;雨水最大含量在400 hPa附近,超过5.0 g/kg;云水最大值位于600 hPa,约0.5 g/kg;造成的降水强度可达30 mm/h,具有明显的β中尺度系统的特征.初始场中水汽是否达到β中尺度降水维持所需条件是至关重要的,如果初始场中水汽条件较差,即使含有云水、雨水、垂直速度的信息,这些信息也会很快消亡,难以维持下去;此外,雷达资料的质量控制也是十分重要的.     

Vertical Observations and Analysis of PM2.5, O3, and NOx at Beijing and Tianjin from Towers during Summer and Autumn 2006

During the period between 18 August and 22 September 2006, an ultraviolet photometric O3 analyzer, a NO-NO2-NOx chemiluminescence analyzer, and a quartz micro-oscillating-scale particle concentration analyzer were simultaneously used for monitoring at three different heights each at Beijing (325-m tower) and Tianjin (255-m tower). These towers belong to the Institute of Atmospheric Physics (IAP) of the Chinese Academy of Sciences (CAS) and to the Tianjin Municipal Meteorological Bureau, respectively. These measurements were used to continuously measure the atmospheric O3 and NOx volume-by-volume concentrations and the PM2.5 mass concentration within a vertical gradient. When combined with meteorological data and information on the variation of vertical characteristics of the various atmospheric pollutants in the two cities, analysis shows that these two cities were seriously polluted by both PM2.5 and O3 during summer and autumn. The highest daily-average concentrations of PM2.5 near the ground in Beijing and Tianjin reached 183 μg m-3 and 165 μg m-3, respectively, while the O3 concentrations reached 52 ppb and 77 ppb, and NOx concentrations reached 48 ppb and 62 ppb for these two cities, respectively. The variations in the daily-average concentrations of PM2.5 between Beijing and Tianjin were demonstrated to be consistent over time. The concentrations of PM2.5 measured in Beijing were found to be higher than those in Tianjin. However, the overall O3 concentrations near the ground in Tianjin were higher than in Beijing. NOx concentrations in Tianjin were consistently lower than in Beijing. It was also found that PM2.5 pollution in Beijings atmosphere may also be affected by the pollutants originating in and delivered from Tianjin, and that Ti     

资源三号卫星影像融合优化方法探讨

针对资源三号卫星影像如何进行影像融合、波段组合才能到达到最佳视觉效果还没有统一意见的问题,该文提出了利用目前测绘项目中普遍采用的融合算法、波段组合比例对不同地形类别资源三号卫星影像进行实验验证的方法。综合主观评价与客观评价融合后的影像质量,得出了Subtractive、Pansharp和Pansharp2方法较为适合资源三号卫星影像融合的结论,其中绿波段与近红外波段的最佳组合比为9∶1。同时,分析了资源三号卫星影像融合后数据量大大增加、如何将近红外波段的波谱信息合理地加入到红、绿、蓝波段中等问题。     

四川九寨黄龙机场高填方地基变形三维动力分析

四川九寨黄龙机场具有高填方、高地震烈度、高海拔等三高的特点,高填方体地基在地震作用下的动力稳定与变形问题成为该机场需着重考虑的主要工程地质问题之一。在对目前各种动力分析方法研究的基础上,选用快速拉格郎日差分分析(FLAC)程序,对该机场元山子沟段高填方地基在地震作用下的变形规律进行了系统地研究,获得了一些有实际意义的认识。     

真三维立体显示技术在不动产登记统一平台中的应用研究

随着国家不动产统一登记制度的实施,城市房屋、林地、草原、土地等不动产统一整合、调查和管理工作迫在眉睫。基于机载多角度倾斜摄影和激光雷达扫描技术的创新,真三维数据可为不动产登记提供真实统一、高精度、多层次的空间载体,保证了城市不动产登记应用创新和制度创新。     

地面三维激光扫描仪测量误差检定

在利用三维激光扫描仪进行测量工作前,我们首先应了解其实际测量精度是否符合标称精度,而可靠的评价方式对得到精确的数据结果至关重要。本文利用北京卓立汉光TSA50-C型电动位移台作为评价标准,通过其精确的位移功能,准确地评价了RIGEL VZ-400三维激光扫描仪在测量单点位移时的误差,从而得到了其最佳工作距离。     

Laboratory Simulation of the Formation Process of Surface Geochemical Anomalies Applied to Hydrocarbon Exploration

The formation mechanisms and processes of geochemical anomalies used as proxies in surface geochemistry exploration (SGE) have not been well understood. Previous studies cannot realize 3D measurement of microseeping hydrocarbons from reservoirs to the surface, which made it difficult to understand the features and pathways of deep hydrocarbon microseepages. Understanding the processes of hydrocarbon microseepages will contribute to the acceptance and effectiveness of surface geochemistry. Based on a simplified geological model of hydrocarbon microseepages, including hydrocarbon reservoir, direct caprock, overlying strata and Quaternary sediments, this work established a 3D experimental system to simulate the mechanisms and processes of deep hydrocarbon microseepes extending to the surface. The dispersive halos of microseeping hydrocarbons in the subsurface were adequately described by using this 3D experimental system. Results indicate that different migration patterns of hydrocarbons above the point gas source within the simulated caprock and overlying strata can be reflected by the ratio of i-butane to n-butane (i-C4/n-C4), which follow diffusion and infiltration (buoyancy) mechanisms. This is not the case for vertical measurement lines far from the point gas source. A vertical gas flow in the form of a plume was found during hydrocarbon microseepage. For sampling methods, the high-density grid sampling is favorable for delineating prospecting targets. Hydrocarbon infiltration or buoyancy flow occurs in the zones of infiltration clusters, coupling with a diffusion mechanism at the top of the water table and forming surface geochemical anomalies. These results are significant in understanding hydrocarbon microseepage and interpreting SGE data.