A laboratory experiment to monitor the contact state of a fault by transmission waves

We performed a series of laboratory experiments in which elastic waves were transmitted across a simulated fault. Two types of experiments were carried out: (1) Normal Stress Holding Test (NSHT): normal stress was kept constant for about 3 h without shear stress and transmission waves were observed. (2) Shear Stress Increasing Test (SSIT): shear stress was gradually increased until a stick-slip event occurred. Transmission waves were continuously observed throughout the process of stress accumulation. We focused on the change in transmission waves during the application of shear stress and especially during precursory slips.It was found in NSHT that the amplitude of transmission waves linearly increased with the logarithm of stationary contact time. The increase amounted to a few percent after about 3 h. Creep at asperity contacts is responsible for this phenomenon. From a theoretical consideration, it was concluded that the real contact area increased with the logarithm of stationary contact time.We observed in SSIT a significant increase in wave amplitude with shear stress application. This phenomenon cannot be attributed to the time effect observed in NSHT. Instead, it can be explained by the mechanism of “junction growth” proposed by Tabor. Junction growth yields an increase in real contact area. It is required for junction growth to occur that the material in contact is already plastic under a purely normal loading condition. A computer simulation confirmed that this requirement was satisfied in our experiments. We also found that the rate at which the amplitude increased was slightly reduced prior to a stick-slip event. The onset time of the reduction well coincides with the onset of precursory slip. The cause of the reduction is attributed to the reset of stationary contact time due to displacement. This interpretation is supported by the result of NSHT. Taking the time of stationary contact in SSIT into account, we may expect the change in wave amplitude to be, at most, only a few percent. The observed slight reduction in increasing rate is, in this sense, reasonable. The static stiffness of the fault also decreases with precursory slip. It was also found that low frequency waves are a better indicator of precursory slip than high frequency waves. This might suggest that low frequency waves with longer wavelength are a better indicator of average behavior of faults. The problem, however, merits a further investigation. The shifts in phase were also found to be a good indicator of the change in contact state of the fault. The changes in both amplitude and phase of transmission waves are unifyingly understood through the theory of transmission coefficient presented by Pyrak-Nolte et al. Rough surfaces have a tendency to give larger stick-slips than smooth surfaces. The amount of precursory slip is larger for rough surfaces than for smooth surfaces. Although it was confirmed by a computer simulation that rough surfaces have larger contact diameters than smooth surfaces, the rigorous relationship between the surface roughness (contact diameter) and the amount of precursory slips was not established.     

石太线下行K135滑坡特征与成因分析

滑坡位于石太线下行K135路段右侧偏西，平面上呈近似椭圆形，由原有老滑坡复活而形成。根据滑坡勘察，滑坡所处地貌单元属侵蚀剥蚀低中山区，滑坡区地层组成为第四系松散堆积物下伏晚古生代二叠系石千峰组泥岩、砂岩互层。在分析滑坡几何特征、地质构造特征、水文地质条件及滑坡变形破坏特征的基础上，探讨了滑坡的成因，认为老滑坡的成因以自然形成为主，新滑坡则发育并活动于老滑坡堆积物中，因某部门在老滑坡体前缘修建收费站，进行了大面积不适当的工程开挖，形成临空面，加之降雨的作用降低了土体的粘聚力及抗剪强度，在上覆岩土体的重力作用下形成新滑坡。老滑坡为巨型厚层滑坡，属于自然滑坡，新滑坡为大型中层滑坡，属于工程滑坡。     

用远场辐射场反演云闪放电参数

用地面电磁场遥感闪电放电参数无论是在实际应用还是理论研究中都具有重要意义。文中基于电流传输线模式 ,提出了一种用单站远场VLF/LF辐射场反演云内放电参数的简便方法。当传输线电流从底部传播到顶部的时间只有几微秒时 ,整个传输线的VLF/LF辐射可以近似成偶极子辐射 ,即远场辐射场与电流的时间变化率和传输线长度的乘积成正比。因此 ,对远场辐射场做时间积分就能获得完整的电流矩波形 (上升沿有所加宽 ) ,而且传输线模式中的重要参数 ,电流从底部传播到顶端经历的时间 ,也可以近似地用辐射场时间积分幅度与辐射场幅度之比来估计。这一方法具有估计云闪双极性大脉冲辐射过程的放电参数的潜力。     

深层水泥土搅拦桩在软土地基处理中的应用

通过对深层水泥土搅拌桩的加固机理及复合地基承载力性状的简要分析,根据国家现行规范,结合具体地基处理工程实例,对深层水泥搅拌桩在软土地区地基加固处理中的方案选择、设计、施工及检测中的常见技术要点作初步探讨。     

Formation and shortening deformation of a back-arc rift basin revealed by deep seismic profiling, central Japan

The northern Fossa Magna (NFM) basin is a Miocene rift system produced in the final stages of the opening of the Sea of Japan. It divides the major structure of Japan into two regions, with north-trending geological structures to the NE of the basin and EW trending structures to the west of the basin. The Itoigawa-Shizuoka Tectonic Line (ISTL) bounds the western part of the northern Fossa Magna and forms an active fault system that displays one of the largest slip rates (4–9 mm/year) in the Japanese islands. Deep seismic reflection and refraction/wide-angle reflection profiling were undertaken in 2002 across the northern part of ISTL in order to delineate structures in the crust, and the deep geometry of the active fault systems. The seismic images are interpreted based on the pattern of reflectors, the surface geology and velocities derived from refraction analysis. The 68-km-long seismic section suggests that the Miocene NFM basin was formed by an east dipping normal fault with a shallow flat segment to 6 km depth and a deeper ramp penetrating to 15 km depth. This low-angle normal fault originated as a comparatively shallow brittle/ductile detachment in a high thermal regime present in the Miocene. The NFM basin was filled by a thick (>6 km) accumulation of sediments. Shortening since the late Neogene is accommodated along NS to NE–SE trending thrust faults that previously accommodated extension and produce fault-related folds on their hanging wall. Based on our balanced geologic cross-section, the total amount of Miocene extension is ca. 42 km and the total amount of late Neogene to Quaternary shortening is ca. 23 km.     

Characteristics and genesis of maghemite in Chinese loess and paleosols: Mechanism for magnetic susceptibility enhancement in paleosols

Morphological characteristics and microstructures of magnetic minerals extracted from Chinese loess and paleosols were investigated using powder X-ray diffraction (XRD) and high-resolution transmission electron microscopy (HRTEM). Our results indicate that maghemite in loess–paleosol sequences was transformed from magnetite through oxidation of magnetite. Maghemite transformed from eolian magnetite during chemical weathering has low-angle grain boundaries among maghemite nano-crystals. Some nano-crystalline maghemites with nanoporous texture resulted from microbe-induced precipitation of magnetite or transformation of poorly crystalline ferric Fe (oxy)hydroxides in presence of Fe-reducing bacteria. Aggregates of euhedral maghemite nano-crystals were transformed from magnetite magnetosomes. Both microbe-induced nanoporous magnetite and microbe-produced magnetite magnetosomes are directly related to microbial activities and pedogenesis of the paleosols. It is proposed that the formation of nano-crystalline maghemite with superparamagnetic property in paleosol results in the enhancement of magnetic susceptibility, although the total amount (weight percent) of magnetic minerals in both paleosol and loess units is similar. Our results also show that nano-crystalline and nanoporous magnetite grains prefer to transform into maghemite in semi-arid soil environments instead of hematite, although hematite is a thermodynamically stable phase. This result also indicates that a decrease in crystal size will increase stability of maghemite. It is also inferred that surface energy of maghemite is lower than that of hematite.     

Les laves du mont Bangou : une première manifestation volcanique éocène, à affinité transitionnelle,de la Ligne du Cameroun

Mount Bangou, an Eocene volcano (⁴⁰K–⁴⁰Ar ages between 44.7 and 43.1 ± 1 Ma) is the oldest dated volcano of the Cameroon Line. In this region, two magmatic series, evolving by fractional crystallization, show transitional affinities that are exceptionally known in this sector. Mineral compositions of basaltic rocks (scarce modal olivine and occurrence of normative hypersthene) as well as geochemical characteristics (low Ba, La, Ta contents and high Y/Nb ratios) are in agreement with this trend. The succession of magmas evolving in time from transitional to more typical alkaline compositions is evidenced in a continental setting. To cite this article: J. Fosso et al., C. R. Geoscience 337 (2005).     

Weakness and mechanical anisotropy of phyllosilicate-rich cataclasites developed after mylonites of a low-angle normal fault (Simplon Line,Western Alps)

The Simplon Fault Zone is a late-collisional low-angle normal fault (LANF) of the Western Alps. The hanging wall shows evidence of brittle deformation only, while the footwall is characterized by a c. 1 km-thick shear zone (the Simplon Fault Zone), which continuously evolved, during exhumation and cooling, from amphibolite facies conditions to brittle-cataclastic deformations. Due to progressive localization of the active section of the shear zone, the thermal-rheological evolution of the footwall resulted in a layered structure, with higher temperature mylonites preserved at the periphery of the shear zone, and cataclasites occurring at the core (indicated as the Simplon Line). In order to investigate the weakness of the Simplon Line, we studied the evolution of brittle/cataclastic fault rocks, from nucleation to the most mature ones. Cataclasites are superposed on greenschist facies mylonites, and their nucleation can be studied at the periphery of the brittle fault zone. This is characterized by fractures, micro-faults and foliated ultracataclasite seams that develop along the mylonitic SCC′ fabric, exploiting the weak phases mainly represented by muscovite and chlorite. Approaching the fault core, both the thickness and frequency of cataclasite horizons increase, and, as their thickness increases, they become less and less foliated. The fault core itself is represented by a thicker non-foliated cataclasite horizon. No Andersonian faults or fractures can be found in the footwall damage zone and core zone, whilst they are present in the hanging wall and in the footwall further from the fault. Applying a stress model based on slip tendency, we have been able to calculate that the friction coefficient of the Simplon Line cataclasites was <0.25, hence this fault zone is absolutely weak. In contrast with other fault zones, the weakening effect of fluids was of secondary importance, since they accessed the fault zone only after an interconnected fracture network developed exploiting the cataclasite network.     

Hydrodynamic performance of a dual cylindrical caisson breakwater

The hydrodynamic performance of a dual cylindrical caisson breakwater (DCBW) formed by a row of caissons each of which consisting of a porous outer cylinder circumscribing an impermeable inner cylinder has been theoretically investigated. The theoretical formulation is based on the eigenfunction expansion method proposed by Spring and Monkmeyer (1974) which was further modified by Linton and Evans [Linton, C.M., Evans, D.V., 1990. The interaction of waves with arrays of vertical circular cylinders. Journal of Fluid Mechanics 215, 549–569] for an array of impermeable cylinders. The present formulation is an extension of the work of Wang and Ren [Wang, K.H., Ren, X., 1994. Wave interaction with a concentric porous cylinder system. Ocean Engineering 21(4), 343–360], wherein; the interaction of linear waves with a single concentric porous cylinder system was studied. In the present study, the formulation has been extended to the case of a group of porous dual cylinder system. Parametric studies are carried out to study the influence of porosity (G₀) on the outer caisson, width of the doughnut chamber (a/b) and the angle of wave incidence on the variation in the hydrodynamic loading, wave run-up, free-surface elevation in its vicinity as well as the transmission on its lee-side. The importance of the presence of the inner cylinder in achieving the required hydrodynamic performance in terms of either protection or providing tranquility on its lee side keeping higher stability for the breakwater system is highlighted.     

Gentrification as space domestication. The High Line Art case

In this paper, we critically examine the role of artistic locational choices and practices in the context of gentrification processes in urban renewal contexts. We characterize gentrification as a form of domestication of space, and explore the extent to which artistic choices and practices relate to such process with reference to the deontological dilemma of legitimization within the art system vs. responsible empowerment of vulnerable local constituencies. We illustrate our argument with an analysis of the High Line Art project, and show how this can be considered as a textbook example of art-driven space domestication leading to brutal forms of gentrification. We comment on the threat that this provides to the social credibility of artistic practices as an agency of responsible social change.