Characteristics and method of synthesis seismic wave based on wavelet reconstruction

A novel method of synthesizing seismic wave using wavelet reconstruction is proposed and compared with the traditional method of using theory of Fourier transform. By adjusting the frequency band energy and taking it as criterion, the formula of synthesizing seismic wave is deduced. Using the design parameters specified in Chinese Seismic Design Code for buildings, seismic waves are synthesized. Moreover, the method of selecting wavelet bases in synthesizing seismic wave and the influence of the damping ratio on synthesizing results are analyzed. The results show that the synthesis seismic waves using wavelet bases can represent the characteristics of the seismic wave as well as the ground characteristic period, and have good time-frequency non-stationary.     

山西数字地震台网单台测定近震震级偏差研究

选用2003年1月～2005年3月山西数字地震台网报告中可交的地震,选取了单台样本数接近和超出100的17个子台数据,从震级偏差频次分布、仪器、量规函数、台基诸因素,对单台震级的影响上作了定量统计和分析,得出仪器影响存在一定的震级负偏差,但不大;量规函数、台基是引起山西台网单台震级偏差的主要原因.本文给出了量规函数和台基校正值,校正之后,单台震级偏差94%(即17个台中除镇川1个)以上震级平均偏差在±0.2之内.这对于提高山西数字地震台网测定近震震级,提高台网速报质量具有极其重要的实际意义.     

高压断路器隔震体系抗震可靠度分析

给出了基于随机地震动模型的高压断路器抗震可靠性分析方法。通过建立高压断路器及其隔震体系的有限元计算模型，分析了在断路器底部瓷套管根部加设叠层橡胶垫后的动力性能，分析中利用随机地震动模型，充分考虑地震动的随机作用，给出了四类场地土条件下结构的地震响应均值和标准差；利用一次二阶矩理论计算得到高压断路器的可靠度，给出了各场地土条件下的震害率曲线。结果表明不同场地土条件下隔震垫的减震效果有所差异。     

Geological analysis and FT dating of the large-scale right-lateral strike-slip movement of the Red River fault zone

Tectonically, the large-scale right-lateral strike-slip movement along the Red River fault zone is char-acterized at its late phase with the southeastward extension and deformation of the Northwestern Yunnan normal fault depression on its northern segment, and the dextral shear displacement on its central-southern segment. Research of the relations between stratum deformation and fault movement on the typical fault segments, such as Jianchuan, southeast Midu, Yuanjiang River, Yuanyang, etc. since the Miocene Epoch shows that there are two times dextral faulting dominated by normal shearing occurring along the Red River fault zone since the Miocene Epoch. The fission track dating (abbrevi-ated to FT dating, the same below) is conducted on apatite samples collected from the above fault segments and relating to these movements. Based on the measured single grain’s age and the con-fined track length, we choose the Laslet annealing model to retrieve the thermal history of the samples, and the results show that the fault zone experienced two times obvious shear displacement, one in 5.5 ± 1.5 MaBP and the other in 2.1± 0.8 MaBP. The central-southern segment sees two intensive uplifts of mountain mass in the Yuanjiang River-Yuanyang region at 3.6―3.8 MaBP and 1.6―2.3 MaBP, which correspond to the above-mentioned two dextral normal displacement events since the late Miocene Epoch.     

Geology and geochemistry of the Bingdaban ophiolitic mélange in the boundary fault zone on the northern Central Tianshan Belt,and its tectonic implications

The properties and tectonic significance of the fault bound zone on the northern margin of the Central Tianshan belt are key issues to understand the tectonic framework and evolutionary history of the Tianshan Orogenic Belt. Based on the geological and geochemical studies in the Tianshan orogenic belt, it is suggested that the ophiolitic slices found in the Bingdaban area represent the remaining oceanic crust of the Early Paleozoic ocean between the Hazakstan and Zhungaer blocks. Mainly composed of basalts, gabbros and diabases, the ophiolites were overthrust onto the boundary fault between the Northern Tianshan and Central Tianshan belts. The major element geochemistry is characterized by high TiO₂ (1.50%–2.25%) and MgO (6.64%–9.35%), low K₂O (0.06%–0.41%) and P₂O₅ (0.1%–0.2%), and Na₂O>K₂O as well. Low ΣREE and depletion in LREE indicate that the original magma was derived from a depleted mantle source. Compared with a primitive mantle, the geochemistry of the basalts from the Bingdaban area is featureded by depletion in Th, U, Nb, La, Ce and Pr, and unfractionated in HFS elements. The ratios of Zr/Nb, Nb/La, Hf/Ta, Th/Yb and Hf/Th are similar to those of the typical N-MORB. It can be interpreted that the basalts in the Bingdaban area were derived from a depleted mantle source, and formed in a matured mid-oceanic ridge setting during the matured evolutionary stage of the Northern Tianshan ocean. In comparison with the basalts, the diabases from the Bingdaban area show higher contents of Al₂O₃, ΣREE and HFS elements as well as unfractionated incompatible elements except Cs, Rb and Ba, and about 10 times the values of the primitive mantle. Thus, the diabases are thought to be derived from a primitive mantle and similar to the typical E-MORB. The diabases also have slight Nb depletion accompanying no apparent Th enrichment compared with N-MORB. From studies of the regional geology and all above evidence, it can be suggested that the diabases from the Bingdaban area were formed in the mid-oceanic ridge of the Northern Tianshan ocean during the initial spreading stage. Supported by the Major State Research Program of PRC (Grant No. 2001CB409801), the National Natural Science Foundation of China (Grant Nos. 40472115 and 40234041) and the State Research Program of China Geological Survey (Grant No. 2001130000-22)     

Recurrence of the world’s largest green-tide in 2009 in Yellow Sea, China: Porphyra yezoensis aquaculture rafts confirmed as nursery for macroalgal blooms

In the summer of 2008, the world’s largest green-tide occurred in the Yellow Sea, China. The hypothesized cause was the expansion of Porphyra yezoensis aquaculture along the Jiangsu coastline and the re-occurrence of a green-tide in 2009 was predicted. In this study, satellite and field images showed the formation of the June 2009 green-tide which again originated from the Jiangsu coast. The responsible species, its source and biomass accumulation were studied to support the previous hypothesis. Morphological and phylogenetic analysis demonstrated the homology of Ulva prolifera in the 2008 green-tide with the U. prolifera from P. yezoensis aquaculture rafts. About 91-505 kg/ha of U. prolifera was attached to the P. yezoensis aquaculture rafts and a total biomass of 4956 tonnes was estimated during the harvesting of P. yezoensis. This is sufficient to seed a bloom when they are dislodged from the rafts as a result of harvesting practices.     

Petroleum Electromagnetic Prospecting Advances and Case Studies in China

Remarkable progress has been made in electromagnetic (EM) techniques as applied to the petroleum industry in instruments, data acquisition, and processing and interpretation in China. Included here is equipment, such as high-power Controlled Source EM (CSEM) acquisition systems, acquisition methods, such as the three dimensional small-bin Continuous Electromagnetic Array acquisition method, Time and Frequency Domain Controlled Source Electromagnetic, Borehole-to-surface Electromagnetic technique and marine magnetotelluric method. Data processing methods, such as fast three dimensional inversion using nonlinear conjugate gradients, and data interpretation methods, like Induced Polarization and Resistivity anomalies for hydrocarbon detection, are also included. These new techniques have been applied in petroleum survey and many cases are in complicated areas. They have successfully served the investigation of deep igneous rock reservoirs, and prediction of potential hydrocarbon targets. The cases indicate that electromagnetic techniques can help seismic survey to effectively detect hydrocarbon reservoir and remarkably improve drilling successes.     

浅谈如何让地震科技信息工作搭上安徽省大建设大发展大环境的快车

探索了地震科技信息工作与地方社会经济发展的内在联系及其作用。21世纪是现代化进程明显加快、经济迅速腾飞的时代,在江淮大地上掀起了以城市为龙头的、壮大工业经济、强化县域经济发展热潮。大发展、大建设、大环境的工作思路及东向发展战略,为地震科技信息工作提出了冷思考。如何搭上安徽"三大推进"的快车,是地震科技信息工作融入安徽经济发展的新起点。     

Analysis of earthquake ground motions using an improved Hilbert–Huang transform

Some limitations of the Hilbert–Huang transform (HHT) for nonlinear and nonstationary signal processing are remarked. As an enhancement to the HHT, a time varying vector autoregressive moving average (VARMA) model based method is proposed to calculate the instantaneous frequencies of the intrinsic mode functions (IMFs) obtained from the empirical mode decomposition (EMD) of a signal. By representing the IMFs as time varying VARMA model and using the Kalman filter to estimate the time varying model parameters, the instantaneous frequencies are calculated according to the time varying parameters, then the instantaneous frequencies and the envelopes derived from the cubic spline interpolation of the maxima of IMFs are used to yield the Hilbert spectrum. The analysis of the length of day dataset and the ground motion record El Centro (1940, N–S) shows that the proposed method offers advantages in frequency resolution, and produces more physically meaningful and readable Hilbert spectrum than the original HHT method, short-time Fourier transform (STFT) and wavelet transform (WT). The analysis of the seismic response of a building during the 1994 Northridge earthquake shows that the proposed method is a powerful tool for structural damage detection, which is expected as the promising area for future research.     

相控震源定向地震波信号分析

应用可控震源地震勘探,当环境噪声很强,采用组合震源工作仍不能满足信噪比要求时,引入能形成定向地震波的相控震源.由相控震源定向照明地震理论分析,主波束方向上3单元相控震源产生的反射地震波信号信噪比比单震源高6.53~9.54 dB,比组合震源高1.76~4.77dB.为研究相控地震实际效果,在同一测区进行了三种震源地震对比实验.由单炮地震记录和水平叠加时间剖面可知,相控震源反射波信号信噪比明显高于单震源情况,略高于组合震源情况.进一步对反射波信号功率谱特性做定量分析,得到如下结果：与单震源情况相比,相控震源使各道反射波信号信噪比提高了0.75~8.15 dB,平均提高3.65 dB;与组合震源情况相比,各道信噪比提高了0.93~3.17 dB,平均提高2.02 dB,实验结果与理论分析吻合.综上所述可知,基于相控震源的定向照明地震技术是可行的,可以有效提高地震信号的信噪比.