The capacity of marine plankton, macrophytes and particulate matter to adsorb Cu in the presence of Mg

A complexometric titration technique was employed to measure the total capacity of a variety of marine organisms to adsorb Cu²⁺. Measured adsorption capacities were 0.22 meq g⁻¹ for phytoplankton, 0.3–1.0 meq g⁻¹ for macrophytes, 1.0–2.5 meq g⁻¹ for zooplankton and 0.3 meq g⁻¹ for suspended particulate matter. The capacity of these materials to adsorb Cu²⁺ was reduced significantly in the presence of Mg²⁺ at seawater concentrations. Competition between Mg^t2+ and Cu²⁺ for adsorption sites at pH 6 is described by an average conditional equilibrium constant of 10^3.7. This constant is such that very little Cu²⁺ may be adsorbed onto particulates and marine phytoplankton in the presence of Mg²⁺. Further, primary productivity data and estimates of the detrital carbon sedimentation in Long Island Sound suggest that the flux of particulate carbon is insufficient to remove significant amounts of Cu from the water column to sediments by adsorption mechanisms.     

An Annotated Check-List of Planktonic Diatoms from the Gulf of Naples

Abstract. New data on the planktonic diatoms from the Gulf of Naples are presented together with those from the literature. Information is given on abundances, seasonal cycles and distributions of 183 taxa, including species, varieties and forms.     

A hypothesis for the formation of a mud bank in the Gulf of Papua

The riverine mud that escapes retention in the estuaries and enters the Gulf of Papua appears to be transported southeastward, across depth contours, by the prevailing currents in a series of wind-driven events. The mud deposits to the southeast of the rivers, at the mid-shelf region within a depth range of 40–60 m. Mud transported farther eastward is carried down the continental rise. Coarser riverine sediment (silt and sand) is deposited closer inshore. On the outer shelf (depth >60 m) relict carbonate debris dominates. The area of mud has maximum rates of pelagic and benthic productivity in the gulf.     

Heat flow and mass wasting in the Wilmington Canyon Region: U.S. Continental Margin

The average corrected heat flow in the Wilmington Canyon region, an area of inferred slope instability, is 35 ± 10 mW/m². This average heat flow is marginally consistent with the 46 ± 9 mW/m² measured at other North Atlantic sites over 160 m.y. old. High topographic relief causes most of the variability in surface heat flow and may lower the mean surface heat flow. There is no significant difference between the average corrected heat flow of 35 ± 10 mW/m² in sediment slide areas and the average corrected heat flow of 34 ± 10 mW/m² in undisturbed sediments.     

Measurement of alkaline and earthy ions in fish otolith and sea water using a high performance ion chromatography

Fish growth and the relation between growth and environmental conditions offer a good opportunity for measuring alkaline and earthy ions in fish otoliths.The analytical method must involve high sensitivity when attempting to discriminate between fish growth and environmental conditions.The aim of this paper is to propose a chromatographic method, with low detection limits, as a new approach in determining some important micronutrients present in sea water and fish otoliths.The work samples are: coastal, off-shore and sediment waters and fish otoliths (Engraulis encrasicholus, Mullus barbatus, Umbrina cirrhosa, Sciaena umbra, Pagellus erythrinus) in the Adriatic Sea and the Canal of Sicily.The analytical method includes an IONPAC CS12A chromatographic column and a 18 mM methanesulfonic acid eluent.The detection limit readings obtained with this method, for one E. encrasicholus fish otolith, weighing 2.6 mg are equal or inferior to 0.1 μg/L for lithium (Li), 59 μg/L for sodium (Na), 46 μg/L for ammonium (NH₄), 23 μg/L for potassium (K), 13 μg/L for magnesium (Mg), 88 μg/L for manganese (Mn), 2.567 μg/L for calcium (Ca) and 13 μg/L for strontium (Sr).The HPIC method minimizes overlaps such as Na on Li, and NH₄ in seawater and Ca on Mg and Sr in fish otolith. These elements are an essential constituent present in otoliths when describing the relation between growth and environmental conditions.Good separation among analytes is achieved within 16 min.     

Geology of the Continental Margin of Enderby and Mac. Robertson Lands, East Antarctica: Insights from a Regional Data Set

In 2001 and 2002, Australia acquired an integrated geophysical data set over the deep-water continental margin of East Antarctica from west of Enderby Land to offshore from Prydz Bay. The data include approximately 7700 km of high-quality, deep-seismic data with coincident gravity, magnetic and bathymetry data, and 37 non-reversed refraction stations using expendable sonobuoys. Integration of these data with similar quality data recorded by Japan in 1999 allows a new regional interpretation of this sector of the Antarctic margin. This part of the Antarctic continental margin formed during the breakup of the eastern margin of India and East Antarctica, which culminated with the onset of seafloor spreading in the Valanginian. The geology of the Antarctic margin and the adjacent oceanic crust can be divided into distinct east and west sectors by an interpreted crustal boundary at approximately 58° E. Across this boundary, the continent–ocean boundary (COB), defined as the inboard edge of unequivocal oceanic crust, steps outboard from west to east by about 100 km. Structure in the sector west of 58° E is largely controlled by the mixed rift-transform setting. The edge of the onshore Archaean–Proterozoic Napier Complex is downfaulted oceanwards near the shelf edge by at least 6 km and these rocks are interpreted to underlie a rift basin beneath the continental slope. The thickness of rift and pre-rift rocks cannot be accurately determined with the available data, but they appear to be relatively thin. The margin is overlain by a blanket of post-rift sedimentary rocks that are up to 6 km thick beneath the lower continental slope. The COB in this sector is interpreted from the seismic reflection data and potential field modelling to coincide with the base of a basement depression at 8.0–8.5 s two-way time, approximately 170 km oceanwards of the shelf-edge bounding fault system. Oceanic crust in this sector is highly variable in character, from rugged with a relief of more than 1 km over distances of 10–20 km, to rugose with low-amplitude relief set on a long-wavelength undulating basement. The crustal velocity profile appears unusual, with velocities of 7.6–7.95 km s⁻¹ being recorded at several stations at a depth that gives a thickness of crust of only 4 km. If these velocities are from mantle, then the thin crust may be due to the presence of fracture zones. Alternatively, the velocities may be coming from a lower crust that has been heavily altered by the intrusion of mantle rocks. The sector east of 58° E has formed in a normal rifted margin setting, with complexities in the east from the underlying structure of the N–S trending Palaeozoic Lambert Graben. The Napier Complex is downfaulted to depths of 8–10 km beneath the upper continental slope, and the margin rift basin is more than 300 km wide. As in the western sector, the rift-stage rocks are probably relatively thin. This part of the margin is blanketed by post-rift sediments that are up to about 8 km thick. The interpreted COB in the eastern sector is the most prominent boundary in deep water, and typically coincides with a prominent oceanwards step-up in the basement level of up to 1 km. As in the west, the interpretation of this boundary is supported by potential field modelling. The oceanic crust adjacent to the COB in this sector has a highly distinctive character, commonly with (1) a smooth upper surface underlain by short, seaward-dipping flows; (2) a transparent upper crustal layer; (3) a lower crust dominated by dipping high-amplitude reflections that probably reflect intruded or altered shears; (4) a strong reflection Moho, confirmed by seismic refraction modelling; and (5) prominent landward-dipping upper mantle reflections on several adjacent lines. A similar style of oceanic crust is also found in contemporaneous ocean basins that developed between Greater India and Australia–Antarctica west of Bruce Rise on the Antarctic margin, and along the Cuvier margin of northwest Australia.