In-well time-of-travel approach to evaluate optimal purge duration during low-flow sampling of monitoring wells

A common assumption with groundwater sampling is that low (<0.5 L/min) pumping rates during well purging and sampling captures primarily lateral flow from the formation through the well-screened interval at a depth coincident with the pump intake. However, if the intake is adjacent to a low hydraulic conductivity part of the screened formation, this scenario will induce vertical groundwater flow to the pump intake from parts of the screened interval with high hydraulic conductivity. Because less formation water will initially be captured during pumping, a substantial volume of water already in the well (preexisting screen water or screen storage) will be captured during this initial time until inflow from the high hydraulic conductivity part of the screened formation can travel vertically in the well to the pump intake. Therefore, the length of the time needed for adequate purging prior to sample collection (called optimal purge duration) is controlled by the in-well, vertical travel times. A preliminary, simple analytical model was used to provide information on the relation between purge duration and capture of formation water for different gross levels of heterogeneity (contrast between low and high hydraulic conductivity layers). The model was then used to compare these time–volume relations to purge data (pumping rates and drawdown) collected at several representative monitoring wells from multiple sites. Results showed that computation of time-dependent capture of formation water (as opposed to capture of preexisting screen water), which were based on vertical travel times in the well, compares favorably with the time required to achieve field parameter stabilization. If field parameter stabilization is an indicator of arrival time of formation water, which has been postulated, then in-well, vertical flow may be an important factor at wells where low-flow sampling is the sample method of choice.     

Groundwater biofilm dynamics grown in situ along a nutrient gradient

This paper describes the in situ response of groundwater biofilms in an alluvial gravel aquifer system on the Canterbury Plains, New Zealand. Biofilms were developed on aquifer gravel, encased in fine mesh bags and suspended in protective columns in monitoring wells for at least 20 weeks. Four sites were selected in the same groundwater system where previous analyses indicated a gradient of increasing nitrate down the hydraulic gradient from Sites 1 to 4. Measurements during the current study classified the groundwater as oligotrophic. Biofilm responses to the nutrient gradients were assessed using bioassays, with biomass determined using protein and cellular and nucleic acid staining and biofilm activity using enzyme assays for lipid, carbohydrate, phosphate metabolism, and cell viability. In general, biofilm activity decreased as nitrate levels increased from Sites 1 to 4, with the opposite relationship for carbon and phosphorus concentrations. These results showed that the groundwater system supported biofilm growth and that the upper catchment supported efficient and productive biofilms (high ratio of activity per unit biomass).     

Recent explosive eruptions and volcano hazards at Soputan volcano—a basalt stratovolcano in north Sulawesi, Indonesia

Soputan is a high-alumina basalt stratovolcano located in the active North Sulawesi-Sangihe Islands magmatic arc. Although immediately adjacent to the still geothermally active Quaternary Tondono Caldera, Soputan’s magmas are geochemically distinct from those of the caldera and from other magmas in the arc. Unusual for a basalt volcano, Soputan produces summit lava domes and explosive eruptions with high-altitude ash plumes and pyroclastic flows—eight explosive eruptions during the period 2003–2011. Our field observations, remote sensing, gas emission, seismic, and petrologic analyses indicate that Soputan is an open-vent-type volcano that taps basalt magma derived from the arc-mantle wedge, accumulated and fractionated in a deep-crustal reservoir and transported slowly or staged at shallow levels prior to eruption. A combination of high phenocryst content, extensive microlite crystallization and separation of a gas phase at shallow levels results in a highly viscous basalt magma and explosive eruptive style. The open-vent structure and frequent eruptions indicate that Soputan will likely erupt again in the next decade, perhaps repeatedly. Explosive eruptions in the Volcano Explosivity Index (VEI) 2–3 range and lava dome growth are most probable, with a small chance of larger VEI 4 eruptions. A rapid ramp up in seismicity preceding the recent eruptions suggests that future eruptions may have no more than a few days of seismic warning. Risk to population in the region is currently greatest for villages located on the southern and western flanks of the volcano where flow deposits are directed by topography. In addition, Soputan’s explosive eruptions produce high-altitude ash clouds that pose a risk to air traffic in the region.     

Elastic anisotropy of ferromagnesian post-perovskite in Earth's D” layer

We report experimental observation of a sizable elastic anisotropy in a polycrystalline sample of ferromagnesian silicate in post-perovskite (ppv) structure. Using a novel composite X-ray transparent gasket to contain and synthesize ppv in a panoramic diamond-anvil cell along with oblique X-ray diffraction geometry, we observed the anisotropic lattice strain and {1 0 0} or {1 1 0} slip-plane texture in the sample at 140 GPa. We deduced the elasticity tensor (c_ij), orientation-dependent compressional wave velocities, polarization-dependent shear-wave velocities, and the velocity anisotropy of the silicate ppv. Our results are consistent with calculations and indicate that with sufficient preferred orientation, the elastic anisotropy of this phase can produce large shear-wave splitting.     

Measured river leakages using conventional streamflow techniques: the case of Souhegan River, New Hampshire, USA

Multiple streamflow measurements were made at coupled discharge measurement stations to quantify rates of aquifer recharge and discharge on two reaches of the Souhegan River, New Hampshire, USA, flowing within a glacial-drift river-valley aquifer. The reaches included a predominantly losing (aquifer recharge) reach and a variable (aquifer recharge and discharge) reach located downstream of the former reach. River leakage, the differential between coupled upstream and downstream streamflow measurements along a reach, varied by almost 30 cubic feet per second (ft³/s) (0.85 m³/s) along the two reaches. The upper reach averaged 3.94 ft³/s (0.11 m³/s) loss whereas the lower reach averaged 4.85 ft³/s (0.14 m³/s) gain. At the upper reach, 13 losses were measured out of 19 coupled measurements. At the lower reach, ten out of 13 coupled measurements indicated gains in flow and suggest that this reach is primarily a gaining river reach. An important factor in river leakage appears to be antecedent trends in river stage. At the upper reach, gains were measured only during periods of declining river stage. Conversely, at the lower reach, streamflow loss was measured primarily during periods of rising river stage. Although some tendencies exist, several factors complicate the analysis of river leakage, most notably the inaccuracies in computed stream discharge.     

Hydraulically Controlled Discrete Sampling from Open Boreholes

Groundwater sampling from open boreholes in fractured‐rock aquifers is particularly challenging because of mixing and dilution of fluid within the borehole from multiple fractures. This note presents an alternative to traditional sampling in open boreholes with packer assemblies. The alternative system called ZONFLO (zonal flow) is based on hydraulic control of borehole flow conditions. Fluid from discrete fractures zones are hydraulically isolated allowing for the collection of representative samples. In rough‐faced open boreholes and formations with less competent rock, hydraulic containment may offer an attractive alternative to physical containment with packers. Preliminary test results indicate a discrete zone can be effectively hydraulically isolated from other zones within a borehole for the purpose of groundwater sampling using this new method.     

BEAVER-POND SEQUENCE MORPHOLOGY AND SEDIMENTATION IN NORTHWESTERN MONTANA

Two adjacent beaver-pond sequences of seven ponds each were examined along the eastern boundary of Glacier National Park, Montana, to determine spatial patterns and amounts of sedimentation, both within individual ponds and along pond sequences. Dams and their associated ponds were categorized into two age groups, young versus old, based on dam morphology and surface vegetation. Old ponds contained significantly more sediment than did young ponds. However, hypothesized patterns of downstream reductions in coarse-grained sediment, both within a pond and along a sequence, were not observed, nor were there any discernible patterns in sediment texture across ponds. [Key words: beaver pond, sedimentation, Rocky Mountains, Montana.]     

Application of a New Vertical Profiling Tool (ESASS) for Sampling Groundwater Quality During Hollow‐Stem Auger Drilling

A new tool called ESASS (Enhanced Screen Auger Sampling System) was developed by the U.S. Geological Survey. The use of ESASS, because of its unique U.S. patent design (U.S. patent no. 7,631,705 B1), allows for the collection of representative, depth‐specific groundwater samples (vertical profiling) in a quick and efficient manner using a 0.305‐m long screen auger during hollow‐stem auger drilling. With ESASS, the water column in the flights above the screen auger is separated from the water in the screen auger by a specially designed removable plug and collar. The tool fits inside an auger of standard inner diameter (82.55 mm). The novel design of the system constituted by the plug, collar, and A‐rod allows the plug to be retrieved using conventional drilling A‐rods. After retrieval, standard‐diameter (50.8 mm) observation wells can be installed within the hollow‐stem augers. Testing of ESASS was conducted at one waste‐disposal site with tetrachloroethylene (PCE) contamination and at two reference sites with no known waste‐disposal history. All three sites have similar geology and are underlain by glacial, stratified‐drift deposits. For the applications tested, ESASS proved to be a useful tool in vertical profiling of groundwater quality. At the waste site, PCE concentrations measured with ESASS profiling at several depths were comparable (relative percent difference <25%) to PCE concentrations sampled from wells. Vertical profiling with ESASS at the reference sites illustrated the vertical resolution achievable in the profile system; shallow groundwater quality varied by a factor of five in concentration of some constituents (nitrate and nitrite) over short (0.61 m) distances.     

Late glacial and holocene landscapes of central Beringia

New palynological and sedimentological data from St. Lawrence Island present a rare view into late-glacial and Holocene environments of the central Bering Land Bridge. The late glaciation was a time of dynamic landscape changes in south-central Beringia, with active thermokarst processes, including the formation and drainage of thaw lakes. The presence of such a wet, unstable substrate, if widespread, probably would have had an adverse impact on food sources and mobility for many of the large mammal populations. The establishment of Betula shrub tundra on the island suggests late-glacial summers that were warmer than present, consistent with regional paleoclimatic interpretations. However, the increasing proximity to the Bering Sea, as postglacial sea levels rose, modified the intensity of warming and prevented the establishment of deciduous forest as found in other areas of Beringia at this time. The mid- to late Holocene is marked by more stable land surfaces and development of Sphagnum and Cyperaceae peat deposits. The accumulation of organic deposits, decline of shrub Betula, and decrease in thermokarst disturbance suggest that conditions were cooler than the previous. A recent decline in peat accumulation at the study sites may relate to local geomorphology, but similar decreases have been noted for other arctic regions.