Anisotropic mechanical properties of zircon and the effect of radiation damage

This study provides new insights into the relationship between radiation-dose-dependent structural damage due to natural U and Th impurities and the anisotropic mechanical properties (Poisson’s ratio, elastic modulus and hardness) of zircon. Natural zircon samples from Sri Lanka (see Muarakami et al. in Am Mineral 76:1510–1532, 1991) and synthetic samples, covering a dose range of zero up to 6.8 × 10¹⁸ α-decays/g, have been studied by nanoindentation. Measurements along the [100] crystallographic direction and calculations, based on elastic stiffness constants determined by Özkan (J Appl Phys 47:4772–4779, 1976), revealed a general radiation-induced decrease in stiffness (~54 %) and hardness (~48 %) and an increase in the Poisson’s ratio (~54 %) with increasing dose. Additional indentations on selected samples along the [001] allowed one to follow the amorphization process to the point that the mechanical properties are isotropic. This work shows that the radiation-dose-dependent changes of the mechanical properties of zircon can be directly correlated with the amorphous fraction as determined by previous investigations with local and global probes (Ríos et al. in J Phys Condens Matter 12:2401–2412, 2000a; Farnan and Salje in J Appl Phys 89:2084–2090, 2001; Zhang and Salje in J Phys Condens Matter 13:3057–3071, 2001). The excellent agreement, revealed by the different methods, indicates a large influence of structural and even local phenomena on the macroscopic mechanical properties. Therefore, this study indicates the importance of acquiring better knowledge about the mechanical long-term stability of radiation-damaged materials.     

A New Tethered Balloon-Borne Payload for Fine-Scale Observations in the Cloudy Boundary Layer

A new scientific payload is introduced for fine-scale measurements of meteorological (wind vector, static air temperature, humidity, and air pressure) and microphysical (aerosol particles and cloud droplets) properties, suspended below a tethered balloon. The high resolution sensors and the tethered balloon are described. Measurements in a lifted fog layer from a first field campaign are presented.The detailed investigation of the fog/haze and the temperature inversion layer demonstrates the damping influence of the fog on temperature fluctuations, while thewind fluctuations are significantly decreased by theevolving temperature inversion, whichwas about 30 m above the fog layer.From spectral analysis the noise floors of the high-resolution sensors are determined to10^-6 kg m^-3 for the LWC (liquid water content) and 4 mK for the fast temperature sensor (UFT-B). The correlation betweentemperature and LWC structures in shallow haze layers is investigated. The release of latent heat and the corresponding warming in the haze of about 0.1 K could be quantified.     

Energy flow and elemental concentrations in the Steina River ecosystem (Black Forest, Germany)

Considering food web energetics and elemental cycling together allows the testing of hypotheses about the coevolution of biological systems and their physical environment. We investigated the energy flow and the distribution of 25 elements in the Steina River.¶We constructed an annual energy flow network and estimated the emergy ("embodied energy" that includes all the energy involved in a process) contributions of resources sustaining the system. Furthermore, we measured the concentration of various macronutrients, essential elements, and heavy metals in the physical environment and trophic compartments. Finally, we examined the hypothesis of a positive relationship between the "rarity" of an element and its tendency to bioaccumulate. To do so, we used transformity, the relative energy input required to sustain a compartment's net production or the concentration differential of an element between the living community and the physical environment.¶The resulting energy flow network is one of the most complete available for streams. In the Steina, over 99% of the energy input is transported through the system without being processed. Dissolved inorganic matter and sunlight are the largest inputs, but uptake efficiency is much higher for dissolved and particulate organic matter. Transformities of trophic compartments and elements span 6 to 7 orders of magnitude.¶The tendency to bioaccumulate was as predicted for most elements, with macronutrients showing no accumulation and heavy elements accumulating in high-transformity compartments. However, Na and K were found at highest concentrations in consumers, and Pb, Ga, and Cd in algae. Improved estimates may become possible as more knowledge is available on ecosystem flows. We suggest further ways of testing hypotheses about strategies of element processing.     

Effects of water use on arsenic release to well water in a confined aquifer

Field-based experiments were designed to investigate the release of naturally occurring, low to moderate (< 50 microg/L) arsenic concentrations to well water in a confined sandstone aquifer in northeastern Wisconsin. Geologic, geochemical, and hydrogeologic data collected from a 115 m2 site demonstrate that arsenic concentrations in ground water are heterogeneous at the scale of the field site, and that the distribution of arsenic in ground water correlates to solid-phase arsenic in aquifer materials. Arsenic concentrations in a test well varied from 1.8 to 22 microg/L during experiments conducted under no, low, and high pumping rates. The quality of ground water consumed from wells under typical domestic water use patterns differs from that of ground water in the aquifer because of reactions that occur within the well. Redox conditions in the well can change rapidly in response to ground water withdrawals. The well borehole is an environment conducive to microbiological growth, and biogeochemical reactions also affect borehole chemistry. While oxidation of sulfide minerals appears to release arsenic to ground water in zones within the aquifer, reduction of arsenic-bearing iron (hydr)oxides is a likely mechanism of arsenic release to water having a long residence time in the well borehole.     

Elimination of source-generated noise from correlated vibroseis data (the ‘ghost-sweep’ problem)

The most common noise-reduction methods employed in the vibroseis technique (e.g. spike and burst reduction, vertical stacking) are applied in the field to reduce noise at a very early stage. In addition, vibrator phase control systems prevent signal distortions produced by non-linearity of the source itself. However, the success of these automatic correction methods depends on parameter justification by the operator and the actual characteristics of the distorting noise. More specific noise-reduction methods (e.g. Combisweep (Trade mark of Geco-Prakla), elimination of harmonics) increase production costs or need uncorrelated data for the correction process. Because the field data are usually correlated and vertically stacked in the field to minimize logistical and processing costs, it is not possible to make subsequent parameter corrections to optimize the noise reduction after correlation and vertical stacking of a production record. The noise-reduction method described here uses the final recorded, correlated and stacked vibroseis field data. This method eliminates signal artifacts caused e.g. by incorrect vibroseis source signals being used in parameter estimation when a frequency–time analysis is combined with a standard convolution process. Depending on the nature of the distortions, a synthetically generated, nearly recursive noise-separation operator compresses the noise artifact in time using a trace-by-trace filter. After elimination of this compressed noise, re-application of the separation operator leads to a noise-corrected replacement of the input data. The method is applied to a synthetic data set and to a real vibroseis field record from deep seismic sounding, with good results.     

Archeoseismic study of damage in Roman and Medieval structures in the center of Cologne, Germany

The causes of damage observed in archeological records or preserved monuments are often difficult to be determined unequivocally, particularly when the possibility of secondary earthquake damage exists. Such secondary damage has been previously proposed for the Roman Praetorium, the governor’s palace in the center of Cologne. Ongoing excavations since 2007 revealed additional damage. The existing ground that has been uncovered and documented extends the affected area to 175?×?180 m. We present a comprehensive virtual model of the excavation area based on 200 3D laserscans together with a systematic analysis of the damage patterns and an improved model of the terrain during Roman/Medieval times including geotechnical parameters of the subsurface. Five locations with different damage patterns, including a Roman sewer, the octagonal central part of the Praetorium, a section with strongly inclined massive walls, a 13 m deep deformed well, a collapsed hypocaust, and damages in the Medieval mikveh are analyzed in detail. We use site-specific synthetic strong ground motion seismograms to test the possibility of earthquake-induced ground failures as a cause for the observed damage. This subsurface model is also used to test the possibility of hydraulically-induced damages by seepage and erosion of fine-grained material from stray sand. Heavy rainstorms can induce a direct stream of surface water through the fine sand layers to the ground water table. Simulated ground motion for assumed worst-case earthquake scenarios do not provoke slope instability at the level necessary to explain the structural damages.     

Über die Vertikalverteilung und jahreszeitliche Entwicklung der Larvendichte vonDreissena polymorpha Pallas im Pelagial des unteren Zürichseebeckens im Jahre 1974

The freshwater musselDreissena polymorpha Pallas was sighted for the first time in Lake Zürich about 1969. This meant a real problem for the water treatment of lake water. By means of a pump and vertical net hauls it was tried to add more information to the scarce results on Lake Zürich. Additional dates about temperature, depth of Secchi disk visibility and beam transmittance were collected. There was a first appearance of the larvae ofD. polymorpha at the beginning of June. Following the mean temperature of the epilimnion the number of individuals/m² reached max. 210,000. The greatest concentration measured in 1974 of larvae/m³ was 54,375 at a depth of 4 m. The last appearance ofD. polymorpha was observed at the end of October.

     

The Messinian Sicilian stratigraphy revisited: new insights for the Messinian salinity crisis

Controversies around the Messinian salinity crisis (MSC) are because of the difficulties in establishing genetic and stratigraphic relationships between its deep and shallow‐water record. Actually, the Sicilian foreland basin shows both shallow and deep‐water Messinian records, thus offering the chance to reconstruct comprehensive MSC scenarios. The Lower Gypsum of Sicily comprises primary and resedimented evaporites separated in space and time by the intra‐Messinian unconformity. A composite unit including halite, resedimented gypsum and Calcare di Base accumulated between 5.6 and 5.55 Ma in the main depocentres; it records the acme of the Messinian Salinity Crisis during a tectonic phase coupled with sea‐level falls at glacials TG14‐TG12. These deposits fully post‐date primary gypsum, which precipitated in shallow‐water wedge‐top and foreland ramp basins between 5.96 and 5.6 Ma. This new stratigraphic framework results in a three‐stage MSC scenario characterized by different primary evaporite associations: selenite in the first and third stages, carbonate, halite and potash salt in the second one associated with hybrid resedimented evaporites.