Numerical Study of the Intertropical Convergence Zone Over the Indian Ocean During the 1997 and 1998 Northeast Monsoon Episodes

—?The hydrostatic Naval Research Laboratory/North Carolina State University (NRL/NCSU) model was used to study the mesoscale dynamics and diurnal variability of the Intertropical Convergence Zone (ITCZ) over the Indian Ocean in the short-range period. To achieve this objective the initial conditions from two northeast monsoon episodes (29 January, 1997 and 29 January, 1998) were run for 48-hour simulations using a triple-nested grid version of the model with 1.5°?×?1.5°, 0.5°?×?0.5° and 0.17°?×?0.17° resolutions. The 1997 case represents a typical northeast monsoon episode, while the 1998 case depicts an abnormal monsoon episode during an El Niño event.¶Comparisons between the model-produced and analyzed mean circulation, wind speed, and associated rainfall for different spatial scales are presented. During the active northeast monsoon season in 1997, the major low-level westerly winds and associated high rainfall rates between 0° and 15°S were simulated reasonably well up to 24 hours. During the 1998 El Niño event, the model was capable of simulating weak anomalous easterly winds (between 0° and 15°S) with much lower rainfall rates up to 48 hours. In both simulations, the finest grid size resulted in largest rainfall rates consistent with Outgoing Longwave Radiation data.¶The model performance was further evaluated using the vertical profiles of the vertical velocity, the specific humidity and temperature differences between the model outputs and the analyses. It is found that during a typical northeast monsoon year, 1997, the water vapor content in the middle troposphere was largely controlled by the low-level convergence determined by strong oceanic heat flux gradient. In contrast, during the 1998 El Niño year moisture was present only in the lower troposphere. Due to strong subsidence associated with Walker circulation over the central and eastern Indian Ocean, deep convection was not present. Finally, the diurnal variations of the maximum rainfall, vertical velocity and total heat flux were noticeable only during the 1997 northeast monsoon year.     

The 1997/1998 mass mortality of corals: effects on fish communities on a Tanzanian coral reef

The abnormally high surface temperatures in the world's oceans during 1997/1998 resulted in widespread coral bleaching and subsequent coral mortality. An experiment was performed to study the effects of this coral mortality as well as the influence of the structural complexity on fish communities on a Tanzanian coral reef. Changes in fish communities were investigated on plots of transplanted corals after 88% of these corals had died. A distinct shift in fish community composition was found, although diversity was not affected. Fish abundance rose by 39% mostly due to an increase in herbivores, which seemed to benefit from enhanced algal growth on the dead corals. Fish abundance, species diversity and community composition were also strongly influenced by the structural complexity provided by the live and dead corals. This suggests that a coral reef can support abundant and diverse fish populations also after the corals have died as long as the reef structure is sustained.     

Spectacular low- and mid-latitude electrical fields and neutral winds during a superstorm

In November 2004, a major magnetic storm occurred, a lengthy portion of which was recorded by the Upper Atmospheric Radar Chain. On the 9th and 10th, the Jicamarca Radar detected the highest magnitude penetrating electric fields (±3 mV/m) and vertical drifts (±120 m/s) ever seen at this premiere facility. These large and variable drifts were highly correlated with the interplanetary magnetic and electric fields and created a double F layer on the dayside and unusual TEC behavior throughout the low-latitude zone. These solar wind-induced drifts both suppressed and generated irregularities at the magnetic equator at different times. Large-scale thermospheric disturbances were generated by high-latitude heating and tracked through the middle- to low-latitude zones where both parallel and perpendicular plasma drifts created major ionospheric changes. The auroral oval was located at a magnetic L shell of about three for many hours.     

基于Gabor-Daubechies小波束叠前深度偏移的角度域共成像道集

传统炮检距域共像集（CIG）在复杂介质中因波传播的多路径而存在反射体位置不确定的问题. 角度域CIG由于克服了这一缺陷而逐步成为速度分析、AVA以及振幅保真偏移成像等研究的主要手段. 以波动理论为基础的地震偏移成像方法的发展为获得高质量的角度域CIG提供了可靠的实现途径. 其中,基于波场局域化分解和传播的小波束域波场延拓和偏移成像方法,因其波场分解基本函数和传播算子在空间和方向上的双重局域特性,而成为角度相关分析研究的有效工具. 本文在采用Gabor Daubechies框架分解的小波束叠前角度域偏移成像基础上,利用不同的叠加方法由局部角度域像矩阵得到了反射角域CIG（CRAIG）和倾角域CIG（CDAIG）. 以SEG EAGE二维盐体模型为例,通过对CRAIG和CDAIG的对比,探讨了这两种角度域CIG的特点及其在地震偏移成像中的潜在应用.     

Application of microseismic multiplet analysis to the Basel geothermal reservoir stimulation events

The stimulation of a geothermal well in Basel, Switzerland produced a distribution of microseismic event locations with an overall alignment in the direction of the maximum horizontal stress. Fault plane solutions of individual larger events indicated movements on fracture planes at an angle to the maximum horizontal stress that could not be reliably interpreted from the event locations. To obtain higher resolution images of the microseismic event locations, events with similar waveforms have been identified by multiplet analysis. A number of receivers were used in the multiplet processing to ensure each multiplet is represented by a unique group of waveforms. The location accuracy within each multiplet has been significantly improved using cross‐correlation to refine the shear‐wave traveltime picks. The distribution of events within each multiplet can be interpreted as being due to movements on a single fracture or a number of near parallel fractures. It is shown that whilst the overall distribution of events is around the direction of the maximum horizontal stress, the individual multiplets representing fracture planes have a variety of azimuths and dips.     

Hydraulic subsurface measurements and hydrodynamic modelling as indicators for groundwater flow systems in the Rotondo granite,Central Alps (Switzerland)

Regional groundwater flow in high mountainous terrain is governed by a multitude of factors such as geology, topography, recharge conditions, structural elements such as fracturation and regional fault zones as well as man‐made underground structures. By means of a numerical groundwater flow model, we consider the impact of deep underground tunnels and of an idealized major fault zone on the groundwater flow systems within the fractured Rotondo granite. The position of the free groundwater table as response to the above subsurface structures and, in particular, with regard to the influence of spatial distributed groundwater recharge rates is addressed. The model results show significant unsaturated zones below the mountain ridges in the study area with a thickness of up to several hundred metres. The subsurface galleries are shown to have a strong effect on the head distribution in the model domain, causing locally a reversal of natural head gradients. With respect to the position of the catchment areas to the tunnel and the corresponding type of recharge source for the tunnel inflows (i.e. glaciers or recent precipitation), as well as water table elevation, the influence of spatial distributed recharge rates is compared to uniform recharge rates. Water table elevations below the well exposed high‐relief mountain ridges are observed to be more sensitive to changes in groundwater recharge rates and permeability than below ridges with less topographic relief. In the conceptual framework of the numerical simulations, the model fault zone has less influence on the groundwater table position, but more importantly acts as fast flow path for recharge from glaciated areas towards the subsurface galleries. This is in agreement with a previous study, where the imprint of glacial recharge was observed in the environmental isotope composition of groundwater sampled in the subsurface galleries. Copyright © 2012 John Wiley & Sons, Ltd.     

Atmospheric and soil moisture controls on evapotranspiration from above and within a Western Boreal Plain aspen forest

The Western Boreal Plain of North Central Alberta comprises a mosaic of wetlands and aspen (Populus tremuloides) dominated uplands where precipitation (P) is normally exceeded by evapotranspiration (ET). As such these systems are highly susceptible to the climatic variability that may upset the balance between P and ET. Above canopy evapotranspiration (ET_C) and understory evapotranspiration (ET_B) were examined using the eddy covariance technique situated at 25.5 m (7.5 m above tree crown) and 4.0 m above the ground surface, respectively. During the peak period of the growing seasons (green periods), ET_C averaged 3.08 mm d^?1 and 3.45 mm d^?1 in 2005 and 2006, respectively, while ET_B averaged 1.56 mm d^?1 and 1.95 mm d^?1. Early in the growing season, ET_B was equal to or greater than ET_C once understory development had occurred. However, upon tree crown growth, ET_B was lessened due to a reduction in available energy. ET_B ranged from 42 to 56% of ET_C over the remainder of the snow‐free seasons. Vapour pressure deficit (VPD) and soil moisture (θ) displayed strong controls on both ET_C and ET_B. ET_C responded to precipitation events as the developed tree crown intercepted and held available water which contributed to peak ET_C following precipitation events >10 mm. While both ET_C and ET_B were shown to respond to VPD, soil moisture in the rooting zone is shown to be the strongest control regardless of atmospheric demand. Further, soil moisture and tension data suggest that rooting zone soil moisture is controlled by the redistribution of soil water by the aspen root system. Copyright © 2013 John Wiley & Sons, Ltd.     

Comparison of fundamental properties of new types of fiber‐mesh‐reinforced seismic isolators with conventional isolators

New types of fiber‐reinforced rubber‐based seismic isolators have been a research interest for a number of engineers in the past decade. These new types of isolators can have similar seismic performances compared with the conventional ones. In most of the previous researches, the fiber‐reinforced rubber‐based isolators is usually manufactured with placing fiber sheets between precut rubber layers with the use of a bonding agent. This research differs from the previous researches in terms of manufacturing process, use of fiber mesh instead of fiber sheets, and use of lead in the core for some of the bearings. The aim of this research is to provide comparisons in fundamental seismic response properties of the new type of fiber mesh reinforced isolators and conventional isolators. In this scope, four pairs of fiber mesh reinforced elastomeric bearings and four pairs of steel‐reinforced elastomeric bearings are subjected to various levels of compression stresses and cyclic shear strains under constant vertical pressure. The tested types of isolators are fiber mesh reinforced elastomeric bearing, fiber mesh reinforced elastomeric bearing with lead core, steel‐reinforced elastomeric bearings, and steel‐reinforced elastomeric bearings with lead core. In this research, steel‐reinforced bearings are called conventional isolators. The major advantage for fiber mesh reinforced bearings observed during the tests is that these isolators can develop a considerable low horizontal stiffness compared with the conventional isolators. The damping characteristics of the new and conventional types are similar to each other. Copyright © 2013 John Wiley & Sons, Ltd.     

Morphological records of storm floods exemplified by the impact of the 1872 Baltic storm on a sandy spit system in south‐eastern Denmark

Beach‐ridge systems are important geo‐archives providing evidence for past wave climate including catastrophic storm flood events. This study investigates the morphological impacts of the 1872 Baltic storm flood on a beach‐ridge system (sandy spit) in south‐eastern Denmark and evaluates the frequency of extreme storm flood events in the area over a longer time perspective. This paper combines field studies of morphology and sedimentary deposits, studies of historical maps, digital terrain model, ground‐penetrating radar profiles, and luminescence dating. Sea water reached 2.8 m above mean sea level (amsl) during peak inundation and, based on studies of the morphological impacts of the 1872 storm flood, the event can be divided into four phases. Phase 1: increasing mean water levels and wave activity at the beach brought sediments from the beach (intertidal bars and normal berm) higher up in the profile and led to the formation of a storm‐berm. Phase 2: water levels further increased and sediment in the upper part of the profile continued to build up the storm‐berm. Phase 3: water levels now reached the top of the dune ridge and were well above the storm‐berm level. Sea water was breaching the dune ridge at several sites and wash‐over fans were generated until a level where the mean water level had dropped too much. Phase 4: the non‐vegetated wash‐over fans functioned as pathways for aeolian sand transport and relatively high dunes were formed in particular along the margins of the fan where aeolian sand was trapped by existing vegetation. The studied beach‐ridge system records about 4500 years of accumulation; the storm flood sediments described are unique suggesting that the 1872 Baltic storm flood event was an extreme event. Thus studies of beach‐ridge systems form a new source for understanding storm surge risk. Copyright © 2013 John Wiley & Sons, Ltd.