Stable isotopic and elemental characteristics of recent tufa from a karstic Krka River (south‐east Slovenia): useful environmental proxies?

Tufa samples from 16 consecutive barrages along a 13 km section of the groundwater‐fed Krka River (Slovenia) were analysed for their petrographical, mineralogical, elemental and stable carbon (δ¹³C) and oxygen (δ¹⁸O) isotope composition, to establish their relation to current climatic and hydrological conditions. Waters constantly oversaturated with calcite and the steep morphology of the Krka riverbed stimulate rapid CO₂ degassing and subsequent tufa precipitation. The carbon isotope fractionation (Δ¹³C) between dissolved inorganic carbon and tufa in the Krka River evolves towards isotopic equilibrium being controlled by continuous CO₂ degassing and tufa precipitation rate downstream. The Δ¹³C increased from 1·9 to 2·5‰ (VPDB); however, since tufa precipitation rates remain similar downstream, the major controlling factor of carbon isotope exchange is most probably related to the continuous ¹²CO₂ degassing downstream leaving the carbon pool enriched in ¹³C. In the case of oxygen, the isotope fractionation (Δ¹⁸O) was found to be from 1·0 to 2·3‰ (VSMOW) smaller than reported in the literature. The observed discrepancies are due to different precipitation rates of calcite deposits because Krka tufas on cascades grow relatively faster compared to slowly precipitated calcite deposits in cave or stream pools. Due to non‐equilibrium oxygen isotope exchange between Krka tufa and water, the δ¹⁸O proxy showed from 1·2 to 8·2°C higher calculated water temperatures compared to measured water temperatures, demonstrating that δ¹⁸O proxy‐based temperature equations are not reliable for water temperature calculations of fast‐growing tufa on cascades. Because Mg is bound to the terrigenous dolomite fraction in the Krka tufa samples, the Mg/Ca was also found to be an unreliable temperature proxy yielding over up to 20°C higher calculated water temperatures.     

Synthesis of cordierite using industrial waste fly ash

Fly ash is a product arising from coal combustion in thermal power plants. It represents a major source of environmental pollution. It is well known by its chemical composition rich of SiO₂ and Al₂O₃. With the aim of preserving the environment against this contamination, fly ash was used along with the starting materials for producing glass cordierite (2MgO, 2Al₂O₃, 5SiO₂). Four formulations were developed by mixing the silica gel, magnesium chloride (MgCl₂.6H₂O) and fly ash in the percentages enclosing the stoichiometry of cordierite (2MgO, 2Al₂O₃, 5SiO₂). Different experimental techniques (DTA/TGA, X-ray diffraction, FTIR and SEM) were used to characterise the prepared formulations. The results shown that for all formulations, a cordierite phase was obtained at 1200 °C along with several secondary phases such as mullite, cristobalite, silicon oxide, enstatite and spinel. At 1300 °C, pure indialite (α-cordierite) was obtained along with a small amount of spinel. The four formulations sintered at 1200 °C exhibit a homogenous morphology and high porosity. The acicular-shaped indialite grains were observed in both formulations with excess of alumina and excess of magnesia.