The influence of shallow landslides on sediment supply: A flume-based investigation using sandy soil

The impact of rainfall-induced shallow landslides on hillslope sediment discharge is not well understood. This paper reports experimental measurements of sediment discharge after water-induced shallow landslides are triggered on sandy soil in a flume under simulated rainfall. The principal aim of the research was to investigate how varying soil depth affects the location and occurrence of shallow slope failures, as well as how it affects sediment yields downslope. Four experiments were conducted using the same sandy soil and a 30° and 10° compound slope configuration under average rainfall intensity of 50 mm h^− 1 for up to 390 min. Soil depths were set to 200, 300, 400 and 500 mm. Engineering and geotechnical properties of the soil were examined. Sediment discharge and runoff were collected from the flume outlet at 15 minute intervals. Changes in the soil slope profiles after landslides and soil physical properties resulted from soil armouring, under continuous rainfall were also recorded. Results showed that sediment yields at the flume outlet, before landslides occurred, were very low and limited to the finer soil particles as would be expected for a sandy soil. However subsequent variations in sediment discharge were strongly related to failure events and their proximity to the outlet. Sediment yield was also affected by the original soil depth; the greater the depth, the higher the sediment yields. Post-failure reductions in sediment discharge were observed and attributed to post-failure slope stabilization under continuing rainfall and extensive soil armouring near the flume outlet. The results provide a clear linkage between landslides and sediment discharge due to hydrological processes occurring in the hillslope. This knowledge is being used to develop a model to predict sediment discharges from hillslopes following shallow landslide events.     

Sedimentological analysis of a Late Quaternary coastal dune system: An example from Gopnath,south‐east Saurashtra,Western India

Coastal dune systems consisting of allochemical grains are important sedimentary archives of Pleistocene age in both of the hemispheres between the latitudes of 20° to 40°. The south Saurashtra coast in western India exhibits a large section of Middle Pleistocene aeolianites in the form of coastal cliffs, which is famous as ‘Miliolite’. Miliolites of Gopnath in south‐east Saurashtra are the oldest known coastal aeolianite deposits (age >156 ka which corresponds to Marine Isotope Stage 6) in western India. Aeolian deposits of similar ages have also been reported from the Thar Desert in north‐west India and from Southern Arabia which were largely controlled by the south‐west monsoon wind system that affects the entire belt corresponding to Sahara–Sahel, the Arabian Peninsula and north‐western India. Miliolite deposits in Gopnath are characterized by grainfall, grainflow and wind ripple laminations. At least three types of aeolian bounding surfaces have been identified. Five major facies have been identified which represent the dune and interdune relationship within the coastal aeolian system. The major dune bodies are identified as transverse dune types. The Gopnath aeolianites were deposited under dominantly dry aeolian conditions. Facies association reveals two different phases of aeolian accumulation, namely initiation of aeolian sedimentation after a prolonged hiatus and the establishment of a regularized aeolian sedimentation system. While initiation of aeolian sedimentation is marked by vast stretches of sheet sand with occasional dune bodies, the overlying thick, tabular, laterally extensive cross‐stratified units manifest regular aeolian sedimentation. However, the dune building events in Gopnath were interrupted by development of laterally extensive palaeosol horizons. Eustasy and climate exerted the major allogenic controls on the aeolian sedimentation by affecting the sediment budget as well as influencing the sedimentation pattern.     

An empirical relation of daytime equatorial total electron content with equatorial electrojet in the Indian zone

The variability of Total Electron Content (TEC) at Trivandrum, located within equatorial anomaly region at the dip equator, with respect to a reference level derived from the TEC measurements at Shimla, located outside the region has been studied during low solar activity period. Chapman function is assumed to hold good for regions outside the anomaly extent. It shows that the difference of total measured TEC at the equator from the derived reference is highly correlated with equatorial electrojet. The observations conform to the previous investigations and are interpreted in light of established relations. A stochastic relationship with electrojet is derived and validated.     

Performance of GCMs for seasonal prediction over India��a case study for 2009 monsoon

The 2009 drought in India was one of the major droughts that the country faced in the last 100?years. This study describes the anomalous features of 2009 summer monsoon and examines real-time seasonal predictions made using six general circulation models (GCMs). El Ni?o conditions evolved in the Pacific Ocean, and sea surface temperatures (SSTs) over the Indian Ocean were warmer than normal during monsoon 2009. The observed circulation patterns indicate a weaker monsoon in that year over India with weaker than normal convection over the Bay of Bengal and Indian landmass. Skill of the GCMs during hindcast period shows that neither these models simulate the observed interannual variability nor their multi-model ensemble (MME) significantly improves the skill of monsoon rainfall predictions. Except for one model used in this study, the real-time predictions with longer lead (2- and 1-month lead) made for the 2009 monsoon season did not provide any indication of a highly anomalous monsoon. However, with less lead time (zero lead), most of the models as well as the MME had provided predictions of below normal rainfall for that monsoon season. This study indicates that the models could not predict the 2009 drought over India due to the use of less warm SST anomalies over the Pacific in the longer lead runs. Hence, it is proposed that the uncertainties in SST predictions (the lower boundary condition) have to be represented in the model predictions of summer monsoon rainfall over India.     

Paleoenvironment of deposition of the Dupi Tila Formation,Lalmai Hills,Comilla, Bangladesh

The Dupi Tila Formation is composed of yellow to light brown medium to very fine moderately hard to loose sandstone, siltstone, silty clay, mudstone and shale with some conglomerates with clasts of petrified wood. The lithofacies of matrix supported conglomerate, trough cross bedded conglomerate, massive sandstone, trough cross bedded sandstone, planar cross bedded sandstone, ripple cross laminated sandstone-siltstone, flaser laminated sandstone-shale, lenticular laminated sandstone-siltstone-shale, parallel laminated sandstone-siltstone, wavy laminated shale, parallel laminated blue shale, and mudstone are delineated within this formation. Based on the grain size, sedimentary structures, water depth and genesis of individual facies, facies are grouped into three types of facies associations like (i) coarse-grained conglomerate facies association in relation to tractive current deposits of alluvial fan set up at the base of litho-succession (FAC), (ii) medium to fine-grained sandstone-siltstone-mudstone facies association or facies association in relation to strong tide (FAT) characterizing the middle part of litho-succession, (iii) very fine-grained sandstone-siltstone-mudstone facies association in relation to less frequent weak tide or heterolithic facies association (FAHL) characterizing upper part of litho-succession and shallow marine facies association (FASM) composing the uppermost litho-succession. Presence of gluconite indicates that the depositional environment was shallow to deep marine. The dominant paleoflow direction during the deposition of Dupi Tila Formation was toward southeast to southwestern direction. The rivers were of braided type at the piedmont alluvial depositional set up at the lower part, which later changed to estuarine-tidal flat type environmental set up in the middle part to upper part and paleo-environment was shallow marine in the uppermost part.     

Correlations between algae and water quality: factors driving eutrophication in Lake Taihu, China

Rapid population increase and economic growth in eastern China has lead to the degradation of many water bodies in the region, such as Lake Taihu, the third largest freshwater lake in China. Using data from recent investigations, the correlations between algae (measured as chlorophyll-a) and water quality indices in Lake Taihu were described by multivariate statistical analyses, and the key driving factors for the lake eutrophication were identified by principal component analysis. Results revealed strong spatiotemporal variation in the correlations between algae and water quality indices, suggesting that the limiting factor for the dominant algae growth depends on seasonality and location and it is necessary to reduce both nitrogen and phosphorus inputs for a long-term eutrophication control in this hyper-eutrophic system. Water temperature was another important controlling factor for algal growth in the lake. Using principal component analysis, nutrient contaminations from anthropogenic and natural inputs were identified as the key driving factor for the water quality problems of the lake. Moreover, five principal components were extracted and characterized with high spatial and seasonal variations in Lake Taihu. The key driving factors were believed to influence spatial variations including heavily polluted areas located in the northern and northwestern parts of the lake, where many manufacturing factories were built and wastewater from domestic and industrial plants was discharged. Based on this analysis, attention should be paid to effective land management, industrial wastewater treatment, and macrophytic vegetation restoration to reduce the pollutant loads and improve water quality. Principal component analysis was found to be a useful and effective method to reduce the number of analytical parameters without notably impairing the quality of information in this study.     

Structural evolution of a gneiss dome in the axial zone of the proterozoic South Delhi Fold Belt in central Rajasthan

The structural geometry of the Anasagar gneiss dome in the axial zone of the South Delhi Fold Belt is controlled by polyphase folding. It is classified as a thrust-related gneiss dome and not as a metamorphic core complex. Four phases of deformation have affected both the gneiss and the enveloping supracrustal rocks. D₂ and D₃ deformations probably represent early and late stages of a progressive deformation episode in a simple shear regime combined with compression. The contact between the gneiss and the supracrustal rocks is a dislocation plane (thrust) with top-to-east sense of movement which is consistent with the vergence of the D₂ folds. The thrust had a ramp-and-flat geometry at depth. At the present level of exposure it is a footwall flat (that is, parallel to the gneissosity in the footwall), but it truncates the bedding of the hanging wall at some places and is parallel at others. The thrusting was probably broadly coeval with the D₂ folds and the thrust plane is locally folded by D₂. D₂ and D₃ folds have similar style and orientation as the first and second phases respectively of major folds in the Delhi Supergroup of the South Delhi Fold Belt and these are mutually correlatable. It is suggested that D1 may be Pre-Delhi in age. Available geochronological data indicate that the emplacement of the Anasagar gneiss predated the formation of volcanic rocks in the Delhi Supergroup and also predated the main crust forming event in the fold belt. The Anasagar gneiss and its enveloping supracrustal rocks are probably older than the Delhi Supergroup.     

Overtaking collision of two ion acoustic soliton in a plasma with a q-nonextensive electron and thermal positrons

Theoretically the propagation of two ion acoustic soliton interaction in a three component collisionless unmagnetized plasma which consists of electrons, positrons and cold ions, has been investigated here by employing reductive perturbation technique. In this study, q distributed electrons and Maxwell-Boltzmann distributed positrons are considered and Korteweged-de Vries (KdV) equation is derived. The KdV equation is solved to get two soliton solution by using Hirota bilinear method. The effects of the q distributed electrons on the profiles of two soliton structures and the corresponding phase shifts are investigated. It is observed that both the nonextensive parameter (q) and the ratio of positrons density and electron density (p=n _p0/n _e0), play a significant role in the formation and existence of two soliton and also in the nature of their phase shifts.