Modelling of oxygen and nitrogen cycling as a function of macrophyte community in the Thau lagoon

A three-dimensional model coupling physical and biological processes for the whole Thau lagoon (Mediterranean coast of France) was developed in order to assess the relationships between macrophytes and the oxygen and nitrogen cycles. Ten species have been inserted as forcing variables in the model. Plankton dynamics, shellfish cultivation impact and mineralization of organic matter are also considered, as well as nutrient and oxygen exchanges between the sediment and the water column.Simulations with and without the macrophytes have shown that the system can be characterized as having a highly structured pattern involving lagoon nitrogen and oxygen cycles. This pattern is created by the combined influence of macrophytes, watershed and oyster farming.The model has been also used to assess the total annual macrophyte production at the whole lagoon scale. Comparisons with phytoplankton production and with results from other temperate lagoons have underlined the high productivity of the Thau lagoon supported by active nutrient regeneration.     

Tensor time domain electromagnetic resistivity measurements at Ngatamariki geothermal field, New Zealand

Experimental measurements in the Ngatamariki geothermal field, North Island, New Zealand were made to test the applicability of the time domain electromagnetic method for detailed investigation of the resistivity structure within a geothermal field. Low-frequency square wave signals were transmitted through three grounded bipole current sources sited about 8 km from the measurement lines. Despite high levels of electrical noise, transient electric field vectors could be determined reliably for times between 0.02 and 3.3 s after each step in the source current. Instantaneous apparent resistivity tensors were then calculated. Apparent resistivity pseudosections along the two measurement lines show smooth variations of resistivity from site to site. Over most of the field the images consistently show a three-layer resistivity structure with a conductive middle layer (3–10 Ωm) representing the conductive upper part of the thermal reservoir. A deep-seated region of low resistivity in the northwest of the field may indicate a conductive structure at about 1 km associated with a deeper diorite intrusion. Measurements sited closer than about 100 m to drillholes appear to have been disturbed by metallic casing in the holes. A change in resistivity structure in the east of the field may indicate a major geological or hydrothermal boundary.     

Failure Mode and Spatial Distribution of Damage in Rothbach Sandstone in the Brittle-ductile Transition

— To elucidate the spatial complexity of damage and evolution of localized failure in the transitional regime from brittle faulting to cataclastic ductile flow in a porous sandstone, we performed a series of triaxial compression experiments on Rothbach sandstone (20% porosity). Quantitative microstructural analysis and X-ray computed tomography (CT) imaging were conducted on deformed samples. Localized failure was observed in samples at effective pressures ranging from 5 MPa to 130 MPa. In the brittle faulting regime, dilating shear bands were observed. The CT images and stereological measurements reveal the geometric complexity and spatial heterogeneity of damage in the failed samples. In the transitional regime (at effective pressures between 45 MPa and 130 MPa), compacting shear bands at high angles and compaction bands perpendicular to the maximum compression direction were observed. The laboratory results suggest that these complex localized features can be pervasive in sandstone formations, not just limited to the very porous aeolian sandstone in which they were first documented. The microstructural observations are in qualitative agreement with theoretical predictions of bifurcation analyses, except for the occurrence of compaction bands in the sample deformed at effective pressure of 130 MPa. The bifurcation analysis with the constitutive model used in this paper is nonadequate to predict compaction band formation, may be due to the neglect of bedding anisotropy of the rock and multiple yield mechanisms in the constitutive model.     

Characterisation of the 1997 Vulcanian explosions of Soufrière Hills Volcano,Montserrat, by video analysis

The activity of Convention at Montserrat Soufrière Hills Volcano, Montserrat, during the period 1995–1999 included numerous violent explosions. Two major cycles of Vulcanian explosions occurred in 1997: a first of 13 explosions between 4 and 12 August and a second of 75 between 22 September and 21 October. The explosions were short-lived events lasting a few tens of seconds during which partial fountain collapse generated pyroclastic surges and pyroclastic flows, and buoyant plumes ascended 3–15 km into the atmosphere. Each explosion discharged on average 3×10⁵ m³ (dense-rock equivalent, DRE) of magma, draining the conduit to depths of 1–2 km. The paper focuses on the first few seconds of three explosions of the 75 that occurred in September/October 1997: 6 October 1997 at 17:50, 7 October 1997 at 16:02 and 9 October 1997 at 12:32. Physical parameters such as exit velocities, magmatic water contents and magma pressures at fragmentation are estimated by following and modelling the ascent of individual momentum-dominated finger jets visible on videos during the initial stages of each explosion. The model treats each finger jet as an incompressible flow sustained by a steady flux of gas and particles during the few seconds of ascent, and produces results that compare favourably with those using a multiphase compressible code run using similar eruptive parameters. Each explosion reveals a progressive increase in eruptive intensity with time, jet exit velocities increasing from 40 m s^–1 at the beginning of the explosion up to 140 m s^–1 after a few seconds. Modelling suggests that the first magma to exit was largely degassed, whereas that discharged after a few seconds contained up to 2 wt% water. Magma overpressures up to ~10 MPa are estimated to have existed in the conduit immediately prior to each explosion. Progressive increases in jet exit velocity with time over the first few seconds of each explosion provide direct evidence for strong pre-eruptive gradients in water content and magma pressure in the upper reaches (probably 100–500 m) of the conduit. Fountain collapse occurred during the first 10–20 s of each explosion because the discharging jets had bulk densities up to 100 times that of the atmosphere and were unable to entrain enough air to become buoyant. Such high eruptive densities were due to the presence of partially degassed magma in the conduit.Editorial responsibility: A. Woods     

Indoor Radon Radioactivity at the University of Brunei Darussalam

— Indoor radon radioactivity in the rooms on the ground floor and first floor of the Physics Department, Faculty of Science, Universiti Brunei Darussalam was measured using a system that consists of an air filter pump, ZnS detector, photomultiplier tube and counter. Ground floor rooms' radon radioactivity was found to be about three times higher than that of the first floor. The maximum ground floor indoor radioactivity is only 0.39 Bqm^?3, a value relatively low and safe compared to the mean outdoor radon concentration of 1.41 Bqm^?3 measured (HU and TAN, 2000). The main source of radon emanation originates from the ground soil rather than the building materials.     

Fishery Water Releases to the Lower Pool of the Volgograd Hydroelectric Power Plant

Conditions of fish reproduction in the Volga–Caspian Basin depending on the hydrological regime in the Volga lower reaches, transformed by water withdrawals and regulatory impact of reservoirs are considered.     

Towards non-linear inversion for characterization of time-lapse phenomena through numerical modelling

We compare two geophysical survey measurements of the same type made at different times in order to characterize the change in the geological medium during the elapsed time. The aim of this study is to develop a strategy using a full non-linear inversion algorithm as the interpretation tool. In this way, not only the location and the form of the changes are recovered, but also the changes in the material parameters of the geological medium can be estimated. In order to solve this fully non-linear problem, the so-called ‘multiplicative regularized contrast source inversion’ (MR-CSI) method is employed. The unique property of this iterative method is that it does not solve the forward problem at each iterative step. This makes it possible to use the non-linear inversion algorithm for large-scale computation problems. The numerical results show that by taking into account the non-linear nature of the problem, interpretation of the time-lapse data can be significantly improved, compared with that obtained using linear inversion.     

Mars in depth

P Lognonné, T Spohn and D Giardini describe the state of knowledge of Mars' interior and make the case for deep seismology to address the unanswered questions.     

Sliding fragility of block‐type non‐structural components. Part 1: Unrestrained components

Motivated by the development of performance‐based design guidelines with emphasis on both structural and non‐structural systems, this paper focuses on seismic vulnerability assessment of block‐type unrestrained non‐structural components under sliding response on the basis of seismic inputs specified by current seismic codes. Two sliding‐related failure modes are considered: excessive relative displacement and excessive absolute acceleration. It is shown that an upper bound for the absolute acceleration response can be assessed deterministically, for which a simple yet completely general equation is proposed. In contrast, fragility curves are proposed as an appropriate tool to evaluate the excessive relative displacement failure mode. Sample fragility curves developed through Monte‐Carlo simulations show that fragility estimates obtained without taking into account vertical base accelerations can be significantly unconservative, especially for relatively large values of the coefficient of friction. It is also found that reasonable estimates of relative displacement response at stories other than the ground in multistorey buildings cannot in general be obtained by simply scaling the ground acceleration to the peak acceleration at the corresponding storey. Failure modes considered in this study are found to be essentially independent of each other, a property that greatly simplifies assessment of conditional limit states. Copyright © 2002 John Wiley & Sons, Ltd.     

A neural network approach for structural identification and diagnosis of a building from seismic response data

This work presents a novel procedure for identifying the dynamic characteristics of a building and diagnosing whether the building has been damaged by earthquakes, using a back‐propagation neural network approach. The dynamic characteristics are directly evaluated from the weighting matrices of the neural network trained by observed acceleration responses and input base excitations. Whether the building is damaged under a large earthquake is assessed by comparing the modal parameters and responses for this large earthquake with those for a small earthquake that has not caused this building any damage. The feasibility of the approach is demonstrated through processing the dynamic responses of a five‐storey steel frame, subjected to different strengths of the Kobe earthquake, in shaking table tests. Copyright © 2002 John Wiley & Sons, Ltd.