The initial responses of hot liquid water released under low atmospheric pressures: Experimental insights

Experiments have been performed to simulate the shallow ascent and surface release of water and brines under low atmospheric pressure. Atmospheric pressure was treated as an independent variable and water temperature and vapor pressure were examined as a function of total pressure variation down to low pressures. The physical and thermal responses of water to reducing pressure were monitored with pressure transducers, temperature sensors and visible imaging. Data were obtained for pure water and for solutions with dissolved NaCl or CO₂. The experiments showed the pressure conditions under which the water remained liquid, underwent a rapid phase change to the gas state by boiling, and then solidified because of removal of latent heat. Liquid water is removed from phase equilibrium by decompression. Solid, liquid and gaseous water are present simultaneously, and not at the 611 Pa triple point, because dynamic interactions between the phases maintain unstable temperature gradients. After phase changes stop, the system reverts to equilibrium with its surroundings. Surface and shallow subsurface pressure conditions were simulated for Mars and the icy satellites of the outer Solar System. Freezing by evaporation in the absence of wind on Mars is shown to be unlikely for pure water at pressures greater than c. 670 Pa, and for saline solutions at pressures greater than c. 610 Pa. The physical nature of ice that forms depends on the salt content. Ice formed from saline water at pressures less than c. 610 Pa could be similar to terrestrial sea ice. Ice formed from pure water at pressures less than c. 100 Pa develops a low thermal conductivity and a ‘honeycomb’ structure created by sublimation. This ice could have a density as low as c. 450 kg m⁻³ and a thermal conductivity as low as 1.6 W m⁻¹ K⁻¹, and is highly reflective, more akin to snow than the clear ice from which it grew. The physical properties of ice formed from either pure or saline water at low pressures will act to reduce the surface temperature, and hence rate of sublimation, thereby prolonging the lifespan of any liquid water beneath.     

The Monitor project: JW 380 – a 0.26-, 0.15-M⊙, pre-main-sequence eclipsing binary in the Orion nebula cluster

We present a general recipe for constructing N -body realizations of galaxies comprising near spherical and disc components. First, an exact spherical distribution function for the spheroids (halo and bulge) is determined, such that it is in equilibrium with the gravitational monopole of the disc components. Second, an N -body realization of this model is adapted to the full disc potential by growing the latter adiabatically from its monopole. Finally, the disc is sampled with particles drawn from an appropriate distribution function, avoiding local-Maxwellian approximations. We performed test simulations and find that the halo and bulge radial density profile very closely match their target model, while they become slightly oblate due to the added disc gravity. Our findings suggest that vertical thickening of the initially thin disc is caused predominantly by spiral and bar instabilities, which also result in a radial re-distribution of matter, rather than scattering off interloping massive halo particles.     

Separation of the visible and dark matter in the Einstein ring LBG J213512.73−010143

We model the mass distribution in the recently discovered Einstein ring LBG J213512.73−010143 (the 'Cosmic Eye') using archival Hubble Space Telescope imaging. We reconstruct the mass density profile of the z = 0.73 lens and the surface brightness distribution of the z = 3.07 source and find that the observed ring is best fitted with a dual-component lens model consisting of a baryonic Sersic component nested within a dark matter halo. The dark matter halo has an inner slope of 1.42^+0.24_−0.22, consistent with cold dark matter simulations after allowing for baryon contraction. The baryonic component has a mass-to-light ratio of  1.71^+0.28_−0.38 M_⊙/L _{B ⊙}  which when evolved to the present day is in agreement with local ellipticals. Within the Einstein radius of 0.77 arcsec (5.6 kpc), the baryons account for 46 ± 11 per cent of the projected lens mass. External shear from a nearby foreground cluster is accurately predicted by the model. The reconstructed surface brightness distribution in the source plane clearly shows two peaks. Through a generalization of our lens inversion method, we conclude that the redshifts of both peaks are consistent with each other, suggesting that we are seeing structure within a single galaxy.     

Streambank dewatering for increased stability

Streambank erosion is often the dominant source of sediment leaving modified watersheds. Mass failure of high, steep banks is one of the most serious forms of streambank erosion. The risk of a given bank experiencing mass failure is a function of bank height, angle, and soil strength, which is governed by soil moisture. Two methods for bank dewatering were tested in adjacent sections of streambank bordering a deeply incised channel in northern Mississippi: a low‐cost pump system and subsurface horizontal drains. Pore water pressures (both positive and negative pressures, or matric suction) were continuously monitored for 2 years at the pumped site, at an adjacent untreated control section, and for 1 year at the site stabilized with horizontal drains. Resulting data were used to calculate a time series of the factor of safety using a computer model. Over the course of two wet seasons, average bank retreats for the control and pumped plots were 0·43 and 0·21 m, respectively. More limited monitoring revealed that the site with passive drains retreated about 0·23 m. At the pumped site pore water pressure was 3–4 kPa lower than at the control site during the most critical periods. Accordingly, computed factors of safety were above the failure threshold at the pumped site, but fell below unity at the control site on 11 occasions over the period of observation. Similarly, the drained site displayed generally lower pore water pressure and higher safety factors except for two events when drains were evidently overwhelmed with the volume of local surface and subsurface flows. These results suggest, but do not prove, that bank dewatering promoted lower rates of bank retreat and higher levels of stability since the three sites had slight differences in soils, geometry and boundary conditions. Initial cost of the dewatering treatments were significantly less than orthodox bank stabilization measures, but operation and maintenance requirements may be greater. Published in 2009 by John Wiley & Sons, Ltd.     

Accessory mineral U–Th–Pb ages and <Superscript>40</Superscript>Ar/<Superscript>39</Superscript>Ar eruption chronology,and their bearing on rhyolitic magma evolution in the Pleistocene Coso volcanic field,California

We determined Ar/Ar eruption ages of eight extrusions from the Pleistocene Coso volcanic field, a long-lived series of small volume rhyolitic domes in eastern California. Combined with ion-microprobe dating of crystal ages of zircon and allanite from these lavas and from granophyre geothermal well cuttings, we were able to track the range of magma-production rates over the past 650 ka at Coso. In ≤230 ka rhyolites we find no evidence of protracted magma residence or recycled zircon (or allanite) from Pleistocene predecessors. A significant subset of zircon in the ~85 ka rhyolites yielded ages between ~100 and 200 Ma, requiring that generation of at least some rhyolites involves material from Mesozoic basement. Similar zircon xenocrysts are found in an ~200 ka granophyre. The new age constraints imply that magma evolution at Coso can occur rapidly as demonstrated by significant changes in rhyolite composition over short time intervals (≤10’s to 100’s ka). In conjunction with radioisotopic age constraints from other young silicic volcanic fields, dating of Coso rhyolites highlights the fact that at least some (and often the more voluminous) rhyolites are produced relatively rapidly, but that many small-volume rhyolites likely represent separation from long-lived mushy magma bodies.     

Industrial structural changes in Hong Kong, China under one country, two systems framework

Hong Kong has undergone substantial economic transformations and developed into a sophisticated business and financial center in the Asia-Pacific region,since the return of sovereignty to China as a Special Administrative Region under the One Country Two Systems (OCTS) in 1997.This paper discusses and analyzes the industrial structural changes of Hong Kong in recent decades as well as its future challenges and opportunities.The data and finding reveal that even though Hong Kong will face fierce competition from the Mainland’s cities as the rise of China,the important role as a bridge between China and the rest of the world will brace Hong Kong itself under the OCTS for developing into a service hub for business and trade in the Asia-Pacific region.