The energy balance experiment EBEX-2000. Part II: Intercomparison of eddy-covariance sensors and post-field data processing methods

The eddy-covariance method is the primary way of measuring turbulent fluxes directly. Many investigators have found that these flux measurements often do not satisfy a fundamental criterion—closure of the surface energy balance. This study investigates to what extent the eddy-covariance measurement technology can be made responsible for this deficiency, in particular the effects of instrumentation or of the post-field data processing. Therefore, current eddy-covariance sensors and several post-field data processing methods were compared. The differences in methodology resulted in deviations of 10% for the sensible heat flux and of 15% for the latent heat flux for an averaging time of 30 min. These disparities were mostly due to different sensor separation corrections and a linear detrending of the data. The impact of different instrumentation on the resulting heat flux estimates was significantly higher. Large deviations from the reference system of up to 50% were found for some sensor combinations. However, very good measurement quality was found for a CSAT3 sonic together with a KH20 krypton hygrometer and also for a UW sonic together with a KH20. If these systems are well calibrated and maintained, an accuracy of better than 5% can be achieved for 30-min values of sensible and latent heat flux measurements. The results from the sonic anemometers Gill Solent-HS, ATI-K, Metek USA-1, and R.M. Young 81000 showed more or less larger deviations from the reference system. The LI-COR LI-7500 open-path H₂O/CO₂ gas analyser in the test was one of the first serial numbers of this sensor type and had technical problems regarding direct solar radiation sensitivity and signal delay. These problems are known by the manufacturer and improvements of the sensor have since been made. The National Center for Atmospheric Research is supported by the National Science Foundation.     

Long-term snow and weather observations at Weissfluhjoch and its relation to other high-altitude observatories in the Alps

Snow and weather observations at Weissfluhjoch were initiated in 1936, when a research team set a snow stake and started digging snow pits on a plateau located at 2,540?m asl above Davos, Switzerland. This was the beginning of what is now the longest series of daily snow depth, new snow height and bi-monthly snow water equivalent measurements from a high-altitude research station. Our investigations reveal that the snow depth at Weissfluhjoch with regard to the evolution and inter-annual variability represents a good proxy for the entire Swiss Alps. In order to set the snow and weather observations from Weissfluhjoch in a broader context, this paper also shows some comparisons with measurements from five other high-altitude observatories in the European Alps. The results show a surprisingly uniform warming of 0.8°C during the last three decades at the six investigated mountain stations. The long-term snow measurements reveal no change in mid-winter, but decreasing trends (especially since the 1980s) for the solid precipitation ratio, snow fall, snow water equivalent and snow depth during the melt season due to a strong temperature increase of 2.5°C in the spring and summer months of the last three decades.     

Intercomparison of measurements of stratospheric hydrogen fluoride

Observations of the vertical profile of hydrogen fluoride (HF) vapor in the stratosphere and of the vertical column amounts of HF above certain altitudes were made using a variety of spectroscopic instruments in the 1982 and 1983 Balloon Intercomparison Campaigns. Both emission instruments working in the far infrared spectral region and absorption instruments using solar occultation in the 2.5m region were employed. No systematic differences were seen in results from the two spectral regions. A mean profile from 20–45 km is presented, with uncertainties ranging from 20% to 50%. Total columns measured from ground and from 12 km are consistent with the profile if the mixing ratio for HF is small in the tropophere and low stratosphere.     

Modelling the multiphase near-surface chemistry related to ozone depletions in polar spring

Near-total depletions of ozone have been observed in the Arctic spring since the mid 1980s. The autocatalytic reaction cycles involving reactive halogens are now recognized to be of main importance for ozone depletion events in the polar boundary layer. We present sensitivity studies using the model MISTRA in the box-model mode on the influence of chemical species on these ozone depletion processes. In order to test the sensitivity of the chemistry under polar conditions, we compared base runs undergoing fluxes of either Br₂, BrCl, or Cl₂ to induce ozone depletions, with similar runs including a modification of the chemical conditions. The role of HCHO, H₂O₂, DMS, Cl₂, C₂H₆, HONO, NO₂, and RONO₂ was investigated. Cases with elevated mixing ratios of HCHO, H₂O₂, DMS, Cl₂, and HONO induced a shift in bromine speciation from Br / BrO to HOBr/HBr, while high mixing ratios of C₂H₆ induced a shift from HOBr/HBr to Br/BrO. The shifts from Br/BrO to HOBr/HBr accelerated the aerosol debromination, but also increased the total amount of deposited bromine at the surface (mainly via increased deposition of HOBr). For all NO_y species studied (HONO, NO₂, RONO₂) the chemistry is characterized by an increased bromine deposition on snow reducing the amount of reactive bromine in the air. Ozone is less depleted under conditions of high mixing ratios of NO_x. The production of HNO₃ led to the acid displacement of HCl, and the release of chlorine out of salt aerosol (Cl₂ or BrCl) increased.     

The effect of particle size distributions on the dynamics of falling precipitation zones

A simplistic study of the dynamics of a falling particle ensemble is described. It shows the effect created by the introduction of particle size distributions on precipitation onset and duration and compares it to the case where air motions or pressure fields triggered by the particles are neglected. The assumption of homogeneously sized raindrops seems adequate if precipitation rates and total rainfall are considered. As soon as timing is involved a more refined treatment is required.     

A multi-hazard regional level impact assessment for Europe combining indicators of climatic and non-climatic change

To better prioritise adaptation strategies to a changing climate that are currently being developed, there is a need for quantitative regional level assessments that are systematic and comparable across multiple weather hazards. This study presents an indicator-based impact assessment framework at NUTS-2 level for the European Union that quantifies potential regional changes in weather-related hazards: heat stress in relation to human health, river flood risk, and forest fire risk. This is done by comparing the current (baseline) situation with two future time periods, 2011–2040 and 2041–2070. The indicator values for the baseline period are validated against observed impact data. For each hazard, the method integrates outcomes of a set of coherent high-resolution regional climate models from the ENSEMBLES project based on the SRES A1B emission scenario, with current and projected non-climatic drivers of risk, such as land use and socio-economic change. An index of regional adaptive capacity has been developed and compared with overall hazard impact in order to identify the potentially most vulnerable regions in Europe. The results show strongest increases in impacts for heat stress, followed by forest fire risk, while for flood risk the sign and magnitude of change vary across regions. A major difference with previous studies is that heat stress risk could increase most in central Europe, which is due to the ageing population there. An overall assessment combining the three hazards shows a clear trend towards increasing impact from climaterelated natural hazards for most parts of Europe, but hotspot regions are found in eastern and southern Europe due to their low adaptive capacities. This spatially explicit assessment can serve as a basis for discussing climate adaptation mainstreaming, and priorities for regional development in the EU.     

Warm frontal structure in association with a rapidly deepening extratropical cyclone

Abstract

The detailed characteristics of a CASPII warm frontal passage are presented in this article. This storm, Intensive Operating Period (IOP) 13 (February 26–27, 1992), was observed in detail with an array of diverse instruments. It has the advantage over earlier freezing precipitation studies of having simultaneous, in situ and remote sensing measurements by aircraft and ground‐based Doppler radar.

The associated precipitation was in the form of banded structures parallel to the front. Within these bands were embedded precipitation cores, some parallel to the band, some perpendicular. The warm front itself was characterized by major perturbations in its kinematic and thermodynamic features. The cores oriented parallel to the front were the result of embedded convection generated, at least in part, by the irregularities in the frontal surface.

The cores oriented perpendicular to the front were closely associated with the 0°C isotherm on the underside of the frontal inversion. Precipitation phase changes played a significant role in the occurrence of wide near 0°C regions, both vertically and horizontally. These regions had a profound influence on the observed precipitation types and led to complex precipitation‐thermodynamic‐dynamic interactions. Instabilities produced by these interactions are seen in wave‐like features observed by the Doppler radar in these regions, both parallel and perpendicular to the frontal zone.     

The GeoForschungsZentrum Potsdam/Groupe de Recherche de Gèodésie Spatiale satellite-only and combined gravity field models: EIGEN-GL04S1 and EIGEN-GL04C

The recent improvements in the Gravity Recovery And Climate Experiment (GRACE) tracking data processing at GeoForschungsZentrum Potsdam (GFZ) and Groupe de Recherche de Géodésie Spatiale (GRGS) Toulouse, the availability of newer surface gravity data sets in the Arctic, Antarctica and North-America, and the availability of a new mean sea surface height model from altimetry processing at GFZ gave rise to the generation of two new global gravity field models. The first, EIGEN-GL04S1, a satellite-only model complete to degree and order 150 in terms of spherical harmonics, was derived by combination of the latest GFZ Potsdam GRACE-only (EIGEN-GRACE04S) and GRGS Toulouse GRACE/LAGEOS (EIGEN-GL04S) mean field solutions. The second, EIGEN-GL04S1 was combined with surface gravity data from altimetry over the oceans and gravimetry over the continents to derive a new high-resolution global gravity field model called EIGEN-GL04C. This model is complete to degree and order 360 and thus resolves geoid and gravity anomalies at half- wavelengths of 55 km at the equator. A degree-dependent combination method has been applied in order to preserve the high accuracy from the GRACE satellite data in the lower frequency band of the geopotential and to form a smooth transition to the high-frequency information coming from the surface data. Compared to pre-CHAMP global high-resolution models, the accuracy was improved at a spatial resolution of 200 km (half-wavelength) by one order of magnitude to 3 cm in terms of geoid heights. The accuracy of this model (i.e. the commission error) at its full spatial resolution is estimated to be 15 cm. The model shows a reduced artificial meridional striping and an increased correlation of EIGEN-GL04C-derived geostrophic meridional currents with World Ocean Atlas 2001 (WOA01) data. These improvements have led to select EIGEN-GL04C for JASON-1 satellite altimeter data reprocessing. Electronic Supplementary Material The online version of this article (doi:) contains supplementary material, which is available to authorized users.     

Dual models of pore spaces

We present a model for pore spaces that consists of two parts related by duality: (1) a decomposition of an open polyhedral pore space into open contractible pore bodies separated by relatively open interfaces and (2) a pore network that is homotopy equivalent to the pore space. The dual model is unique and free of parameters, but it relies on regularity conditions for the pore space. We show how to approximate any pore space by the interior of a polyhedral complex such that the regularity conditions are fulfilled. Thus, we are able to calculate the dual model from synthetic porous media and images of real porous media. The pore bodies are unions of relatively open Delaunay cells with respect to the corners of the pore boundary, and the pore network consists of certain at most two-dimensional (2D) Voronoi cells with respect to the corners of the pore boundary. The pore network describes the neighborhood relations between the pore bodies. In particular, any relatively open 2D Delaunay face f separating two pore bodies has a unique (relatively open) dual network edge. In our model, f is a pore throat only if it is hit by its dual network edge. Thus, as opposed to widespread intuition, any pore throat is convex, and adjacent pore bodies are not necessarily separated by pore throats. Due to the duality between the pore network and the decomposition of the pore space into pore bodies it is straightforward to store the geometrical properties of the pore bodies [pore throats] as attributes of the dual network vertices [edges]. Such an attributed network is used to perform 2D drainage simulations. The results agree very well with those from a pore-morphology based modeling approach performed directly on the digital image of a porous medium. Contractibility of the pore bodies and homotopy equivalence of the pore space and the pore network is proven using discrete Morse theory and the nerve theorem from combinatorial topology.