Geochemical modeling and low-frequency geoelectrical methods to evaluate the impact of an open dump in arid and deltaic environments

In Mexico, open dumps that are maintained by the municipality but provide no covering of waste are not uncommon. Further, disposal at these sites is often performed by burning. The aim of this study was to determine the leachate plume from an open dump located in a depositional deltaic environment, with arid climate, low rainfall and where the water table is about 2 m below the surface. The methodology comprised analysis of groundwater monitoring wells and geophysical and geochemical prospecting techniques. The 3D geoelectric interpretation shows a typical area of these depositional environments with low resistive values (10–20 Ω-m) associated with the presence of sands and clays interbedded. However, there is a very low resistivity zone associated with the dump’s impact which reaches values below 5 Ω-m, and it is located where the disposal and burning of wastes occurred. Another zone with values above 16 Ω-m appears as a limit for the advance of the saline. This is interpreted as a sandy lenses area. These sandy lenses with higher porosity transport aquifer’s water. Thus the dump is in direct contact by this conduct with clean groundwater. Piper diagrams constructed with the chemical data analysis reveal that the groundwater in the area corresponds to the chlorinated and/or sulfated sodium type, showing the impact caused by the dump. The monitoring well (NP8, on-site) with the highest dissolved solids content behaves anomalously and belongs to the more conductive zone according to the geoelectric profiles. The subsoil geochemical behavior is influenced by the seasonal water table variations provoking the dissolution of burned and unburned wastes, but the effects of slow flows in the direction of the regional flow are not discarded. Although the most impacted area within the dump is characterized to a depth of 10 m, there is a slow flow in the direction of the regional flow that has been moving pollutants out of the dumpsite during its almost 20 years of operation. The results of this study provide valuable information for the authorities to carry out an appropriate restoration project.     

First Late Triassic Record of a Paleoentomofauna from South America(Malargüe Basin,Mendoza Province,Argentina)

<正>Late Middle Triassic to early Late Triassic insects from Argentina have been previously described from the Bermejo and Cuyana Basins where they have been recovered from the Ischichuca-Los Rastros and Potrerillos-Cacheuta Formations,respectively.The insect fauna discussed herein was collected during field studies in 1986/1987 from the Llantenes section(Norian to Rhaetian? Late Triassic),which is situated in the Malargue Basin in southern Mendoza province.The insect remains were found in the upper part of the Llantenes section (Llantenes Formation),which is built up of two coarsening-upwards cycles reflecting a deltaic progradation of a fluvial into a lacustrine environment(lower part),succeeded by repeated progradations into a floodplain-dominated environment(upper part;with finds of insects,conchostracans,fish remains,plant fragments,and drifted logs).The new finds represent the youngest Triassic insect records described from Argentina and even from South America in its entirety.There is only one contemporaneous fossil assemblage in Gondwana:in the Clarence/Moreton Basin(Aberdare Conglomerate;Late Norian)in Australia.The new Triassic insects include an impression of an isolated Mecopterida-like wing(Mendozachorista volkheimeri gen.et sp.nov.; Mendozachoristidae fam.nov.),coleopteran elytra of the Permosynidae(Ademosyne rosenfeldi sp.nov.and Ademosyne llantenesensis sp.nov.)and other isolated body fragments.This new Late Triassic entomofauna from Argentina is of considerable importance in the reconstruction of the biotic recovery of continental environments in Gondwana after the catastrophic mass extinction at the P/T boundary.     

Heavy metal mobility assessment in sediments from the Odiel River (Iberian Pyritic Belt) using sequential extraction

The Tessier sequential extraction scheme (SES) was applied to sediments from the Odiel river catchment (Iberian Pyritic Belt, SW of Spain), one of the most acid rivers on Earth, to assess the chemical association (exchangeable, carbonatic, bound to manganese and iron oxides, bound to organic matter and residual mineral) of heavy metals (Zn, Cd, Pb, Cu, Cr, Mn, Ni, Fe, and Hg). Sediments are very heterogeneous in their textural characteristics, showing different grain size. Twenty-seven samples were studied from from areas along the Odiel River, from the source to the mouth, with special interest in the Odiel Marshes Natural Park due to its ecological significance. Samples were classified as sandy (especially at the river mouth with low iron oxide and organic matter content) and clay-silty (in the middle of the river catchment with high iron oxide content). The numerous sandy samples with low pH values explain the low levels of metals upstream, although potential metals contributions arise from mining and ore. However, the presence of sulfate in the mining area and carbonate at the mouth may explain the high presence of lead and iron in these sandy zones. Some percentage of mobile Ni, Cu, and Zn were detected in the mining area, but the elevated relative percentage of exchangeable Cd in the estuary is even more remarkable. The percentage of Zn bound to carbonate is considerable in the catchment but especially in the estuary. However, Cu is only detected in the carbonate phase downstream, in spite of the low concentration of carbonate, which represents a drawback in the application of the Tessier SES to these types of samples. Finally, relatively high percentages of residual, non-mobile, Hg and Pb were observed, in the estuarine and mining areas, respectively. Sand, lime, and clay fractions of representative samples from Areas I, II, and III were used in a metal speciation study. Mainly, the elements analyzed had accumulated in the non-residual fractions. In the mining area of the Pyrite Belt, the elements analyzed are mainly bound to Fe–Mn oxides (Fe + Mn + Cu + Cr + Pb + Mn ± Zn) and the organic matter/sulfide fraction (Ni + Zn + Hg ± Cd), independent of sediment grain size. In conclusion, we show that the results of the study of chemical speciation in sediments from acid rivers are independent of the sediment grain size considered.     

Dynamics of contaminants in phosphogypsum of the fertilizer industry of Huelva (SW Spain): From phosphate rock ore to the environment

The dynamics of trace elements from phosphate rock ore to the environment in a phosphoric acid plant located in SW Spain and the impact of phosphogypsum wastes were investigated through total digestion and BCR-sequential extraction. Based on total concentration, element transfer factors as criteria for examining the potential environmental risk of waste with respect to ore rock were calculated, and it was observed that most trace elements are only transferred into phosphogypsum at rates of 2–12%. However, based on those concentrations that are likely to be most readily mobile in the environment, phosphogypsum acts as a higher emission source of contaminants than the original rock. About 100 million tonnes of phosphogypsum are stack-piled in a dump of 1200 ha over salt-marshes of an estuary formed by the confluence of the Tinto and Odiel rivers. Phosphogypsum has been applied, at the recommended rate of 20–25 t/ha since 1978–2001, to improve fertility and reduce Na saturation in agricultural soils of the Guadalquivir river valley (140 km²). Phosphogypsum capacity as a source of mobile contaminants in three environmental scenarios (water leaching, exposure to oxidising and reducing conditions) was quantified by combining sequential extraction and waste mass. The amounts of mobile contaminants that could be released for every tonne of phosphogypsum are approximately 7 × 10² g Sr, 1.1 × 10² g Fe, 55 g Y, 30 g Ce, 12 g Cr, 11 g Ti, 5 g Zn, 4 g each of Cu and Pb, 3 g each of V and Cd, 2 g each of As and Ni and 1 g U. Multiplying these amounts by 100 Mt and 20–25 t/ha, it is possible to calculate risk assessments of phosphogypsum for both estuarine zones, e.g. in a hypothetical stack collapse and waste spilling, and agricultural soils, respectively.     

Composition,Technology of Manufacture,and Circulation of Hellenistic Pottery from the Eastern Adriatic: A Case Study of Three Archaeological Sites along the Dalmatian Coast,Croatia

Archaeological excavations in Dalmatia have yielded a large amount of Hellenistic pottery that has yet to be archaeometrically analyzed. Stylistic analyses suggest that some vessels were imported, but the bulk of the material must have been produced locally. Our objectives are to demonstrate local ceramic production in both Greek colonies and native settlements in Dalmatia, and also to report on the composition and manufacture technology associated with this pottery. We examine 36 Hellenistic potsherds recovered from the coast of Croatia: a sanctuary on Cape Ploča, the native settlement of Resnik, and the Greek colony Issa. For the first time, archaeometric evidence supporting local production in Resnik is presented, while two local manufacturing centers are proposed for the bulk of the Cape Ploča pottery. The term Dalmatian production is suggested here to describe these indigenous ceramics. Material characteristics of the Issa samples suggest local colonial production and sophisticated ceramic technology.