Improved Petrological Modal Analyses from X-ray Powder Diffraction Data by use of the Rietveld Method I. Selected Igneous, Volcanic, and Metamorphic Rocks

Mineral modes have been determined for specimens of eight rocktypes from CuK X-ray powder diffraction data using the Rietveldmethod. The samples include two granites, a granodiorite, adamellite,gabbro, basalt, trachyte, and two granulite-facies metamorphicrocks. Up to eight individual mineral components have been measuredin each sample (no glassy phases were observed), with a detectionlimit of {small tilde}1 wt.%, depending on the mineral assemblage.Marked variations in grain size (i.e., granite vs. trachyte)provide no difficulties for the X-ray method. The X-ray resultscompare very favourably with (1) optical modes determined forthe medium–coarse-grained samples by point counting, (2)normative calculations obtained using locally enhanced catanormand mesonorm software, and (3) corresponding Rietveld modesdetermined, for two samples, from neutron powder data. Wheredifferences occur, these are discussed in relation to the limitationsof each of the methods. The improved accuracy of the X-ray method is due primarily tothe incorporation of the full diffraction profile in the Rietveldanalysis calculations, and the elimination of preferred orientationby collecting the data from samples packed in glass capillaries(i.e., Debye–Scherrer mode). The good agreement of theX-ray and neutron modes shows that the usual problems encounteredwith microabsorption, extinction, and sampling are of littleconcern in these rocks. The results highlight one of the majoradvantages provided by Rietveld modal analysis over the moretraditional ‘reference intensity’ X-ray methods,namely, that the crystal chemistry (and thus the calibrationconstants) of the individual phases can be adjusted dynamicallyduring each individual analysis. This not only provides moreaccurate phase abundances, but also gives important supplementaryinformation about the mineralogy of the major components.     

A case study of warm air advection over a melting snow surface

When relatively warm, moist air moves over a snow surface, sensible heat and moisture are extracted from its lower layers and used to melt the snow. The depth of the cooled layer depends on horizontal wind speeds and the presence of high vertical wind shear. The mechanism for air mass modification appears to be turbulent mixing.     

Desert vegetation and timing of solar radiation

Timing and amount of solar radiation were examined as factors influencing the distribution of seven perennial plants on a small mountain located in the Chihuahuan Desert. Average direct beam solar radiation fluxes at differing times throughout the day and year were estimated with computer calculations. Principal components analysis was used to reduce the number of solar radiation parameters and include the maximum available information with a manageable number of variables. The remaining solar radiation parameters were compared to plant distributions using redundancy analysis and generalized additive models. Unimodal, bimodal, and monotonic responses were all found depending upon the species and solar radiation parameter. Niche separation at this location depends upon the timing as well as the amount of solar radiation.     

Investigation of submicron volcanic aerosol-particles by photoelectron emission

Volcanic aerosol emissions have been studied for the first time by in situ photoelectric charging. Explorative studies on Mt Etna reveal large concentrations of particles below 1000 nm with the spectrum peaking in the size range of 100–1000 nm diameter. Although a large fraction of the particles is already charged upon emission, the net electrical charge carried by the aerosol turned out to be close to zero.Particles with high photoelectric yield vary greatly in their relative abundance and seem to occur mainly at active points of the volcano.     

Authigenic iron and titanium oxides in triassic red beds: (St. Bees Sandstone), Cumbria,Northern England

Authigenic iron and titanium oxides occur in three main textural varieties in the St. Bees Sandstone, a Triassic red bed succession in Cumbria. These are: (a) overgrowths of haematite, titaniferous haematite, anatase, and rutile which generally occur on detrital host grains of similar compositions. The overgrowths may occur as syntaxial rim cements or rhombohedral and prismatic projections and are always in optical continuity, (b) discrete crystals of anatase (including octahedrite) and haematite 10-40 μm in size occur in pore spaces, and (c) fine grained ( < 1 μm) pigmentary haematite occurs as grain coatings around detrital grains and in the interstitial matrix. The euhedral nature and pore-filling habit clearly indicate the authigenic origin of these iron- and titanium oxides. All three textural varieties are believed to have been precipitated from ground waters containing dissolved ferrous and titanium ions. These ions were derived from the intrastratal solution of detrital iron and titanium bearing grains including ferromagnesian silicates and iron-titanium oxides. The precipitation of iron oxides from migrating ground waters in the manner described here goes some way to explaining how thick, uniformly red successions can be formed.     

On the eigenvalues of kinematic α-effect dynamos

The kinematic α-effect dynamo problem is investigated in the case of an exterior perfect conductor. It is shown that certain approximate symmetries discovered in the numerical analysis of ROBERTS (1972) are exact for this case. As an illustration, an exact solution is given in a cylindrical geometry, where the equations can be written in terms of one variable. The implications for the earth's dynamo are discussed.     

Revised identifications in the 5C2 survey

In the present paper revised distances of optical objects from radio sources of the 5C2 survey are given. A statistical investigation of the data is given for blue objects and galaxies by the statistical method of the “first neighbour”. The identification rate on blue plates for both the blue objects and galaxies amounts to about 40% out of the total number of 26 identifications. For every blue object and galaxy which are proposed as an identification the statistical reliability is given.     

Photometrische Kalibrierung von Schmidtspiegelaufnahmen durch ein bildteilendes Hilfsprisma

Plates of the Tautenburg Schmidt can be calibrated with the aid of a beam-splitting prisma only if Schraffierkassette plates are used. The effects of image structure, scintillation and intermittence on in-focus images are different for the main component and the prismatic companion. Therefore, such plates cannot be used to set up a photometric scale.     

Der Mechanismus der dreimonatigen Oszillation des Großen Roten Flecks auf dem Jupiter

The present paper is a test to explain the three-month oscillation of the Great Red Spot on Jupiter as a solution of the NAVIER-STOKES equation which is coupled with a nonlinear equation of oscillation. Since several parameters resp. functions are unknown it is difficult to find quantitative solutions.