Effects of Drying on the Low-Frequency Electrical Properties of Tournemire Argillites

Nearly water-saturated argillite samples (initial water content near 3.4 wt%) were cored from an undisturbed area of an underground facility of the French Institute for Radioprotection and Nuclear Safety (IRSN), located at Tournemire (Aveyron, France). These samples were subjected to the following desiccation path: (a) A desaturation phase during which the samples were dried at ambient temperature conditions, relative humidity equal to 43% in average and (b) a heating phase during which the same samples were heated at four temperature levels from 70°C up to 105°C. During both phases, the low-frequency complex resistivity (0.18Hz–12 kHz) was recorded by a four-electrode device. The amplitude of the complex resistivity was extremely sensitive to water content change. At the end of the isotherm desaturation phase, it was multiplied by a factor of 3 to 5. During the heating phase, the resistivity increased by more than two orders of magnitude compared to the initial state. The percentage of Frequency Effect shows a low sensitivity to water content changes during the desaturation stage while it increased by two orders of magnitude during the heating phase. This result confirms that low-frequency spectral signature is extremely sensitive to textural changes (i.e., thermal-induced microcracking in this case) that occurred during heating. Moreover, the complex resistivity of the samples shows a strong anisotropy (a ratio of 10 between both amplitudes measured in the perpendicular directions). The classical Cole-Cole model cannot be used to fit the experimental data obtained in the heating phase. A generalized formulation of this model is required and was successfully applied to represent the complex resistivity data.     

Observational Evidence And Modelling Of An Internal Hydraulic Jump At The Atmospheric Boundary-Layer Top During A Tramontane Event

A hydraulic jump has been observed with the airborne backscatter lidar LEANDRE 1 (Lidar embarqué pour l'Etude des Aérosols, des Nuages, des interactions Dynamique-Rayonnement etdu cycle de l'Eau) at the top of the atmospheric boundary layer (ABL) during a Tramontane event in the framework of the Pyréneés experiment. An analytical fluid mechanics model is used to interpret lidar observations in connection with in situ measurements andto study the sensitivity of the hydraulic jump triggering to the boundary conditions. This model, which generalizes the reduced-gravity shallow-water theory for two-dimensional stratified flows over a topograpy, is diagnostic (i.e., the reduced gravity g' = g _{v v} is prescribed) and uses boundary conditions defined in terms of Riemann invariants. Using inflow and outflow boundary conditions as well as the reduced gravity prescribed from in situ measurements, the model is able to diagnose the presence of a hydraulic jump at the location suspected from the lidar observations. The wind speed, ABL height and Froude number derived from the model are in good agreement with the observations (within about 20–30%).     

Extraction of water and solutes from argillaceous rocks for geochemical characterisation: Methods, processes and current understanding

This paper summarises the results of a comprehensive critical review, initiated by the OECD/NEA "Clay Club," of the extraction techniques available to obtain water and solutes from argillaceous rocks. The paper focuses on the mechanisms involved in the extraction processes, the consequences on the isotopic and chemical composition of the extracted pore water and the attempts made to reconstruct its original composition. Finally, it provides some examples of reliable techniques and information, as a function of the purpose of the geochemical study. Electronic Publication     

Mouvements actuels des blocs tectoniques dans l’arc Bético-Rifain à partir des mesures GPS entre 1999 et 2005

GPS velocities and seismicity across the Betic–Rif Arc structural domains (Morocco and Iberia) provide a basis to evaluate present-day seismotectonic processes between different deformation belts. The results show asymmetric movements in the complex Alboran system accommodating the convergence between the African (Nubian) and Eurasian plates. While the Betic Mountains are attached to Iberia, moving toward the southeast with respect to Africa, the Rif is divided into three blocks with distinct displacements relative to Nubia: (1) the Tangier block moving southeastward, (2) the Central Rif block moving SSW, and (3) the Oriental Rif block undergoing clockwise rotation. GPS-derived motions decrease in rate from the Rif nappes complex to the foreland.     

Collision and stress trajectories in Taiwan: a finite element model

Field analyses of Plio-Quaternary compressional deformations in Taiwan have enabled us to reconstruct the paleostress trajectories resulting from the collision of the Luzon arc (Philippine Sea plate) with the Chinese continental margin (Eurasian plate). The direction of the maximum compressional stress σ₁ shows a fan-shaped pattern that we interpret as resulting from the collision of a rigid body (the Luzon arc) indenting a more deformable material (the thick sediments of the Chinese continental margin). Simple analytical models qualitatively explain the fan-shaped pattern, but the influence of various parameters such as boundary conditions and rheology cannot be quantitatively accounted for by this approach. Consequently, we have used a finite element technique to compute the stresses and strains induced by the push of a rigid body against a two-dimensional, viscous material. The boundary conditions are the velocities based on plate kinematics. A motion in the N300°E direction best explains the stress trajectories observed in central Taiwan. Viscosity contrasts as well as small changes in the shape of the northern edge of the indenter have little influence on the computed stress pattern. The most important parameter is the direction of convergence. Our model quantitatively explains the general pattern of the stress trajectories observed in the collision zone of Taiwan, between the Philippine Sea plate and Eurasia.     

The Pleistocene hominid site of Ternifine, Algeria: New results on the environment, age, and human industries

A new multidisciplinary research program, started in 1981, provided new data on the stratigraphy, fauna, and human industries, as well as the first results on paleomagnetism and sedimentology, for the Ternifine site in Algeria, which yielded the earliest hominid remains known in North Africa. The fossils were deposited in a swamp or lake surrounded by a very open, dry environment. The lake was fed by artesian springs that raised the underlying Miocene sands. Although nothing suggests a camp or butchery site, we discovered the first undisputable bone artifact in this site, the earliest known in this part of Africa. According to paleontological data, 700,000 yr B.P. is a likely age for the Ternifine deposits, which is consistent with the paleomagnetic results.     

Tectonic record of convergence changes in a collision area: the Boso and Miura peninsulas, Central Japan

Late Cenozoic formations in Boso and Miura have been affected by several tectonic events. Tectonic analysis enables us to reconstruct six different paleostress types: (1) early extension affecting the Oligocene/early Miocene Mineoka Group, (2) and (3), relatively minor compressional and extensional events probably early Pliocene in age, (4) major NNE-SSW compression dominating prior to 2 or 3 Ma ago, and (5) and (6) more recent major NNW-SSE compression to the west and WNW-ESE extension to the east, both types affecting the Pleistocene and prevailing since 1–2 Ma ago. The counterclockwise change from NNE-SSW to NNW-SSE compression is not accurately dated, but very likely occurred between 2 and 3 Ma ago; it is compared to similar evolutions in other areas of the Izu collision zone. We conclude that it corresponds to a major counterclockwise change in the direction of plate convergence (from SSE-NNW to SE-NW). The relationships between the directions of convergence and the distributions of Plio-Quaternary compressional paleostresses in and around the collision zone are described through a simple analogy, for the two stages of Plio-Quaternary collision. This counterclockwise change in stress fields and relative motions, also described in the Taiwan collision zone along the same Philippine Sea plate-Eurasia boundary, is interpreted as a major event at the scale of the plate. The possible significances of the other paleostress types identified in Boso are discussed. We conclude that tectonic analysis in and along collision boundaries provides a key for understanding kinematic evolution.