Sediment salt-load in the St Lucia Estuary during the severe drought of 2002–2006

The purpose of this study was to determine whether there was a sufficiently high residual salt load in the dry sediments of the St Lucia Estuary to cause salinity problems should it later fill up with either freshwater or seawater. The estuary lakes have suffered the effects of a severe drought since 2002 with the result that many areas were dry, and the salinity of the residual water varied between 4 psu and up to five times that of seawater. Measurements of the salts content in the sediments to a depth of 20 cm showed that more than 2 million tonnes of salt was held in this layer of the sediment in 2006. Recent management of the estuary (since 1970) has ensured that the mouth was not artificially opened. This was to prevent the inflow of seawater, with its salts, that would otherwise enter while the drought was in place. The results of the sediment salinity data showed that if the drought had been broken and the lake area filled with rain and river water, the resulting salinity would be about 6 psu. In March 2007, Cyclone Gamede in the Indian Ocean off the east coast of South Africa produced a wave climate at sea that resulted in the mouth breaching; thus introducing an estimated 12 million tonnes of salts. The high salinity in the system resulting from this breach is expected to have an adverse effect on the ecology of the system, whereas the residual salinity in the sediments would not have caused an environmental problem. If the estuary and lake system were to fill completely with seawater, the residual salts together with seawater will raise the salinity to an initial value higher than 40 psu, which will have the effect of suppressing much of the important submerged vegetation that is vital for sustaining juvenile fish in the system. Many of the large fauna will also suffer from a shortage of freshwater.     

The Ca-Eskola component in eclogitic clinopyroxene as a function of pressure, temperature and bulk composition: an experimental study to 15 GPa with possible implications for the formation of oriented SiO2-inclusions in omphacite

Experiments have been conducted in the P-T range 2.5–15 GPa and 850–1,500°C using bulk compositions in the systems SiO₂–TiO₂–Al₂O₃–Fe₂O₃–FeO–MnO–MgO–CaO–Na₂O–K₂O–P₂O₅ and SiO₂–TiO₂–Al₂O₃–MgO–CaO–Na₂O to investigate the Ca-Eskola (CaEs Ca_0.5□_0.5AlSi₂O₆) content of clinopyroxene in eclogitic assemblages containing garnet + clinopyroxene + SiO₂ ± TiO₂ ± kyanite as a function of P, T, and bulk composition. The results show that CaEs_ss in clinopyroxene increases with increasing T and is strongly bulk composition dependent whereby high CaEs-contents are favoured by bulk compositions with high normative anorthite and low diopside contents. In this study, a maximum of 18 mol% CaEs_ss was found at 6 GPa and 1,350°C in a kyanite-eclogite assemblage garnet + clinopyroxene + kyanite + rutile + coesite. By comparison, no significant increase in CaEs_ss with increasing P could be observed. If the formation of oriented SiO₂-rods frequently observed in eclogititc clinopyroxenes is due to the retrogressive breakdown of a CaEs-component then these textures are a cooling rather than a decompression phenomenon and are most likely to be found in kyanite-bearing eclogites cooled from temperatures ≥750°C. The presence of clinopyroxene with approx. 4 mol% CaEs_ss in an experiment conducted at 2.5 GPa/850°C confirms earlier suggestions based on field data that vacancy-rich clinopyroxenes are not necessarily restricted to ultrahigh pressure metamorphic conditions. Electronic supplementary material The online version of this article (doi:) contains supplementary material, which is available to authorized users.     

Solar wind helium, neon, and argon isotopic and elemental composition: Data from the metallic glass flown on NASA’s Genesis mission

Solar wind (SW) helium, neon, and argon trapped in a bulk metallic glass (BMG) target flown on NASA’s Genesis mission were analyzed for their bulk composition and depth-dependent distribution. The bulk isotopic and elemental composition for all three elements is in good agreement with the mean values observed in the Apollo Solar Wind Composition (SWC) experiment. Conversely, the He fluence derived from the BMG is up to 30% lower than values reported from other Genesis bulk targets or in-situ measurements during the exposure period. SRIM implantation simulations using a uniform isotopic composition and the observed bulk velocity histogram during exposure reproduces the Ne and Ar isotopic variations with depth within the BMG in a way which is generally consistent with observations. The similarity of the BMG release patterns with the depth-dependent distributions of trapped solar He, Ne, and Ar found in lunar and asteroidal regolith samples shows that also the solar noble gas record of extraterrestrial samples can be explained by mass separation of implanted SW ions with depth. Consequently, we conclude that a second solar noble gas component in lunar samples, referred to as the “SEP” component, is not needed. On the other hand, a small fraction of the total solar gas in the BMG released from shallow depths is markedly enriched in the light isotopes relative to predictions from implantation simulations with a uniform isotopic composition. Contributions from a neutral solar or interstellar component are too small to explain this shallow sited gas. We tentatively attribute this superficially implanted gas to low-speed, current-sheet related SW, which was fractionated in the corona due to inefficient Coulomb drag. This fractionation process could also explain relatively high Ne/Ar elemental ratios in the same initial gas fraction.     

Phthalic acid complexation and the dissolution of forsteritic glass studied via in situ FTIR and X-ray scattering

Multiple Internal Reflection Fourier Transform Infra-Red (MIR-FTIR) spectroscopy was developed and used for in situ flow-through experiments designed to study the process of organic acid promoted silicate dissolution. In tandem with the FTIR analysis, ex situ X-ray scattering was used to perform detailed analyses of the changes in the surface structure and chemistry resulting from the dissolution process. Phthalic acid and forsteritic glass that had been Chemically Vapour Deposited (CVD) onto an internal reflection element were used as reactants, and the MIR-FTIR results showed that phthalic acid may promote dissolution by directly binding to exposed Mg metal ion centers on the solid surface. Integrated infrared absorption intensity as a function of time shows that phthalic acid attachment apparently follows a t^1/2 dependence, indicating that attachment is a diffusive process. The diffusion coefficient of phthalic acid was estimated to be approximately 7 × 10⁻⁶ cm² s⁻¹ in the solution near the interface with the glass. Shifts in the infrared absorption structure of the phthalate complexed with the surface compared to the solute species indicate that phthalate forms a seven-membered ring chelate complex. This bidentate complex efficiently depletes Mg from the glass surface, such that after reaction as much as 95% of the Mg may be removed. Surface depletion in Mg causes adsorbate density to fall after an initial attachment stage for the organic ligand. In addition, the infrared analysis shows that silica in the near surface polymerizes after Mg removal, presumably to maintain charge balance. X-ray reflectivity shows that the dissolution rate of forsteritic glass at pH 4 based on Mg removal in such flow-through experiments was equal to 4 × 10⁻¹² mol cm⁻² s⁻¹ (geometric surface area normalized). Reflectivity also shows how the surface mass density decreases during reaction from 2.64 g cm⁻³ to 2.2 g cm⁻³, consistent with preferential loss of Mg from the surface. Auxiliary batch experiments with forsteritic glass films deposited onto soda glass were also completed to add further constraints to the mechanism of reaction. By combining reflectivity with diffuse scatter measurements it is shown that the primary interface changes little in terms of atomic-scale roughness even after removal of several hundred angstroms of material. These measurements unequivocally show how a dicarboxylic acid bonds to and may chelate the dissolution of a magnesium-bearing silicate. At the molecular level the solid surface retreat may best be described by a depinning model where Mg is preferentially removed and residual silica tetrahedra polymerize and act to episodically “pin” the surface.     

The persistence of lead from past gasoline emissions and mining drainage in a large riparian system: Evidence from lead isotopes in the Sacramento River, California

Lead concentrations and isotope ratios measured in river water colloids and streambed sediment samples along 426 km of the Sacramento River, California reveal that the influence of lead from the historical mining of massive sulfide deposits in the West Shasta Cu-mining district (at the headwaters of the Sacramento River) is confined to a 60 km stretch of river immediately downstream of that mining region, whereas inputs from past leaded gasoline emissions and historical hydraulic Au-mining in the Sierra Nevadan foothills are the dominant lead sources in the remaining 370 km of the river. Binary mixing calculations suggest that more than 50% of the lead in the Sacramento River outside of the region of influence of the West Shasta Cu-mining district is derived from past depositions of leaded gasoline emissions. This predominance is the first direct documentation of the geographic extent of gasoline lead persistence throughout a large riparian system (>160,000 km²) and corroborates previous observations based on samples taken at the mouth of the Sacramento River. In addition, new analyses of sediment samples from the hydraulic gold mines of the Sierra Nevada foothills confirm the present-day fluxes into the Sacramento River of contaminant metals derived from historical hydraulic Au-mining that occurred during the latter half of the 19th and early part of the 20th centuries. These fluxes occur predominantly during periods of elevated river discharge associated with heavy winter precipitation in northern California. In the broadest context, the study demonstrates the potential for altered precipitation patterns resulting from climate change to affect the mobility and transport of soil-bound contaminants in the surface environment.     

Airports, mobility and the calculative architecture of affective control

Drawing on work surrounding the theorisation of concepts such as mobility, affect and emotion, the paper argues that their control is now being intertwined in places like airports which are employing a number of techniques that engineer affects. Airport affect is enacted, in one way, by planning and designing the situational affective context one inhabits - throwing up structures of ethological possibility that shape capacities for the corporeal body to move and be moved. It is shown that the engineering of airport affect is premised upon a wider discursive framework of calculation and indeterminacy, and that selective techniques summon a number of different modalities of control. The paper concludes with a series of implications for the understanding of power, and the study of mobility, emotion and affect.     

Atmospheric mercury near Salmon Falls Creek Reservoir in southern Idaho

Gaseous elemental mercury (GEM) and reactive gaseous mercury (RGM) were measured over 2-week seasonal field campaigns near Salmon Falls Creek Reservoir in south-central Idaho from the summer of 2005 through the fall of 2006 and over the entire summer of 2006 using automated Tekran Hg analyzers. GEM, RGM, and particulate Hg (HgP) were also measured at a secondary site 90 km to the west in southwestern Idaho during the summer of 2006. The study was performed to characterize Hg air concentrations in the southern Idaho area for the first time, estimate Hg dry deposition rates, and investigate the source of observed elevated concentrations. High seasonal variability was observed with the highest GEM (1.91 ± 0.9 ng m⁻³) and RGM (8.1 ± 5.6 pg m⁻³) concentrations occurring in the summer and lower values in the winter (1.32 ± 0.3 ng m⁻³, 3.2 ± 2.9 pg m⁻³ for GEM, RGM, respectively). The summer-average HgP concentrations were generally below detection limit (0.6 ± 1 pg m⁻³). Seasonally averaged deposition velocities calculated using a resistance model were 0.034 ± 0.032, 0.043 ± 0.040, 0.00084 ± 0.0017 and 0.00036 ± 0.0011 cm s⁻¹ for GEM (spring, summer, fall and winter, respectively) and 0.50 ± 0.39, 0.40 ± 0.31, 0.51 ± 0.43 and 0.76 ± 0.57 cm s⁻¹ for RGM. The total annual RGM + GEM dry deposition estimate was calculated to be 11.9 ± 3.3 μg m⁻², or about 2/3 of the total (wet + dry) deposition estimate for the area. Periodic elevated short-term GEM (2.2–12 ng m⁻³) and RGM (50–150 pg m⁻³) events were observed primarily during the warm seasons. Back-trajectory modeling and PSCF analysis indicate predominant source directions to the SE (western Utah, northeastern Nevada) and SW (north-central Nevada) with fewer inputs from the NW (southeastern Oregon and southwestern Idaho).     

The passivation of calcite by acid mine water. Column experiments with ferric sulfate and ferric chloride solutions at pH 2

Column experiments, simulating the behavior of passive treatment systems for acid mine drainage, have been performed. Acid solutions (HCl or H₂SO₄, pH 2), with initial concentrations of Fe(III) ranging from 250 to 1500 mg L⁻¹, were injected into column reactors packed with calcite grains at a constant flow rate. The composition of the solutions was monitored during the experiments. At the end of the experiments (passivation of the columns), the composition and structure of the solids were measured. The dissolution of calcite in the columns caused an increase in pH and the release of Ca into the solution, leading to the precipitation of gypsum and Fe–oxyhydroxysulfates (Fe(III)–SO₄–H⁺ solutions) or Fe–oxyhydroxychlorides (Fe(III)–Cl–H⁺ solutions). The columns worked as an efficient barrier for some time, increasing the pH of the circulating solutions from 2 to 6–7 and removing its metal content. However, after some time (several weeks, depending on the conditions), the columns became chemically inert. The results showed that passivation time increased with decreasing anion and metal content of the solutions. Gypsum was the phase responsible for the passivation of calcite in the experiments with Fe(III)–SO₄–H⁺ solutions. Schwertmannite and goethite appeared as the Fe(III) secondary phases in those experiments. Akaganeite was the phase responsible for the passivation of the system in the experiments with Fe(III)–Cl–H⁺ solutions.     

Millennium-long recession of limestone facades in London

Historical data on the temperature and precipitation data for London has been combined with output from the Hadley Model to estimate the climate of London for the period 1100–2100 CE. This has been converted to other parameters such as freeze–thaw frequency and snowfall relevant to the weathering of stone facades. The pollutant concentrations have been estimated for the same period, with the historical values taken from single box modelling and future values from changes likely given current policy within the metropolis. These values are used in the Lipfert model to show that the recession from karst weathering dominates across the period, while the contributions of sulphur deposition seem notable only across a shorter period 1700–2000 CE. Observations of the late seventeenth century suggest London architects witnessed a notable increase in the recession rate and attributed “fretting quality” to “smoaks of the sea-coal”. The recession rates measured in the late twentieth century lend some support to the estimates from the Lipfert model. The recession looks to increase only slightly, and frost shattering will decrease while salt weathering is likely to increase.