A simple non-linear model for the investigation of the effects of the gap closure at the abutment joints of short bridges

Closure of the gap at the abutment joints of bridges has been the source of extensive damage during the 1971 San Fernando and more recent earthquakes. In this paper a model for the investigation of the effects of this gap closure is presented and analysed. The focus of the model is the representation of the non-linear response of the bridge abutments, the foundation and the columns. The model is used for the investigation of the response of a short bridge located in California.     

Tropical atmospheric stability and wind structures as inferred from the Indian MST radar observations

Summary The MST (Mesosphere-Stratosphere-Tropospher) Radar Facility at Gadanki (13.47° N, 79.18° E), near Tirupati, Andhra Pradesh, India has been operated over seven diurnal cycles—three in November 1994, one in September 1995 and three in January–February 1996 with an objective to study the wind and stability characteristics in the troposphere and lower-stratosphere. The radar-measured height profiles of both zonal (EW) and meridional (NS) wind components and near-simultaneous radiosonde measurements from Madras (13.04° N, 80.7° E) and Bangalore (12.85° N, 77.58° E), the two stations close to either side of the radar site, have been compared and they are found to be in gross agreement within the limitations of the sensing techniques.The results of the study also indicated multiple stable and turbulent structures/stratification throughout the height region from about 4 to 30 km. It is noticed that the stable layers are well marked around the altitudes 4 km, 12 km and the tropopause while the turbulent layers exist a few kilometers below the tropopause. These stable and turbulent layer structures showed good correspondence with the radar-measured wind gradients and also with the radiosonde-derived temperature and wind distributions over Madras. The maximum positive gradient in the signal-tonoise ratio (SNR) which corresponds to radar tropopause is found to coincide with the greater potential temperature gradient and smaller wind gradient. The time evolution of atmospheric stability structure, derived from the SNR, spectral width and vertical wind revealed a diffused tropopause or tropopause weakening which is found to be associated with broader spectral width and larger gradients of winds. This feature is considered to be due either to the instability associated with large vertical gradients in horizontal winds (dynamical instability) or to the instability generated by the convection (convective instability).With 6 Figures     

Characteristics of landslide in Koshi River Basin,Central Himalaya

Koshi River basin, which lies in the Central Himalayas with an area of 71,500 km2, is an important trans-boundary river basin shared by China, Nepal and India. Yet, landslide-prone areas are all located in China and Nepal, imposing alarming risks of widespread damages to property and loss of human life in both countries. Against this backdrop, this research, by utilizing remote sensing images and topographic maps, has identified a total number of 6877 landslides for the past 23 years and further examined their distribution, characteristics and causes. Analysis shows that the two-step topography in the Himalayan region has a considerable effect on the distribution of landslides in this area. Dense distribution of landslides falls into two regions: the Lesser Himalaya(mostly small and medium size landslides in east-west direction) and the TransitionBelt(mostly large and medium size landslides along the river in north-south direction). Landslides decrease against the elevation while the southern slopes of the Himalayas have more landslides than its northern side. Change analysis was carried out by comparing landslide distribution data of 1992, 2010 and 2015 in the Koshi River basin. The rainfallinduced landslides, usually small and shallow and occurring more frequently in regions with an elevation lower than 1000 m, are common in the south and south-east slopes due to heavy precipitation in the region, and are more prone to the slope gradient of 20°~30°. Most of them are distributed in Proterozoic stratum(Pt3ε, Pt3 and Pt2-3) and Quaternary stratum. While for earthquake-induced landslides, they are more prone to higher elevations(2000~3000 m) and steeper slopes(40°~50°).     

Review of studies on land use and land cover change in Nepal

Land use and land cover(LULC) in Nepal has undergone constant change over the past few decades due to major changes caused by anthropogenic and natural factors and their impacts on the national and regional environment and climate.This comprehensive review of past and present studies of land use and land cover change(LUCC) in Nepal concentrates on cropland, grassland, forest, snow/glacier cover and urban areas. While most small area studies have gathered data from different sources and research over a short period, across large areas most historical studies have been based on aerial photographs such as the Land Resource Mapping Project in 1986. The recent trend in studies in Nepal is to focus on new concepts and techniques to analyze LULC status on the basis of satellite imagery, with the help of geographic information system and remote sensing tools. Studies based on historical documents, and historical and recent spatial data on LULC, have clearly shown an increase in cropland areas in Nepal,and present results indicating different rates and magnitudes. A decrease in forest and snow/glacier coverage is reported in most studies. Little information is available on grassland and urban areas from past research. The unprecedented rate of urbanization in Nepal has led to significant urban land changes over the past 30 years. Meanwhile, long term historical LUCC research in Nepal is required for extensive work on spatially explicit reconstructions on the basis of historical and primary data collection, including LULC archives and drivers for future change.     

Ionospheric response to X-class solar flares in the ascending half of the subdued solar cycle 24

The signature of 11 X-class solar flares that occurred during the ascending half of the present subdued solar cycle 24 from 2009 to 2013 on the ionosphere over the low- and mid-latitude station, Dibrugarh (27.5^°N, 95^°E; magnetic latitude 17.6^°N), are examined. Total electron content (TEC) data derived from Global Positioning System satellite transmissions are used to study the effect of the flares on the ionosphere. A nonlinear significant correlation (R² = 0.86) has been observed between EUV enhancement (ΔEUV) and corresponding enhancement in TEC (ΔTEC). This nonlinearity is triggered by a rapid increase in ΔTEC beyond the threshold value ～1.5 (×10¹⁰ ph cm^?2 s^?1) in ΔEUV. It is also found that this nonlinear relationship between TEC and EUV flux is driven by a similar nonlinear relationship between flare induced enhancement in X-ray and EUV fluxes. The local time of occurrence of the flares determines the magnitude of enhancement in TEC for flares originating from nearly similar longitudes on the solar disc, and hence proximity to the central meridian alone may not play the dominating role. Further, the X-ray peak flux, when corrected for the earth zenith angle effect, did not improve the correlation between ΔX-ray and ΔTEC.     

Experimental and Isothermal Studies on Sorption of Congo Red by Modified Mycelial Biomass of Wood‐rotting Fungus

Batch biosorption experiments were carried out for the removal of Congo red from aqueous solution using native and pretreated mycelial pellets/biomass of Trametes versicolor. The effect of process parameters such as contact time, dye concentration, and pH on the extent of Congo red biosorption has been investigated. Higher dye concentrations resulted in lower biosorption. Increases in biomass dosage led to increases in the levels of biosorption. Biosorption kinetics and equilibrium data are essential basic requirements to develop an effective and accurate design model for the removal of the dye. A kinetic study showed that the biosorption of the dye on fungal biomass was a gradual process. Pseudo‐first‐order, pseudo‐second‐order, and Bangham's model were used to fit the experimental data. The results of the kinetic studies showed that the second‐order kinetic model fitted well for the present experimental data. Equilibrium isotherms were analyzed by Langmuir, Freundlich, Dubnin‐Radushkevich, and Temkin isotherms. The biosorption equilibrium data obeyed the Langmuir and Temkin isotherms well. Acidic pH was favorable for the biosorption of the dye. Studies on the pH effect and desorption show that chemisorption seems to play a major role in the biosorption process. Among the native and pretreated biomass studied, autoclaved biomass showed a better biosorption capacity.     

Fluoride contamination in groundwater resources of Alleppey,southern India

Alleppey is one of the thickly populated coastal towns of the Kerala state in southern India.Groundwater is the main source of drinking water for the 240,991 people living in this region.The groundwater is being extracted from a multi-layer aquifer system of unconsolidated to semi-consolidated sedimentary formations,which range in age from Recent to Tertiary.The public water distribution system uses dug and tube wells.Though there were reports on fluoride contamination,this study reports for the first time excess fluoride and excess salinity in the drinking water of the region.The quality parameters,like Electrical Conductivity(EC) ranges from 266 to 3900 μs/cm,the fluoride content ranges from 0.68 to2.88 mg/L,and the chloride ranges between the 5.7 to 1253 mg/L.The main water types are Na-HC03,NaCO_3 and Na-Cl.The aqueous concentrations of F~- and CO_3~(2-) show positive correlation whereas F~- and Ca~(2+) show negative correlation.The source of fluoride in the groundwater could be from dissolution of fluorapatite,which is a common mineral in the Tertiary sediments of the area.Long residence time,sediment-groundwater interaction and facies changes(Ca-HCO_3 to Na-HCO_3) during groundwater flow regime are the major factors responsible for the high fluoride content in the groundwater of the area.High strontium content and high EC in some of the wells indicate saline water intrusion that could be due to the excess pumping from the deeper aquifers of the area.The water quality index computation has revealed that 62%of groundwater belongs to poor quality and is not suitable for domestic purposes as per BIS and WHO standards.Since the groundwater is the only source of drinking water in the area,proper treatment strategies and regulating the groundwater extraction are required as the quality deterioration poses serious threat to human health.     

Last-five-decade heavy metal pollution records from the Rewalsar Lake,Himachal Pradesh,India

The lakes of the Himalaya are degrading due to increase in toxic heavy metal loading. This study reports the last 50-year heavy metal pollution loading in the Rewalsar Lake, Himachal Pradesh, India. Sediment cores were recovered to study the pollution loading in the lake sediments. The ¹³⁷Cs and ²¹⁰Pb isotope-based sedimentation rate suggest rapid sedimentation in the lake during the last ~50 years. The concentrations of Mn, Cu, Zn, Cd, Pb, Co, Ni, Cr metals in the lake sediments owe its contributions both to the natural and anthropogenic sources. Prior to ca 1990 AD, metal loading was dominated by the lithogenic input, whereas post ca 1990 AD the metal loading was controlled by the anthropogenic factors. The Pb concentration in the lake gradually increased during 1990–2004 and then decreased significantly till present. The higher concentration of Pb seems to be derived from the fossil fuel burning, while the Cr concentration in the lake indicates the use of fertilizer in the catchment area. The lowest concentrations of elements around ca 1990 AD seem to have occurred due to channelization of the lake feeding system.     

Mapping of magnetic basement in Central India from aeromagnetic data for scaling geology

The Central Indian region has a complex geology covering the Godavari Graben, the Bastar Craton (including the Chhattisgarh Basin), the Eastern Ghat Mobile Belt, the Mahanadi Graben and some part of the Deccan Trap, the northern Singhbhum Orogen and the eastern Dharwar Craton. The region is well covered by reconnaissance‐scale aeromagnetic data, analysed for the estimation of basement and shallow anomalous magnetic sources depth using scaling spectral method. The shallow magnetic anomalies are found to vary from 1 to 3 km, whereas magnetic basement depth values are found to vary from 2 to 7 km. The shallowest basement depth of 2 km corresponds to the Kanker granites, a part of the Bastar Craton, whereas the deepest basement depth of 7 km is for the Godavari Basin and the southeastern part of the Eastern Ghat Mobile Belt near the Parvatipuram Bobbili fault. The estimated basement depth values correlate well with the values found from earlier geophysical studies. The earlier geophysical studies are limited to few tectonic units, whereas our estimation provides detailed magnetic basement mapping in the region. The magnetic basement and shallow depth values in the region indicate complex tectonic, heterogeneity, and intrusive bodies at different depths, which can be attributed to different thermo‐tectonic processes since Precambrian.     

Soft X-ray Focusing Telescope Aboard AstroSat: Design,Characteristics and Performance

The Soft X-ray focusing Telescope (SXT), India’s first X-ray telescope based on the principle of grazing incidence, was launched aboard the AstroSat and made operational on October 26, 2015. X-rays in the energy band of 0.3–8.0 keV are focussed on to a cooled charge coupled device thus providing medium resolution X-ray spectroscopy of cosmic X-ray sources of various types. It is the most sensitive X-ray instrument aboard the AstroSat. In its first year of operation, SXT has been used to observe objects ranging from active stars, compact binaries, supernova remnants, active galactic nuclei and clusters of galaxies in order to study its performance and quantify its characteriztics. Here, we present an overview of its design, mechanical hardware, electronics, data modes, observational constraints, pipeline processing and its in-orbit performance based on preliminary results from its characterization during the performance verification phase.