Anthropogenic affects on lake sedimentation process: a case study from Lake Sapanca, NW Turkey

Lake Sapanca in NW Turkey is a fault originated freshwater basin fed by seasonally variable flows of 15 streams. Considerations of lake–river interaction, supported by statistical measures of 47 bottom samples, suggest that sediment transport and deposition within the lake is controlled by two types of human constructed structures in addition to natural factors: (1) the dykes constructed in the front of streams, which feed the lake by strong flows, to prevent the filling of lakebed by coarse-grained sediments; (2) the constructed regulator on the outflowing Çarksuyu stream results in a higher sedimentation rate of clay-sized material on the NE corner of the lake, which is extraordinary in the shelf environment.     

Sediment salt-load in the St Lucia Estuary during the severe drought of 2002–2006

The purpose of this study was to determine whether there was a sufficiently high residual salt load in the dry sediments of the St Lucia Estuary to cause salinity problems should it later fill up with either freshwater or seawater. The estuary lakes have suffered the effects of a severe drought since 2002 with the result that many areas were dry, and the salinity of the residual water varied between 4 psu and up to five times that of seawater. Measurements of the salts content in the sediments to a depth of 20 cm showed that more than 2 million tonnes of salt was held in this layer of the sediment in 2006. Recent management of the estuary (since 1970) has ensured that the mouth was not artificially opened. This was to prevent the inflow of seawater, with its salts, that would otherwise enter while the drought was in place. The results of the sediment salinity data showed that if the drought had been broken and the lake area filled with rain and river water, the resulting salinity would be about 6 psu. In March 2007, Cyclone Gamede in the Indian Ocean off the east coast of South Africa produced a wave climate at sea that resulted in the mouth breaching; thus introducing an estimated 12 million tonnes of salts. The high salinity in the system resulting from this breach is expected to have an adverse effect on the ecology of the system, whereas the residual salinity in the sediments would not have caused an environmental problem. If the estuary and lake system were to fill completely with seawater, the residual salts together with seawater will raise the salinity to an initial value higher than 40 psu, which will have the effect of suppressing much of the important submerged vegetation that is vital for sustaining juvenile fish in the system. Many of the large fauna will also suffer from a shortage of freshwater.     

Problems of soil and groundwater pollution in the disposal of “marble” slurries in NW Sicily

This work deals with disposal of slurries generated during the cutting and polishing processes of slabs of decorative sedimentary carbonate rocks in the north western Sicily. At present, they are used as fillers of dismantled quarries near the sawmills and, as a final step of reclamation, are covered with earth layers. In spite of such inexpensive solution, there is lack of knowledge about the composition of the waste. In order to assess if there is any threat for the environment and to suggest indications for alternative solutions, such as recycling or inactivation processes, the slurries were analysed by XR diffraction, simultaneous thermal analysis, ICP/MS, ionic chromatography, FTIR, UV-Vis, COD and TOC measurements, grain size analysis. Results indicate that the slurries can threaten the groundwater, because of the high chemical oxygen demand; furthermore they can modify the mechanism of groundwater recharge, because of their grain size distribution. Some laboratory tests show that, even in very aggressive conditions, the solid pollutants persist in the waste and slowly release into water the products of their degradation. The slurry therefore should be subjected to inactivation treatment before disposal or, alternatively, recycled as secondary raw material for a suitable process.     

Deciphering potential groundwater zone in hard rock through the application of GIS

Remote Sensing and Geographic Information System has become one of the leading tools in the field of hydrogeological science, which helps in assessing, monitoring and conserving groundwater resources. It allows manipulation and analysis of individual layer of spatial data. It is used for analysing and modelling the interrelationship between the layers. This paper mainly deals with the integrated approach of Remote Sensing and geographical information system (GIS) to delineate groundwater potential zones in hard rock terrain. The remotely sensed data at the scale of 1:50,000 and topographical information from available maps, have been used for the preparation of ground water prospective map by integrating geology, geomorphology, slope, drainage-density and lineaments map of the study area. Further, the data on yield of aquifer, as observed from existing bore wells in the area, has been used to validate the groundwater potential map. The final result depicts the favourable prospective zones in the study area and can be helpful in better planning and management of groundwater resources especially in hard rock terrains.     

Anthropogenic influence on trace element geochemistry of healing mud (peloid) from Makirina Cove (Croatia)

Due to their balneotherapeutic features, the organic-rich sediments in Makirina Cove are an important source of healing mud. An environmental geochemistry approach using normalization techniques was applied to evaluate the anthropogenic contribution of trace metals to sediments used as healing mud. Sediment geochemistry was found to be associated with land-use change and storm events, as well as with proximity of a road with heavy traffic in the summer months. Local valley topography preferentially channels lithogenic and pollutant transport to the cove. Concentrations and distribution of trace metals indicate lithogenic (Ni, Cr, Co) and anthropogenic (Pb, Cu, Zn and Se) contributions to the sediments. The calculation of enrichment factors indicates a moderate (EFs between 2–3.5) input of anthropogenic Cu and Pb in surficial sediments to a depth of 10 cm. Patients using the Makirina Cove sediments as healing mud could be to some extent exposed to enhanced uptake of metals from anthropogenic sources via dermal contact.     

The relationship between hydrodynamic properties and weathering of soils derived from volcanic rocks,Galapagos Islands (Ecuador)

The aim of this interdisciplinary study is to examine a component of the hydrological cycle in Galapagos by characterizing soil properties. Nine soil profiles were sampled on two islands. Their physical and hydrodynamic properties were analyzed, along with their mineralogical composition. Two groups of soils were identified, with major differences between them. The first group consists of soils located in the highlands (>350 m a.s.l.), characterized by low hydraulic conductivity (<10⁻⁵ m s⁻¹) and low porosity (<25%). These soils are thick (several meters) and homogeneous without coarse components. Their clay fraction is considerable and dominated by gibbsite. The second group includes soils located in the low parts of the islands (<300 m a.s.l.). These soils are characterized by high hydraulic conductivity (>10⁻³ m s⁻¹) and high porosity (>35%). The structure of these soils is heterogeneous and includes coarse materials. The physical properties of the soils are in good agreement with the variations of the rainfall according to the elevation, which appears as the main factor controlling the soil development. The clayey alteration products constrain soils physical and hydrodynamic properties by reducing the porosity and consequently the permeability and also by increasing water retention.     

Regional distribution pattern of groundwater heavy metals resulting from agricultural activities

Contaminations of groundwater by heavy metals due to agricultural activities are growing recently. The objective of this study was to evaluate and map regional patterns of heavy metals (Cd, Zn and Cu) in groundwater on a plain with high agricultural activities. The study was conducted to investigate the concentration of heavy metals and distribution in groundwater in regions of Shush Danial and Andimeshk aquifers in the southern part of Iran. Presently, groundwater is the only appropriate and widely used source of drinking water for rural and urban communities in this region. The region covers an area of 1,100 km² between the Dez and Karkhe rivers, which lead to the Persian Gulf. For this study, the region was divided into four sub-regions A, B, C and D. Additionally, 168 groundwater samples were collected from 42 water wells during the earlier months of 2004. The flame atomic absorption spectrometry (AAS-Flame) was used to measure the concentration of heavy metals in water samples and the Surfer software was used for determination of the contour map of metal distribution. The results demonstrated that in all of the samples, Cd and Zn concentrations were below the EPA MCLG and EPA secondary standard, respectively. However, the Cu contents of 4.8 % of all samples were higher than EPA MCL. It is also indicated that the concentrations of metals were more pronounced at the southern part of the studied region than at the others. The analysis of fertilizers applied for agricultural activities at this region also indicated that a great majority of the above-mentioned heavy metals were discharged into the environment. Absence of confining layers, proximity to land surface, excess agricultural activities in the southern part and groundwater flow direction that is generally from the north to the southern parts in this area make the southern region of the Shush plain especially vulnerable to pollution by heavy metals than by other contaminants.     

Inclusions of silicate and sulfate melts in chrome diposide from the Inagli deposit,Yakutia, Russia

Melt inclusions were studied in chrome diopside from the Inagli deposit of gemstones in the Inagli massif of alkaline ultrabasic rocks of potassic affinity in the northwestern Aldan shield, Yakutia, Russia. The chrome diopside is highly transparent and has an intense green color. Its Cr₂O₃ content varies from 0.13 to 0.75 wt %. Primary and primary-secondary polyphase inclusions in chrome diopside are dominated by crystal phases (80–90 vol %) and contain aqueous solution and a gas phase. Using electron microprobe analysis and Raman spectroscopy, the following crystalline phases were identified. Silicate minerals are represented by potassium feldspar, pectolite [NaCa₂Si₃O₈(OH)], and phlogopite. The most abundant minerals in the majority of inclusions are sulfates: glaserite (aphthitalite) [K₃Na(SO₄)₂], glauberite [Na₂Ca(SO₄)₂], aluminum sulfate, anhydrite (CaSO₄), gypsum (CaSO₄ × 2H₂O), barite (BaSO₄), bloedite [Na₂Mg(SO₄)₂ × 4H₂O], thenardite (NaSO₄), polyhalite [K₂Ca₂Mg(SO₄)₄ × 2H₂O], arcanite (K₂SO₄), and celestite (SrSO₄). In addition, apatite was detected in some inclusions. Chlorides are probably present among small crystalline phases, because some analyses of aggregates of silicate and sulfate minerals showed up to 0.19–10.3 wt % Cl. Hydrogen was identified in the gas phase of polyphase inclusions by Raman spectroscopy. The composition of melt from which the chrome diopside crystallized was calculated on the basis of the investigation of silicate melt inclusions. This melt contains 53.5 wt % SiO₂, considerable amounts of CaO (16.3 wt %), K₂O (7.9 wt %), Na₂O (3.5 wt %), and SO₃ (1.4 wt %) and moderate amounts of Al₂O₃ (7.5 wt %), MgO (5.8 wt %), FeO (1.1 wt %), and H₂O (0.75 wt %). The content of Cr₂O₃ in the melt was 0.13 wt %. Many inclusions were homogenized at 770–850°C, when all of the crystals and the gas phase were dissolved. The material of inclusions heated up to the homogenization temperature became heterogeneous even during very fast quenching (two seconds) producing numerous small crystals. This fact implies that most of the inclusions contained a salt (rather than silicate) melt of sulfate-dominated composition. Such inclusions were formed from salt globules (with a density of about 2.5 g/cm³) occurring as an emulsion in the denser (2.6 g/cm³) silicate melt from which the chrome diopside crystallized.