A Numerical Study of Effects of Valley-Weathering and Valley-Shape-Ratio on the Ground Motion Characteristics

A study of combined effects of valley-weathering and valley-shaperatio on the ground motion characteristics and associated differential ground motion (DGM) is documented in this paper. In order to properly quantify the weathering effects, a forth-order-accurate staggered-grid viscoelastic time-domain finite-difference program has been used for the simulation of SH-wave responses. Simulated results revealed that the defocusing caused by valley is frequency-independent in contrast to the ridge-focusing. A decrease of average spectral amplification (ASA) with an increase of shape-ratio of the non-weathered triangular and elliptical valleys was obtained. Overall, the amplification and de-amplification pattern was larger in case of triangular valleys as compared to the elliptical valleys. It can be concluded that the dwelling within or near the topcorners of weathered valleys may suffer more damage as compared to their surroundings. A weathered triangular valley with large shape-ratio may cause unexpected damage very near its top-corners since both the ASA and DGM are largest.     

Initiation of a convective dust storm over North India on 21 April 2010 inferred using satellite data

Dust storms commonly occur during the pre-monsoon (summer) season in north and northwest parts of India. Characteristics of dust events of the pressure gradient type are well understood. However, comprehensive studies on mechanism of convective dust storms in India are few. A convective dust storm which occurred on 21 April 2010 in association with a western disturbance over North India was hence studied. In the absence of in situ data, we used available satellite data to study the event. Dust storm that occurred on 20 April 2010 on the surface of the Thar Desert transported dust to northern and northwestern parts of India (Rajasthan, Haryana, Delhi and some parts of Uttar Pradesh). This formed a background of aerosols that affected the thunderstorm formed in association with western disturbance and the strong updraft in the thunderstorm carried the dust lingering in the atmosphere to higher altitudes. Large amount of aerosols carried to higher altitude suppressed the chance of precipitation by affecting the cloud top microphysics. Enhancement in evaporation due to an increase in aerosol concentration and strong downdrafts during dissipation of the thunderstorm resulted in emission of dust particles which led to the convective dust event of 21 April 2010.     

GIS-based high-resolution spatial interpolation of precipitation in mountain–plain areas of Upper Pakistan for regional climate change impact studies

In this study, the baseline period (1960–1990) precipitation simulation of regional climate model PRECIS is evaluated and downscaled on a monthly basis for northwestern Himalayan mountains and upper Indus plains of Pakistan. Different interpolation models in GIS environment are used to generate fine scale (250?×?250 m²) precipitation surfaces from PRECIS precipitation data. Results show that the multivariate extension model of ordinary kriging that uses elevation as secondary data is the best model especially for monsoon months. Model results are further compared with observations from 25 meteorological stations in the study area. Modeled data show overall good correlation with observations confirming the ability of PRECIS to capture major precipitation features in the region. Results for low and erratic precipitation months, September and October, are however showing poor correlation with observations. During monsoon months (June, July, August) precipitation pattern is different from the rest of the months. It increases from south to north, but during monsoon maximum precipitation is in the southern regions of the Himalayas, and extreme northern areas receive very less precipitation. Modeled precipitation toward the end of the twenty-first century under A2 and B2 scenarios show overall decrease during winter and increase in spring and monsoon in the study area. Spatially, both scenarios show similar pattern but with varying magnitude. In monsoon, the Himalayan southern regions will have more precipitation, whereas northern areas and southern plains will face decrease in precipitation. Western and south western areas will suffer from less precipitation throughout the year except peak monsoon months. T test results also show that changes in monthly precipitation over the study area are significant except for July, August, and December. Result of this study provide reliable basis for further climate change impact studies on various resources.     

Green and Eco‐Friendly Removal of Mycotoxins with Organo‐Bentonites; Isothermal,Kinetic, and Thermodynamic Studies

In the current study the application of organo‐modified bentonite for the adsorption of mycotoxins (aflatoxin B1, citrinin, patulin, and zearalenone) is presented. The modification of clays is carried out using benzyl‐tri‐n‐butyl ammonium bromide (BTB), benzethonium chloride (BTC), and dioctyl sodium sulfosuccinate (DSS). Various experimental parameters such as pH, time, adsorbent dose, and mycotoxins concentration are thoroughly studied. The modified clays (B‐BTB, B‐BTC and B‐DSS) are characterized by X‐ray fluorescence, X‐ray diffraction, and Fourier transform infrared spectroscopy. The results depicted the high detoxification efficiency (≈99%) of modified clays for the removal of mycotoxins under optimized conditions (pH 5, time: 30 min, adsorbent amount: 50 mg). The adsorption capacities of modified clays are found in the order of: B‐BTC (AFB1: 18.02, CIT: 18.35, PAT: 18.21, ZEA: 18.09 mg g^?1) > B‐BTB (AFB1: 17.7, CIT: 18.11, PAT: 17.95, ZEA: 17.90 mg g^?1) > B‐DSS (AFB1: 17.5, CIT: 18.02, PAT: 17.86, ZEA: 17.80 mg g^?1). The obtained results fitted well with thermodynamic, isothermal (Langmuir) and pseudo‐second order kinetics. Low cost organo‐modified bentonite shows the promise in mitigating mycotoxin contamination, which could improve food safety and reduce environmental contamination.     

地热储层单裂隙岩体渗流传热数值模拟研究

研究地热储层裂隙岩体中的渗流传热过程对干热岩地热资源的开采具有重要的意义。本文以干热岩地热工程为背景,采用COMSOL Multiphysics数值模拟软件对地热储层单裂隙岩体中渗流传热机理进行了研究,并分析了流体注入速度和温度对岩体温度场的影响及其对干热岩地热工程的影响。研究发现流体参数对岩体温度场的影响主要体现在两个方面：一方面是对岩体温度场受扰动区域以及幅度的影响,另一方面是对岩体温度场达到稳态所需要时间的影响。流体注入速度的提升会降低系统的寿命和寿命期的出口法向总热量值,当考虑出口法向总热通量时,存在最佳流体注入速度,本研究中最佳流体注入速度为0.011m/s。流体注入温度的提升会增加系统的寿命和系统的出口法向总热通量和总热量。研究为干热岩自热资源的开发与利用提供了理论依据,为工程运行参数的设计提供了参考依据。     

Spatio-Temporal Assessment of Groundwater Potential Zone in the Drought-Prone Area of Bangladesh Using GIS-Based Bivariate Models

Natural Resources Research - Groundwater is one of the most dynamic and renewable natural resources found in the earth’s crust. A spatio-temporal assessment of groundwater potential zone...     

Effect of Water Flooding on Oil Reservoir Permeability: Saturation Index Prediction Model for Giant Oil Reservoirs,Southern Iraq

Natural Resources Research - This research was conducted on five oilfields in the Mishrif reservoir, southern Iraq, to illustrate the effects of permeability on the damage caused by the injection...     

Velocity and Structural Modeling of Mesozoic Chiltan Limestone and Goru Formation for Hydrocarbon Evaluation in the Bitrisim Area, Lower Indus Basin, Pakistan

The present study focuses on building a workflow for structural interpretation and velocity modeling and implementing to Jurassic-Cretaceous succession (Chiltan Limestone and Massive sand of the Lower Goru Formation). 2D-Migrated seismic sections of the area are used as data set and in order to confirm the presence of hydrocarbons in the study area, P and S-wave seismic velocities are estimated from single-component seismic data. Some specific issues in the use of seismic data for modeling and hydrocarbon evaluation need to deal with including distinguishing the reservoir and cap rocks, and the effects of faults, folds and presence of hydrocarbons on these rocks. This study has carried out the structural interpretation and modeling of the seismic data for the identification of traps. The results demonstrate existence of appropriate structural traps in the form of horst and grabens in the area. 2D and 3D velocity modeling of the horizons indicates the presence of high velocity zones in the eastern half of the study while relatively low velocity zones are encountered in the western half of the area. Two wells were drilled in the study area (i.e. Fateh-01 and Ichhri-01) and both are dry. Immature hydrocarbons migration is considered as a failure reason for Fateh-01 and Ichhri-01 well.     

Tectonic Imprints of the Hazara Kashmir Syntaxis on the Mesozoic Rocks Exposed in Munda,Mohmand Agency,Northwest Pakistan

Two well-developed mesoscopic folds, D_2 and D_3, which postdate the middle amphibolite metamorphism, were recognized in the western hinterland zone of Pakistan. NW–SE trending D_2 folds developed during NE–SW horizontal bulk shortening followed by NE–SW trending D_3 folds, which developed during SE–NW shortening. Micro- to mesoscopically the NW–SE trending S2 crenulation cleavage, boudins and mineral stretching lineations are overprinted by D_3. The newly established NW–SE trending micro- to mesoscopic structures in Munda termed D_2, which postdated F_1/F_2, is synchronously developed with F3 structures in the western hinterland zone of Pakistan. We interpret that D_2 and D_3 folds are counterclockwise rotated in the tectonic event that has evolved the Hazara Kashmir Syntaxis after the main phase Indian plate and Kohistan Island Arc collision. Chlorite replacement by biotite in the main matrix crenulation cleavages indicates prograde metamorphism related with D_2. The inclusion of muscovite and biotite in garnet porphyroblasts and the presence of staurolite in these rocks indicate that the Barrovian metamorphic conditions predate D_2 and D_3. We interpret that garnet, staurolite and calcite porphyroblasts grew before D_2 because the well developed S2 crenulation cleavage wraps around these porphyroblasts.