The Potential of Eleocharis acicularis for Phytoremediation: Case Study at an Abandoned Mine Site

Phytoremediation, a plant‐based and cost‐effective technology for the cleanup of contaminated soil and water, is receiving increasing attention. In this study, the aquatic macrophyte Eleocharis acicularis was examined for its ability to take up multiple heavy metals and its potential application for phytoremediation at an abandoned mining area in Hokkaido, Japan. Elemental concentrations were measured in samples of E. acicularis, water, and soil collected from areas of mine tailing and drainage. The results reveal that Pb, Fe, Cr, Cu, Ni, and Mn accumulation in the plants increased over the course of the experiment, exceeding their initial concentrations by factors of 930, 430, 60, 25, 10, and 6, respectively. The highest concentrations of Fe, Pb, Zn, Mn, Cr, Cu, and Ni within the plants were 59500, 1120, 964, 388, 265, 235, and 47.4 mg/kg dry wt., respectively, for plants growing in mine drainage after 11 months of the experiment. These results indicate that E. acicularis is a hyperaccumulator of Pb. We also found high Si concentrations in E. acicularis (2.08%). It is likely that heavy metals exist in opal‐A within cells of the plant. The bioconcentration factors (BCF: ratio of metal concentration in the plant shoots to that in the soil) obtained for Cr, Cu, Zn, Ni, Mn, and Pb were 3.27, 1.65, 1.29, 1.26, 1.11, and 0.82, respectively. The existence of heavy metals as sulphides is thought to have restricted the metal‐uptake efficiency of E. acicularis at the mine site. The results of this study indicate that E. acicularis shows great potential in the phytoremediation of mine tailing and drainage rich in heavy metals.     

Predominance of parallel‐ and cross‐predation in anglerfish

Several studies in the last 20 years have revealed that morphological asymmetry in fish can be characterized as ‘antisymmetry’. Antisymmetry is a lateral dimorphism in which each population consists of individuals with well‐developed left sides (lefties) and well‐developed right sides (righties). This dimorphism influences predator–prey interactions. In some piscivorous fishes, it has been found that predators can catch more prey of the opposite morphological type to themselves (cross‐predation) than of the same morphological type (parallel‐predation). Our previous work clarified that the predominance of cross‐predation is caused by lateralized behaviors of predators and prey that correspond to their morphological antisymmetry. Moreover, based on the results of our behavioral observations, we hypothesized that parallel‐predation can predominate when predators encounter the potential prey frontally. To test this hypothesis, in the present study we investigated the relationship between lateral morphological types of anglerfish (Lophiomus setigerus) and those of the prey fishes found in their stomachs. Anglerfish attract potential prey using their first dorsal fin (illicium) as a lure, and their frontal encounters with potential prey fishes were photographed in situ and observed in an aquarium. The results of a stomach contents analysis indicated that parallel‐predation predominated in five benthopelagic prey fish species (perches and eels). By contrast, five benthic prey fishes (gobies and weevers) exhibited the predominance of cross‐predation. These results not only demonstrate the predominance of parallel‐predation in a natural fish community, but also suggest that the relationship between morphological types of predator and prey species can be reversed depending on the lifestyle of prey.     

Seismic activity associated with the subducting motion of the Philippine Sea plate beneath the Kanto district, Japan

The Pacific plate and the Philippine Sea plate overlap and subduct underneath the Kanto region, central Japan, causing complex seismic activities in the upper mantle. In this research, we used a map selection tool with a graphic display to create a data set for earthquakes caused by the subducting motion of the Philippine Sea plate that are easily determined. As a result, we determined that there are at least four earthquake groups present in the upper mantle above the Pacific plate. Major seismic activity (Group 1) has been observed throughout the Kanto region and is considered to originate in the uppermost part of mantle in the subducted Philippine Sea plate, judging from the formation of the focal region and comparison with the 3D structure of seismic velocity. The focal mechanism of these earthquakes is characterized by the down-dip compression. A second earthquake layer characterized by down-dip extension (Group 2), below the earthquakes in this group, is also noted. The focal region for those earthquakes is considered to be located at the lower part of the slab mantle, and the Pacific plate located directly below is considered to influence the activity. Earthquakes located at the shallowest part (Group 3) form a few clusters distributed directly above the Group 1 focal region. Judging from the characteristics of later phases in these earthquakes and comparing against the 3D structure of seismic velocity, the focal regions for the earthquakes are considered to be located near the upper surface of the slab. Another earthquake group (Group 4) originates further below Group 2; it is difficult to consider these earthquakes within a single slab. The seismic activities representing the upper area of the Philippine Sea plate are Group 3. This paper proposes a slab geometry model that is substantially different from conventional models by strictly differentiating the groups.     

Geochemical and hydrological controls on biannual lamination of tufa deposits

Fluvial tufa deposits in southwest Japan commonly develop biannual lamination consisting of dense summer layers and porous winter layers, and the clearness of the laminae varies among the sites. The laminae have been largely attributed to a seasonally variable inorganic precipitation rate of calcite. This rate-controlled hypothesis was examined by using quantitative data for calcite packing-density (CPD) and the precipitation rate of calcite (PWP rate) calculated from water chemistry. The results for four tufa-depositing sites in SW Japan show that a positive correlation between CPD and PWP rate becomes less certain with increasing PWP rate. In the temperature realm of SW Japan, tufas develop regular distinct seasonal change in CPD when deposited in water containing Ca values less than 65 mg/l, which results in a relatively low precipitation rate. The CPD of tufa deposits rarely exceeds 65%, owing to pore space between fine-grained calcite crystals and to porosity derived from decomposed cyanobacteria and other microorganisms. By increasing the Ca content to more than 65 mg/l, the CPD often attains an upper limit and becomes insensitive to seasonal changes in the PWP rate. Therefore, seasonal variations in CPD at sites with a higher Ca content are unclear, as seen in two examples from tropical islands in southern Japan and in one locality in a temperate climate. The flow rate and microbial density on the tufa surface are subordinate factors with respect to the CPD. Seasonal changes in these two factors often enhance the porous/dense contrast of biannual lamination in SW Japan.     

Experimental and analytical studies on earthquake resisting behaviour of confined concrete block masonry structures

To improve the seismic performance of masonry structures, confined masonry that improves the seismic resistance of masonry structures by the confining effect of surrounding bond beams and tie columns is constructed. This study investigated the earthquake resisting behaviour of confined masonry structures that are being studied and constructed in China. The structural system consists of unreinforced block masonry walls with surrounding reinforced concrete bond beams and tie columns. The characteristics of the structure include: (1) damage to blocks is reduced and brittle failure is avoided by the comparatively lower strength of the joint mortar than that of the blocks, (2) the masonry walls and surrounding reinforced concrete bond beams and tie columns are securely jointed by the shear keys of the tie columns. In this study, wall specimens made of concrete blocks were tested under a cyclic lateral load and simulated by a rigid body spring model that models non‐linear behaviour by rigid bodies and boundary springs. The results of studies outline the resisting mechanism, indicating that a rigid body spring model is considered appropriate for analysing this type of structure. Copyright © 2006 John Wiley & Sons, Ltd.     

Strong ground motion prediction using macro–micro analysis method

The authors propose a new analysis method, called the macro–micro analysis method (MMAM) in a companion paper. (Earthquake Engng. Struct. Dyn., this issue) for strong motion prediction with higher resolution and accuracy. The MMAM takes advantage of the bounding medium theory to obtain optimistic and pessimistic estimates of the expected strong motion and the singular perturbation expansion that leads to an efficient multi‐scale analysis. The results of the numerical simulation with the MMAM are given as the sum of waves of low resolution covering the whole city and waves of high resolution for each part of the city. While the huge computation amount is reduced by the MMAM, the computation amount is huge still. For resolving this problem, this paper applies the finite element method with voxel element to numerical simulation tools after some numerical verification. To reproduce complicated material properties of surface soft deposits, fundamental hysteresis attenuation is implemented in the three‐dimensional simulation code. The proposed method is verified by carrying out the strong motion prediction with MMAM and comparing with measured data. In addition, the effect of three‐dimensional soil–structure and frequency component on the maximum velocity distribution, which is simulated by proposed method with high spatial resolution, is discussed. Copyright © 2005 John Wiley & Sons, Ltd.     

On the divergence of the ionospheric electric field around the westward travelling surge

The pattern of the ionospheric electric field around the westward travelling surge (WTS) is theoretically studied. This is obtained by solving the current continuity equation at the ionospheric altitude for temporal and spatial development of the field-aligned current density modelled as the WTS phenomenon. The results show that the divergence of the ionospheric electric field is significantly changed depending on the dawn-to-dusk convection electric field E₀ because of non-uniformity in the ionospheric conductivity: the ionospheric electric field diverges in the upward current region (around the head of the WTS) when a westward electric field E₀ of 10 mV m⁻¹ is uniformly applied. On the other hand, the ionospheric electric field converges without E₀. From the observational inference that the ionospheric electric field converges around the head of the WTS, it is suggested that the WTS phenomenon may not be accounted for by the discharging process in the presence of the enhanced dawn-to-dusk convection electric field and non-uniform conductivity as was studied by previous authors.     

Trends in the seasonal length and opening dates of a winter road in the western James Bay region,Ontario, Canada

Theoretical and Applied Climatology - In northern Canada, winter roads are essential for communities. The duration of the winter road season depends on particular meteorological conditions. In this...