The macroinfauna of the Galician sandy beaches (NW Spain) affected by the Prestige oil-spill

Eighteen sandy beaches were sampled along the 1659 km of the Galician coast (NW Spain) six months after the Prestige oil-spill to study the impact of the fuel and the clean-up activities on the macroinfauna community. A transect was extended at each beach, from above the drift line to below the swash line at five sampled levels; at each level six 0.05 m2 replicates were taken to a depth of 30 cm and sieved through a 1mm mesh, and the organisms collected and preserved. Results were compared with previous data obtained using the same procedures. The macroinfauna was numerically dominated by the amphipod Pontocrates arenarius, the isopod genus Eurydice, the polychaete Scolelepis squamata, and the amphipod Talitrus saltator. As a result of the Prestige oil-spill and the clean-up activities, beach populations were reduced, with Eurydice and S. squamata as the most affected taxa.     

Volcano-tectonic controls and emplacement kinematics of the Iriga debris avalanches (Philippines)

Mt Iriga in southeastern Luzon is known for its spectacular collapse scar that was possibly created in 1628 ad by a 1.5-km³ debris avalanche. The debris avalanche deposit (DAD) covered 70?km² and dammed the Barit River to form Lake Buhi. The collapse has been ascribed to a non-volcanic trigger related to a major strike-slip fault under the volcano. Using a combination of fieldwork and remote sensing, we have identified a similar size, older DAD to the southwest of the edifice that originated from a sector oblique to the underlying strike-slip fault. Both deposits cover wide areas of low, waterlogged plains, to a distance of about 16?km for the oldest and 12?km for the youngest. Hundreds of metre-wide and up to 50-m-high hummocks of intact conglomerate, sand and clay units derived from the base of the volcano show that the initial failure planes cut deep into the substrata. In addition, large proportions of both DAD consist of ring-plain sediments that were incorporated by soft-sediment bulking and extensive bulldozing. An ignimbrite unit incorporated into the younger DAD forms small (less than 5?m high) discrete hummocks between the larger ones. Both debris avalanches slid over water-saturated soft sediment or ignimbrite and spread out on a basal shear zone, accommodated by horst and graben formation and strike-slip faults in the main mass. The faults are listric and flatten into a well-developed basal shear zone. This shear zone contains components from the substrate and has a diffuse contact with the intact substrata. Long, transport-normal ridges in the distal parts are evidence of compression related to deceleration and bulldozing. The collapse orientation and structure on both sectors and DAD constituents are consistent with collapse being a response to combined transtensional faulting and gravity spreading. Iriga can serve as a model for other volcanoes, such as Mayon, that stand in sedimentary basins undergoing transtensional strike-slip faulting.     

贵州关岭生物群中植物化石的发现及其意义

关岭生物群是近年来在我国贵州关岭地区瓦窑组中发现的一个十分重要的生物群 ,其中的植物化石经研究计有 Equisetites cf.arenaceus(Jaeger) Bronn.、Ctenozamitessarrani Zeiller。依据植物化石 C.sarrani常见于晚三叠世和 E.cf.arenaceus系似木贼属中较古老的类型 ,指出含植物化石的地层时代为晚三叠世卡尼期。瓦窑组系海相沉积 ,其中的植物化石无疑为异地埋藏 ,但从化石通常保存尚好来看 ,估计搬运的距离不会很远 ,它们可能是从距海岸不远的陆地被河流带到较平静的海湾或海槽而沉积下来的。此外 ,从该组植物茎干化石具清楚的年轮分析 ,推测卡尼期时 ,贵州关岭一带为非热带雨林地区 ,一年中气候不是四季如一 ,而是有明显的季节变化     

Pre main sequence stars as UV sources for the World Space Observatory-UV mission

Pre-main sequence stars are bright UV (UV) sources compared with their main sequence analogues. The source of this excess is the high energy processes associated with the physics of accretion/outflow during early stellar evolution. In this review, the main sources of UV excess are described as well as the most significant “unknowns” in the field. Special emphasis is made on the results from the last observations carried out with the Hubble Space Telescope and on the relevance of future dedicated monitoring programs with the World Space Observatory-UV.     

Erodibility of soft freshwater sediments in Markermeer: the role of bioturbation by meiobenthic fauna

The Markermeer is a large and shallow man-made freshwater lake in the Netherlands, characterized by its high turbidity. As part of a study aiming to mitigate this high turbidity, we studied the water–bed exchange processes of the lake’s muddy bed. The upper centimeter’s–decimeter’s of the lake bed sediments mainly consists of soft anoxic mud. Recent measurements have proved the existence of a thin oxic layer on top of this soft anoxic mud. This oxic layer, which is much easier to be eroded than the anoxic mud, is believed to be related with Markermeer’s high-turbidity levels. Our hypothesis is that the thin oxic layer develops from the anoxic mud, enhanced by bioturbation. Actually, we will demonstrate that it is the bioturbated state of the bed that increases its erodability, and not the oxidation state of the sediments. In particular, we will refer to bioturbation caused by meiobenthic fauna. The objective of this study is therefore to determine the influence of the development of the thin oxic layer on the water–bed exchange processes, as well as to establish the role of bioturbation on those processes. This is done by quantifying the erosion rate as a function of bed shear stresses, and at different stages of the development of the oxic layer. Our experiments show that bioturbation increases the rate at which Markermeer sediments are eroded by almost an order of magnitude. The short-term fine sediment dynamics in Markermeer are found to be driven by the complex and highly dynamic interactions between physics, chemistry, and biology. Finally, the long-term fine sediment dynamics are driven by the erosion of the historical deposits in the lake’s bed, which is only possible after bioturbation, and which leads to an increase of the stock of sediments in the lake’s muddy bed.     

Star formation properties of Universidad Complutense de Madrid survey galaxies

We present new near-infrared J and K imaging data for 67 galaxies from the Universidad Complutense de Madrid (UCM) survey used in the determination of the SFR density of the local Universe by Gallego et al. This is a sample of local star-forming galaxies with redshift lower than 0.045, and they constitute a representative subsample of the galaxies in the complete UCM survey. From the new data, complemented with our own Gunn- r images and long-slit optical spectroscopy, we have measured integrated K -band luminosities, r − J and J − K colours, and H α luminosities and equivalent widths. Using a maximum likelihood estimator and a complete set of evolutionary synthesis models, these observations allow us to estimate the strength of the current (or most recent) burst of star formation, its age, the star formation rate and the total stellar mass of the galaxies. An average galaxy in the sample has a stellar mass of 5×10¹⁰ M_⊙ and is undergoing (or has recently completed) a burst of star formation involving about 2 per cent of its total stellar mass. We identify two separate classes of star-forming galaxies in the UCM sample: low-luminosity, high-excitation galaxies (H  ii like ) and relatively luminous spiral galaxies (starburst disc- like ). The former show higher specific star formation rates (SFRs per unit mass) and burst strengths, and lower stellar masses than the latter. With regard to their specific star formation rates, the UCM galaxies are intermediate objects between normal quiescent spirals and the most extreme H  ii galaxies.     

Effect of frictional heating and thermal advection on pre-seismic sliding: a numerical simulation using a rate-, state- and temperature-dependent friction law

Laboratory experiments on simulated faults in rocks clearly show the temperature dependence of dynamic rock friction. Since rocks surrounding faults are permeable, we have developed a numerical method to describe the thermo-mechanical evolution of the pre-seismic sliding phase which takes into account both the rate-, state- and temperature-dependent friction law and the heat advection term in the energy equation. We consider a laminar fluid motion perpendicular to a vertical fault plane and assume that fluids move away from the fault plane. A semi-analytical temperature solution which accounts for the variability of slip velocity and stress on the fault has been found. This solution has been generalized to the case of a time varying fluid velocity and then was used to include the thermal pressurization effect. After discretizing the temperature solution, the evolution of the system is obtained by the solution of a system of first order differential equations which allows us to determine the evolution of slip, slip rate, friction coefficient, effective normal stress, temperature and fluid velocity. The numerical solutions are found using a Runge-Kutta method with an adaptative stepsize control in time. When the thermal pressurization effects can be neglected, the heat advection effect gives rise to a delay, with respect to the purely conductive case, of the earthquake occurrence time. This delay increases with increasing permeability H of the system. When the thermal pressurization effects are taken into account the situation is opposite, i.e. the onset of instability tends to precede that of the purely conductive case. The advance in the time of occurrence of instability increases with increasing coefficient of thermal pressurization. In the small permeability range (H ≤ 10^?18 m²), the seismic moment and nucleation length of the pre-seismic phase are significantly smaller than those predicted by the purely conductive model.     

Using slowness and azimuth fluctuations as new observables for four‐dimensional reservoir seismic monitoring

Four‐dimensional imaging using geophysical data is of increasing interest in the oil and gas industries. While travel‐time and amplitude variations are commonly used to monitor reservoir properties at depth, their interpretation can suffer from a lack of information to decipher the parts played by different parameters. In this context, this study focuses on the slowness and azimuth angle measured at the surface using source and receiver arrays as complementary observables. In the first step, array processing techniques are used to extract both azimuth and incidence angles at the source side (departure angles) and at the receiver side (arrival angles). In the second step, the slowness and angle variations are monitored in a laboratory environment. These new observables are compared with traditional arrival‐time variations when the propagation medium is subject to temperature fluctuations. Finally, field data from a heavy‐oil permanent reservoir monitoring system installed onshore and facing steam injection and temperature variations are investigated. The slowness variations are computed over a period of 152 days. In agreement with Fermat's principle, strong correlations between the slowness and arrival‐time variations are highlighted, as well as good consistency with other techniques and field pressure measurements. Although the temporal variations of slowness and arrival time show the same features, there are still differences that can be considered for further characterization of the physical changes at depth.