Cation ordering of orthopyroxenes from the Skaergaard Intrusion: implications for the subsolidus cooling rates and permeabilities

 We have determined the quenched cation ordering states of five orthopyroxene crystals collected from the marginal border group and the lower zone a and b of the Skaergaard intrusion, and modeled these data to retrieve their closure temperatures (T _c) of Fe–Mg ordering and cooling rates. According to existing thermal models for the Skaergaard pluton, conductive cooling dominated the high and low temperature regimes, which were separated by an intermediate temperature regime in which the cooling was controlled primarily by convective fluid circulation. The cooling rates retrieved from the quenched cation ordering states of the orthopyroxene crystals strictly apply to temperatures around the closure temperatures of the ordering states, ∼340–400^° C, which fall at the transition from convective to the lower temperature conductive cooling. The cooling rates obtained from the cation ordering states of orthopyroxene vary from ∼1 to 270 K/ka. These results agree well with a thermal model calculated using an assumed average permeability of 10^-12 cm² for the pluton, but not completely with a model calculated on the basis of an average permeability of 10^-13 cm², although both values produced shifts of δ¹⁸O that are comparable to those observed in the pluton. Received: 27 February 1995/Accepted: 20 July 1995     

冬小麦遥感冠层温度监测土壤含水量的试验研究

在冬小麦主要生育期(2002年4月初到5月底),对不灌溉的冬小麦测定了冠层温度、地温、气温以及土壤含水量,计算了冠气温差且分析了冠层温度和冠气温差与不同土层厚度的土壤含水量相关关系。结果表明:14:00的冠层温度能较好地反映20cm土层的土壤含水量变化,但与其它各土层相关性有较大的波动性;14:00的冠气温差能较好地反映40cm以上土层的土壤含水量变化,二者的相关性很高,在20cm、40cm土层,两者相关系数R2分别为0.98866、0.99389,这为用区域遥感数据反演主要生育期冬小麦的冠气温差进而监测区域40cm土壤含水量提供了实验性的依据;拔节期和灌浆期,用14:00冠气温差来拟合各土壤层的土壤含水量有较高的精度,从而为用区域遥感数据监测区域土壤含水量提供了经验性的模型。     

Extraction and recovery of precious metals from electronic waste printed circuit boards by bioleaching acidophilic fungi

Printed circuit boards contain precious metals. They are produced in large volumes, rendering them an important component of the electronic waste. In view of the heterogeneity of the metals present, reprocessing of electronic waste is a heinous task. The present study focused on leaching of valuable metals from electronic waste printed circuit boards using Aspergillus niger DDNS1. The adaptation phases began at 0.1, 0.5 and 1.0% of fine powder of printed circuit boards with 10% inoculum and were optimized with three effective factors, viz. initial pH, particle size and pulp density, to achieve the maximum simultaneous recovery of the valuable metals. The interactions of these metals were also deciphered using scanning electron microscopy, energy-dispersive X-ray spectroscopy, X-ray diffraction, Fourier transform infrared spectrum and atomic absorption spectroscopy. The results indicated that extraction of the precious metals was accomplished mainly through the unique organic acids originating from A. niger DDNS1. The initial pH played an important role in the extraction of the precious metals and the metals precipitate formation. The leaching rate of the metals was generally higher at low powder dosage of printed circuit boards. The toxicity of the printed circuit boards had little effect on two-step bioleaching at the pulp density of 0.1% compared to one-step bioleaching. The two-step bioleaching process was followed under organic acid-forming conditions for the maximum mobilization of metals. Thus, the precious metals from printed circuit boards could be mobilized through fungal bioleaching which promises an important industrial application in recycling of electronic wastes.