Responses of marine phytoplankton in iron enrichment experiments in the northern North Sea and northeast Atlantic Ocean

Short-term iron enrichment experiments were carried out with samples collected in areas with different phytoplankton activity in the northern North Sea and northeast Atlantic Ocean in the summer of 1993. The research area was dominated by high numbers of pico-phytoplankton, up to 70,000 ml⁻¹. Maximum chlorophyll a concentrations varied from about 1.0 μg l⁻¹ in a high-reflectance zone (caused by loose coccoliths, remnants from a bloom of Emiliania huxleyi) and about 3.5 μg l⁻¹ in a zone in which the phytoplankton were growing, to about 0.5 μg l⁻¹ in the northeast Atlantic Ocean. From the high-reflectance zone to the northeast Atlantic Ocean, nitrate concentrations increased from 0.5 μM to 6.0 μM. Concentrations of reactive iron in surface water showed an opposite trend and decreased from about 2.6 nM in the high-reflectance zone to <1.0 nM in the northeast Atlantic Ocean. In the research area, no signs of true iron deficiency were found, but iron enrichments in the high-reflectance zone, numerically dominated by Synechococcus sp., resulted in increased nitrate uptake. Ammonium uptake was hardly affected. Strong support for the effect of Fe on cell physiology is given by the increase in the f-ratio. Net growth rates of the phytoplankton (changes in cell numbers over 24 h) were almost unchanged. Phytoplankton collected from the northeast Atlantic Ocean, did not show changes in the nitrogen metabolism upon addition of iron. Net growth rates in these incubations were low or negative, with only slightly higher values with additional iron.     

Dissolved aluminium and the silicon cycle in the Arctic Ocean

Concentrations of dissolved (0.2 µm filtered) aluminium (Al) have been determined for the first time in the Eurasian part of the Arctic Ocean over the entire water column during expedition ARK XXII/2 aboard R.V. Polarstern (2007). An unprecedented number of 666 samples was analysed for 44 stations along 5 ocean transects. Dissolved Al in surface layer water (SLW) was very low, close to 1 nM, with lowest SLW concentrations towards the Canadian part of the Arctic Ocean and higher values adjacent to and in the shelf seas. The low SLW concentrations indicate no or little influence from aeolian dust input. Dissolved Al showed a nutrient-type increase with depth up to 28 nM, but large differences existed between the different deep Arctic basins. The differences in concentrations of Al between water masses and basins could largely be related to the different origins of the water masses. In the SLW and intermediate water layers, Atlantic and Pacific inflows were of importance. Deep shelf convection appeared to influence the Al distribution in the deep Eurasian Basin. The Al distribution of the deep Makarov Basin provides evidence for Eurasian Basin water inflow into the deep Makarov Basin. A strong correlation between Al and Silicon (Si) was observed in all basins. This correlation and the nutrient-like profile indicate a strong biological influence on the cycling and distribution of Al. The biological influence can be direct by the incorporation of Al in biogenic silica, indirect by preferential scavenging of Al onto biogenic siliceous particles, or by a combination of both processes. From the slope of the overall Al–Si relationship in the intermediate water layer (AIDW; ~ 200–2000 m depth), an Al/Si ratio of 2.2 atoms Al per 1000 atoms Si was derived. This ratio is consistent with the range of previously reported Al/Si uptake ratio in biogenic opal frustules of diatoms. In the deepest waters (>2000 m depth) a steeper slope of the Al–Si relationship of 7.4 to 13 atoms Al per 1000 atoms Si likely results from entrainment of cold shelf water into the deep basins, carrying the signal of dissolution of terrigenous particles with a much higher Al:Si ratio of crustal abundance. Only a small enrichment with such crustal Al and Si component may readily account for the higher Al:Si slope in the deepest waters.     

Dynamics of arrays of floating point-absorber wave energy converters with inter-body and bottom slack-mooring connections

If point absorbers are employed in the extensive exploitation of the offshore wave energy resource, they should be deployed in arrays, the distance between the elements in the array being possibly tens of meters. In such cases, it may be more convenient that the array is spread moored to the sea bottom through only some of its elements, located in the periphery, while the other array elements are prevented from drifting and colliding with each other by connections to adjacent elements. An array of identical floating point absorbers located at the grid points of an equilateral triangular grid is considered in the paper. A spread set of slack-mooring lines connect the peripheric floaters to the bottom. A weight is located at the centre of each triangle whose function is to pull the three floaters towards each other and keep the inter-body mooring lines under tension. The power take-off system (PTO) is a linear damper activated by the buoy heaving motion. The whole system–buoys, moorings and power take-off systems–is assumed linear, so that a frequency domain analysis may be employed. Hydrodynamic interference between the oscillating buoys in array is accounted for. Equations are presented for a set of three identical point absorbers. This is then extended to more complex equilateral triangular grid arrays. Results from numerical simulations, with regular and irregular waves, are presented for the motions and power absorption of hemispherical converters in arrays of three and seven elements and for different mooring parameters and wave incidence angles. Comparisons are given with the unmoored and independently-moored buoy situations.     

Determination of residence time and mixing processes of the Ubatuba,Brazil, inner shelf waters using natural Ra isotopes

Coastal waters contain elevated dissolved activities of short-lived radium isotopes, ²²³Ra and ²²⁴Ra, having half-lives of 11.4 and 3.66 days, respectively. The input of these isotopes near the coast must be balanced by decay and mixing into the open ocean, where excess activities are zero. Since the decay rate is known, in the ideal case the mixing rate may be determined from the offshore distribution of these isotopes. This study found that samples collected in June 2000 followed the expected exponential decrease with distance offshore. We assign a dispersion coefficient of 28–39 m² s⁻¹ for this study. During January 2002 and November 2003, there was not a consistent decrease of activity with distance offshore. This is likely due to the ruggedness of the coastline, where many bays and small islands interrupt simple mixing patterns. To estimate exchange rates during 2002 and 2003, we used a model based on the decrease in the ²²⁴Ra/²²³Ra activity ratio (AR) with time for samples isolated from fresh inputs of Ra. This model yielded residence times of 1–2 weeks for samples collected within 20 km of the coast. We used this residence time to calculate the flux of ²²⁸Ra (half-life = 5.7 years) to the study area necessary to maintain the enrichment relative to ocean water. This enrichment is a factor of ten greater than the flux of ²²⁸Ra expected from submarine groundwater discharge (SGD) occurring within 50 m of shore.     

Isotopic,trace element and nutrient characterization of coastal waters from Ubatuba inner shelf area,south-eastern Brazil

Stable isotopes, tritium, radium isotopes, radon, trace elements and nutrients data were collected during two sampling campaigns in the Ubatuba coastal area (south-eastern Brazil) with the aim of investigating submarine groundwater discharge (SGD) in the region. The isotopic composition (δD, δ¹⁸O, ³H) of submarine waters was characterised by significant variability and heavy isotope enrichment. The stable isotopes and tritium data showed good separation of groundwater and seawater groups. The contribution of groundwater in submarine waters varied from a few % to 17%. Spatial distribution of ²²²Rn activity concentration in surface seawater revealed changes between 50 and 200 Bq m⁻³ which were in opposite relationship with observed salinities. Time series measurements of ²²²Rn activity concentration in Flamengo Bay (from 1 to 5 kBq m⁻³), obtained by in situ underwater gamma-spectrometry showed a negative correlation between the ²²²Rn activity concentration and tide/salinity. This may be caused by sea level changes as tide effects induce variations of hydraulic gradients, which increase ²²²Rn concentration during lower sea level, and opposite, during high tides where the ²²²Rn activity concentration is smaller. The estimated SGD fluxes varied during 22–26 November between 8 and 40 cm d⁻¹, with an average value of 21 cm d⁻¹ (the unit is cm³/cm² per day). The radium isotopes and nutrient data showed scattered distributions with offshore distance and salinity, which implies that in a complex coast with many small bays and islands, the area has been influenced by local currents and groundwater–seawater mixing. SGD in the Ubatuba area is fed by coastal contaminated groundwater and re-circulated seawater (with small admixtures of groundwater), which claims for potential environmental concern with implications on the management of freshwater resources in the region.     

Developing a building policy for the erosion zone: Solutions to some key (Dutch) questions

In those coastal communities where the most seaward strip of mainland consists of dunes, these dunes often serve as a flexible sea defence. In addition, this strip offers large potential for housing and commercial enterprises. Unfortunately, due to severe storm surges part of this strip (the erosion zone) is subject to erosion, and as a result of which any buildings or infrastructure located here, are destroyed. Therefore, as we will illustrate in this paper, a building policy for this zone should reflect a compromise between two opposite interests: exploitation of the existing potential and, prevention of an unacceptable high risk due to erosion. Accordingly, the authors have developed a framework for such a building policy on the basis of which the desirability of various different types of investments and the location within the erosion zone of such investments can be determined. The examples that are used to illustrate this framework in this paper are limited to experiences in The Netherlands as relevant data and experiences are available and relatively easy accessible here. Nevertheless, the approach as is described is generic and applicable worldwide suggesting that the discovered unused potential for exploitation is not just limited to The Netherlands.     

The effect of a topographic high on the morphological stability of a two-inlet bay system

The cross-sectional stability of two tidal inlets connecting the same back-barrier lagoon to the ocean is investigated. The condition for equilibrium is the cross-sectional area tidal prism relationship. In an earlier study [Van de Kreeke, J., 1990. Can multiple inlets be stable? Estuarine, Coastal and Shelf Science 30: 261–273.], using the same equilibrium condition, it was concluded that where two inlets connect the same basin to the ocean ultimately one inlet will close. One of the major assumptions in that study was that the water level in the basin fluctuated uniformly. In hindsight this assumption might be too restrictive. For example, in the Wadden Sea the back barrier lagoon consists of a series of basins, rather than one single basin, separated by topographic highs. These topographic highs limit but do not exclude the exchange of water between the sub-basins. For this reason in the present study, a topographic high in the form of a weir was added, separating the back-barrier lagoon in two sub-basins. The water level in the sub-basins, rather than in the back-barrier as a whole, is assumed to fluctuate uniformly. For this schematization the hydrodynamic equations are solved using a finite difference method. The results, together with the equilibrium condition, yield the equilibrium flow curve for each of the inlets. The intersections of the two equilibrium flow curves represent combinations of cross-sectional areas for which both inlets are in equilibrium. The stability of the equilibriums was investigated using a non-linear stability analysis resulting in a flow diagram. Calculations were carried out for different inlet and weir characteristics. Sinussoidal tides were the same for both inlets. The results show that for relatively large wetted cross-sectional areas over the topographic high, approaching the situation of a single basin, there are no combinations of inlet cross-sectional areas for which both inlets are in a stable equilibrium. This supports the conclusion in the earlier study. For relatively small wetted cross-sectional areas over the topographic high there is one set of stable equilibriums. In that case the two-inlet bay system approaches that of two single-inlet bay systems.     

Large-scale dune erosion tests to study the influence of wave periods

Large-scale physical model tests were performed to quantify the effects of the wave period on dune erosion. Attention was focussed on 2D cross-shore effects in a situation with sandy dunes and extreme water levels and wave conditions. Besides profile measurements, detailed measurements in time and space of water pressure, flow velocities and sediment concentrations were performed in the near near-shore area. It was concluded that a longer wave period leads to a larger dune erosion volume and to a larger landward retreat of the dune face. Tests with double-peaked wave spectra showed that the influence of the spectral shape on dune erosion was best represented by the T_m − 1,0 spectral mean wave period, better than the peak wave period, T_p. The effect of the wave period on dune erosion was implemented in a dune erosion prediction method that estimates erosion volumes during normative storm conditions for the Dutch coast. More details of the measurements and additional analyses of physical processes are described in an accompanying paper by Van Thiel de Vries et al. [Van Thiel de Vries, J.S.M., van Gent, M.R.A., Reniers, A.J.H.M. and Walstra, D.J.R., submitted for publication. Analysis of dune erosion processes in large scale flume experiments, In this volume of Coastal Engineering.].     

Conspicuous sediment structures in fossil beach deposits (southern Tenerife, Canary Islands, Spain): paleoliquefaction features versus biogenic origin

Tubular-shaped concretions and concretionary dykes occur in Holocene fossil beach deposits between the township of El Médano and Punta Roja in southern Tenerife, Canary Islands. These sediment structures have been interpreted either as the result of (a) the interaction between hot ignimbrites that overflowed wet beaches; (b) fast accumulation of beach sands on hot and degassing ignimbrites; (c) paleoliquefaction caused by an earthquake (seismites). Based on the interpretation as seismites, an intense paleoearthquake with a moment magnitude of M = 6.8 was proposed to be responsible for the generation of the paleoliquefaction structures. However, we here reinterpret the sedimentary structures in question using the general criteria diagnostic for rhizocretions and root tubules with respect to their orientation, size, branching system, and style of cementation and, thus, consider them, to be of biogenic origin.