Aerial electromagnetic sounding of the lithosphere of Venus

Electromagnetic (EM) investigation depths are larger on Venus than Earth due to the dearth of water in rocks, in spite of higher temperatures. Whistlers detected by Venus Express proved that lightning is present, so the Schumann resonances ～10–40 Hz may provide a global source of electromagnetic energy that penetrates ～10–100 km. Electrical conductivity will be sensitive at these depths to temperature structure and hence thermal lithospheric thickness. Using 1D analytic and 2D numerical models, we demonstrate that the Schumann resonances—transverse EM waves in the ground-ionosphere waveguide—remain sensitive at all altitudes to the properties of the boundaries. This is in marked contrast to other EM methods in which sensitivity to the ground falls off sharply with altitude. We develop a 1D analytical model for aerial EM sounding that treats the electrical properties of the subsurface (thermal gradient, water content, and presence of conductive crust) and ionosphere, and the effects of both random errors and biases that can influence the measurements. We initially consider specified 1D lithospheric thicknesses 100–500 km, but we turn to 2D convection models with Newtonian temperature-dependent viscosity to provide representative vertical and lateral temperature variations. We invert for the conductivity-depth structure and then temperature gradient. For a dry Venus, we find that the error on temperature gradient obtained from any single local measurement is ～100%—perhaps enough to distinguish “thick” vs. “thin” lithospheres. When averaging over thousands of kilometers, however, the standard deviation of the recovered thermal gradient is within the natural variability of the convection models, <25%. A “wet” interior (hundreds of ppm H₂O) limits EM sounding depths using the Schumann resonances to <20 km, and errors are too large to estimate lithospheric properties. A 30-km conductive crust has little influence on the dry-interior models because the Schumann penetration depths are significantly larger. We conclude that EM sounding of the interior of Venus is feasible from a 55-km high balloon. Lithospheric thickness can be measured if the upper-mantle water content is low. If H₂O at hundreds of ppm is present, the deeper, temperature-sensitive structure is screened, but the “wet” nature of the upper mantle, as well as structure of the upper crust, is revealed.     

Macroscopic quantum resonators (MAQRO)

Quantum physics challenges our understanding of the nature of physical reality and of space-time and suggests the necessity of radical revisions of their underlying concepts. Experimental tests of quantum phenomena involving massive macroscopic objects would provide novel insights into these fundamental questions. Making use of the unique environment provided by space, MAQRO aims at investigating this largely unexplored realm of macroscopic quantum physics. MAQRO has originally been proposed as a medium-sized fundamental-science space mission for the 2010 call of Cosmic Vision. MAQRO unites two experiments: DECIDE (DECoherence In Double-Slit Experiments) and CASE (Comparative Acceleration Sensing Experiment). The main scientific objective of MAQRO, which is addressed by the experiment DECIDE, is to test the predictions of quantum theory for quantum superpositions of macroscopic objects containing more than 10⁸ atoms. Under these conditions, deviations due to various suggested alternative models to quantum theory would become visible. These models have been suggested to harmonize the paradoxical quantum phenomena both with the classical macroscopic world and with our notion of Minkowski space-time. The second scientific objective of MAQRO, which is addressed by the experiment CASE, is to demonstrate the performance of a novel type of inertial sensor based on optically trapped microspheres. CASE is a technology demonstrator that shows how the modular design of DECIDE allows to easily incorporate it with other missions that have compatible requirements in terms of spacecraft and orbit. CASE can, at the same time, serve as a test bench for the weak equivalence principle, i.e., the universality of free fall with test-masses differing in their mass by 7 orders of magnitude.     

Using micro-catchment experiments for multi-local scale modelling of nature-based solutions

The Q-natural flood management project has co-developed with the Environment Agency 18 monitored micro-catchments (~1 km²) in Cumbria, UK installing calibrated flumes aimed at quantifying the potential shift in observed flows resulting from a range of nature-based-solutions installed by local organizations. The small-scale reduces the influence of variability characterizing larger catchments that would otherwise mask any such shifts, which we attempt to relate to a shift in model parameters. This paper demonstrates an approach to applying donor-parameter-shifts obtained from modelling two of the paired micro-catchments to a much larger scale, in order to understand the potential for improved distributed modelling of nature-based solutions in the form of additional tree-planting. The models include a rainfall-runoff model, Dynamic Topmodel, and a 2D hydrodynamic model, JFlow, permitting analysis of changes in hillslope processes and channel hydrodynamics resulting from a range of distributed measures designed to emulate natural hydrological processes that evaporate, store or infiltrate flows. We report on attempts to detect shift in hydrological response using one of the paired-micro-catchment moorland versus forestry sites in Lorton using Dynamic Topmodel. A donor-parameter-shift approach is used in a hypothetical experiment to represent new woodland in a much larger catchment, although testing all combinations of spatial planting strategies, responses to multiple-extremes, failure-modes and changes to synchronization becomes intractable to support good decision making. We argue that the problem can be re-framed to use donor-parameter-shifts at multi-local-scale catchments above communities known to be at risk, commensurate with most of the evidence of NbS impacts being effective at the small scale (ca. 10 km²). This might lead to more effective modelling to help catchment managers prioritize those communities-at-risk where there is more evidence that NbS might be effective.     

Critical evaluation of the customisation process of the UNDRR disaster resilience scorecard for cities to earthquake-induced soil liquefaction disaster events

Bulletin of Earthquake Engineering - As cities become larger and more densely populated the impacts of major earthquake events on city communities become more severe. Improving community resilience...     

Optimizing GPS-guidance transit route for cable crane collision avoidance using artificial immune algorithm

GPS Solutions - A cable crane collision accident usually causes serious damage to workers, equipment and materials. Owing to the emergence of global position system (GPS), some new collision...     

Modeling the environmental susceptibility of landfill sites in California

??The proper management of solid waste (SW) is a global environmental challenge. A major issue is the proper disposal of SW while balancing a wide range of criteria and working with different spatial data. In this study, we used geographic information system as a tool to perform multi-criteria decision analysis with an analytical hierarchy process to develop an environmental impact susceptibility model (EISM) for landfills. The model was applied to the state of California, USA and results are presented herein. In particular, the EISM considers factors such as geology, pedology, geomorphology, water resources, and climate as represented by 13 associated environmental indicators. The results of the EISM indicate that more than 75% of California’s territory is situated in areas with very low, low, and medium environmental impact susceptibility categories. However, in the remaining 25% of the state’s land, 61 landfills are located in the high and very high categories. These results are alarming because during the period from 2000 to 2015, these 61 landfills received approximately 308 million tons of SW, which corresponds to more than 57% of all SW disposed in California. The model results can be used toward mitigating the environmental impacts of these facilities.     

Clinopyroxene + liquid equilibria to 100 kbar and 2450 K

One of the most active issues in igneous petrology is the investigation of mantle melting, and subsequent differentiation. To evaluate alternative hypotheses for melting and differentiation it is essential to accurately predict clinopyroxene compositions in natural systems. Expressions have thus been derived that describe clinopyroxene-melt equilibria, and allow equilibrium clinopyroxene compositions to be calculated. These equations were constructed from least-squares regression analysis of experimental clinopyroxene-liquid pairs. The calibration database included clinopyroxenes synthesized from both natural and synthetic basalt compositions; experimental conditions ranged from 0 to 100 kbar and 1350 to 2450 K. Regression equations were based on thermodynamic functions. Empirical expressions were also derived, since such models yield more precise estimates of clinopyroxene compositions, and may be easily incorporated into existing liquid line-of-descent models. Such equations may be useful for calculation of high pressure liquid fractionation, or for constraining P-T conditions for basalts produced by partial melting of a pyroxene-bearing source. Models of mantle melting often rely on expressions involving simple element ratios. Partition coefficients (K _d ^cpx/liq ) for the minor elements, Na and Ti, were thus also calibrated as a function of P, T and composition. K _Ti ^cpx/liq , while sensitive to composition was relatively insensitive to P and T. In contrast, K _Na ^cpx/liq increases substantially with increasing P, and exceeded 1 in some experiments. Since oceanic basalts show variations in Na/Ti ratios, the potential exists for partial melting depths to be inferred from K _Na ^cpx/liq . Received: 28 May 1997 / Accepted: 20 November 1998     

Recharge and Groundwater Flow Within an Intracratonic Basin,Midwestern United States

The conservative nature of chloride (Cl^?) in groundwater and the abundance of geochemical data from various sources (both published and unpublished) provided a means of developing, for the first time, a representation of the hydrogeology of the Illinois Basin on a basin‐wide scale. The creation of Cl^? isocons superimposed on plan view maps of selected formations and on cross sections across the Illinois Basin yielded a conceptual model on a basin‐wide scale of recharge into, groundwater flow within and through the Illinois Basin. The maps and cross sections reveal the infiltration and movement of freshwater into the basin and dilution of brines within various geologic strata occurring at basin margins and along geologic structures. Cross‐formational movement of brines is also seen in the northern part of the basin. The maps and cross sections also show barriers to groundwater movement created by aquitards resulting in areas of apparent isolation/stagnation of concentrated brines within the basin. The distribution of Cl^? within the Illinois Basin suggests that the current chemical composition of groundwater and distribution of brines within the basin is dependent on five parameters: (1) presence of bedrock exposures along basin margins; (2) permeability of geologic strata and their distribution relative to one another; (3) presence or absence of major geologic structures; (4) intersection of major waterways with geologic structures, basin margins, and permeable bedrock exposures; and (5) isolation of brines within the basin due to aquitards, inhomogeneous permeability, and, in the case of the deepest part of the basin, brine density effects.     

A method for uncertainty constraint of catchment discharge and phosphorus load estimates

River discharge and nutrient measurements are subject to aleatory and epistemic uncertainties. In this study, we present a novel method for estimating these uncertainties in colocated discharge and phosphorus (P) measurements. The “voting point”‐based method constrains the derived stage‐discharge rating curve both on the fit to available gaugings and to the catchment water balance. This helps reduce the uncertainty beyond the range of available gaugings and during out of bank situations. In the example presented here, for the top 5% of flows, uncertainties are shown to be 139% using a traditional power law fit, compared with 40% when using our updated “voting point” method. Furthermore, the method is extended to in situ and lab analysed nutrient concentration data pairings, with lower uncertainties (81%) shown for high concentrations (top 5%) than when a traditional regression is applied (102%). Overall, for both discharge and nutrient data, the method presented goes some way to accounting for epistemic uncertainties associated with nonstationary physical characteristics of the monitoring site.