Geophysical investigation using resistivity and GPR methods: a case study of a lubricant oil waste disposal area in the city of Ribeirão Preto,São Paulo,Brazil

Geophysics has been shown to be effective in identifying areas contaminated by waste disposal, contributing to the greater efficiency of soundings programs and the installation of monitoring wells. In the study area, four trenches were constructed with a total volume of about 25,000 m³. They were almost totally filled with re-refined lubricating oil waste for approximately 25 years. No protection liners were used in the bottoms and laterals of the disposal trenches. The purpose of this work is to evaluate the potential of the resistivity and ground penetrating radar (GPR) methods in characterizing the contamination of this lubricant oil waste disposal area in Ribeirão Preto, SP, situated on the geological domain of the basalt spills of the Serra Geral Formation and the sandstones of the Botucatu Formation. Geophysical results were shown in 2D profiles. The geophysical methods used enabled the identification of geophysical anomalies, which characterized the contamination produced by the trenches filled with lubricant oil waste. Conductive anomalies (smaller than 185 Ωm) immediately below the trenches suggest the action of bacteria in the hydrocarbons, as has been observed in several sites contaminated by hydrocarbons in previously reported cases in the literature. It was also possible to define the geometry of the trenches, as evidenced by the GPR method. Direct sampling (chemical analysis of the soil and the water in the monitoring well) confirmed the contamination. In the soil analysis, low concentrations of several polycyclic aromatic hydrocarbons (PAHs) were found, mainly naphthalene and phenanthrene. In the water samples, an analysis verified contamination of the groundwater by lead (Pb). The geophysical methods used in the investigation provided an excellent tool for environmental characterization in this study of a lubricant oil waste disposal area, and could be applied in the study of similar areas.     

Decompression and H<Subscript>2</Subscript>O exsolution driven crystallization and fractionation: development of a new model for low-pressure fractional crystallization in calc-alkaline magmatic systems

Magma ascent, decompression-induced H₂O exsolution and crystallization is now recognized as an important process in hydrous subduction zone magmas. During the course of such a process calculations suggest that the ascent rate of a degassing and crystallizing mafic magma will be greater than crystal settling velocities. Thus, any crystals formed as a consequence of volatile exsolution will remain suspended in the magma. If the magma erupts before the percentage of suspended crystals reaches the critical crystallinity value for mafic magma (~55 vol.%) it will produce the commonly observed crystal rich island arc basalt lava. If the magma reaches its critical crystallinity before it erupts then it will stall within the crust. Extension of compaction experiments on a 55 vol.% sand-Karo syrup suspension at different temperatures (and liquid viscosities) to the likely viscosities of interstitial andesitic to dacitic liquid within such a stalled magma suggest that small amounts (up to ~10%) can be expelled on a time scale of 1–10 years. The expelled liquid can create a new intermediate to silicic body of magma that is related to the original mafic magma via fractional crystallization. The short time scale for liquid expulsion indicate that decompression-induced H₂O exsolution and crystallization can be an important mechanism for fractional crystallization. Based on this assumption a general model of decompression-induced crystallization and fractionation is proposed that explains many of the compositional, mineralogical and textural features of Aleutian (and other andesites).     

Eutrophication,health risk assessment and spatial analysis of water quality in Gucheng Lake,China

The water characteristics of the Gucheng Lake, such as eutrophication, health and spatial distribution, were investigated. On the basis of the trophic state index (TSI) and entropy weight, a synthesized trophic state index (STSI) model was established to assess lake eutrophication condition through calculating STSI, choosing TP, TN, COD, BOD and NH₃-N as trophic variables. The STSI ranged from 50.58 to 62.44, which showed that the water has been between eutrophic and supereutrophic. A histogram was applied to health risk assessment which was analyzed from carcinogenic substances (Cr⁺⁶, As and Cd) and non-carcinogenic substances (hydroxybenzene, Pb, Hg, CN⁻ and NH₃), and the results showed that the former was much greater than the latter for effect. The total risk for each resident caused by all pollutants ranged from 5.18E-05 to 8.34E-05, which is far higher than the standard, recommended by Sweden Bureau of Environment Protection and Holland Ministry of Building and Environment Protection (1.0E-05). Cluster analysis was used to detect similarities and dissimilarities among the seven sampling sites and explain the observed clustering in terms of affected conditions. Twenty-one variables were used to divide seven sampling sites into three groups, namely, north lake, south lake and lake center.     

Microstructure characteristics and forming environment of late Quaternary Period loess in the Loess Plateau of China

Since the late Quaternary Period, the rapid rising of the northeastern Qinghai-Tibetan Plateau has greatly changed the East Asian climate and formed different regional monsoon climates. Various microstructures of the loess in northern China have formed under a variety of climatic conditions. The scanning electron microscope (SEM) and energy spectrum analysis are used in this paper to study the relationship between the indexes of loess microstructures and the forming climates, and the indexes include the diameter of sand grains, Ca/Fe value and the characteristic shapes of the loess from SEM microstructures pictures. In terms of their respective climatic circumstances, the major microstructures of regional loess may be classified into nine categories according to their forms and particle sizes, such as loess formed in near-sand source, loess of granule sand dropping, and loess formed in hot and rainy places, i.e. with the loess SEM pictures, climates of about 15 ka b.p. in different places may be evaluated. In conclusion, the clear and distinguishable loess microstructures and their indexes in the Loess Plateau of China can also deduce the evolution of climate, such as warm or cold and wet or dry, and even sandstorm activities when the loess is deposited.     

Rate of growth of the preserved North American continental crust: Evidence from Hf and O isotopes in Mississippi detrital zircons

Detrital zircons from the Mississippi River have been analyzed for U-Th-Pb, Lu-Hf and O isotopes to constrain the rate of growth of the preserved North American continental crust. One hundred and forty two concordant zircon U/Pb dates on grains mounted in epoxy, obtained by Excimer laser ablation ICP-MS method, resolved six major periods of zircon crystallization: 0-0.25, 0.3-0.6, 0.95-1.25, 1.3-1.5, 1.65-1.95 and 2.5-3.0 Ga. These age ranges match the ages of the recognized lithotectonic units of the North American continent in the hinterland of the Mississippi River. Ninety-six zircons mounted on tape, which show no age zonation and were within 7.5% of concordance, were selected to represent the six U/Pb age time intervals and analyzed for Lu-Hf and O isotope by laser ablation MC-ICP-MS and SHRIMP II, respectively. The δ¹⁸O values of the zircons show a small step increase in the maximum δ¹⁸O values at the Archean-Proterozoic boundary from 7.5‰ in the Archean to 9.5‰, and rarely 13‰, in the Proterozoic and Phanerozoic. However, the average value of δ¹⁸O in zircons changes little with time, showing that the increase in the maximum δ¹⁸O values between 2.5 and 2.0 Ga, which can be attributed to an increase in the sediment content of the source regions of younger granitoids, is largely balanced by an increase in zircons with anomalously low δ¹⁸O, which can be attributed to hydrothermally altered crust in the granitoid source region.εHf_i values for the zircons range from 13.1 to −26.9. Zircons derived from juvenile crust, which we define as having mantle δ¹⁸O (4.5-6.5‰) and lying within error of the Hf depleted mantle growth curve, are rare or absent in the Mississippi basin. The overwhelming majority of zircons crystallized from melted pre-existing continental crust, or mantle-derived magmas that were contaminated by continental crust. The average time difference between primitive crust formation and remelting for each of the recognized lithotectonic time intervals, which is defined as crustal incubation time in this study, is 890 ± 460 Myr. There is also a suggestion that the crustal incubation time increases with decreasing age in the Mississippi basin, which is consistent with the declining role of radioactive heat production in the lower crust with time.The average Hf model age (1.94 Ga), weighted by fraction of zircons in the river load is in reasonable agreement with the Nd model age (1.7 Ga) for the Mississippi River. However, if the zircons are weighted by the area of North America covered by the six recognized periods of zircon crystallization the average model age is 2.35 Ga, which compares favorably with an area weighted Nd model age of 2.36 Ga. Our preferred approach is to use the measured O isotope values to constrain variations in the ¹⁷⁶Lu/¹⁷⁷Hf ratio of the granitic source region from which the zircons crystallized, making the assumption that zircons with mantle-like O isotopic ratios have higher ¹⁷⁶Lu/¹⁷⁷Hf than zircons with higher O isotope values. This method gives an average Hf model age of 2.53 Ga, which is 180 Myr older than the constant ¹⁷⁶Lu/¹⁷⁷Hf calculation.The area weighted zircon Hf model ages show two distinct periods of crust formation for the North American continent, 1.6-2.2 and 2.9-3.4 Ga. At least 50% of the preserved North American continental crust was extracted from the mantle by 2.9 Ga and 90% by 1.6 Ga. Two similar periods of crustal growth are also recognized in Gondwana (Hawkesworth C. J. and Kemp A. I. S. (2006) Using hafnium and oxygen isotopes in zircons to unravel the record of crustal evolution. Chem. Geol.226, 144-162.), suggesting that these may be periods of global continental crustal growth. However, we stress that more data from other continents are required before the hypothesis of episodic global continental growth can be accepted with confidence.     

Efficient Modeling of Gravity Fields Caused by Sources with Arbitrary Geometry and Arbitrary Density Distribution

We present a brief review of gravity forward algorithms in Cartesian coordinate system, including both space-domain and Fourier-domain approaches, after which we introduce a truly general and efficient algorithm, namely the convolution-type Gauss fast Fourier transform (Conv-Gauss-FFT) algorithm, for 2D and 3D modeling of gravity potential and its derivatives due to sources with arbitrary geometry and arbitrary density distribution which are defined either by discrete or by continuous functions. The Conv-Gauss-FFT algorithm is based on the combined use of a hybrid rectangle-Gaussian grid and the fast Fourier transform (FFT) algorithm. Since the gravity forward problem in Cartesian coordinate system can be expressed as continuous convolution-type integrals, we first approximate the continuous convolution by a weighted sum of a series of shifted discrete convolutions, and then each shifted discrete convolution, which is essentially a Toeplitz system, is calculated efficiently and accurately by combining circulant embedding with the FFT algorithm. Synthetic and real model tests show that the Conv-Gauss-FFT algorithm can obtain high-precision forward results very efficiently for almost any practical model, and it works especially well for complex 3D models when gravity fields on large 3D regular grids are needed.