Sunspot intensities and their correction for scattered light

Photoelectric measurements of monochromatic spot intensities obtained with the domeless Coudé refractor in Anacapri are given. The scattered light superimposed on the spot, as deduced from measurements outside the sun's limb, amounts on the average to about 4% of the photospheric intensity. The accuracy of the derived spot intensities is better than 10%. Two of four investigated spots yielded temperatures below 3900K (ΔΘ > 0.5).     

Solar wind induction in Mercury: Constraints on the formation of a magnetosphere

The discovery of Mercury's magnetosphere by Mariner 10 was surprising since the conventional view of regenerative planetary dynamos had been that the spin requirement would likely have been in excess of the observed spin rate of Mercury. Also internal fluid motions were not expected to be sufficiently large. This paper explores the alternative model of the formation of Mercury's magnetosphere via electromagnetic induction forced by the solar wind. It is shown, however, that the constraints are so severe as to limit severely the applicability of such a model. Although induction is easily observed on the Moon, the modification of the magnetic boundary condition associated with a plasma magnetosphere on Mercury rules out its formation via induction except for interplanetary driving fields which are decreasing in amplitude. That model is explored but retains the difficulty that induced magnetospheres tend to be of small radial and temporal extent compared to that inferred by Ness et al. for Mercury.     

On the Structure of the Perseus Cluster of Galaxies

The investigation of the distribution of number densities and radial velocities in the Perseus cluster led us to the conclusion that this cluster possesses dominant substructures. This result is in agreement with a corresponding result for the Hydra-I cluster and with former conclusions of different authors that substructures are a typical phenomenon for a high percentage of all clusters of galaxies. The complex of the Perseus cluster has a diameter of 60–80 minutes of arc.     

Russian studies of atmospheric electricity in 2011–2014

This review contains the most significant results of Russian studies in the field of atmospheric electricity in 2011–2014. It is part of the Russian National Report on Meteorology and Atmospheric Sciences to the International Association of Meteorology and Atmospheric Sciences (IAMAS). The report was presented and approved at the XXVI General Assembly of the International Union of Geodesy and Geophysics (IUGG).¹ The review is followed by a list of the main published works on the studies of atmospheric electricity of Russian scientists in 2011–2014.     

Linear spin-up in a sliced cylinder

Abstract

spin-up and spin-down in a circular tank with a uniformly sloping bottom are studied experimentally and numerically for small values of the relative change in the angular velocity of the tank. Generally, the initial single-cell flow evolves into a number of smaller vortices. The evolution is compared with an analytical model based on an expansion of the flow field in linear Rossby waves (Pedlosky and Greenspan, 1967). Although it is possible to tune the experimental parameters in such a way that agreement with the theory is found, in most cases the experiments show shedding of vortices in the initial stage of the spin-up or spin-down, a phenomenon not described by the analytical model. Nonetheless, in such cases the analytical model still accounts for other observations: the alternating generation of cyclonic and anticyclonic vortices in the eastern part of the tank and their subsequent westward motion.     

Probabilistic calibration of a distributed hydrological model for flood forecasting

Abstract

The complexity of distributed hydrological models has led to improvements in calibration methodologies in recent years. There are various manual, automatic and hybrid methods of calibration. Most use a single objective function to calculate estimation errors. The use of multi-objective calibration improves results, since different aspects of the hydrograph may be considered simultaneously. However, the uncertainty of estimates from a hydrological model can only be taken into account by using a probabilistic approach. This paper presents a calibration method of probabilistic nature, based on the determination of probability functions that best characterize different parameters of the model. The method was applied to the Real-time Interactive Basin Simulator (RIBS) distributed hydrological model using the Manzanares River basin in Spain as a case study. The proposed method allows us to consider the uncertainty in the model estimates by obtaining the probability distributions of flows in the flood hydrograph.

Citation Mediero, L., Garrote, L. & Martín-Carrasco, F. J. (2011) Probabilistic calibration of a distributed hydrological model for flood forecasting. Hydrol. Sci. J. 56(7), 1129–1149.     

Geomorphological site classification for the Fujian province

Geomorphological classification of the Fujian province was done based on remote-sensing imaging, digital elevation maps, and slope gradient data acquired by ArcGIS 9.2. The engineering geological units in the Fujian province were divided into five types by the geomorphologic shape and genesis. The relationship among geomorphological type, engineering geological unit, and site category was determined using engineering geological data and site category data. Then, after making a preliminary site classification adjusted by drill hole data, the site was classified into four types: I₀, I₁, II, and III according to site classification standards of equivalent shear-wave velocity and overburden thickness. The results showed that the site categories in the Fujian province mainly consist of type II, which accounts for 85.26 % of the land area. The percentage of I₀ was the smallest, which accounts for only 2.44 % of the total area.     

Application of data assimilation for improving forecast of water levels and residual currents in Singapore regional waters

Hydrodynamic models are commonly used for predicting water levels and currents in the deep ocean, ocean margins and shelf seas. Their accuracy is typically limited by factors, such as the complexity of the coastal geometry and bathymetry, plus the uncertainty in the flow forcing (deep ocean tide, winds and pressure). In Southeast Asian waters with its strongly hydrodynamic characteristics, the lack of detailed marine observations (bathymetry and tides) for model validation is an additional factor limiting flow representation. This paper deals with the application of ensemble Kalman filter (EnKF)-based data assimilation with the purpose of improving the deterministic model forecast. The efficacy of the EnKF is analysed via a twin experiment conducted with the 2D barotropic Singapore regional model. The results show that the applied data assimilation can improve the forecasts significantly in this complex flow regime.     

Condensed hyperelements method of non-vertical consistent boundaries for wave propagation analysis in irregular media

The study of wave propagation in finite/infinite media has many applications in geotechnical and structural earthquake engineering and has been a focus of research for the past few decades. This paper presents an analysis of 2D anti- plane problems （Love waves） and 2D in-plane problems （Rayleigh waves） in the frequency domain in media consisting of a near-field irregular and a far-field regular part. The near field part may contain structures and its boundaries with the far-field can be of any shape. In this study, the irregular boundaries of the near-field are treated as consistent boundaries, extending the concept of Lysmer＇s vertical consistent boundaries. The presented technique is called the Condensed Hyperelements Method （CHM）. In this method, the irregular boundary is limited to a vertical boundary at each end that is a consistent boundary at the far-field side. Between the two ends, the medium is discretized with hyperelements. Using static condensation, the stiffness matrix of the far-field is derived for the nodes on the irregular boundary. Examples of the application of the CHM illustrate its excellent accuracy and efficiency.     

The Aterno valley strong-motion array: seismic characterization and determination of subsoil model

The paper focuses on the strong motion array deployed in the upper Aterno River Valley, in the immediate outskirts north-west of the town of L’Aquila, which is part of the Italian Strong Motion Network operated by the Department of Civil Protection. The array is composed of six accelerometric stations located along a cross section of the valley. The importance of this array relies on the fact that a large amount of high-quality records were obtained during the 2009 L’Aquila seismic sequence, from both the mainshock and several aftershocks. These data are especially important to investigate site effects in sediment-filled valleys during moderate earthquakes in epicentral area because well-documented observational studies are very limited in the literature. However, the main drawback for the study of site effects in the Aterno valley is the lack of a detailed knowledge of the geometry of the valley, soil layering and dynamic properties of materials. The main motivation for this study stems from the need to provide a reliable subsoil model of the valley coupled with high-quality strong motion data. Based on the above, in the framework of S4 project, a major effort was undertaken to get a trustworthy cross section of the valley by an ad hoc investigation, comprising geological and geotechnical surveys as well as an extensive geophysical campaign, characterized by both active and passive measurements. These results were complemented by additional geological and geotechnical data available in the literature. By merging all the information acquired, a 2D subsoil model of the transversal section of the upper Aterno valley has been produced. The valley is characterised by an asymmetric shape with a shallower rock basement at the western edge of the valley that deepens at the valley centre. Moreover, based on the results of geophysical tests, representative V_s values were assigned to the different lithologic units forming the alluvial deposits filling the valley. Shear wave velocity is a fundamental parameter for ground response studies and it is also effective in classifying the accelerometric station from a seismic point of view. The 2D model may be therefore, considered a benchmark model for future studies of site effects. It will offer the possibility to examine site effects with a complex underlying geology and to validate the results of numerical simulations of site response analyses with the numerous observations from earthquake recordings, both for weak and strong ground motion conditions.