Phosphorus input by upwelling in the eastern Gotland Basin (Baltic Sea) in summer and its effects on filamentous cyanobacteria

In July 2007, phosphorus input by an upwelling event along the east coast of Gotland Island and the response of filamentous cyanobacteria were studied to determine whether introduced phosphorus can intensify cyanobacterial bloom formation in the eastern Gotland Basin. Surface temperature, nutrient concentrations, phytoplankton biomass and its stoichiometry, as well as phosphate uptake rates were determined in two transects between the coasts of Gotland and Latvia and in a short grid offshore of Gotland. In the upwelling area, surface temperatures of 11–12 °C and average dissolved inorganic phosphorus (DIP) concentrations of 0.26 μM were measured. Outside the upwelling, surface temperatures were higher (15.5–16.6 °C) and DIP supplies in the upper 10 m layer were exhausted. Nitrite and nitrate concentrations (0.01–0.22 μM) were very low within and outside the upwelling region. Abundances of filamentous cyanobacteria were highly reduced in the upwelling area, accounting for only 1.4–6.0% of the total phytoplankton biomass, in contrast to 18–20% outside the upwelling. The C:P ratio of filamentous cyanobacteria varied between 32.8 and 310 in the upwelling region, most likely due to the introduction of phosphorus-depleted organisms into the upwelling water. These organisms accumulate DIP in upwelling water and have lower C:P ratios as long as they remain in DIP-rich water. Thus, diazotrophic cyanobacteria benefit from phosphorus input directly in the upwelling region. Outside the upwelling region, the C:P ratios of filamentous cyanobacteria varied widely, between 240 and 463, whereas those of particulate material in the water ranged only between 96 and 224. To reduce their C:P ratio from 300 to 35, cyanobacteria in the upwelling region had to take up 0.05 mmol m⁻³ DIP, which is about 20% of the available DIP. Thus, a larger biomass of filamentous cyanobacteria may be able to benefit from a given DIP input. As determined from the DIP uptake rates measured in upwelling cells, the time needed to reduce the C:P ratio from 300 to 35 was too long to explain the huge bloom formations that typically occur in summer. However, phosphorus uptake rates increased significantly with increasing C:P ratios, allowing phosphorus accumulation within 4–5 days, a span of time suitable for bloom formation in July and August.     

The influence of spatial dispersion on the coefficient of spontaneous emission of cyclotron radiation in a non-equilibrium plasma

The coefficient of spontaneous emission of cyclotron radiation propagating in the direction of an external magnetic field in non-equilibrium plasma is calculated including the effect of spatial dispersion on the emission process. The resulting part of the emission coefficient may become important in the vicinity of the cyclotron frequency.     

Formation and early history of Lakes Pepin and St. Croix of the upper Mississippi River

Study of Lake Pepin and Lake St. Croix began more than a century ago, but new information has permitted a closer look at the geologic history of these two riverine lakes located on the upper Mississippi River system. Drainages from large proglacial lakes Agassiz and Duluth at the end of the last glaciation helped shape the current valleys. As high-discharge outlet waters receded, tributary streams deposited fans of sediment in the incised river valleys. These tributary fans dammed the main river, forming riverine lakes. Lake Pepin was previously thought to be a single long continuous lake, extending for 80 km from its dam at the Chippewa River fan all the way up to St. Paul, with an arm extending up the St. Croix valley. Recent borings taken at bridge and dam locations show more than a single section of lake sediments, indicating a more complex history. The Minnesota and Mississippi Rivers did not always follow their current paths. Valleys cut into bedrock but now buried by glacial sediment indicate former river courses, with the most recent of these from the last interglacial period marked at the surface by chains of lakes. The morphology of the Mississippi valley bottom, and thus the morphology of Lake Pepin as it filled the valley, is reflect in part by the existence of these old valleys but also by the presence of glacial outwash terraces and the alluvial fans of tributary streams. A sediment core taken in Lake Pepin near Lake City had a piece of wood in gravels just below lake sediments that dated to 10.3 ka cal. BP, indicating that the lake formed as the Chippewa River fan grew shortly after the floodwaters of Lakes Agassiz and Duluth receded. Data from new borings indicate small lakes were dammed behind several tributary fans in the Mississippi River valley between the modern Lake Pepin and St. Paul. One tributary lake, here called Early Lake Vermillion, may have hydraulically dammed the St. Croix River, creating an incipient Lake St. Croix. The tributary fans from the Vermillion River, the Cannon River, and the Chippewa River all served to segment the main river valley into a series of riverine lakes. Later the growth of the Chippewa fan surpassed that of the Vermillion and Cannon fans to create a single large lake, here called late Lake Pepin, which extended upstream to St. Paul. Sediment cores taken from Lake Pepin did not have significant organic matter to develop a chronology from radiocarbon dating. Rather, magnetic features were matched with those from a Lake St. Croix core, which did have a known radiocarbon chronology. The Pepin delta migration rate was then estimated by projecting the elevations of the top of the buried lake sediments to the dated Lake Pepin core, using an estimated slope of 10 cm/km, the current slope of Lake Pepin sediment surface. By these approximations, the Lake Pepin delta prograded past Hastings 6.0 ka cal BP and Red Wing 1.4 ka cal BP. This is one of eight papers dedicated to the “Recent Environmental History of the Upper Mississippi River” published in this special issue of the Journal of Paleolimnology. D. R. Engstrom served as guest editor of the special issue.     

A note on the howard-Malkus-Whitehead floating heat sources

Abstract

Some deficiencies in a recent paper by Howard, Malkus and Whitehead are examined. The problem is reformulated in terms of an integro-differential equation, from which both asymptotic and numerical solutions are obtained.     

An explosive end to intermediate-mass zero-metallicity stars and early Universe nucleosynthesis

We use the Cambridge stellar evolution code stars to model the evolution of 5 and  7 M_⊙  zero-metallicity stars. With enhanced resolution at the hydrogen- and helium-burning shell in the asymptotic giant branch (AGB) phases, we are able to model the entire thermally pulsing AGB (TP-AGB) phase. The helium luminosities of the thermal pulses are significantly lower than in higher metallicity stars so there is no third dredge-up. The envelope is enriched in nitrogen by hot-bottom burning of carbon that was previously mixed in during second dredge-up. There is no s -process enrichment owing to the lack of third dredge-up. The thermal pulses grow weaker as the core mass increases and they eventually cease. From then on the star enters a quiescent burning phase which lasts until carbon ignites at the centre of the star when the CO core mass is  1.36 M_⊙  . With such a high degeneracy and a core mass so close to the Chandrasekhar mass, we expect these stars to explode as type 1.5 supernovae, very similar to type Ia supernovae but inside a hydrogen-rich envelope.     

Computing a design flood in the absence of historical records

Summary A design flood for a Venezuelan river is computed in the absence of rainfall and stream-flow data of more than a few years. From synoptic studies of an area embracing northern South America and the Caribbean, the type of disturbance producing the abundant rains of the area is determined. A disturbance of this type is maximized on the basis of the ratio of energy dissipated through friction to released latent energy represented by rainfall — in other words, theefficiency of the system is given its highest reasonable value. The synthetic disturbance is moved over the river basin in a manner most favorable for heavy rain. Certain data available from other rivers are used as a cross-check on the resultant flood values.     

Cores of soft lake sediments

Short cores of soft sediment, used in studying the pollution history of lakes, can be obtained with a plastic tube fitted with a piston and piston wire. If the sediments of deep water are annually laminated (and thus difficult to sample without disturbance) or contain excess gas (which can disrupt the stratigraphy during its escape), a short 'core' can be acquired by producing a frozen crust on a tube filled with dry ice and butanol.
A continuous core of soft lake sediment at least 7 m long can be obtained in a single drive beneath deep water with a hand-driven piston corer. Such a core assures the complete continuity necessary for counting annual laminations or for making close-interval analyses without fear of gaps, and it provides the uniform orientation required for measurements of paleomagnetic directions.