Observations of desert flood bores

Flood bores have been measured in desert stream floods. The bores were steep and small pebbles were observed to be pushed ahead. Bore velocity changed downstream and was controlled by local channel geometry. In narrow reaches, the bore advanced at rates twice those of wide reaches. Mean bore velocity was about 50 per cent of that of mean flow at peak flood discharge. The surfaces of shallow bores were covered by air foams. This was not the case in deeper, faster examples.     

Adaptation to climate change in desertified lands of the marginal regions in Egypt through sustainable crop and livestock diversification systems

Environmental degradation resulting from current climate changes, including prolonged drought, land degradation, desertification, and loss of biodiversity, is presenting enormous challenges to achieve ...     

Structure sismique du socle paléozoı̈que du bassin des Doukkala,Môle côtier,Maroc occidental. Indication en faveur de l'existence d'une phase éo-varisqueSeismic structure of the Doukkala basin,Palaeozoic basement,western Morocco: a hint for an Eovariscan fold-and-thrust belt

Seismic profiles and well data from the Doukkala basin unravel the structure of the Palaeozoic basement and suggest that this coastal zone of western Morocco was affected by a compressive phase during the Frasnian. This resulted in the formation of upright, plurikilometric folds associated with reverse faults (North Doukkala), and of asymmetrical folds associated with mostly west verging ramps (South Doukkala). Folding involved all pre-Upper Frasnian formations and caused partial or total hiatus of Upper Frasnian–Strunian strata. This event can be correlated with the orogenic phase reported from more internal domains of the Morocco Hercynian belt, where it is referred to as the ‘Bretonne’ or ‘Eovariscan’ phase. To cite this article: H. Echarfaoui et al., C. R. Geoscience 334 (2002) 13–20     

Evidence for Holocene environmental change from C/N ratios, and δ13C and δ15N values in Swan Lake sediments, western Sand Hills, Nebraska

Profiles of percent carbon and nitrogen, carbon/nitrogen (C/N) ratios and stable carbon (¹³C), and nitrogen (¹⁵N) isotopic ratios in organic matter from an 11.6 m core were used to reconstruct environments of deposition in the Swan Lake basin during the past 5300 YBP. The upper 6.5 m consisted of gyttja containing variable amounts of reddish brown-colored fine organic matter and calcium carbonate. It was followed by a 0.5 m sandy silt, which was followed by a 3.6 m reduced layer characterized by large quantities of black organic plant remains, sapropel, and then by another sapropel layer consisting mainly of well-sorted sapropelic sand with relatively low organic matter content. The C- and N-contents in the organic matter in the sediment profile ranged from 0.5 to 23% and from 0.02 to 2%, respectively. Carbon content were positively correlated to both N and clay content while carbon content was negatively correlated to sand content. Two major environmental phases in Swan Lake were apparent from large differences in the C and N data of the sediment organic matter. These include the sapropel (marsh) stage that stretched from approximately 5330 to 3930 YBP, and the following gyttja (open water stage). During the sapropel marsh plants identified in a previous pollen study as cattails and sedges proliferated and produced copious amounts of well-preserved organic matter. C/N ratios, ¹³C values, and ¹⁵N values in the sapropel were significantly different from those that characterized organic matter in the gyttja. During the gyttja ¹³C values indicated that deep primary producers have dominated lake biomass. By utilizing bicarbonate as their C-source, the accumulating biomass became relatively enriched ¹³C values. The presence of high sediment CaCO₃ contents indicated more alkaline and deeper water conditions prevailed during the gyttja. Further refinement of the data suggested that each major phase initially contained an identifiable transition stage. During the sapropelic (initial marsh stage) which occurred before 5330 YBP, sand content gradually decreased as organic matter increased. As reflected by high C/N ratios and slightly enriched ¹³C values, these sands appear to have contained sufficient permeability to promote partial mineralization of accumulated organic-N containing compounds. A short initial gyttja transition period from about 3930–3830 YBP occurred in which the sediment silt content was anomalously high relative that measured in the surrounding layers. The silt content suggests that this turbid transition layer can not be completely explained by sediment mixing via bioturbation. The silts appeared to have been associated with the sharp climate change that resulted in higher water-table conditions during the gyttja stage.     

Prediction of the sawing quality of Marmarit stones using the capability of artificial neural network

The sawing rate is one of the most significant and effective parameters in extracting building stones via diamond wire sawing. This parameter designates the capability of diamond wire sawing for sawing different stones; in addition, the parameter gives rise to economical considerations for quarry designers. In this study, the existent relations between stone geotechnical parameters and the sawing rate of stones via diamond wire sawing were analyzed using regression and correlation coefficient as well as the collected data from Marmarit stone quarries. Moreover, we estimated the sawing rate of Marmarit using the dimensional stone rock mass rating (DSRMR); upon comparison of the data obtained from DSRMR our pre‐collected data on quarries, we did not gain satisfactory results from DSRMR, hence we used artificial neural network (ANN). The results showed that the percentage of Silica, the coefficient of water absorption, the uniaxial compressive strength (UCS), and abrasive hardness are the proper parameters for creating the ANN. Discontinuities have the least effects possible on diamond wire sawing. Having given the training possibility of the ANN, and its ability to evaluate relations among input parameters, the ANN, which was being trained with Marmarit's traits, was an accurate network for estimating diamond wire sawing in Marmarit quarries, although it could not generalize this network for other stones such as Chini and Crystal. Copyright © 2011 John Wiley & Sons, Ltd.     

Numerical Prediction of Induced Pressure and Lift of the Planing Surfaces

This paper discusses the numerical prediction of the induced pressure and lift of the planing surfaces in a steady motion based on the potential flow solver as well as the spray drag by use of the practical method.The numerical method for computation of the induced pressure and lift is potential-based boundary element method.Special technique is identified to present upwash geometry and to determine the spray drag.Numerical results of a planing flat plate and planing craft model 4666 are presented.It is shown that the method is robust and efficient and the results agree well with the experimental measurements with various Froude humors.     

Reach‐scale contributions of road‐surface sediment to the Honna River,Haida Gwaii,BC

Gravel road surfaces can be a major source of fine sediment to streams, yet their contribution to channel reach sediment balances remains poorly documented. To quantify the input of road surface material and to compare this input with natural sediment sources at the reach scale, suspended sediment dynamics was examined and a 16‐month sediment balance was developed for a ~35 channel‐width (approx. 425 m) reach of the Honna River, a medium‐size, road‐affected stream located in coastal British Columbia. Of the 105 ± 33 t of suspended material passing through the reach, 18 ± 6% was attributed to the road surface. The high availability of sediment on the road surface appears to limit hysteresis in road run‐off. During rainstorms that increase streamflow, road surface material composed 0.5–15% of sediment inputs during relatively dry conditions from April to the end of September and 5–70% through wetter conditions from October to the end of March, but our data do not show evidence of major sediment accumulation on the riverbed in the reach. A comparison of modelled sediment production on the road surface with observed yields from drainage channels suggests that (1) during low intensity rainfall, ditches and drainage channels may trap sediment from road run‐off, which is subsequently released during events of greater intensity, and/or (2) production models do not effectively describe processes, such as deposition or erosion of sediment in ditches, which control sediment transport and delivery. Our findings further emphasize the risk of unpaved roads in polluting river systems and highlight the continued need for careful road design and location away from sensitive aquatic environments. Copyright © 2016 John Wiley & Sons, Ltd.     

Spatially-Weighted Factor Analysis for Extraction of Source-Oriented Mineralization Feature in 3D Coordinates of Surface Geochemical Signal

Natural Resources Research - This contribution proposes a spatially weighted factor analysis (SWFA) to recognize effectively the underlying mineralization-related feature(s) in geochemical signals....     

Hydrocarbon pollution of the Mediterranean coastline of Morocco

Organic geochemical study of hydrocarbon pollution of the Mediterranean coastline of Morocco (Tangier-Nador) was performed during March–April 2002. It corresponds to a preliminary work representing an initial assessment of oil contamination of Moroccan coast.Three coastal sites corresponding to Tangier, Tetouan and Nador, representing the main built-up area of this marine region, were selected for superficial sediments, water and organism sampling. Results showed high contamination levels in these three selected sites, known as the most exposed areas to urban and industrial discharges. The maximal contamination corresponding to the sum of non-aromatic (NAH) and polycyclic aromatic hydrocarbons (PAH) encountered in sediment samples was about 553 μg/g (dw). Nevertheless, even a small city agglomeration without any industrial activity showed high values reaching 370 μg/g (dw), which confirm the important hydrocarbons input coming from discharges of fishing ships and oil transporting tankers.The obtained results from this survey reflecting in part the important amounts drained via effluents toward the Moroccan Mediterranean coasts, presented to the concerned authorities drove to the realization of the project of treatment of the wastewater.They later expect to lower rates by 50%, which is still insufficient for a fragile ecosystem such as the Mediterranean and sensitive to anthropogenic effects.     

Use of remote sensing data in comprehending an extremely unusual flooding event over southwest Bangladesh

Natural Hazards - Flooding is one of the natural disasters that affect the livelihood of the people living in the floodplains, like Bangladesh. Here, we proposed to employ SAR satellite images in...