Reef exploration in the East Sengkang Basin,Sulawesi, Indonesia

Reconnaissance seismic shot in 1971/72 showed a number of well defined seismic anomalies within the East Sengkang Basin which were interpreted as buried reefs. Subsequent fieldwork revealed that Upper Miocene reefs outcropped along the southern margin of the basin. A drilling programme in 1975 and 1976 proved the presence of shallow, gas-bearing, Upper Miocene reefs in the northern part of the basin. Seismic acquisition and drilling during 1981 confirmed the economic significance of these discoveries, with four separate accumulations containing about 750 × 10⁹ cubic feet of dry gas in place at an average depth of 700 m. Kampung Baru is the largest field and contains over half the total, both reservoir quality and gas deliverability are excellent. Deposition in the East Sengkang Basin probably started during the Early Miocene. A sequence of Lower Miocene mudstones and limestones unconformably overlies acoustic basement which consists of Eocene volcanics. During the tectonically active Middle Miocene, deposition was interrupted by two periods of deformation and erosion. Carbonate deposition became established in the Late Miocene with widespread development of platform limestones throughout the East Sengkang Basin. Thick pinnacle reef complexes developed in the areas where reef growth could keep pace with the relative rise in sea level. Most reef growth ceased at the end of the Miocene and subsequent renewed clastic sedimentation covered the irregular limestone surface. Late Pliocene regression culminated in the Holocene with erosion. The Walanae fault zone, part of a major regional sinistral strike-slip system, separates the East and West Sengkang Basins. Both normal and reverse faulting are inferred from seismic data and post Late Pliocene reverse faulting is seen in outcrop.     

Multiple longshore sand bars in the upper Chesapeake Bay

In the upper Chesapeake Bay (Maryland, U.S.A.) field surveys were conducted at 18 multiple longshore sand bar sites. The multiple bar systems were found in water depths less than approximately 2 m (mean sea level), and exhibited mild bottom slopes of 0·0052 or less. The number of bars composing each system ranged from four to 17 and the spacing between the crests typically increased in the offshore direction, ranging from 12 to 70 m. Bar height also typically increased with distance offshore and ranged from 0·03 to 0·61 m. A grain size analysis of crest and trough sediment did not reveal any significant differences and the sediment was categorized as ‘fine sand’. A review of the literature data indicated that the Chesapeake Bay multiple bars possessed similar characteristics to those found in Gelding Bay (Baltic Sea); similarities in fetch, wave height and tidal range between the two bays may account for this finding. The surf-scaling parameter indicated that the multiple bar systems were extremely dissipative with regard to wave energy, and wave height appeared to be an important factor in controlling bar spacing and bar height. A multiple wave break point hypothesis was discussed as a possible mechanism for the formation of Chesapeake Bay multiple longshore bars, and limited observational evidence appeared to support such a mechanism.     

Sonar cross sections of bodies partially insonified by finite sound beams

An object that is partially insonified by a collimated sound beam may have a scattering cross section sometimes much larger than when the object is totally covered by the incident beam. We quantitatively study this partial insonification problem here, under the classical method of physical optics. The importance of this study stems from the fact that partial coverage of the target by the beam is the situation most likely to occur in many cases of practical importance. We consider several basic target shapes partially insonified by finite beams. These shapes include the spherical, the infinite and finite cylinder, the flat plate, and the capped sphere. High-frequency approximations of the resulting integrals, obtained by means of the saddle-point method, show the relative importance of the scattering centers located at the beam's specular reflection points, or at the edges of the spots that the beam shines on the scatterers. The physical-optics method is extended to obtain formulas for the bistatic cross sections of partially insonified objects. The results are numerically evaluated and graphically displayed in many pertinent instances and compared to the predictions of approaches, such as the Fresnel-zones method and the Geometrical Theory of Diffraction (GTD). The predictions of the physical-optics method have all the advantages and deficiencies of this method and, with very minor modifications, hold equally well for the partial illumination of objects by beams of electromagnetic radiation.     

SHRIMP U–Pb ages of diagenetic and hydrothermal xenotime from the Archaean Witwatersrand Supergroup of South Africa

SHRIMP dating of xenotime overgrowths on detrital zircon grains can constrain maximum durations since diagenesis and therefore provide minimum dates of sediment deposition. Thus, xenotime dating has significant economic application to Precambrian sediment-hosted ore deposits, such as Witwatersrand Au–U, for which there are no precise depositional ages. The growth history of xenotime in the Witwatersrand Supergroup is texturally complex, with several phases evident. The oldest authigenic xenotime ²⁰⁷Pb/²⁰⁶Pb age obtained in sandstone underlying the Vaal Reef is 2764 ± 5 Myr (1 σ), and most likely represents a mixture of diagenetic and hydrothermal growth. Nevertheless, this represents the oldest authigenic mineral age yet recorded in the sequence and provides a minimum age of deposition. Other xenotime data record a spread of ages that correspond to numerous post-diagenetic thermotectonic events (including a Ventersdorp event at ≈ 2720 Ma) up to the ≈2020 Ma Vredefort event.     

Control synthesis and adaptation for an underactuated autonomousunderwater vehicle

The motion of an autonomous underwater vehicle (AUV) is controllable even with reduced control authority such as in the event of an actuator failure. In this paper we describe a technique for synthesizing controls for underactuated AUV's and show how to use this technique to provide adaptation to changes in control authority. Our framework is a motion control system architecture which includes both feed-forward control as well as feedback control. We confine ourselves to kinematic models and exploit model nonlinearities to synthesize controls. Our results are illustrated for two examples, the first a yaw maneuver of an AUV using only roll and pitch actuation, and the second a “parking maneuver” for an AUV. Experimental results for the yaw maneuver example are described     

Porphyroblast inclusion-trail orientation data: eppure non son girate*!

Extensive examination of large numbers of spatially orientated thin sections of orientated samples from orogens of all ages around the world has demonstrated that porphyroblasts do not rotate relative to geographical coordinates during highly non-coaxial ductile deformation of the matrix subsequent to their growth. This has been demonstrated for all tectonic environments so far investigated. The work also has provided new insights and data on metamorphic, structural and tectonic processes including: (1) the intimate control of deformation partitioning on metamorphic reactions; (2) solutions to the lack of correlation between lineations that indicate the direction of movement within thrusts and shear zones, and relative plate motion; and (3) a possible technique for determining the direction of relative plate motion that caused orogenesis in ancient orogens.     

Structurally controlled gold and sulfosalt mineralization: the Altenberg example, Salzburg Province, Austria

Summary ?In the south-eastern Altenbergkar–Silbereck area in the eastern Tauern window (Lungau, Salzburg) structurally controlled precious-metal (Au–Ag) mineralization is hosted in marbles of the Permo(?)-Mesozoic Silbereck Formation and in the underlying Variscan Central gneiss. During the Alpine otogeny both lithologies were affected by ductile deformation (shearing, D1; folding, D2/D3) and subsequent brittle deformation (tension gashes, D4; normal faulting, D5) related to the uplift and exhumation of the Tauern window. Mineralization is controlled by brittle D4 structures. NE–SW trending steeply dipping tension gashes of the “Tauerngoldgang” type occur within the Central gneiss. Three different marble-hosted ore types following fracture systems as well as foliation and bedding planes can be distinguished: 1) metasomatic replacement ores, 2) ores in tension gashes and 3) ores in talc-bearing structures, often containing high-grade gold and silver mineralization (native gold in association with Ag–Pb–Bi–sulfosalts). Four stages of mineralization can be distinguished which occur in all ore types: arsenopyrite–pyrite–pyrrhotite (first stage), Au–(Ag–Pb–Bi–sulfosalts) (second stage), base-metal sulfides and tetrahedrite–tennantite (third stage) and Ag-rich galena (fourth stage). Preliminary fluid inclusion data indicate temperatures of ore formation well above 300 °C (346 °C mean) for the second stage within the Central gneiss and temperatures between 310 and 230 °C for the second and third stages in the marble. Received October 12, 2001; revised version accepted September 5, 2002 Published online March 10, 2003     

Biological and granulometric controls on sedimentary organic matter of an intertidal mudflat

A variety of measures of organic matter concentration and quality were made on samples collected from the top few mm of intertidal mudflat sediment over the course of a year, in order to assess the relative importance of biological and sedimentological influences on sedimentary organic matter. Winter and summer were times of relatively fine-grained sediment accumulation, caused by biological deposition or stabilization processes and resulting in higher organic matter concentrations. Stable carbon isotope and Br:C ratios indicated a planktonic source of bulk organic matter. Ratios of organic carbon to specific surface area of the sediments were consistent with an organic monolayer coverage of sediment grains. Correction for changing grain size during the year showed no change in the organic concentration per unit surface area, in spite of organic matter inputs by in situ primary production, buildup of heterotroph biomass and mucus coatings, and biodeposition of organic-rich seston. There were also no indications of changes in bulk organic quality, measured as hydrolyzable carbohydrates and amino acids, in response to these biological processes. It is concluded that biological processes on a seasonal time scale affect the bulk organic matter of these sediments via a modulation of grain size rather than creation or decay of organic matter.