A simple fiber-optic microprobe for high resolution light measurements: application in marine sediment

A fiber-optic microphobe is described which is inexpensive and simple to build and use. It consists of an 80-micrometers optical fiber which at the end is tapered down to a rounded sensing tip of 20-30-micrometers diameter. The detector is a hybrid photodiode/amplifier. The probe has a sensitivity of 0.01 microEinst m-2 s-1 and a spectral range of 300-1,100 nm. Spectral light gradients were measured in fine-grained San Francisco Bay sediment that had an undisturbed diatom coating on the surface. The photic zone of the mud was only 0.4 mm deep. Measured in situ spectra showed extinction maxima at 430-520, 620-630, 670, and 825-850 nm due to absorption by chlorophyll a, carotenoids, phycocyanin, and bacterio-chlorophyll a. Maximum light penetration in the visible range was found in both the violet and the red < or = 400 and > or = 700 nm.     

旅游消费对区域经济贡献的研究

旅游消费对区域经济贡献是旅游经济的一个重要方面。旅游经济系统是一个具有网络结构的输入输出系统。文章在旅游实际消费和乘数理论的基础上,研究了旅游消费对区域经济贡献的空间差异、产业差异和总体贡献。     

The diffusive boundary layer of sediments: oxygen microgradients over a microbial mat

Oxygen microelectrodes were used to analyze the distribution of the diffusive boundary layer (DBL) at the sediment-water interface in relation to surface topography and flow velocity. The sediment, collected from saline ponds, was covered by a microbial mat that had high oxygen consumption rate and well-defined surface structure. Diffusion through the DBL constituted an important rate limitation to the oxygen uptake of the sediment. The mean effective DBL thickness decreased from 0.59 to 0.16 mm as the flow velocity of the overlying water was increased from 0.3 to 7.7 cm s-1 (measured 1 cm above the mat). The oxygen uptake rate concurrently increased from 3.9 to 9.4 nmol cm-2 min-1. The effects of surface roughness and topography on the thickness and distribution of the DBL were studied by three-dimensional mapping of the sediment-water interface and the upper DBL boundary at 0.1-mm spatial resolution. The DBL boundary followed mat structures that had characteristic dimensions > 1/2 DBL thickness but the DBL had a dampened relief relative to the mat. The effective surface area of the sediment-water interface and of the upper DBL boundary were 31 and 14% larger, respectively, than a flat plane. Surface topography thereby increased the oxygen flux across the sediment-water interface by 49% relative to a one-dimensional diffusion flux calculated from the vertical oxygen microgradients.     

Small-scale electrical resistivity tomography of wet fractured rocks

This paper describes a series of experiments that tested the ability of the electrical resistivity tomography (ERT) method to locate correctly wet and dry fractures in a meso-scale model. The goal was to develop a method of monitoring the flow of water through a fractured rock matrix. The model was a four by six array of limestone blocks equipped with 28 stainless steel electrodes. Dry fractures were created by placing pieces of vinyl between one or more blocks. Wet fractures were created by injecting tap water into a joint between blocks. In electrical terms, the dry fractures are resistive and the wet fractures are conductive. The quantities measured by the ERT system are current and voltage around the outside edge of the model. The raw ERT data were translated to resistivity values inside the model using a three-dimensional Occam's inversion routine. This routine was one of the key components of ERT being tested. The model presented several challenges. First, the resistivity of both the blocks and the joints was highly variable. Second, the resistive targets introduced extreme changes the software could not precisely quantify. Third, the abrupt changes inherent in a fracture system were contrary to the smoothly varying changes expected by the Occam's inversion routine. Fourth, the response of the conductive fractures was small compared to the background variability. In general, ERT was able to locate correctly resistive fractures. Problems occurred, however, when the resistive fracture was near the edges of the model or when multiple fractures were close together. In particular, ERT tended to position the fracture closer to the model center than its true location. Conductive fractures yielded much smaller responses than the resistive case. A difference-inversion method was able to correctly locate these targets.     

Does sedimentary organic delta 13C record variations in quaternary ocean [CO2(aq)]?

Ocean surface water [CO2(aq)] variations based on glacial/interglacial changes in sediment delta 13Corg are shown to compare favorably with reconstructions based on ice core [CO2]. In particular, an approximate 80 microatmospheres increase in atmospheric pCO2 during the last glacial-interglacial transition is calculated to correspond to a 3-4 micromolar increase in ocean surface water [CO2(aq)] at atmospheric equilibrium. A widespread marine delta 13Corg decrease of 1-2% accompanied this event and was not preceded by an equivalent isotopic change in surface water total dissolved inorganic carbon. These observations support the hypothesis that [CO2(aq)] influences photosynthetic isotope fractionation between marine inorganic and organic carbon pools, and therefore that plankton/sediment delta 13Corg may serve as a proxy for surface water [CO2(aq)].     

Effect of wharves on intertidal assemblages on seawalls in Sydney Harbour, Australia

Worldwide, urbanisation has resulted in extensive replacement of natural habitats with man-made habitats. In Sydney Harbour, Australia, approximately half of the natural foreshore has been replaced by seawalls. Many of these have wharves built over part of their length, which could affect intertidal assemblages on seawalls beneath the wharves. This was tested by sampling and comparing assemblages under and not under wharves in Sydney Harbour. Assemblages differed between the two habitats, with greater cover of macro-algae and abundance of grazing molluscs on seawalls without a wharf and, to a lesser extent, greater cover of sessile invertebrates on seawalls under a wharf. There was, however, considerable spatial variability among locations in composition of assemblages and the species dominating differences between the two habitats. The impact of multiple artificial structures in close proximity and the variability among apparently homogeneous artificial habitats must be considered for the management of urbanised estuaries.