Sources and sinks of sea salt in a newfoundland blanket bog

Over an oceanic peatland, the concentration of Na in fog averaged 38.1 mgl^?1 compared with 1.8 mgl^?1 in rain, resulting in a significant flux of mineral elements to the surface. Between 16 May and 20 June 1990 the average mass flux of Na to the bog surface by fog, rain, and dry deposition was 21.9, 10.4 and 7.0 mg m^?2 d^?1. There was little long-term storage of Na within the peatland system, where Na losses measured in stream runoff averaged 34.8 mg m² d^?1, and deep groundwater losses 4 mg m^?2 d^?1. Calcium and Mg were preferentially retained in the organic soil, whereas K was relatively mobile. Potassium tended to become concentrated in the unsaturated zone. Stream runoff had a consistently higher pH than groundwater, corresponding to higher Ca and Mg concentrations, which may have been from mineral sources in the headwater ponds. Otherwise, the stream water chemistry was closely related to groundwater in the upper layers of the peat deposit.     

Comparison of results from several AOGCMs for global and regional sea-level change 1900–2100

 Sea-level rise is an important aspect of climate change because of its impact on society and ecosystems. Here we present an intercomparison of results from ten coupled atmosphere-ocean general circulation models (AOGCMs) for sea-level changes simulated for the twentieth century and projected to occur during the twenty first century in experiments following scenario IS92a for greenhouse gases and sulphate aerosols. The model results suggest that the rate of sea-level rise due to thermal expansion of sea water has increased during the twentieth century, but the small set of tide gauges with long records might not be adequate to detect this acceleration. The rate of sea-level rise due to thermal expansion continues to increase throughout the twenty first century, and the projected total is consequently larger than in the twentieth century; for 1990–2090 it amounts to 0.20–0.37 m. This wide range results from systematic uncertainty in modelling of climate change and of heat uptake by the ocean. The AOGCMs agree that sea-level rise is expected to be geographically non-uniform, with some regions experiencing as much as twice the global average, and others practically zero, but they do not agree about the geographical pattern. The lack of agreement indicates that we cannot currently have confidence in projections of local sea-level changes, and reveals a need for detailed analysis and intercomparison in order to understand and reduce the disagreements. Received: 1 September 2000 / Accepted: 20 April 2001     

Grain boundary diffusion in enstatite

We have investigated grain boundary diffusion rates in enstatite by heating single crystals of quartz packed in powdered San Carlos olivine (Mg_0.90Fe_0.10)₂SiO₄ at controlled oxygen fugacities in the range 10^?5.7 to 10^?8.7?atm and temperatures from 1350° to 1450?°C for times from 5 to 100?h at 1?atm total pressure. Following the experiments, the thickness of the coherent polycrystalline reaction rim of pyroxene that had formed between the quartz and olivine was measured using backscatter scanning imaging in the electron microprobe. Quantitative microprobe analysis indicated that the composition of this reaction phase is (Mg_0.92Fe_0.08)₂Si₂O₆. The rate of growth of the pyroxene increases with increasing temperature, is independent of the oxygen fugacity, and is consistent with a parabolic rate law, indicating that the growth rate is controlled by ionic diffusion through the pyroxene rim. Microstructural observations and platinum marker experiments suggest that the reaction phase is formed at the olivine-pyroxene interface, and is therefore controlled by the diffusion of silicon and oxygen. The parabolic rate constants determined from the experiments were analyzed in terms of the oxide activity gradient across the rim to yield mean effective diffusivities for the rate-limiting ionic species, assuming bulk transport through the pyroxene layer. These effective diffusivities are faster than the lattice diffusivities for the slowest species (silicon) calculated from creep experiments, but slower than measured lattice diffusivities for oxygen in enstatite. Thus, silicon grain boundary diffusion is most likely to be the rate-limiting process in the growth of the pyroxene rims. Also, as oxygen transport through the pyroxene rims must be faster than silicon transport, diffusion of oxygen along the grain boundaries must be faster than through the lattice. The grain boundary diffusivity for silicon in orthopyroxenite is then given by D¯gbSiδ=(3.3±3.0)×10^?9f0.0O₂e^?400±65/RT?m³s^?1, where the activation energy for diffusion is in kJ/mol, and δ is the grain boundary width in m. Calculated growth rates for enstatite under these conditions are significantly slower than predicted by an extrapolation from similar experiments performed at 1000?°C under high pressure (hydrous) conditions by Yund and Tullis (1992), perhaps due to water-enhancement of diffusion in their experiments.     

An experimental study in forming a long synthetic aperture at sea

The testing of a synthetic aperture technique, the ETAM algorithm, is extended and its performance for CW pseudorandom signals and broadband ship noise is examined. The results show the limitations of the technique and are of special interest for operational systems development. In the CW experiments, the transmitted signal was generated with high temporal coherence, and loss of the spatial and temporal coherence of the received signal was introduced only by the medium and the stability of the towed array. In the experiments that included the pseudorandom signal and the ship noise, the temporal coherence of the transmitted signals was deliberately chosen to be poor in order to study the effects and the performance of this algorithm with broadband signals. The related experimental results show that for received signals, which have their segments over the synthesizing period highly cross-correlated, a synthetic aperture array gain was achieved that corresponds to the length of an equivalent fully populated array     

A techno-economic comparison of power systems for autonomousunderwater vehicles

This paper compares lead-acid batteries, sodium-sulfur batteries, solid polymer fuel cells and closed-cycle diesel engines for autonomous underwater vehicle (AUV) applications. The service is described in terms of a parametric mission and life cycle. A generic AUV is used as a basis for comparison. Power systems are evaluated by two criteria: (1) submerged endurance capability and (2) life cycle cost. This study determines categories of service for which each power system is preferred. The solid polymer fuel cell can provide greater submerged endurance than other power systems examined. For extremely long duration AUV missions, the fuel cell is the required system, indicating a possible market niche for today's fuel cell technology. Considering cost projections for each power system, the results also show that the SPFC can become cost-competitive with conventional technologies, particularly for services characterized by high levels of utilization     

Metamorphic evolution of exhumed middle to lower crustal rocks in the Mojave Extensional Belt, southern California, USA

The Waterman Metamorphic Complex of the central Mojave Desert was exposed as a consequence of early Miocene detachment-dominated extension. However, it has evidence consistent with a more extensive geological history that involves collision of a crustal fragment(s), tectonic thickening by overthrusting and two periods of extension. The metamorphic complex contains granitoid intrusives and felsic mylonitic gneisses as well as polymetamorphic rocks that include marble, calc-silicate, quartzite. mafic granulite, pyribolite, amphibolite, migmatite and biotite schist. The latter group of rocks was affected by an initial series of high-grade metamorphic events (M1 and M2) and a localized lower grade overprint (M3). The initial metamorphism (M1) can be separated into two stages along its high-grade P–T path: M1a, a granulite facies metamorphism at 800–850° C and 7.5–9 kbar and Mlb, an upper amphibolite facies overprint at 750–800° C and 10–12 kbar. M1a developed mineral assemblages and textures consistent with granulite facies conditions at a reduced activity of H₂O and is associated with intense ductile deformation (D1) and minor local partial melting. M1b overprinted the granulite assemblages with a series of hydrous phases under conditions of increasing pressure and H₂O activity and is accompanied by little or no deformation. M2 developed at lower pressures and temperatures (650–750° C, 4.5–5.5 kbar) and is distinguished by a second local overprint of hydrous phases that reflects an input of aqueous fluids probably associated with the intrusion of a series of granitic dykes and veins. Effects of M3 are confined to the Mitchel detachment zone, an anastomosing early Miocene detachment fault, and are characterized by local ductile/brittle deformation (D2) of the pre-existing high-grade rocks and granitoid intrusives and by the production of mylonites and mylonitic gneisses under greenschist facies conditions (300–350° C, 3–5 kbar). The initial overprint (M1a) represents metamorphism, devolatilization and minor partial melting of supracrustal rocks under granulite facies conditions as a consequence of tectonic and, possibly, magmatic thickening. The increasing pressure transition of M1a to M1b reflects a period of continued compressional tectonism, thrusting and influx of H₂O, in part, locally related to crystallization of partial melts. The near isothermal decompression between M1b and M2 probably represents a pre-112-Ma extensional episode that may have been the result of a decompressional readjustment of a thickened crust. Following the initial extensional event, the metamorphic complex remained at depths of 10–17 km for at least 90 Ma until it was uplifted following Miocene extension. M3 develops locally in response to this second extensional period resulting from the early Miocene detachment faulting.     

Multiple-source localization using GPS technology and receivedarrival time structure analysis in an air-deployed system

An efficient and robust method has been developed to locate multiple impulsive sources in an ocean environment. Global position system (GPS) receivers were installed on sonobuoys to obtain their locations within a few meters of accuracy. A sonobuoy field was deployed in a ring-type pattern. Charges were then set off at arbitrary locations within the ring, High-resolution plots were used to obtain direct path and/or first bottom bounce arrivals on each buoy. A model grid of arrival times was constructed, corresponding to the dimensions of the buoy field. A ray model previously developed here at the Applied Research Laboratories at the University of Texas at Austin (ARL:UT) was used to obtain model travel times. The minimum value of the least-square-type error between the real arrival times and the modeled travel times resulted in an unambiguous location of the source, within the limits of the grid spacing chosen. This value was calculated by picking one receiver as the reference and then summing the timing errors of the remaining receivers relative to the reference. Successive iterations with finer grid spacings result in source localization within the accuracy of the buoy locations. The localization routine was extended by allowing permutations of the pulse arrivals on each buoy to account for multiple sources closely separated in time and/or space. An automated correlation technique is presented as an alternative to the leading edge-detection method used here for obtaining relative arrival times. Two proof-of-concept experiments were performed and some results of data obtained at Lake Travis and the Gulf of Mexico are presented     

Recurrent Red-tides in the Southampton Water Estuary Caused by the Phototrophic CiliateMesodinium rubrum

In the Southampton Water estuary (southern England, U.K.), red-tides caused by the planktonic, phototrophic ciliateMesodinium rubrum(=Myrionecta rubra) occur during most summers and sometimes in autumn. These events were investigated in detail between 1985 and 1987 and were characterized by levels of chlorophylla(chl a) of over 100 μg l⁻¹, cell numbers ofM. rubrumof over 1×10³ ml⁻¹, oxygen saturations of around 150%, and depleted numbers of macrozooplankton. Initiation of red-water did not appear to be triggered by irradiance or nutrients, but coincided with an increase in temperature and water column stability. This enhanced stability was promoted by increased surface to bottom gradients of both temperature and salinity, and by reduced mixing during neap tides. Development of red-water was accompanied by removal of most of the dissolved NH⁺₄from the water column, whereas some NO⁻₃persisted, presumably maintained by freshwater input. NO⁻₃and NH⁺₄gradually returned to pre-bloom concentrations as the red-water declined in late summer. Maximal biomass ofM. rubrumappeared to be limited by irradiance, and self-shading probably imposed an upper limit of around 300 mg chl a m⁻²within the water column. At the observed levels of chl a, irradiance values within the population maximum between 1 and 3 m depth were only just of the order (≈15 μmol photons m⁻² s⁻¹) required to balance estimated respiratory demands. Oxygen concentration became undersaturated during the late bloom phase, with minimal values of 20–30% saturation recorded in deeper waters; however, despite this and reduced numbers of macrozooplankton, direct deleterious effects on other organisms were not observed.     

Trace-element contents and cathodoluminescence of “trapiche” rubies from Mong Hsu, Myanmar (Burma): geological significance

Summary ?Mong Hsu rubies of the “trapiche” type are sporadically seen in the gem market. However, they have never been described in the field. The study of the nature of solid inclusions, the variation of trace-element contents, as well as the cathodoluminescence behaviour of six “trapiche” rubies permit the conclusion that these rubies crystallised in the same geological environment (marble-type deposit) as the normal rubies from Mong Hsu: (1) Cr and V are the main chromophorous elements in both ruby types; they act, together with Ti, as activators or quenchers for cathodoluminescence; (2) calcite, dolomite, rutile, mica, diaspore, apatite, chlorite, and feldspar are solid inclusions found in both ruby types; (3) the presence of bastn?site in trapiche ruby and fluorite in non-trapiche ruby indicates the circulation of F-bearing fluids during ruby deposition; (4) the distribution of trace-element contents in the crystal is similar for both ruby types. In the Cr₂O₃ vs. Fe₂O₃ and Cr₂O₃ vs. Fe₂O₃/TiO₂ diagrams, the population fields of Mong Hsu “trapiche” and non-“trapiche” rubies overlap. They are distinct from those of rubies and sapphires hosted in basalts from South-east Asia. Received October 30, 2001; revised version accepted March 25, 2002     

A 2000-YEAR CONTEXT FOR MODERN CLIMATE CHANGE

ABSTRACT. Although considerable attention has been paid to the record of temperature change over the last few centuries, the range and rate of change of atmospheric circulation and hydrology remain elusive. Here, eight latitudinally well-distributed (pole-equator-pole), highly resolved (annual to decadal) climate proxy records are presented that demonstrate major changes in these variables over the last 2000 years. A comparison between atmospheric ¹⁴C and these changes in climate demonstrates a first-order relationship between a variable Sun and climate. The relationship is seen on a global scale.