Photometry of pluto in the last decade and before: evidence for volatile transport?

Photometric observations of Pluto in the BVR filter system were obtained in 1999 and in 1990-1993, and observations in the 0.89-μm methane absorption band were obtained in 2000. Our 1999 observations yield lightcurve amplitudes of 0.30 ± 0.01, 0.26 ± 0.01, and 0.21 ± 0.02 and geometric albedos of 0.44 ± 0.04, 0.52 ± 0.03, and 0.58 ± 0.02 in the B, V, and R filters, respectively. The low-albedo hemisphere of Pluto is slightly redder than the higher albedo hemisphere. A comparison of our results and those from previous epochs shows that the lightcurve of Pluto changes substantially through time. We developed a model that fully accounts for changes in the lightcurve caused by changes in the viewing geometry between the Earth, Pluto, and the Sun. We find that the observed changes in the amplitude of Pluto’s lightcurve can be explained by viewing geometry rather than by volatile transport. We also discovered a measurable decrease since 1992 of ∼0.03 magnitudes in the amplitude of Pluto’s lightcurve, as the model predicts. Pluto’s geometric albedo does not appear to be currently increasing, as our model predicts, although given the uncertainties in both the model and the measurements of geometric albedo, this result is not firm evidence for volatile transport. The maximum of methane-absorption lightcurve occurs near the minimum of the BVR lightcurves. This result suggests that methane is more abundant in the brightest regions of Pluto. Pluto’s phase coefficient exhibits a color dependence, ranging from 0.037 ± 0.01 in the B filter to 0.032 ± 0.01 in the R filter. Pluto’s phase curve is most like those of the bright, recently resurfaced satellites Triton and Europa. Although Pluto shows no strong evidence for volatile transport now (unlike Triton), it is important to continue to observe Pluto as it moves away from perihelion.     

Speckle interferometry observations of asteroids at tng

The Speckle camera of the 3.5 m Telescopio Nazionale Galileo (TNG) has been used to measure apparent sizes and shapes of a number of main belt asteroids. The average size measurements are in a generally good agreement with the results of indirect IRAS-based radiometric techniques. The measured shapes are compared with predictions based on previously derived spin axis directions and lightcurve photometry of some of the observed objects. Also in this case the agreement is reasonable and the speckle observations allow us to discriminate in some cases between the two pole solutions usually found for each object. No clear evidence of binaries was found. The results show that the TNG speckle camera can be a powerful tool to resolve relatively large main belt asteroids and to calibrate the results of the IRAS survey.     

Mesoscale linear streaks on Mars: environments of dust entrainment

Variable surface albedo features on Mars are likely caused by the entrainment and deposition of dust by the wind. Most discrete markings are associated with topographic forms or with regional slopes that serve to alter the effective wind shear stress on the surface. Some of the largest variable features, here termed mesoscale linear streaks, are up to 400 km in length and repeatedly occur in one of the smoothest regions of Mars: Amazonis Planitia. Their orientations and apparent season of variability as observed by Viking and Mars Orbiter cameras indicate linear streak formation by enhanced surface wind stresses during regional or local dust storms and during the initial stages of global dust storms. They provide an example of the ability of large-scale winds, without significant local enhancement, to initiate dust motion on Mars. The sizes and spacing of the linear streaks may be controlled by boundary layer rolls. The repetitive formation of these streaks, over a span of more than 11 Mars years, gives one measure of the stability of Mars’ eolian processes.     

Size and shape evolution of pores in a viscoplastic matrix under compression

The frequent use of soils and earth materials for hydraulic capping and for geo‐environmental waste containment motivated our interest in detailed modelling of changes in size and shape of macro‐pores to establish links between soil mechanical behaviour and concurrent changes in hydraulic and transport properties. The objective of this study was to use finite element analysis (FEA) to test and extend previous analytical solutions proposed by the authors describing deformation of a single macro‐pore embedded in linear viscoplastic soil material subjected to anisotropic remote stress. The FEA enables to consider more complex pore geometries and provides a detailed picture of matrix yield behaviour to explain shortcomings of approximate analytical solutions. Finite element and analytical calculations agreed very well for linear viscous as well as for viscoplastic materials, only limited for the case of isotropic remote stress due to the simplifications of the analytical model related to patterns and onset of matrix‐yielding behaviour. FEA calculations were compared with experimental data obtained from a compaction experiment in which pore deformation within a uniform modelling clay sample was monitored using CAT scanning. FEA predictions based on independently measured material properties and initial pore geometry provided an excellent match with experimentally determined evolution of pore size and shape hence lending credence to the potential use of FEA for more complex pore geometries and eventually connect macro‐pore deformation with hydraulic properties. Copyright © 2006 John Wiley & Sons, Ltd.     

The petrogenesis of type B1 Ca‐Al‐rich inclusions: The spinel perspective

Abstract— Minor element variations in MgAl₂O₄ spinel from the type B1 calcium‐aluminum‐rich inclusion (CAI) Allende TS‐34 confirm earlier studies in showing correlations between the minor element chemistry of spinels with their location within the inclusion and with the chemistry of host silicate phases. These correlations result from a combination of crystallization of a liquid produced by re‐melting event(s) and local re‐equilibration during subsolidus reheating. The correlation of the Ti and V in spinel inclusions with the Ti and V in the adjacent host clinopyroxene can be qualitatively explained by spinel and clinopyroxene crystallization prior to melilite, following a partial melting event. There are, however, difficulties in quantitative modeling of the observed trends, and it is easier to explain the Ti correlation in terms of complete re‐equilibration. The correlation of V in spinel inclusions with that in the adjacent host clinopyroxene also cannot be quantitatively modeled by fractional crystallization of the liquid produced by re‐melting, but it can be explained by partial re‐equilibration. The distinct V and Ti concentrations in spinel inclusions in melilite from the edge regions of the CAI are best explained as being affected by only a minor degree of re‐equilibration. The center melilites and included spinels formed during crystallization of the liquid produced by re‐melting, while the edge melilites and included spinels are primary. The oxygen isotope compositions of TS‐34 spinels are uniformly ¹⁶O‐rich, regardless of the host silicate phase or its location within the inclusion. Similar to other type B1 CAIs, clinopyroxene is ¹⁶O‐rich, but melilite is relatively ¹⁶O‐poor. These data require that the oxygen isotope exchange in TS‐34 melilite occurred subsequent to the last re‐melting event.     

Resonant and Secular Families of the Kuiper Belt

We review ongoing efforts to identify occupants of mean-motion resonances(MMRs) and collisional families in the Edgeworth–Kuiper belt. Directintegrations of trajectories of Kuiper belt objects (KBOs) reveal the 1:1(Trojan), 5:4, 4:3, 3:2 (Plutino), 5:3, 7:4, 9:5, 2:1 (Twotino), and 5:2 MMRsto be inhabited. Apart from the Trojan, resonant KBOs typically have largeorbital eccentricities and inclinations. The observed pattern of resonanceoccupation is consistent with resonant capture and adiabatic excitation bya migratory Neptune; however, the dynamically cold initial conditions priorto resonance sweeping that are typically assumed by migration simulationsare probably inadequate. Given the dynamically hot residents of the 5:2 MMRand the substantial inclinations observed in all exterior MMRs, a fraction ofthe primordial belt was likely dynamically pre-heated prior to resonancesweeping. A pre-heated population may have arisen as Neptune gravitationallyscattered objects into trans-Neptunian space. The spatial distribution of Twotinosoffers a unique diagnostic of Neptune's migration history. The Neptunian Trojanpopulation may rival the Jovian Trojan population, and the former's existence isargued to rule out violent orbital histories for Neptune. Finally, lowest-order seculartheory is applied to several hundred non-resonant KBOs with well-measured orbitsto update proposals of collisional families. No convincing family is detected.     

In-Orbit Vignetting Calibrations of XMM-Newton Telescopes

We describe measurements of the mirror vignetting in the XMM-Newton Observatory made in-orbit, using observations of SNR G21.5-09 and SNR 3C58 with the EPIC imaging cameras. The instrument features that complicate these measurements are briefly described. We show the spatial and energy dependences of measured vignetting, outlining assumptions made in deriving the eventual agreement between simulation and measurement. Alternate methods to confirm these are described, including an assessment of source elongation with off-axis angle, the surface brightness distribution of the diffuse X-ray background, and the consistency of Coma cluster emission at different position angles. A synthesis of these measurements leads to a change in the XMM calibration data base, for the optical axis of two of the three telescopes, by in excess of 1 arcmin. This has a small but measureable effect on the assumed spectral responses of the cameras for on-axis targets. This revised version was published online in July 2006 with corrections to the Cover Date.     

Investigation of ion beam techniques for the analysis and exposure of particles encapsulated by silica aerogel: Applicability for Stardust

Abstract— In 2006, the Stardust spacecraft will return to Earth with cometary and perhaps interstellar dust particles embedded in silica aerogel collectors for analysis in terrestrial laboratories. These particles will be the first sample return from a solid planetary body since the Apollo missions. In preparation for the return, analogue particles were implanted into a keystone of silica aerogel that had been extracted from bulk silica aerogel using the optical technique described in Westphal et al. (2004). These particles were subsequently analyzed using analytical techniques associated with the use of a nuclear microprobe. The particles have been analyzed using: a) scanning transmission ion microscopy (STIM) that enables quantitative density imaging; b) proton elastic scattering analysis (PESA) and proton backscattering (PBS) for the detection of light elements including hydrogen; and c) proton‐induced X‐ray emission (PIXE) for elements with Z > 11. These analytical techniques have enabled us to quantify the composition of the encapsulated particles. A significant observation from the study is the variable column density of the silica aerogel. We also observed organic contamination within the silica aerogel. The implanted particles were then subjected to focused ion beam (FIB) milling using a 30 keV gallium ion beam to ablate silica aerogel in site‐specific areas to expose embedded particles. An ion polished flat surface of one of the particles was also prepared using the FIB. Here, we show that ion beam techniques have great potential in assisting with the analysis and exposure of Stardust particles.