Measurement of the spatial distribution of fluvial bedload transport velocity in both sand and gravel

Maps are presented of the spatial distribution of two‐dimensional bedload transport velocity vectors. Bedload velocity data were collected using the bottom tracking feature of an acoustic Doppler current pro?ler (aDcp) in both a gravel‐bed reach and a sand‐bed reach of Fraser River, British Columbia. Block‐averaged bedload velocity vectors, and bedload velocity vectors interpolated onto a uniform grid, revealed coherent patterns in the bedload velocity distribution. Concurrent Helley‐Smith bedload sampling in the sand‐bed reach corroborated the trends observed in the bedload velocity map. Contemporaneous 2D vector maps of near‐bed water velocity (velocity in bins centered between 25 cm and 50 cm from the bottom) and depth‐averaged water velocity were also generated from the aDcp data. Using a vector correlation coef?cient, which is independent of the choice of coordinate system, the bedload velocity distribution was signi?cantly correlated to the near‐bed and depth‐averaged water velocity distributions. The bedload velocity distribution also compared favorably with variations in depth and estimates of the spatial distribution of shear stress. Published in 2004 by John Wiley & Sons, Ltd.     

An experimental study of phase equilibria in the systems H2O–CO2–CaCl2 and H2O–CO2–NaCl at high pressures and temperatures (500–800?°C, 0.5–0.9?GPa): geological and geophysical applications

Phase equilibria in the ternary systems H₂O–CO₂–NaCl and H₂O–CO₂–CaCl₂ have been determined from the study of synthetic fluid inclusions in quartz at 500 and 800 °C, 0.5 and 0.9 GPa. The crystallographic control on rates of quartz overgrowth on synthetic quartz crystals was exploited to prevent trapping of fluid inclusions prior to attainment of run conditions. Two types of fluid inclusion were found with different density or CO₂ homogenisation temperature (T_h(CO₂)): a CO₂-rich phase with low T_h(CO₂), and a brine with relatively high T_h(CO₂). The density of CO₂ was calibrated using inclusions in the binary system H₂O–CO₂. Mass balance calculations constrain tie lines and the miscibility gap between brines and CO₂-rich fluids in the H₂O–CO₂–NaCl and H₂O–CO₂–CaCl₂ systems at 500 and 800 °C, and 0.5 and 0.9 GPa. The miscibility gap in the CaCl₂ system is larger than in the NaCl system, and solubilities of CO₂ are smaller. CaCl₂ demonstrates a larger salting-out effect than NaCl at the same P–T conditions. In ternary systems, homogeneous fluids are H₂O-rich and of extremely low salinity, but at medium to high concentrations of salts and non-polar gases fluids are unlikely to be homogeneous. The two-phase state of crustal fluids should be common. For low fluid-rock ratios the cation compositions of crustal fluids are buffered by major crustal minerals: feldspars and micas in pelites and granitic rocks, calcite (dolomite) in carbonates, and pyroxenes and amphiboles in metabasites. Fluids in pelitic and granitic rocks are Na-K rich, while for carbonate and metabasic rocks fluids are Ca-Mg-Fe rich. On lithological boundaries between silicate and carbonate rocks, or between pelites and metabasites, diffusive cation exchange of the salt components of the fluid will cause the surfaces of immiscibility to intersect, leading to unmixing in the fluid phase. Dispersion of acoustic energy at critical conditions of the fluid may amplify seismic reflections that result from different fluid densities on lithological boundaries.Editorial responsibility: I. Parsons     

Nickel speciation in Sebertia acuminata,a plant growing on a lateritic soil of New Caledonia

Nickel speciation in a nickel hyperaccumulating plant (Sebertia acuminata) and its associated soil of southern New Caledonia was studied using various analytical methods. The soil is formed of iron oxides (goethite, hematite), which contain almost all the nickel. The available nickel is probably linked to the organic matter in the litter. Sebertia acuminata, acts as a nickel pump, and concentrates the metal in its leaves. It partitions nickel and silica; nickel is concentrated in the cells (probably in the vacuoles) as organometallic complexes, whereas silica forms the framework of the cells, and the phytolithes. A thorough study of these plants seems essential in order to define the soil–plant relations, and to propose appropriate ways for ecological restoration. To cite this article: N. Perrier et al., C. R. Geoscience 336 (2004).     

A three-dimensional approach to fault seal analysis: fault-block juxtaposition & argillaceous smear modelling

Three‐dimensional (3D) numerical modelling of fault displacement enables the building of geological models to represent the complex 3D geometry and geological properties of faulted sedimentary basins. Using these models, cross‐fault juxtaposition relationships are predicted in 3D space and through time, based on the geometries of strata that are cut by faults. Forward modelling of fault development allows a 3D prediction of fault‐zone argillaceous smear using a 3D application of the Shale Gouge Ratio. Numerical models of the Artemis Field, Southern North Sea, UK and the Moab Fault, Utah, USA are used to demonstrate the developed techniques and compare them to traditional one‐ and two‐dimensional solutions. These examples demonstrate that a 3D analysis leads to significant improvements in the prediction of fault seal, the analysis of the interaction of the sealing properties of multiple faults, and the interpretation of fault seal within the context of sedimentary basin geometry.     

Detecting trends in seagrass abundance using aerial photograph interpretation: Problems arising with the evolution of mapping methods

In the late 1970s and early 1980s an inventory of seagrass distribution in southeast Australia was made from multiscale aerial photographs using a simple analog mapping method, referred to here as theCamera lucida technique. Four priority estuaries were remapped in 2003, also using multi-scale aerial photographs, but using a geographic information system (GIS)-based analog mapping technique. We quantified the degree of error that arose when estimates of seagrass distribution were compared for the two techniques be ressessing. with GIS, the same aerial photographs used earlier for four estuaries: Port Hacking, Bermagui River, Merimbula Lake, and St Georges Basin.Camera lucida produced a larger estimate of total seagrass area than GIS in all four locations: 8% of total seagrass area or 12.9 ha in Port Hacking, 15% or 5 ha in Bermagui River, 20% or 38.0 ha in Merimbula Lake, and 243% or 502.2 ha in St Georges Basin. The consistent and moderate discrepancy in Port Hacking, Bermagui River, and Merimbula Lake was attributed mainly to differences betweenCamera lucida and GIS, such as the tendency ofCamera lucida to overestimate seagrass area by amalgamating disjunct seagrass patches into continuous meadows. The large discrepancy at St Georges Basin was attributed to interoperator error; i.e., the operators who mapped photographs taken in 1979 had widely differing interpretations of the aerial photographs. A 20-yr trend was calculated for each estuary using either theCamera lucida or revised GIS value as the start point. Perceived management status of the seagrass depended greatly on the initial data used. In St Georges Basin, a catastrophic decline (65%, 553.9 ha) occurred based on theCamera lucida-GIS comparison but only a small decline (14.7%, 51.8 ha) when all photos were GIS assessed, In view of the technical developments in habitat mapping, evaluation of change in seagrass abundance using remote sensing needs an assessment of intra-operator error, inter-operator error, and systemic error before maps produced by superseded technology are considered useful baselines.     

The spectacular fossils of the ‘water margin’: the Cambrian biota of Chengjiang,Yunnan, China

Shi Nai'an's fourteenth century Chinese epic ‘Water Margin’ tells of the release of 36 heavenly spirits and 72 baleful stars from their captivity beneath a tablet of stone at Mount Longhu in Jiangxi Province. They are reincarnated as the 108 heroes of the Liangshan marsh in Shandong Province, who rise against an unjust world. The virtuous exploits of the ‘108’ were brought to life through the cathode‐ray screens of 1970s television sets, as the TV series The Water Margin introduced heroes like Lin Chong battling his evil nemesis Gao Qiu. Far to the west of Jiangxi Province and several hundred years after the Water Margin during the summer of 1984, a young scientist from Nanjing was working amongst the hills and lakes of southern Yunnan Province. He too overturned a stone slab, releasing from their half‐billion year captivity a cornucopia of new Chinese legends. His name was Xianguang Hou and he had made one of the most momentous fossil discoveries in history, uncovering the exceptionally preserved marine fossils of the Chengjiang biota from the ancient water margin of Cambrian seas.     

Primary aragonite and high‐Mg calcite in the late Cambrian (Furongian). Potential evidence from marine carbonates in Oman

Transient aragonite seas occurred in the early Cambrian but several models suggest the late Cambrian was a time of calcite seas. Here, evidence is presented from the Andam Group, Huqf High, Oman (Gondwana) that suggests a transient Furongian (late Cambrian) aragonite sea, characterized by the precipitation of aragonite and high‐Mg calcite ooids and aragonite isopachous, fibrous, cements. Stable carbon isotope data suggest that precipitation occurred just before and during the SPICE (Steptoean Positive Carbonate Isotope Excursion). Aragonite and high‐Mg calcite precipitation can be accounted for if mMg:Ca ratios were around 1.2 given the very high atmospheric CO₂ at that time and if precipitation occurred in warm waters associated with the SPICE. This, together with reported occurrences of early Furongian aragonite ooids from various locations in North America (Laurentia), suggests that aragonite and high‐Mg calcite precipitation from seawater may have been more than just a local phenomenon.     

Understory and small trees contribute importantly to stemflow of a lower montane cloud forest

Stemflow (Sf) measurements in tropical rain and montane forests dominated by large trees rarely include the understory and small trees. In this study, contributions of lower (1‐ to 2‐m height) and upper (>2‐m height and <5‐cm diameter at breast height [DBH]) woody understory, small trees (5 < DBH < 10 cm), and canopy trees (>10‐cm DBH) to Sf per unit ground area (Sf_a) of a Mexican lower montane cloud forest were quantified for 32 days with rainfall (P) during the 2014 wet season. Rainfall, stemflow yield (Sf_y), vegetation height, density, and basal area were measured. Subsequently, stemflow funneling ratios (SFRs) were calculated, and three common methods to scale up Sf_y from individual trees to the stand level (tree‐Sf_y correlation, P‐Sf_y correlation, and mean‐Sf_y extrapolation) were used to calculate Sf_a. Understory woody plants, small trees, and upper canopy trees represented 96%, 2%, and 2%, respectively, of the total density. Upper canopy trees had the lowest SFRs (1.6 ± 0.5 Standard Error (SE) on average), although the lower understory had the highest (36.1 ± 6.4). Small trees and upper understory presented similar SFRs (22.9 ± 5.4 and 20.2 ± 3.9, respectively). Different Sf scaling methods generally yielded similar results. Overall Sf_a during the study period was 22.7 mm (4.5% of rainfall), to which the understory contributed 70.1% (15.9 mm), small trees 10.6% (2.4 mm), and upper canopy trees 19.3% (4.4 mm). Our results strongly suggest that for humid tropical forests with dense understory of woody plants and small trees, Sf of these groups should be measured to avoid an underestimation of overall Sf at the stand level.