An ocean-bottom hydrophone recorder for seismic refraction experiments

A new and inexpensive pop-up ocean-bottom hydrophone recorder has been developed for use in seismic refraction experiments. It is capable of operating in water depths of up to 4000 m and in very rugged topography, and uses an acoustic command system built by the U.K. Institute of Oceanographic Sciences for recovery. The instrument is mounted in an inexpensive cylindrical pressure case based on commercially available extruded aluminium alloy tubing, and uses glass spheres and syntactic foam for buoyancy. Hydrophone and clock signals are frequency modulated and recorded on tape cassettes, with a recording duration of three hours allowing up to 18 programmed shot windows. The prototype has made seven free descents on the Mid-Atlantic ridge and in the Gulf of Oman, and successfully recorded shots under operational conditions for the first time in September 1979. The total component cost of the prototype was £2740 (1979 prices).(Department of Earth Sciences, University of Cambridge Contribution No. ES135).     

An overview and general results of the Lopez island OBS experiment

The purpose of the experiment was to determine the effects of coupling and bottom currents on ocean bottom seismometers. Twelve operational OBSs, three specially designed three-component systems, and a hydrophone were compared with each other. Unlike seismometers placed on hard rock at land stations, ocean bottom seismometers can be affected by soft sediments (which act as lossy mechanical springs) and by buoyancy. Coupling through soft sediments can modify the response to ground motion much as a low pass filter does, and high buoyancy tends to counteract this effect. These effects are observed in the Lopez data, which consist of signals from mechanical transient tests, cap shots, airgun pulses, and general background noise. The modification of response is pronounced for some instruments and barely noticeable in others. Instruments that stand high in the water relative to their base width tend to be susceptible to rocking motion that shows up as a mechanical cross coupling between horizontal and vertical motion. Correlation of Lopez results with coupling theory suggests that it is possible to design ocean bottom seismometers that will couple well to any sediment. Current levels at the Lopez site (<5 cm s^-1) were too small to produce noticeable effect on any of the instruments; however, the same design criteria that will minimize coupling problems will also lessen problems caused by ocean currents.Hawaii Institute of Geophysics Contribution No. 1171.     

The use of controlled experimental ecosystems: A review

During the past 20 years, the controlled experimental ecosystem has found wide-spread use in marine sciences. Uses have included the study of natural ecology, environmental pollution and computer model analysis. In all these roles, the experimental ecosystem serves as a model of nature and results can be used to obtain greater insight into the oceanography of the sea. Four different types of experimental apparatus are described, and experimental procedures and results are reviewed and discussed.     

Vertical migration and mortality of benthos in dredged material: Part II—crustacea

Benthic invertebrates have many characteristics which make them prime candidates for burial studies in dredged material. A major concern in dredging and disposal projects is the effect of burial on the survival of benthic invertebrates. The purpose of the research reported in this paper was to determine the ability of estuarine benthos—in particular three species of molluscs (Mercenaria mercenaria, Nucula proxima and Ilyanassa obsoleta)—to migrate vertically in natural and exotic sediments and to determine the survival of benthos when exposed to particular amounts of simulated dredged material.Mortalities generally increased with increased sediment depth, with increased burial time and with overlying sediments whose particle size distribution differed from that of the species native sediment. Temperature affected mortalities and vertical migration. It was concluded that vertical migration is a viable process which can significantly affect rehabilitation of a dredged disposal area. Under certain conditions, vertical migration should be considered, together with larval settling and immigration from outside impacted areas, as a mechanism of recruiting a dredgedump site.     

Toxicity of Santa Barbara seep oil to starfish embryos: Part 2—the growth bioassay

The asteroid Patiria miniata was used to develop a static bioassay for various crude oil water-soluble fractions (WSF). The criterion used is the size of 48-h exposed embryos. The reasons for choosing this species and the growth criterion are discussed. Experiments show that the body length of 48-h exposed embryos is inversely proportional to hydrocarbon concentration of the WSF and the time of exposure. It is also shown that the toxicity of the WSF decreases with the age of the preparation and that the first 12 h following fertilisation are most sensitive to the effects of WSF.     

Observed foundation behaviour of concrete gravity platforms installed in the North Sea 1973–1978

Available measurements of foundation behaviour of the 13 concrete gravity platforms installed in the North Sea in the years 1973–1978 are presented. The measurements cover both the installation phase and the early part of the operation period. For the installation phase, measurements of dowel and skirt penetration resistance, base contact stresses, tilt, piping and erosion, are presented. For the operation period, the presentation includes measurements of settlements, pore water pressures, base contact stresses, permanent lateral displacements, cyclic displacements, dynamic behaviour and erosion. The measurements are used to back calculate soil properties and to evaluate the adequacy of the design procedures which have been used. The observations give valuable experience with respect to the foundation performance of offshore gravity platforms.     

The status of geological dredging techniques

Scientific sea-floor dredging is currently used in marine geology primarily by the hard-rock community interested in the recovery of basement rock samples from the unsedimented deep ocean floor. The technique has generally been eclipsed by ocean drilling for recovery of sedimentary rocks, because of perceived uncertainties in the location of sampling and in the representativeness of recovered material. This contribution reviews dredging equipment currently in use by marine geological institutions and refers to pinger attachments that allow precise information on the behaviour of the dredge to be telemetered back to the ship. We argue that improvements in ship navigation and transponder navigation at the seafloor, when used in conjunction with surface and/or deeply towed sidescan and swathemapping surveys, now allow for considerably less uncertainty on the location of dredge sampling. Refined sorting criteria for dredge hauls are now also available. Recent comparisons of regional sample recovery by ocean drilling and by dredge sampling indicate that the dredge hauls can usefully supplement the drilling data in the construction of sedimentary and tectonic histories of seafloor areas.     

Aquatic surface microlayer contamination in chesapeake bay

The aquatic surface microlayer (SMIC), 50 μm thick, serves as a concentration point for metal and organic contaminants that have low water solubility or are associated with floatable particles. Also, the eggs and larvae of many fish and shellfish species float on, or come in contact with, the water surface throughout their early development. The objectives of this study were (1) to determine the present degree of aquatic surface microlayer pollution at selected sites in Chesapeake Bay, and (2) to provide a preliminary evaluation of sources contributing to any observed contamination.Twelve stations located in urban bays, major rivers, and the north central bay were sampled three times, each at 5-day intervals during May 1986. Samples of 1.4–4.1 each were collected from the upper 30–60-μm water surface (surface microlayer, SMIC) using a Teflon-coated rotating drum microlayer sampler. One sample of subsurface water was collected in the central bay.At all stations, concentrations of metals, alkanes, and aromatic hydrocarbons in the SMIC were high compared with one bulk-water sample and with typical concentrations in water of Chesapeake Bay and elsewhere. SMIC contamination varied greatly among the three sampling times, but high mean contaminant levels (total polycyclic aromatic hydrocarbons, 1.9–6.2 μg 1⁻¹; Pb, 4.9–24 μg 1⁻¹; Cu, 4–16 μg 1⁻¹; and Zn, 34–59 μg 1⁻¹) were found at the upper Potomac and northern bay sites. Three separate areas were identified on the basis of relative concentrations of different aromatic hydrocarbons in SMIC samples - the northern bay, the Potomac River, and the cleaner southern and eastern portions of the sampling area.Suspected sources of surface contamination include gasoline and diesel fuel combustion, coal combustion, and petroleum product releases. Concentrations of metals and hydrocarbons, at approximately half the stations sampled, are sufficient to pose a threat to the reproductive stages of some fish and shellfish. Sampling and analysis of the surface microlayer provides a sensitive tool for source identification and monitoring of potentially harmful aquatic pollution.     

Hydrography and phytoplankton of waters off south-west Ireland

Distributions of physical, chemical and biological characteristics were recorded for coastal waters off south-west Ireland during the summers of 1985–1987. A number of thermal fronts were identified from both shipboard measurements and satellite imagery. Upwelling was shown to be an important process in the area and enhanced phytoplankton biomass and productivity were associated with areas of upwelling and the fronts. Phytoplankton species composition, although varying between cruises, was associated with differences in hydrographic features.     

Low-frequency damping of a moored semisubmersible obtained from simulated extinction tests and mean wave drift forces

Low-frequency damping of a moored semisubmersible drilling platform was obtained from numerical extinction tests simulated in still water and in regular waves and from mean wave drift forces calculated at zero forward speed. The influence of drag forces was represented by the modified Morison equation. The platform as used for the 18th ITTC Comparative Mooring Study was analyzed in irregular beam waves. The computed time series of sway as well as the corresponding sway response spectrum compared favourably with model test measurements, demonstrating that this procedure to determine low-frequency damping can be effective.