Development of FBMINC model for particle diffusion in fluids

An accurate particle tracking method using FBMINC （new fractional Brownian motion） is outlined. It generates non-Fickian diffusion rather than Fickian diffusion as traditional particle tracking model does. The FBMINC model is based on fractional Brownian motion （fl3m） which is generalization of regular Brownian motion. The two models of fBms （FBM model and FBMINC model） were explored and the differences of the two models are compared from the three aspects： the standard deviation of each step, the small memory and the effect of the number of particles in the cloud. The results show the FBMINC model is a better model as it produces more accurate statistics. The effect of simple shear dispersion for both Brownian and fBm was investigated. The power law scaling of fBm shear dispersion was correctly identified. In addition, a scaling coettieient was found numerically. The FBMINC model is then used for producing both superdiffusive and subdiffusive particle paths, therefore, the non-Fickian diffusion of soil particle clouds can be modelled. The particle clouds represent soil contaminant are released in an idealised coastal bay and the fBm particle tracking method is used for simulation the particle cloud spreading in the bay. There is a noticeable increase in the spreading rate of the cloud. In addition, owning to the spreading rate of the cloud, a noticeable part of it has escaped the bay area and transported downstream. The variation of the Hurst exponent can lead to an area of the flow being affected by a contaminant cloud which is not picked up by the regular Brownian motion models. The purpose of this paper is to bring soil transport engineers a new angle on soil particle transport research in fluids. Using FBM1NC particle tracking model allows more flexibility in simulation of diffusion in soil contaminant spread in coastal bay or ocean surface.     

甘肃省花海盆地土壤氡分布特征及控制因素研究

花海盆地位于甘肃省走廊盆地群西缘,是中国深部铀资源勘探的重要潜力区之一。根据对土壤氡气浓度信息提取和野外勘探钻探成果分析,花海盆地土壤氡浓度可分为东部正常场-偏高场氡晕和西部偏高-高场晕氡晕;下白垩统下沟组（K1x）砂岩层段为本区铀矿化有利层位,建议在西部、南部土壤氡气偏高-高场晕氡晕过渡带追索层铀矿化带,寻找有利靶区。     

一种基于点特征的高精度图像配准方法

提出了一种基于点特征的多源图像高精度配准方法。通过在遥感影像上提取密集特征点,利用多种方法结合进行严格匹配获得同名点对。通过构建不规则三角网分割影像,再利用仿射变换模型实现每个三角形的配准。实验证明了该方法的有效性和较高的适用性。     

巴颜喀拉山东段及其邻区大地电磁测深成果地质解释

本文主要依据青海省囊歉至大河坝大地电磁测深成果,并结合重力资料对巴颜喀拉及南北两侧地区的壳幔结构进行了地质解释。指出了该区壳幔存在4个明显的低阻层,并简述了它们的形态特征,推断了其地质含意。认为昆中断裂带与昆南断裂带间是一个巨大的构造混杂岩带,影响深度亦很大。推断该区可能存在太古代地层。划出了8条壳幔断裂带,认为昆中断裂应是塔里木—华北板块与华南板块的分界线。     

南华北盆地青白口系—侏罗系层序界面时空分布特征研究

以位于秦岭—大别造山带之北、华北陆块南部、地跨华北陆块稳定块体、陆块南部边缘变形带的南华北盆地为研究对象,通过对研究区42条不同时代的野外剖面详细观测,运用层序地层学理论,把南华北盆地作为一个整体系统,对青白口系—侏罗系层序界面特征及时空分布规律进行了系统分析,共识别出了8种类型层序界面的物质表现形式,分别是不整合面、渣状层、古喀斯特作用面、冲刷侵蚀面、超覆面、岩性岩相转换面、最大海泛面、最大湖泛面。并重点讨论了各类型界面的时空分布特征。结果表明:在时间演化上,从早到晚由海相—海陆过渡相—陆相,层序界面经历了海相沉积不整合、古喀斯特作用面、渣状层到陆相不整合面、冲刷侵蚀面等;在空间上,同一层序界面在不同相带表现形式不同,同一种类型的界面可在不同相带出现,但不同相带表现特征有一定差异性。     

Estimation of non-CO2 GHGs emissions by analyzing burn severity in the Samcheok fire, South Korea

This study was performed to estimate the emission of non-CO 2 greenhouse gases(GHGs) from biomass burning at a large fire area.The extended methodology adopted the IPCC Guidelines(2003) equation for use on data from the Samcheok forest fire gathered using 30 m resolution Landsat TM satellite imagery,digital forest type maps,and growing stock information per hectare by forest type in 1999.Normalized burn ratio(NBR) technique was employed to analyze the area and severity of the Samcheok forest fire that occurred in 2000.The differences between NBR from pre-and post-fire datasets are examined to determine the extent and degree of change detected from burning.The results of burn severity analysis by dNBR of the Samcheok forest fire area revealed that a total of 16,200 ha of forest were burned.The proportion of the area characterized by a ’Low’ burn severity(dNBR below 152) was 35%,with ’Moderate’(dNBR 153-190) and ’High’(dNBR 191-255) areas were at 33% and 32%,respectively.The combustion efficiency for burn severity was calculated as 0.43 for crown fire where burn severity was ’High’,as 0.40 for ’Moderate’ severity,and 0.15 for ’Low’ severity surface fire.The emission factors for estimating non-CO 2 GHGs were separately applied to CO 130,CH 4 9,NO x 0.7 and N 2 O 0.11.Non-CO 2 GHGs emissions from biomass burning in the Samcheok forest fire area were estimated to be CO 44.100,CH 4 3.053,NO x 0.238 and N 2 O 0.038 Gg.     

航空重力测量中牛顿中心差分器对确定载体加速度的影响

讨论不同点数的牛顿中心差分器对航空重力测量中确定载体加速度的影响。理论分析表明,当航空重力测量的有效频段位于牛顿中心差分器的通带时,不同点数的牛顿中心差分器所得结果经低通滤波后几乎没有差异。实验表明,当采样间隔为1 s、载体平均速度为155 m/s、所需重力数据的分辨率为10 km时,低通滤波后不同点数的牛顿中心差分器输出结果之间的较差优于2.1 mGal。     

Omni-directional distribution patterns of montane coniferous forest in the Helan Mountains of China

Slope aspect has significant effect on the development and distribution of montane forest,especially in arid and semiarid regions.This paper,using SPOT5 images and 1:50,000 DEM,digitally extracts and analyzes the spatial information of montane coniferous forest(mainly Qinghai spruce),and thereby explores how the upper and lower limits and the altitudinal range of coniferous forest vary and how the area of coniferous forest is related with annual insolation with all aspects in the Helan Mountains.The results show that: 1) In the eastern flank,the lower limit of coniferous forest is between 1,600 m and 2,000 m a.s.l.,and the upper limit between 2,800 m and 3,000 m a.s.l.;in the western flank,the lower limit of coniferous forest is between 2,000 m and 2,300 m a.s.l.,and the upper limit between 2,800 m and 3,100 m a.s.l.2) The altitudinal ranges of coniferous forest are 806~1,435 m,438~1,140 m for eastern flank and western flank,respectively.3) The area of coniferous forest takes on a normal distribution with aspect,and it has a close relationship with annual insolation.This distribution model developed in this paper quantitatively reveals the significant effect of slope aspect on the distribution of coniferous forest in arid and semi-arid land.     

一种程控宽频带多波形信号发生器的研制

针对目前专门的函数信号发生器IC功能简单、精度不高、调节方式不灵活等缺点和DDS芯片外围电路设计复杂、成本较高等问题,设计研制了一种程控宽频带多波形信号发生器。该信号发生器采用单片机STC89C52控制专用函数发生器MAX038实现,通过键盘设置输出波形类型、频率、占空比和幅度等各种参数,采用闭环控制方法对输出频率自动反馈控制以提高频率精度,并由八位LED显示器实时显示状态信息。实际运行结果表明:该系统可以产生频率范围在1Hz~20MHz、幅度在2~10V(VPP)连续可调、占空比在10%~90%变化的三角波、锯齿波、方波、正弦波和PWM波,输出频率精度小于0.01%。该仪器具有电路结构简单、性能优良、成本低廉、功能多样、使用方便等优点,在生产实践和科技研究领域中具有广泛的应用前景。