Coastal erosion vs riverine sediment discharge in the Arctic Shelf seas

This article presents a comparison of sediment input by rivers and by coastal erosion into both the Laptev Sea and the Canadian Beaufort Sea (CBS). New data on coastal erosion in the Laptev Sea, which are based on field measurements and remote sensing information, and existing data on coastal erosion in the CBS as well as riverine sediment discharge into both the Laptev Sea and the CBS are included. Strong regional differences in the percentages of coastal erosion and riverine sediment supply are observed. The CBS is dominated by the riverine sediment discharge (64.45᎒⁶ t a^-1) mainly of the Mackenzie River, which is the largest single source of sediments in the Arctic. Riverine sediment discharge into the Laptev Sea amounts to 24.10᎒⁶ t a^-1, more than 70% of which are related to the Lena River. In comparison with the CBS, the Laptev Sea coast on average delivers approximately twice as much sediment mass per kilometer, a result of higher erosion rates due to higher cliffs and seasonal ice melting. In the Laptev Sea sediment input by coastal erosion (58.4᎒⁶ t a^-1) is therefore more important than in the CBS and the ratio between riverine and coastal sediment input amounts to 0.4. Coastal erosion supplying 5.6᎒⁶ t a^-1 is less significant for the sediment budget of the CBS where riverine sediment discharge exceeds coastal sediment input by a factor of ca. 10.     

A cross-ecosystem comparison of spatial and temporal patterns of covariation in the recruitment of functionally analogous fish stocks

Temporal and spatial patterns of recruitment (R) and spawning stock biomass (S) variability were compared among functionally analogous species and similar feeding guilds from six marine ecosystems. Data were aggregated into four regions including the Gulf of Maine/Georges Bank, the Norwegian/Barents Seas, the eastern Bering Sea, and the Gulf of Alaska. Variability was characterized by calculating coefficients of variation and anomalies for three response variables: ln(R), ln(R/S), and stock–recruit model residuals. Patterns of synchrony and asynchrony in the response variables were examined among and between ecosystems, between- and within-ocean basins and among functionally analogous species groups using pair-wise correlation analysis corrected for within-time series autocorrelation, multivariate cross-correlation analyses and regime shift detectors. Time series trends in response variables showed consistent within basin similarities and consistent and coherent differences between the Atlantic and Pacific basin ecosystems. Regime shift detection algorithms identified two broad-scale regime shift time periods for the pelagic feeding guild (1972–1976 and 1999–2002) and possibly one for the benthic feeding guild (1999–2002). No spatial patterns in response variable coefficients of variation were observed. Results from multivariate cross-correlation analysis showed similar trends. The data suggest common external factors act in synchrony on stocks within ocean basins but temporal stock patterns, often of the same species or functional group, between basins change in opposition to each other. Basin-scale results (similar within but different between) suggest that the two geographically broad areas are connected by unknown mechanisms that, depending on the year, may influence the two basins in opposite ways. This work demonstrates that commonalities and synchronies in recruitment fluctuations can be found across geographically distant ecosystems but biophysical causes of the fluctuations remain difficult to identify.     

Ilmenite composition in the Tellnes Fe–Ti deposit,SW Norway: fractional crystallization,postcumulus evolution and ilmenite–zircon relation

Major and trace element XRF and in situ LA-ICP-MS analyses of ilmenite in the Tellnes ilmenite deposit, Rogaland Anorthosite Province, SW Norway, constrains a two stage fractional crystallization model of a ferrodioritic Fe-Ti-P rich melt. Stage 1 is characterized by ilmenite-plagioclase cumulates, partly stored in the lower part of the ore body (Lower Central Zone, LCZ), and stage 2 by ilmenite-plagioclase-orthopyroxene-olivine cumulates (Upper Central Zone, UCZ). The concentration of V and Cr in ilmenite, corrected for the trapped liquid effect, (1) defines the cotectic proportion of ilmenite to be 17.5 wt% during stage 1, and (2) implies an increase of D _V^Ilm during stage 2, most likely related to a shift in fO₂. The proportion of 17.5 wt% is lower than the modal proportion of ilmenite (ca. 50 wt%) in the ore body, implying accumulation of ilmenite and flotation of plagioclase. The fraction of residual liquid left after crystallization of Tellnes cumulates is estimated at 0.6 and the flotation of plagioclase at 26 wt% of the initial melt mass. The increasing content of intercumulus magnetite with stratigraphic height, from 0 to ca. 3 wt%, results from differentiation of the trapped liquid towards magnetite saturation. The MgO content of ilmenite (1.4–4.4 wt%) is much lower than the expected cumulus composition. It shows extensive postcumulus re-equilibration with trapped liquid and ferromagnesian silicates, correlated with distance to the host anorthosite. The Zr content of ilmenite, provided by in situ analyses, is low (<114 ppm) and uncorrelated with stratigraphy or Cr content. The data demonstrate that zircon coronas observed around ilmenite formed by subsolidus exsolution of ZrO₂ from ilmenite. The U-Pb zircon age of 920 ± 3 Ma probably records this exsolution process. Electronic supplementary material The online version of this article (doi:) contains supplementary material, which is available to authorized users.     

Rock Mass Grouting in the Løren Tunnel: Case Study with the Main Focus on the Groutability and Feasibility of Drill Parameter Interpretation

The Løren road tunnel is a part of a major project at Ring road 3 in Oslo, Norway. The rock part of the tunnel is 915 m long and has two tubes with three lanes and breakdown lanes. Strict water ingress restriction was specified and continuous rock mass grouting was, therefore, carried out for the entire tunnel, which was excavated in folded Cambro-Silurian shales intruded by numerous dykes. This paper describes the rock mass grouting that was carried out for the Løren tunnel. Particular emphasis is placed on discussing grout consumption and the challenges that were encountered when passing under a distinct rock depression. Measurement while drilling (MWD) technology was used for this project, and, in this paper, the relationships between the drill parameter interpretation (DPI) factors water and fracturing are examined in relation to grout volumes. A lowering of the groundwater table was experienced during excavation under the rock depression, but the groundwater was nearly re-established after completion of the main construction work. A planned 80-m watertight concrete lining was not required to be built due to the excellent results from grouting in the rock depression area. A relationship was found between leakages mapped in the tunnel and the DPI water factor, indicating that water is actually present where the DPI water factor shows water in the rock. It is concluded that, for the Løren tunnel, careful planning and high-quality execution of the rock mass grouting made the measured water ingress meet the restrictions. For future projects, the DPI water factor may be used to give a better understanding of the material in which the rock mass grouting is performed and may also be used to reduce the time spent and volumes used when grouting.     

Using thermoterrace dimensions to calculate the coastal erosion rate

Thermoterraces in syngenetic ice complexes are widespread along the erosion dominated Yakutia Arctic coast. Thermoterraces progressively record quantitative information about their existence, which may be used to determine the mean shore retreat rate during the time they are present. Initial measurements of four thermoterraces on the south coast of the Dmitry Laptev Strait were carried out by the authors in 2002 and shore retreat rates were calculated. Comparison of erosion rates obtained using thermoterrace dimensions and geodetic survey results with those determined using aerial photographs showed that erosion rate values obtained in these two ways are approximately of the same order.