Coupling parameters of the MIT OBS at two nearshore sites

A model representing the coupling of an ocean-bottom seismometer (OBS) to the seafloor as a mass-spring-dashpot system satisfactorily explains the results of transient tests performed on different instruments during the Lopez Island intercomparison test. In this paper, we compare the results obtained for the MIT OBS at Lopez Island to results from similar tests at a dockside site at Woods Hole, Massachusetts. The vertical instrument response at the Lopez Island site shows a highly damped resonance at a frequency of 22 Hz, whereas the response at the Woods Hole site shows a marked resonance at 13 Hz. The difference between the responses at the two sites can be qualitatively attributed to the difference between the surficial sediments.     

Volcanic stratigraphy of DSDP/ODP Hole 395A: An interpretation using well-logging data

Deep Sea Drilling Project/Ocean Drilling Program Hole 395A was drilled approximately 500 m deep into young oceanic crust west of the Mid-Atlantic Ridge. Core recovery is very poor in this hole and therefore continuous downhole measurements are important to understand the drilled lithology. Geophysical downhole measurements were carried out during several cruises. A new set of logs was recorded during Leg 174B in summer 1997. The new logging data show a significant improvement in data quality compared to older measurements from Leg 109. The lithostratigraphy established from cores gives only limited information because of the poor core recovery in this hole. The gaps in the core lithostratigraphy are filled by reconstructing a synthetic lithological profile using the standard well-logging data. Three types of lava morphologies, massive basalts, altered lava flows, and pillow basalts, may be distinguished using the logs because the lava morphologies show differences in their physical properties due to differences in fracturing and alteration. The synthetic lithological profile gives a more detailed and precise vertical definition of single layers than the core profile. The integration of further logging and core data enables a detailed reconstruction of the accretion history at the drill site. Cyclic, upward decreasing trends in the resistivity logs were already observed during earlier cruises and were referred to magmatic cycles. Similar trends occur in the density log and, inversely, in the total gamma ray log. The trends reflect gradual changes in fracturing, porosity, permeability, and alteration and cover depth intervals of several tens of meters. Boundaries between cycles are interpreted to correspond to periods of volcanic quiescence. Two types of boundaries may be identified. Boundaries correlating with reversals in the magnetic field and/or changes in the geochemical composition of the basalts are interpreted as long pauses. Basalts separated by these boundaries were probably fed by separate magma reservoirs. Boundaries identified only by changes in alteration but not in geochemistry are interpreted to represent shorter pauses. They separate basalts that were probably fed by the same magma chamber. This revised version was published online in November 2006 with corrections to the Cover Date.     

Ozone production potential following convective redistribution of biomass burning emissions

The effects of deep convection on the potential for forming ozone (ozone production potential) in the free troposphere have been simulated for regions where the trace gas composition is influenced by biomass burning. Cloud dynamical and photochemical simulations based on observations in 1980 and 1985 Brazilian campaigns form the basis of a sensitivity study of the ozone production potential under differing conditions. The photochemical fate of pollutants actually entrained in a cumulus event of August 1985 during NASA/GTE/ABLE 2A (Case 1) is compared to photochemical ozone production that could have occurred if the same storm had been located closer to regions of savanna burning (Case 2) and forest burning (Case 3). In each case studied, the ozone production potential is calculated for a 24-hour period following convective redistribution of ozone precursors and compared to ozone production in the absence of convection. In all cases there is considerably more ozone formed in the middle and upper troposphere when convection has redistributed NO_x, hydrocarbons and CO compared to the case of no convection.In the August 1985 ABLE 2A event, entrainment of a layer polluted with biomass burning into a convective squall line changes the free tropospheric cloud outflow column (5–13 km) ozone production potential from net destruction to net production. If it is assumed that the same cloud dynamics occur directly over regions of savanna burning, ozone production rates in the middle and upper troposphere are much greater. Diurnally averaged ozone production following convection may reach 7 ppbv/day averaged over the layer from 5–13 km-compared to typical free tropospheric concentrations of 25–30 ppbv O₃ during nonpolluted conditions in ABLE 2A. Convection over a forested region where isoprene as well as hydrocarbons from combustion can be transported into the free troposphere leads to yet higher amounts of ozone production.     

The evolution and orientation of early cycle 22 active regions

The evolution of six major active regions which appeared during the first phase of the present solar cycle (cycle 22) has been studied. It was found that the northern hemisphere regions exhibited a broad range of evolutionary behavior in which the commonly accepted normal pattern (whereby the follower flux moves preferentially polewards ahead of the leader flux) is represented only at one end of the range. At the other end of the range, the leader flux is displaced polewards of the follower flux. In the latter cases equatorward extensions of the polar coronal hole are noted.While it is emphasized that some of the regions in this study follow the more conventional pattern and that all regions in this study emerged during the early phase of cycle 22, the implications for theories of the solar polar field reversals are noted.     

Unpacking multilevel adaptation to climate change in the Great Barrier Reef,Australia

Multilevel governance is regarded as a promising approach to deal with the multidimensional nature of climate change adaptation. However, the policy context in which it is implemented is very often complex and fragmented, characterised by interacting climate and non-climate strategies. An understanding of multilevel decision-making and governance is particularly important, if desired adaptation outcomes are to be achieved. This paper examines how climate change adaptation takes place in a complex multilevel system of governance, in the context of Australia's Great Barrier Reef (GBR) region. It examines over one hundred adaptation strategies at federal, state, regional and local levels in terms of type, manifestation, purposefulness, drivers and triggers, and geographic and temporal scope. Interactions between strategies are investigated both at the same level of governance and across governance levels. This study demonstrates that multilevel approach is a necessary, but not a sufficient condition in responding to complex multiscale and multisector issues, such as climate change adaptation. Short-term adaptation measures; a predominant incremental, sectoral, top-down approach to adaptation; and the lack of a framework for managing interactions are major threats to effective climate adaptation in the GBR region. Coping with such threats will require long-term transformative action, establishing enabling conditions to support local adaptation, and, most important, creating and maintaining strategic interactions among adaptation strategies. Coordinating and integrating climate and non-climate strategies across jurisdictions and policy sectors are the most significant and challenging tasks for multilevel governance in the GBR region and elsewhere.     

A new approach for vertical impedance in radially inhomogeneous soil layer

In the past studies on pile vibrations, the soil around the pile is mainly regarded as homogeneous or multi‐layered piecewise homogeneous. However, under most engineering conditions, the surrounding soil becomes seriously disturbed due to construction effects. This may strengthen or weaken the shear modulus of the soil resulting in the soil becoming radially inhomogeneous. As a consequence of this, El Naggar extended Novak's plane‐strain model to account for the radial inhomogeneity by the use of multiple springs connected in series. Rather than using this approach, this paper proposes a new model which is thought to be theoretically more rigorous and one which may be described as complex stiffness transfer model. It is shown that the solution developed in this study agrees well with the more limited solutions of Novak and Dotson and Veletsos under several special conditions. Finally, the scope of application has been enlarged as a result of the generalizations made in the present model. Copyright © 2011 John Wiley & Sons, Ltd.     

Use of stable water isotopes to assess sources and influences of slope groundwater on slope failure

This study employs stable oxygen and hydrogen isotopes as natural tracers to assess the headwater of a landslide next to a drainage divide and the importance of the slope's headwater in the study area. The study is undertaken near Wu‐She Township in the mountains of central Taiwan. Because a reservoir is located on the other side of the divide, this study evaluates the relationship between the reservoir water and headwater of the landslide as well. Over a 1‐year period, water samples from September 2008 to September 2009, including local precipitation (LP), Wu‐She Reservoir's water (WSRW), slope groundwater (SGW), upper‐reach stream water (USTW), and down‐reach stream water (DSTW), were analysed for deuterium (δD) and oxygen (δ¹⁸O) stable isotopes. Results indicate that WSRW is the predominant component in SGW: approximately 70% of SGW originates from WSRW and 30% from LP based on a two end‐member mass‐balance mixing model for δ¹⁸O. The similar two end‐member mixing model is also employed to assess the contributions of USTW and SGW to DSTW. Model results indicate that SGW is the major source of DSTW with a contribution of about 67%. Accordingly, about 47% of DSTW sources from the WSRW. In short, owing to reservoir leakage, WSRW contributes the greater part of both SGW and DSTW. Plentiful WSRW in SGW threatens the stability of the slope in the divide area. To avoid subsequent continuous slope failure, necessary mitigation steps are required. Copyright © 2011 John Wiley & Sons, Ltd.     

The interplay of sediment characteristics,depth, water temperature,and ocean currents shaping the biogeography of lancelets (Subphylum Cephalochordata) in the NW Pacific waters

Lancelets (or amphioxus) are often found within the soft bottom of shallow tropical and temperate seas. The present study is the first to provide a fine‐scale biogeography of five species of lancelets (Asymmetron lucayanum, Branchiostoma belcheri, Branchiostoma japonicum, Epigonichthys cultellus, and Epigonichthys maldivensis) in the NW Pacific and examine the effects of multiple environmental parameters. From multivariate analyses, the distribution and abundance patterns of lancelets were explained by a combination of factors comprising depth, temperature of the collecting month, mean temperature of the coldest month in the year, medium particle size and silt/clay ratio of the sediments. In addition, ocean currents also affect their distribution range. The major occurrence of A. lucayanum and E. maldivensis was associated with the warm Kuroshio current, but E. maldivensis exhibited higher tolerance to low salinity and low temperature, and preferred substrata of slightly larger grain size, a lower ratio of suspended sediments, and deeper water. The closely related B. belcheri and B. japonicum exhibited fine‐scale habitat differentiation, and B. japonicum was abundant along the southern coast of China, where the salinity is lower in winter because of the China Coastal Current and the substratum is composed of very coarse sand with suspended sediments. Branchiostoma belcheri occurred in low abundance and was only recorded in Northern Taiwan and the Taiwan Banks. Epigonichthys cultellus was found only at the Taiwan Banks, which had deep water, coarse sand, and a negligible amount of suspended sediments.     

Development of a fluorescence quenching assay to measure the fraction of organic carbon present in self-assembled gels in seawater

The dissolved organic carbon pool (DOC) is among the largest reservoir of reduced carbon on our planet. The demonstration that DOC polymers remain in assembly/dispersion equilibrium forming microscopic hydrogels has a broad range of critical implications. Previous studies estimate that  10% of DOC could be assembled as gels, yielding values of  7 × 10¹⁶ g of organic carbon present as microscopic hotspots of high substrate concentration. This huge mass of reduced carbon emphasizes the need to develop reliable methods to systematically investigate the budget of self-assembled marine gels (SAG), and their role in biogeochemical cycling. However, a quantitative method to measure SAG in seawater has not been available. Here we present the validation of a simple assay to measure the mass of organic carbon assembled as microgels in native seawater. This method is based on the ratio of Chlortetracycline (CTC) fluorescence quenching between Ca bound to non-assembled organic molecules and molecules assembled as microgels. This assay can be readily implemented on board using a low cost fluorometer and provisions to measure TOC.