‘Committing to Place’ at the Local Scale: the potential of youth education programs for promoting community participation in regional natural resource management

Emerging approaches to environmental governance require a greater level of community participation than did previous approaches in which these responsibilities largely rested with government agencies. There is consequently a need for increased engagement with NRM among a broad community sector. This paper examines initiatives by two prominent government agencies, the Murray–Darling Basin Commission (MDBC) and the National Museum of Australia (NMA), to engage school children from regional communities using education programs that focus on place and environmental health. We focus on the MDBC's International Riverhealth Conference held in Mildura in 2003 and the associated Murray–Darling Basin TalkBack Classroom sponsored by the NMA and the Parliamentary Education Office (PEO). We explore how key themes of local scale, place-based identities, youth voice and critical engagement are developed in these programs and consider how they relate to the environmental agency of children. We then reflect on the potential for the kinds of environmental agency promoted through these programs to help build the capacity of local communities to progress larger goals of environmental restoration and sustainability in the Murray–Darling Basin. The evaluation research reported here forms part of the Committing to Place research project, an Australian Research Council Linkage grant involving the University of Tasmania, the National Museum of Australia and the Murray–Darling Basin Commission.     

The chronology of a large ice-dammed lake and the Barents–Kara Ice Sheet advances, Northern Russia

Beach and shoreface sediments deposited in the more than 800-km long ice-dammed Lake Komi in northern European Russia have been investigated and dated. The lake flooded the lowland areas between the Barents–Kara Ice Sheet in the north and the continental drainage divide in the south. Shoreline facies have been dated by 18 optical stimulated luminescence (OSL) dates, most of which are closely grouped in the range 80–100 ka, with a mean of 88±3 ka. This implies that that the Barents–Kara Ice Sheet had its Late Pleistocene maximum extension during the Early Weichselian, probably in the cold interval (Rederstall) between the Brørup and Odderade interstadials of western Europe, correlated with marine isotope stage 5b. This is in strong contrast to the Scandinavian and North American ice sheets, which had their maxima in isotope stage 2, about 20 ka. Field and air photo interpretations suggest that Lake Komi was dammed by the ice advance, which formed the Harbei–Harmon–Sopkay Moraines. These has earlier been correlated with the Markhida moraine across the Pechora River Valley and its western extension. However, OSL dates on fluvial sediments below the Markhida moraine have yielded ages as young as 60 ka. This suggests that the Russian mainland was inundated by two major ice sheet advances from the Barents–Kara seas after the last interglacial: one during the Early Weichselian (about 90 ka) that dammed Lake Komi and one during the Middle Weichselian (about 60 ka). Normal fluvial drainage prevailed during the Late Weichselian, when the ice front was located offshore.     

Late Wisconsinan glaciation models of northern Maine and adjacent Canada

Surficial stratigraphic units of Aroostook County, Maine, have been mapped and formal stratigraphic names for these units are proposed. Evidence exists for at least two distinct glacial phases which are represented by three tills. Two of these tills were deposited penecontemporaneously either as the result of coalescing ice sheets or as the result of the thermal regime existing within a single ice sheet. The oldest till is named the St. Francis and is correlated with the Chaudière Till of southeastern Quebec. The other tills are named the Mars Hill and Van Buren tills, respectively, and are correlated with the Lennoxville till of southeastern Quebec. Interbedded stratified sediments associated with the St. Francis till are correlated with the Gayhurst Formation. Stratified sediments associated with Van Buren and Mars Hill tills are correlated with post Lennoxville sediments of Quebec. Granite-gneiss erratics of Canadian Shield provenance in the Van Buren till indicate advance of the Laurentide ice into northern Maine during late Wisconsinan time. Moraines in southern Aroostook County with associated outwash and eskers record general recession from coastal Maine. Recession occurred after the formation of the Pineo Ridge moraine in Maine and the St. Antonin-Highland Front moraine complex in Quebec. The Caribou-Winterville moraine complex in northern Maine marks the boundary between the penecontemporaneously deposited Van Buren and Mars Hill surface tills and is correlated with the Grand Falls moraine at Grand Falls, New Brunswick.     

Water Resources Implications of Global Warming: A U.S. Regional Perspective

The implications of global warming for the performance of six U.S. water resource systems are evaluated. The six case study sites represent a range of geographic and hydrologic, as well as institutional and social settings. Large, multi-reservoir systems (Columbia River, Missouri River, Apalachicola-Chatahoochee-Flint (ACF) Rivers), small, one or two reservoir systems (Tacoma and Boston) and medium size systems (Savannah River) are represented. The river basins range from mountainous to low relief and semi-humid to semi-arid, and the system operational purposes range from predominantly municipal to broadly multi-purpose. The studies inferred, using a chain of climate downscaling, hydrologic and water resources systems models, the sensitivity of six water resources systems to changes in precipitation, temperature and solar radiation. The climate change scenarios used in this study are based on results from transient climate change experiments performed with coupled ocean-atmosphere General Circulation Models (GCMs) for the 1995 Intergovernmental Panel on Climate Change (IPCC) assessment. An earlier doubled-CO₂ scenario from one of the GCMs was also used in the evaluation. The GCM scenarios were transferred to the local level using a simple downscaling approach that scales local weather variables by fixed monthly ratios (for precipitation) and fixed monthly shifts (for temperature). For those river basins where snow plays an important role in the current climate hydrology (Tacoma, Columbia, Missouri and, to a lesser extent, Boston) changes in temperature result in important changes in seasonal streamflow hydrographs. In these systems, spring snowmelt peaks are reduced and winter flows increase, on average. Changes in precipitation are generally reflected in the annual total runoff volumes more than in the seasonal shape of the hydrographs. In the Savannah and ACF systems, where snow plays a minor hydrological role, changes in hydrological response are linked more directly to temperature and precipitation changes. Effects on system performance varied from system to system, from GCM to GCM, and for each system operating objective (such as hydropower production, municipal and industrial supply, flood control, recreation, navigation and instream flow protection). Effects were generally smaller for the transient scenarios than for the doubled CO₂ scenario. In terms of streamflow, one of the transient scenarios tended to have increases at most sites, while another tended to have decreases at most sites. The third showed no general consistency over the six sites. Generally, the water resource system performance effects were determined by the hydrologic changes and the amount of buffering provided by the system's storage capacity. The effects of demand growth and other plausible future operational considerations were evaluated as well. For most sites, the effects of these non-climatic effects on future system performance would about equal or exceed the effects of climate change over system planning horizons.     

Revisiting the morphological method in two-dimensions to quantify bed-material transport in braided rivers

Research in the 1990s showed that bed-material transport rates could be estimated at the reach scale in both one-dimension and, over small spatial scales (10s of m), in two-dimensions. The limit on the latter was the spatial scale over which it was possible to obtain distributed data on morphological change. Here, we revisit the morphological method given progress in both topographical data acquisition and hydraulic modelling. The bed-material transport needed to conserve mass is calculated in both one and two dimensions for a 1600 m × 300 m Alpine braided river “laboratory”. High-resolution topographical data were acquired by laser scanning to quantify Digital Elevation Models (DEMs), and morphological changes caused by the flushing of the water intake were derived from repeated surveys. Based on DEMs of differences, 1D bed-material transport rates were calculated using the morphological method. Then, a 2D hydraulic model was combined with a topographic correction to route sediment through the network of braided channels and to obtain a spatially variable estimate of transport in both downstream and cross-stream directions. Monte Carlo simulation was applied to the routing model parameters, allowing identification of the most probable parameter values needed to minimize negative transport. The results show that within-section spatial compensation of erosion and deposition using the 1D treatment leads to substantial local errors in transport rate estimates, to a degree related to braiding intensity. Even though the 2D application showed that a large proportion of the total transport was actually concentrated into one main channel during the studied low flow event, the proportion of transport in secondary anabranches is substantial when the river starts braiding. Investigations of the effects of DEM resolution, competent flow duration and survey frequency related to ‘travelling bedload’ and sequential erosion-deposition emphasized the critical importance of careful data collection in the application of the morphological method. © 2019 John Wiley & Sons, Ltd.     

Structural controls on the formation of BSR over a diapiric anticline from a dense MCS survey offshore southwestern Taiwan

A dense seismic reflection survey with up to 250-m line-spacing has been conducted in a 15 × 15 km wide area offshore southwestern Taiwan where Bottom Simulating Reflector is highly concentrated and geochemical signals for the presence of gas hydrate are strong. A complex interplay between north–south trending thrust faults and northwest–southeast oblique ramps exists in this region, leading to the formation of 3 plunging anticlines arranged in a relay pattern. Landward in the slope basin, a north–south trending diapiric fold, accompanied by bright reflections and numerous diffractions on the seismic profiles, extends across the entire survey area. This fold is bounded to the west by a minor east-verging back-thrust and assumes a symmetric shape, except at the northern and southern edges of this area, where it actively overrides the anticlines along a west-verging thrust, forming a duplex structure. A clear BSR is observed along 67% of the acquired profiles. The BSR is almost continuous in the slope basin but poorly imaged near the crest of the anticlines. Local geothermal gradient values estimated from BSR sub-bottom depths are low along the western limb and crest of the anticlines ranging from 40 to 50 °C/km, increase toward 50–60 °C/km in the slope basin and 55–65 °C/km along the diapiric fold, and reach maximum values of 70 °C/km at the southern tip of the Good Weather Ridge. Furthermore, the local dips of BSR and sedimentary strata that crosscut the BSR at intersections of any 2 seismic profiles have been computed. The stratigraphic dips indicated a dominant east–west shortening in the study area, but strata near the crest of the plunging anticlines generally strike to southwest almost perpendicular to the direction of plate convergence. The intensity of the estimated bedding-guided fluid and gas flux into the hydrate stability zone is weaker than 2 in the slope basin and the south-central half of the diapiric fold, increases to 7 in the northern half of the diapiric fold and plunging anticlines, and reaches a maximum of 16 at the western frontal thrust system. Rapid sedimentation, active tectonics and fluid migration paths with significant dissolved gas content impact on the mechanism for BSR formation and gas hydrate accumulation. As we begin to integrate the results from these studies, we are able to outline the regional variations, and discuss the importance of structural controls in the mechanisms leading to the gas hydrate emplacements.     

Cryptic sequence boundaries in braided fluvial successions

In braided fluvial deposits, consisting of monotonous successions of sandstone or conglomerate, it may be difficult to distinguish regionally significant bounding surfaces (sequence boundaries) from autogenic channel-scour surfaces. Major surfaces may be characterized by erosional relief and draped by lag deposits, but not all sequence boundaries show these characteristics. Other clues to the presence of a major surface are sharp changes in detrital composition, shifts in regional palaeocurrent trends and evidence of early diagenesis of the sandstones immediately below the sequence boundary. Examples of these attributes of cryptic sequence boundaries are illustrated from three Mesozoic units in the Colorado Plateau area of the United States. In the Chinle Formation (Triassic), near Moab, Utah, angular intraformational unconformities overlie sandstones showing evidence of early diagenesis. In the Castlegate Sandstone (Upper Cretaceous) of east-central Utah, a cryptic sequence boundary can be discriminated from other erosion surfaces by the evidence of detrital petrography and early diagenesis. Palaeocurrent data indicate changes in regional palaeoslope at two sequence boundaries within this unit. Evidence of early diagenesis is also present at a sequence boundary in the Kayenta Formation (Jurassic) of westernmost Colorado.     

Hazardous processes and events from glacier and permafrost areas: lessons from the Chilean and Argentinean Andes

Glacier and permafrost hazards such as glacial‐lake outburst floods and rock–ice avalanches cause significant socio‐economic damages worldwide, and these processes may increase in frequency and magnitude if the atmospheric temperature rises. In the extratropical Andes nearly 200 human deaths were linked to these processes during the twentieth century. We analysed bibliographical sources and satellite images to document the glacier and permafrost dynamics that have caused socio‐economic damages in this region in historic time (including glacial lake outburst floods, ice and rock–ice avalanches and lahars) to unravel their causes and geomorphological impacts. In the extratropical Andes, at least 15 ice‐dammed lakes and 16 moraine‐dammed lakes have failed since the eighteenth century, causing dozens of floods. Some floods rank amongst the largest events ever recorded (5000 × 10⁶ m³ and 229 × 10⁶ m³, respectively). Outburst flood frequency has increased in the last three decades, partially as a consequence of long‐term (decades to centuries) climatic changes, glaciers shrinkage, and lake growth. Short‐term (days to weeks) meteorological conditions (i.e. intense and/or prolonged rainfall and high temperature that increased meltwater production) have also triggered outburst floods and mass movements. Enormous mass failures of glaciers and permafrost (> 10 × 10⁶ m³) have impacted lakes, glaciers, and snow‐covered valleys, initiating chain reactions that have ultimately resulted in lake tsunamis and far‐reaching (> 50 km) flows. The eruption of ice‐covered volcanoes has also caused dozens of damaging lahars with volumes up to 45 × 10⁶ m³. Despite the importance of these events, basic information about their occurrence (e.g. date, causes, and geomorphological impact), which is well established in other mountain ranges, is absent in the extratropical Andes. A better knowledge of the processes involved can help to forecast and mitigate these events. Copyright © 2014 John Wiley & Sons, Ltd.     

A community-wide intercomparison exercise for the determination of dissolved iron in seawater

The first large-scale international intercomparison of analytical methods for the determination of dissolved iron in seawater was carried out between October 2000 and December 2002. The exercise was conducted as a rigorously “blind” comparison of 7 analytical techniques by 24 international laboratories. The comparison was based on a large volume (700 L), filtered surface seawater sample collected from the South Atlantic Ocean (the “IRONAGES” sample), which was acidified, mixed and bottled at sea. Two 1-L sample bottles were sent to each participant. Integrity and blindness were achieved by having the experiment designed and carried out by a small team, and overseen by an independent data manager. Storage, homogeneity and time-series stability experiments conducted over 2.5 years showed that inter-bottle variability of the IRONAGES sample was good (< 7%), although there was a decrease in iron concentration in the bottles over time (0.8–0.5 nM) before a stable value was observed. This raises questions over the suitability of sample acidification and storage.